Evaluation of electrochemical methods for determination of the seebeck coefficient of redox electrolytes

Recent advances in thermoelectrochemical cells, which are being developed for harvesting low grade waste heat, have shown the promise of cobalt bipyridyl salts as the active redox couple. The Seebeck coefficient, Se, of a redox couple determines the open circuit voltage achievable, for a given temperature gradient, across the thermoelectrochemical cell. Thus, the accurate determination of this thermodynamic parameter is key to the development and study of new redox electrolytes. Further, techniques for accurate determination of Se using only one half of the redox couple reduces the synthetic requirements. Here, we compare three different experimental techniques for measuring Se of a cobalt tris(bipyridyl) redox couple in ionic liquid electrolytes. The use of temperature dependent cyclic voltammetry (CV) in isothermal and non-isothermal cells was investigated in depth, and the Se values compared to those from thermo-electromotive force measurements. Within experimental error, the Se values derived from CV methods were found to be in accordance with those obtained from electromotive force (emf) measurements. The applicability of cyclic voltammetry techniques for determining Se when employing only one part of the redox couple was demonstrated.

Rapid determination of protein contents in microencapsulated fish oil supplements by ATR-FTIR spectroscopy and partial least square regression (PLSR) analysis

Following the recent success in quantitative analysis of essential fatty acid compositions in a commercial microencapsulated fish oil (?EFO) supplement, we extended the application of portable attenuated total reflection Fourier transform infrared (ATR-FTIR) spectroscopic technique and partial least square regression (PLSR) analysis for rapid determination of total protein contents-the other major component in most commercial ?EFO powders. In contrast to the traditional chromatographic methodology used in a routine amino acid analysis (AAA), the ATR-FTIR spectra of the ?EFO powder can be acquired directly from its original powder form with no requirement of any sample preparation, making the technique exceptionally fast, noninvasive, and environmentally friendly as well as being cost effective and hence eminently suitable for routine use by industry. By optimizing the spectral region of interest and number of latent factors through the developed PLSR strategy, a good linear calibration model was produced as indicated by an excellent value of coefficient of determination R2 = 0.9975, using standard ?EFO powders with total protein contents in the range of 140-450 mg/g. The prediction of the protein contents acquired from an independent validation set through the optimized PLSR model was highly accurate as evidenced through (1) a good linear fitting (R2 = 0.9759) in the plot of predicted versus reference values, which were obtained from a standard AAA method, (2) lowest root mean square error of prediction (11.64 mg/g), and (3) high residual predictive deviation (6.83) ranked in very good level of predictive quality indicating high robustness and good predictive performance of the achieved PLSR calibration model. The study therefore demonstrated the potential application of the portable ATR-FTIR technique when used together with PLSR analysis for rapid online monitoring of the two major components (i.e., oil and protein contents) in finished ?EFO powders in the actual manufacturing setting.

Rapid discrimination and determination of polyunsaturated fatty acid composition in marine oils by FTIR Spectroscopy and Multivariate Data Analysis

A rapid analytical approach for discrimination and quantitative determination of polyunsaturated fatty acid (PUFA) contents, particularly eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA), in a range of oils extracted from marine resources has been developed by using attenuated total reflection Fourier transform infrared spectroscopy and multivariate data analysis. The spectral data were collected without any sample preparation; thus, no chemical preparation was involved, but data were rather processed directly using the developed spectral analysis platform, making it fast, very cost effective, and suitable for routine use in various biotechnological and food research and related industries. Unsupervised pattern recognition techniques, including principal component analysis and unsupervised hierarchical cluster analysis, discriminated the marine oils into groups by correlating similarities and differences in their fatty acid (FA) compositions that corresponded well to the FA profiles obtained from traditional lipid analysis based on gas chromatography (GC). Furthermore, quantitative determination of unsaturated fatty acids, PUFAs, EPA and DHA, by partial least square regression analysis through which calibration models were optimized specifically for each targeted FA, was performed in both known marine oils and totally independent unknown n - 3 oil samples obtained from an actual commercial product in order to provide prospective testing of the developed models towards actual applications. The resultant predicted FAs were achieved at a good accuracy compared to their reference GC values as evidenced through (1) low root mean square error of prediction, (2) good coefficient of determination close to 1 (i.e., R 2≥ 0.96), and (3) the residual predictive deviation values that indicated the predictive power at good and higher levels for all the target FAs. © 2014 Springer Science+Business Media New York.

