Experimental evaluation of curl and tensile properties of advanced high strength sheet steels

The response of HSLA steel, 590R, and dual-phase steel, DP-600, to non-uniform deformation imposed in a laboratory Bending-Under-Tension (BUT) test apparatus was evaluated. Samples were deformed with both low and high back tension forces at bend angles of 45 and 90 degrees, and evaluated to determine the ""side-wall curl,"" i.e., the curvature in the sheet section in contact with the die. The results indicate that there are no consistent differences between the two steels, 590R and DP-600. It was found that back tension, tensile strength and sheet thickness were the primary factors affecting curl. The bend angle has an influence on curl, with the curl radius at a 90ø bend angle being greater than the curl radius at a 45\mD bend angle.

Experimental investigation of the dissolution of quartz by a muscovite mica surface : implications for pressure solution

Using the surface forces apparatus, which can measure small changes in thickness occurring even at essentially geological timescales, we have measured dissolution of quartz sheets when pressed against muscovite mica surfaces in aqueous electrolyte solution, but no dissolution is observed under dry conditions. It is postulated that the dissolved quartz may reprecipitate outside the contact junction as a fragile silica gel, which could be the main factor limiting the rate of further dissolution.