Blocking semiovals of Type (1,M+1,N+1)

We consider the existence of blocking semiovals in finite projective planes which have intersection sizes 1, m+1 or n+1 with the lines of the plane for $1 \leq m < n$. For those prime powers $q \leq 1024$, in almost all cases, we are able to show that, apart from a trivial example, no such blocking semioval exists in a projective plane of order q. We are also able to prove, for general q, that if q2+q+1 is a prime or three times a prime, then only the same trivial example can exist in a projective plane of order q.

Electromagnetic shielding properties of polypyrrole/polyester composites in the 1–18 GHz frequency range

The dielectric characteristics of conducting polymer-coated textiles in the frequency range 1–18 GHz were investigated using a non-contact, non-destructive free space technique. Polypyrrole coatings were applied by solution polymerization on fabric substrates using a range of concentrations of para-toluene-2-sulfonic acid (pTSA) as dopant and ferric chloride as oxidant. The conducting polymer coatings exhibited dispersive permittivity behaviour with a decrease in real and imaginary components of complex permittivity as frequency increased in the range tested. Both the permittivity and the loss factor were affected by the polymerization time of the conductive coating. It was found that the total shielding efficiency of these conductive fabrics is significant at short polymerization times and increases to values exceeding 80% with longer polymerization times. The reflection contribution to electromagnetic shielding also increases with polymerization time.

A new approach for reducing blocking artefacts using linear filter for block based transform coded images

This paper presents a new approach to filtering the reconstructed image of block based transform coded images.

Reducing blocking artefacts in MPEG video coded images using entropic methods

In this paper investigation is made of the. use of entropic methods to identify smooth image blocks in order to filter the reconstructed image of block based transform coded images. We know that blocking artefact is Visually more prominent in the smooth region of a block rather than in the textured region. The entropic methods are employed to distinguish between smooth and textured blocks in a reconstructed image. The linear filtering is then carried out on the smooth region of the image to reduce the blocking artefact. The en tropic criteria investigated in this paper are: Shannon's (Logarithmic) Entropy, Exponential Entropy, and Quadratic Entropy.

Performance of statistical inference for block classification in reducing blocking artefact in video coded images

This paper presents a performance study of four statistical test algorithms used to identify smooth image blocks in order to filter the reconstructed image of a video coded image. The four algorithms considered are the Coefficient of Variation (CV), Exponential Entropy of Pal and Pal (E), Shannon's (Logarithmic) Entropy (H), and Quadratic Entropy (Q). These statistical algorithms are employed to distinguish between smooth and textured blocks in a reconstructed image. The linear filtering is carried out on the smooth blocks of the image to reduce the blocking artefact. The rationale behind applying the filter on the smooth blocks only is that the blocking artefact is visually more prominent in the smooth region of an image rather than in the textured region.

Electromagnetic receiving properties of overhead power line

This paper examines the use of overhead power transmission lines as electromagnetic sensors for detecting electric discharges caused by defective power transmission equipment. The experimental study involved the use of a spark gap (point-point configuration) and two HV conductors of different lengths to simulate electric discharge that takes place on transmission line. The experimental results show that large amount of energy are coupled onto the conductors and the amount of electromagnetic energy is dependent on the length of the conductor and the distance between the source and the conductor.

Electromagnetic interference shielding and radiation absorption in thin polypyrrole films

Results of permittivity measurements, electromagnetic interference shielding effectiveness, and heat generation due to microwave absorption in conducting polymer coated textiles are reported and discussed. The intrinsically conducting polymer, polypyrrole, doped with anthraquinone-2-sulfonic acid (AQSA) or para-toluene-2-sulfonic acid (pTSA) was applied on textile substrates and the resulting materials were investigated in the frequency range 1–18 GHz. The 0.54 mm thick conducting textile/polypyrrole composites absorbed up to 49.5% of the incident 30–35 W microwave radiation. A thermography station was used to monitor the temperature of these composites during the irradiation process, where absorption was confirmed via visible heat losses. Samples with lower conductivity showed larger temperature increases caused by microwave absorption compared to samples with higher conductivity. A sample with an average sheet resistivity of 150 Ω/sq. showed a maximum temperature increase of 5.27 °C, whilst a sample with a lower resistivity (105 Ω/sq.) rose by 3.85 °C.

Conducting polymer coated fabrics for potential applications in microwave frequencies : a study of electromagnetic properties

The microwave reflection, transmission and complex permittivity of paratoluene-2-sulfonic acid doped conducting polypyrrole (PPy/pTSA) coated Nylon-Lycra textiles in the 1-18 GHz frequency were investigated. The real part of permittivity increased with polymerization time and dopant concentration, reaching a plateau at certain dopant concentration and polymerization time. The imaginary part of permittivity showed a frequency dependent change throughout the tested range. All the samples had higher values of absorption than reflection. The total electromagnetic shielding effectiveness exceeded 80% for the highly pTSA doped samples coated for 3 hours.

Ice and pulsed electromagnetic field to reduce pain and swelling after distal radius fractures

Objective: To examine the relative effectiveness of ice therapy and/or pulsed electromagnetic field in reducing pain and swelling after the immobilization period following a distal radius fracture.Methods: A total of 83 subjects were randomly allocated to receive 30 minutes of either ice plus pulsed electromagnetic field (group A); ice plus sham pulsed electromagnetic field (group B); pulsed electromagnetic field alone (group C), or sham pulsed electromagnetic field treatment for 5 consecutive days (group D). All subjects received a standard home exercise programme. A visual analogue scale was used for recording pain; volumetric displacement for measuring the swelling of the forearm; and a hand-held goniometer for measuring the range of wrist motions before treatment on days 1, 3 and 5.Results: At day 5, a significantly greater cumulative reduction in the visual analogue scores as well as ulnar deviation range of motion was found in group A than the other 3 groups. For volumetric measurement and pronation, participants in group A performed better than subjects in group D but not those in group B.Conclusion: The addition of pulsed electromagnetic field to ice therapy produces better overall treatment outcomes than ice alone, or pulsed electromagnetic field alone in pain reduction and range of joint motion in ulnar deviation and flexion for a distal radius fracture after an immobilization period of 6 weeks.

A study of the effects of flux density and frequency on Pulsed electromagnetic field on Neurite outgrowth in PC12 cells.

The aim of this study was to investigate the influence of pulsed electromagnetic fields with various flux densities and frequencies on neurite outgrowth in PC12 rat pheochromocytoma cells. We have studied the percentage of neurite-bearing cells, average length of neurites and directivity of neurite outgrowth in PC12 cells cultured for 96 hours in the presence of nerve growth factor (NGF). PC12 cells were exposed to 50 Hz pulsed electromagnetic fields with a flux density of 1.37 mT, 0.19 mT and 0.016 mT respectively. The field was generated through a Helmholtz coil pair housed in one incubator and the control samples were placed in another identical incubator. It was found that exposure to both a relatively high flux density (1.37 mT) and a medium flux density (0.19 mT) inhibited the percentage of neurite-bearing cells and promoted neurite length significantly. Exposure to high flux density (1.37 mT) also resulted in nearly 20% enhancement of neurite directivity along the field direction. However, exposure to low flux density field (0.016 mT) had no detectable effect on neurite outgrowth. We also studied the effect of frequency at the constant flux density of 1.37 mT. In the range from 1 ~ 100 Hz, only 50 and 70 Hz pulse frequencies had significant effects on neurite outgrowth. Our study has shown that neurite outgrowth in PC12 cells is sensitive to flux density and frequency of pulsed electromagnetic field.