Chemiluminescence detection with water-soluble iridium(III) complexes containing a sulfonate-functionalised ancillary ligand

The chemiluminescence from four cyclometalated iridium(III) complexes containing an ancillary bathophenanthroline-disulfonate ligand exhibited a wide range of emission colours (green to red), and in some cases intensities that are far greater than the commonly employed benchmark reagent, [Ru(bpy)3](2+). A similar complex incorporating a sulfonated triazolylpyridine-based ligand enabled the emission to be shifted into the blue region of the spectrum, but the responses with this complex were relatively poor. DFT calculations of electronic structure and emission spectra support the experimental findings.

A comparison of novel organoiridium(III) complexes and their ligands as a potential treatment for prostate cancer

A range of 1,4-substituted 2-pyridyl-N-phenyl triazoles were synthesised and evaluated for their antiproliferative properties against lymph node cancer of the prostate (LNCaP) and bone metastasis of prostate cancer (PC-3) cells. Excellent-to-low IC50 values were determined (5.6-250 μM), and a representative group of 4 ligands were then complexed to iridium(III) giving highly luminescent species. Re-evaluation of these compounds against both cell lines was then undertaken and improved potency (up to 72-fold) was observed, giving IC50 values of 0.36-11 μM for LNCaP and 0.85-5.9 μM for PC-3. Preliminary screens for in vivo toxicity were conducted using a zebrafish model showing a wide range of induced toxicity depending of the compound evaluated. Apoptosis and Caspase-3 levels were also determined and showed no statistical difference between some of the treated specimens and the controls. This study may identify novel therapeutic agents for advanced stage of prostate cancer in humans.

Iridium(III) N-heterocyclic carbene complexes: an experimental and theoretical study of structural, spectroscopic, electrochemical and electrogenerated chemiluminescence properties

Four cationic heteroleptic iridium(III) complexes have been prepared from methyl- or benzyl-substituted chelating imidazolylidene or benzimidazolylidene ligands using a Ag(I) transmetallation protocol. The synthesised iridium(III) complexes were characterised by elemental analysis, (1)H and (13)C NMR spectroscopy and the molecular structures for three complexes were determined by single crystal X-ray diffraction. A combined theoretical and experimental investigation into the spectroscopic and electrochemical properties of the series was performed in order to gain understanding into the factors influencing photoluminescence and electrochemiluminescence efficiency for these complexes, with the results compared with those of similar NHC complexes of iridium and ruthenium. The N^C coordination mode in these complexes is thought to stabilise thermally accessible non-emissive states relative to the case with analogous complexes with C^C coordinated NHC ligands, resulting in low quantum yields. As a result of this and the instability of the oxidised and reduced forms of the complexes, the electrogenerated chemiluminescence intensities for the compounds are also low, despite favourable energetics. These studies provide valuable insights into the factors that must be considered when designing new NHC-based luminescent complexes.

Blue electrogenerated chemiluminescence from water-soluble iridium complexes containing sulfonated phenylpyridine or tetraethylene glycol derivatized triazolylpyridine ligands

Incorporating phenylpyridine- and triazolylpyridine-based ligands decorated with methylsulfonate or tetraethylene glycol (TEG) groups, a series of iridium(III) complexes has been created for green and blue electrogenerated chemiluminescence under analytically useful aqueous conditions, with tri-n-propylamine as a coreactant. The relative electrochemiluminescence (ECL) intensities of the complexes were dependent on the sensitivity of the photodetector over the wavelength range and the pulse time of the applied electrochemical potential. In terms of the integrated area of corrected ECL spectra, with a pulse time of 0.5 s, the intensities of the Ir(III) complexes were between 18 and 102 % that of [Ru(bpy)3 ](2+) (bpy=2,2'-bipyridine). However, when the intensities were measured with a typical bialkali photomultiplier tube, the signal of the most effective blue emitter, [Ir(df-ppy)2 (pt-TEG)](+) (df-ppy=2-(2,4-difluorophenyl)pyridine anion, pt-TEG=1-(2-(2-(2-(2-hydroxyethoxy)ethoxy)ethoxy)ethyl)-4-(2-pyridyl)-1,2,3-triazole), was over 1200 % that of the orange-red emitter [Ru(bpy)3 ](2+) . A combined experimental and theoretical investigation of the electrochemical and spectroscopic properties of the Ir(III) complexes indicated that the greater intensity from [Ir(df-ppy)2 (pt-TEG)](+) relative to those of the other Ir(III) complexes resulted from a combination of many factors, rather than being significantly favored in one area.

