Analysis of the current distribution in an aluminum electrolysis cell with copper collector-bar cathode assembly

Understanding the magneto-hydrodynamic forces generated due to the external magnetic field and current density distribution within the cell (current in cell linings) is important in the optimization of cell dynamics. It is well documented that these factors play a crucial role in establishing the metal-pad stability of the cell. Conventional cells use the cathode-collector-bar assembly to carry the current through molten aluminium, the cathode and the steel collector-bar to nearest external bus. The electrical conductivity of the steel is so poor relative to the molten aluminium that the outer third of the collector bar carries the maximum load, which in turn increases the horizontal components of the current within the cell. Previous studies have modelled improvement in the cell instability through external magnetic compensation by redistributing current in the cathode busbar. Very little to date has been published on work to improve the current distribution within the cell. In this work, the current distribution in an aluminium electrolysis cell with copper collector-bar was predicted using finite element modelling. A 2D cross-section of a commercial cell was used under steady conditions of electrical fields in anode, electrolyte, molten aluminium and copper cathode-assembly. Different shapes and sizes of the cathode assembly are also considered to optimise the distribution of current throughout the cathode lining. The findings indicated that the copper-bar of similar size to steel could save voltage up to 150 mV. There is a reduction of more than 70% in peak current density value due to the copper inserts. The predicted trends of current distribution show a good agreement with previously published data.

Development and application of a microelectrode based scanning voltammetric detector

A large part of the work presented in this thesis describes the development and use of a novel electrochemical detector designed to allow the electrochemical characterisation of compounds in flowing solution by means of cyclic voltammetry. The detector was microprocessor controlled, which provides digital generation of the potential waveform and collection of data for subsequent analysis. Microdisk working electrodes are employed to permit both thermodynamic and kinetically controlled processes to be studied under steady-state conditions in flowing solutions without the distortion or hysteresis normally encountered with larger sized electrodes. The effect of electrode size, potential scan rate, and solution flow rate are studied extensively with the oxidation of ferrocene used as an example of a thermodynamically controlled process and a series of catecholamines as examples of a kinetically controlled process. The performance of the detector was best demonstrated when used as a HPLC post-column detector. The 3-dimensional chromatovoltammograms obtained allow on-line characterisation of each fraction as it elutes from the column. The rest of the work presented in this thesis involves the study of the oxidative degradation pathway of dithranol. The oxidative pathway was shown to involve a complex free radical mechanism, dependent on the presence of both oxygen and, in particular light. The pathway is further complicated by the fact that dithranol may exist in either a keto or enol form, the enol being most susceptible to oxidation. A likely mechanism is proposed from studies performed with cyclic voltammetry and controlled potential electrolysis, then defined by subsequent kinetic studies.

Synthesis, X-ray structure and electrochemical characterization of palladium(II) bearing ferrocenyldiphenylphosphine complexes

Four new complexes, [PdX(κ2-2-C6R4PPh2)(PPh2Fc)] [X = Br, R = H (1), R = F (2); X = I, R = H (3), R = F (4)], containing ferrocenyldiphenylphosphine (PPh2Fc) have been prepared and fully characterised. The X-ray structures of complexes trans-1, cis-2 and cis-4, and that of a decomposition product of 4, [Pd(κ2-2-C6F4PPh2)(μ-I)(μ-2-C6F4PPh2)PdI(PPh2Fc)] (5), have been determined. These complexes show a distorted square planar geometry about the metal atom, the bite angles of the chelate ligands being about 69°, as expected. The cis/trans ratio of 1–4 in solution is strongly dependent on solvent. The new complexes and the uncoordinated PPh2Fc ligand were electrochemically characterised by cyclic and rotating disk voltammetry, UV-visible spectroelectrochemistry, and bulk electrolysis in dichloromethane and acetonitrile. In both cases, oxidation occurs at both the ferrocene and phosphine centres, but the complexes oxidise at more positive potentials than uncoordinated PPh2Fc; subsequently, the metal–phosphorus bond is cleaved, leading to free PPh2Fc+, which undergoes further chemical and electrochemical reactions.

Toward design of synergistically active carbon-based catalysts for electrocatalytic hydrogen evolution

Replacement of precious Pt catalyst with cost-effective alternatives would be significantly beneficial for hydrogen production via electrocatalytic hydrogen evolution reaction (HER). All candidates thus far are exclusively metallic catalysts, which suffer inherent corrosion and oxidation susceptibility during acidic proton-exchange membrane electrolysis. Herein, based on theoretical predictions, we designed and synthesized nitrogen (N) and phosphorus (P) dual-doped graphene as a nonmetallic electrocatalyst for sustainable and efficient hydrogen production. The N and P heteroatoms could coactivate the adjacent C atom in the graphene matrix by affecting its valence orbital energy levels to induce a synergistically enhanced reactivity toward HER. As a result, the dual-doped graphene showed higher electrocatalytic HER activity than single-doped ones and comparable performance to some of the traditional metallic catalysts.

Conditions favoring the formation of monomeric Pt(III) derivatives in the electrochemical oxidation of trans-[Pt(II){(p-BrC6F4)NCH2CH2NEt2}Cl(py)]

Characterization of the anticancer active compound trans-[Pt^II{(p-BrC6F4)NCH2CH2NEt2}Cl(py)] is described along with identification of electrochemical conditions that favor formation of a monomeric one-electron-oxidized Pt^III derivative. The square-planar organoamidoplatinum(II) compound was synthesized through a carbon dioxide elimination reaction. Structural characterization by using single-crystal X-Ray diffraction reveals a trans configuration with respect to donor atoms of like charges. As Pt^III intermediates have been implicated in the reactions of platinum anticancer agents, electrochemical conditions favoring the formation of one-electron-oxidized species were sought. Transient cyclic voltammetry at fast scan rates or steady-state rotating disc and microelectrode techniques in a range of molecular solvents and an ionic liquid confirm the existence of a well-defined, chemically and electrochemically reversible one-electron oxidation process that, under suitable conditions, generates a Pt^III complex, which is proposed to be monomeric [Pt^III{(p-BrC6F4)NCH2CH2NEt2}Cl(py)]⁺. Electron paramagnetic resonance spectra obtained from highly non-coordinating dichloromethane/([Bu4N][B(C6F5)4]) solutions, frozen to liquid nitrogen temperature immediately after bulk electrolysis in a glove box, support the Pt^III assignment rather than formation of a Pt^II cation radical. However, the voltammetric behavior is highly dependent on the timescale of the experiments, temperature, concentration of trans-[Pt^II{(p-BrC6F4)NCH2CH2NEt2}- Cl(py)], and the solvent/electrolyte. In the low-polarity solvent CH2Cl2 containing the very weakly coordinating electrolyte [Bu4N][B(C6F5)4], a well-defined reversible one-electron oxidation process is observed on relatively long timescales, which is consistent with the stabilization of the cationic platinum(III) complex in non-coordinating media. Bulk electrolysis of low concentrations of [Pt{(p-BrC6F4)NCH2CH2NEt2}Cl(py)] favors the formation of monomeric [Pt^III{(p-BrC6F4)NCH2CH2NEt2}Cl(py)]⁺. Simulations allow the reversible potential of the Pt^II/Pt^III process and the diffusion coefficient of [Pt^III{(p-BrC6F4)- NCH2CH2NEt2}Cl(py)]⁺ to be calculated. Reversible electrochemical behavior, giving rise to monomeric platinum(III) derivatives, is rare in the field of platinum chemistry.