NMR studies of modified nasicon-like, lithium conducting solid electrolytes*1

²⁷Al, ³¹P and ⁷Li NMR measurements have been performed on lithium conducting ceramics based on the LiTi₂(PO₄)₃ structure with Al, V and Nb metal ions substituted for either Ti or P within the framework NASICON structure. The ²⁷Al magic angle spinning NMR measurements have revealed that, although Al is intended to substitute for octahedral Ti sites, additional substitution into tetrahedral environments (presumably phosphorous sites) occurs with increasing amount of Al addition. This tetrahedral substitution appears to occur more readily in the presence of vanadium, in Li_1+xAl_xTi_2−x(PO₄)_2.9(VO₄)_0.1, whereas similar niobium additions (in place of vanadium) appear to stifle tetrahedral substitution. ⁷Li static NMR spectra reveal quadrupolar structure with C_q approximately 42 kHz, largely independent of substitution. Measurement of the ⁷Li central transition linewidth at room temperature reveals a relatively mobile lithium species (300–900 Hz) with linewidth tending to decrease with Al substitution and increase with increasing V or Nb. This new structural information is discussed in the context of ionic conduction in these ceramics.

Adsorption kinetics and optimum conditions for Cr(VI) removal by activated carbon prepared from luffa sponge

Activated carbon (AC) prepared from luffa sponge was firstly used as an adsorbent to remove Cr(VI) from aqueous solution. The Cr(VI) adsorption behaviors of AC under different conditions, including initial Cr(VI) concentration, quantity of AC, solution pH, and temperature were investigated. The optimal conditions for adsorption of Cr(VI) by AC were pH = 1, initial Cr(VI) concentration = 80 mg/L, T = 303 K, and AC content = 1.6 g/L. The adsorption kinetics could be described by the pseudo-second-order model. Fourier transform infrared spectroscopy was used to investigate the sorption mechanism. Some functional groups such as C–O and O–H were formed on the carbon surface, which could then react with Cr(VI). The surface structure of AC before and after adsorption was analyzed by scanning electronic microscopy. Adsorbed ions choked some of the pores in AC after adsorption. The Brunauer–Emmett–Teller surface area and average pore size of the AC were 834.13 m2/g and 5.17 nm, respectively. The maximum adsorption of Cr(VI) by AC was 149.06 mg/g, which makes AC prepared from luffa sponge promising for removing Cr(VI) from wastewater.