Control of excitation and quenching in multi-colour electrogenerated chemiluminescence systems through choice of co-reactant

We demonstrate a new approach to manipulate the selective emission in mixed electrogenerated chemiluminescence (ECL) systems, where subtle changes in co-reactant properties are exploited to control the relative electron-transfer processes of excitation and quenching. Two closely related tertiary-amine co-reactants, tri-n-propylamine and N,N-diisopropylethylamine, generate remarkably different emission profiles: one provides distinct green and red ECL from [Ir(ppy)3] (ppy=2-phenylpyridinato-C2,N) and a [Ru(bpy)3](2+) (bpy=2,2'-bipyridine) derivative at different applied potentials, whereas the other generates both emissions simultaneously across a wide potential range. These phenomena can be rationalized through the relative exergonicities of electron-transfer quenching of the excited states, in conjunction with the change in concentration of the quenchers over the applied potential range.

Considering the chemical energy requirements of the tri-n-propylamine co-reactant pathways for the judicious design of new electrogenerated chemiluminescence detection systems

The introduction of a 'co-reactant' was a critical step in the evolution of electrogenerated chemiluminescence (ECL) from a laboratory curiosity to a widely utilised detection system. In conjunction with a suitable electrochemiluminophore, the co-reactant enables generation of both the oxidised and reduced precursors to the emitting species at a single electrode potential, under the aqueous conditions required for most analytical applications. The most commonly used co-reactant is tri-n-propylamine (TPrA), which was developed for the classic tris(2,2'-bipyridine)ruthenium(ii) ECL reagent. New electrochemiluminophores such as cyclometalated iridium(iii) complexes are also evaluated with this co-reactant. However, attaining the excited states in these systems can require much greater energy than that of tris(2,2'-bipyridine)ruthenium(ii), which has implications for the co-reactant reaction pathways. In this tutorial review, we describe a simple graphical approach to characterise the energetically feasible ECL pathways with TPrA, as a useful tool for the development of new ECL detection systems.

Mobile phone-based electrochemiluminescence sensing exploiting the 'USB On-The-Go' protocol

A low-cost system to generate, control and detect electrochemiluminescence using a mobile smartphone is described. A simple tone-detection integrated circuit is used to switch power sourced from the phone's Universal Serial Bus (USB) 'On-The-Go' (OTG) port, using audible tone pulses played over the device's audio jack. We have successfully applied this approach to smartphones from different manufacturers and with different operating system versions. ECL calibrations of a common luminophore, tris(2,2′-bipyridine)ruthenium(II) ([Ru(bpy)3]²⁺), with 2-(dibutylamino)ethanol (DBAE) as a co-reactant, showed no significant difference in light intensities when an electrochemical cell was controlled by a mobile phone in this manner, compared to the same calibration generated using a conventional potentiostat. Combining this novel approach to control the applied potential with the measurement of the emitted light through the smart phone camera (using an in-house built Android app), we explored the ECL properties of a water-soluble iridium(III) complex that emits in the blue region of the spectrum. The iridium(III) complex exhibited superior co-reactant ECL intensities and limits of detection to that of the conventional [Ru(bpy)3]²⁺ luminophore.

Potential-resolved electrogenerated chemiluminescence for the selective detection of multiple luminophores

Electrogenerated chemiluminescence (ECL) is fundamentally dependent on the applied electrode potential, and measuring ECL intensity over a range of different potentials is commonly used to examine the underlying chemical reaction pathways responsible for the emission of light. Several research groups have now demonstrated that the applied potential can be exploited to selectively elicit ECL from: 1) multiple excited states within a single chemical species; 2) multiple emitters sharing a common co-reactant; or 3) distinct ECL systems. This new generation of multiplexed ECL processes has been facilitated by the extensive development of novel electrochemiluminophores and instrumental approaches such as the near-continuous collection of ECL spectra with CCD detectors during voltammetry or chronoamperometry experiments. New dimensions: In electrogenerated chemiluminescence experiments the applied potential can be exploited to selectively elicit light from: multiple excited states within a single chemical species, multiple emitters sharing a common co-reactant, and distinct electrogenerated chemiluminescence systems. These findings may be used to develop low-cost portable analytical devices.

Synthesis, structure and spectral properties of dithiocarbamato bridged dirhenium(III,II) complexes: a combined experimental and theoretical study

Sodium salts of dimethyldithiocarbamate, diethyldithiocarbamate and pyrrolidinedithiocarbamate react with the multiply bonded paramagnetic dirhenium(III,II) complex Re₂(μ-O₂CCH₃)Cl₄(μ-dppm)₂, 1 (dppm = Ph₂PCH₂PPh₂) in refluxing ethanol to afford the paramagnetic substitution products of the type Re₂(η²-S,S)₂(μ-S,S)(μ-Cl)₂(μ-dppm), where S,S represents the dithiocarbamato ligands [S,S = S₂CNMe₂, 4(L_Me); S₂CNEt₂, 4(L_Et) and S₂CN(CH₂)₄, 4(L_Pyr)]. These are the first examples of dirhenium complexes that contain bridging dithiocarbamato ligand along with the dppm ligand. These complexes have very similar spectral (UV-Vis, IR, EPR) and electrochemical properties which are also reported. The identity of 4(L_Et) has been established by single-crystal X-ray structure determination (Re-Re distance 2.6385 (9) Å) and is shown to have edge-shared bioctahedral structure. The electronic structure and the absorption spectra of the complexes are scrutinized by the density functional theory (DFT) and time-dependent density functional theory (TD-DFT) analyses.

Green chemiluminescence from a bis-cyclometalated iridium(III) complex with an ancillary bathophenanthroline disulfonate ligand

The reaction of a fluorinated iridium complex with cerium(IV) and organic reducing agents generates an intense emission with a significant hypsochromic shift compared to contemporary chemically-initiated luminescence from metal complexes.

Evaluation of selected platinum group metal complexes as chemiluminescence reagents

This research extends the investigations into the chemiluminescence and electrochemiluminescence of platinum group metal reagents and their applications. The effect of the chemical nature of tris(2,2'-bipyridyl)ruthenium(II) and selected analogues on the chemiluminescence reaction is further explored, and this chemistry is extended to include novel iridium(III) and osmium(II) based chemiluminescence reagents.

New perspectives on the annihilation electrogenerated chemiluminescence of mixed metal complexes in solution

Preliminary explorations of the annihilation electrogenerated chemiluminescence (ECL) of mixed metal complexes have revealed opportunities to enhance emission intensities and control the relative intensities from multiple luminophores through the applied potentials. However, the mechanisms of these systems are only poorly understood. Herein, we present a comprehensive characterisation of the annihilation ECL of mixtures of tris(2,2′-bipyridine)ruthenium(ii) hexafluorophosphate ([Ru(bpy)3](PF6)2) and fac-tris(2-phenylpyridine)iridium(iii) ([Ir(ppy)3]). This includes a detailed investigation of the change in emission intensity from each luminophore as a function of both the applied electrochemical potentials and the relative concentrations of the two complexes, and a direct comparison with two mixed (Ru/Ir) ECL systems for which emission from only the ruthenium-complex was previously reported. Concomitant emission from both luminophores was observed in all three systems, but only when: (1) the applied potentials were sufficient to generate the intermediates required to form the electronically excited state of both complexes; and (2) the concentration of the iridium complex (relative to the ruthenium complex) was sufficient to overcome quenching processes. Both enhancement and quenching of the ECL of the ruthenium complex was observed, depending on the experimental conditions. The observations were rationalised through several complementary mechanisms, including resonance energy transfer and various energetically favourable electron-transfer pathways.