Application of bending under tension test to determine the effect of tool radius and the contact pressure on the coefficient of friction in sheet metal forming

To quantify the frictional behaviour in sheet forming operations, several laboratory experiments which simulate the real forming conditions are performed. The Bending Under Tension Test is one such experiment which is often used to represent the frictional flow of sheet material around a die or a punch radius. Different mathematical representations are used to determine the coefficient of friction in the Bending Under Tension Test. In general the change in the strip thickness in passing over the die radius is neglected and the radius of curvature to thickness ratio is assumed to be constant in these equations. However, the effect of roller radius, sheet thickness and the surface pressure are also omitted in some of these equations. This work quantitatively determined the effect of roller radius and the tooling pressure on the coefficient of friction. The Bending Under Tension Test was performed using rollers with different radii and also lubricants with different properties. The tool radii were found to have a direct influence in the contact pressure. The effect of roller radius on friction was considerable and it was observed that there is a clear relationship between the contact pressure and the coefficient of friction.

Variation of fibre diameter coefficient of variation and fibre curvature across mohair fleeces: Implications for animal selection, genetic selection and fleece evaluation

The presentwork aimed to determine howthe average fibre diameter coefficient of variation (CVD) and fibre curvature (FC) differences between nine sampling sites vary between sex and flock, to identify differences in variability between sampling sites as a result of between animal and between sire variability and to determine correlations between sampling sites in between animal and between sire variability. Australian Angoras (n = 313) from two farms in southern Australia were sampled at 12 and 18 months of age at nine sites (mid side, belly, brisket, hind flank, hip, hock, mid back, neck, shoulder). Staples were taken prior to shearing at skin level and CVD and FC determined. For each shearing, differences in CVD and FC between sampling sites, how these differences were affected by farm, sex, and sire, and the covariance between sites for sire and individual animal effects were investigated by restricted maximum likelihood (REML) analyses. The median mid side CVD at 12 and 18 months of age ranged from 23.6 to 25.1% but the actual range was 16.8–34.2%. The median mid side FC at 12 and 18 months of age ranged from 14.4 to 18.6◦/mm but the actual range was 10.5–26.3◦/mm. The general pattern for CVDwas for the mid back, hip and neck sites to have similar CVD, the brisket, hind flank and hock sites to have larger CVD and the belly to have smaller CVD than the mid side site. The between animal variation for CVD was lowest at the mid back site. This implies that the mid back would be the most effective site for between animal selection for CVD. Heritabilities for CVD (range at 18 months 0.18–0.30) were only about half the heritabilities for mean fibre diameter in the same study. There was a marked anterior–posterior increase in FC at both farms and with both ages. The results give no clear indication of the best site for between animal selection for FC, other than that the hock should be avoided. Heritabilities for FC are moderate to high (range at 18 months 0.44–0.77) and the genetic correlations are high except for the hock. Thus genetic selection for FC at any site, other than the hock, should be effective for changing FC over the entire fleece. There was more variability between animals than between sites and sires. These results are put into context with associated research on variation in mean fibre diameter and staple length.

Determination of discharge coefficient for flow over one cycle compound trapezoidal plan form labyrinth weir

Weirs are common structure to regulate discharge and flow control inwater conveyance channels and hydraulic structures. Labyrinth weirsconsidered one of economical and effective methods to increase the efficiency of weirs that crest length of weirs increase without a related increase in structure width. Therefore, flow discharge will be increased. Compared to use compound weir, there are some benefits including the simultaneous passage of floating materials such as wood, ice, etc. Also, sedimentations are pass through compound weir. The trapezoidal Labyrinth weir is one of the combined models. In present study 15 physical models that discussion effect changes sidewall angle of labyrinth weir on discharge coefficient of flow over and through the compound trapezoidal one cycle Labyrinth weir. Also, it is developed design curves with various shapes and configurations. The researchshowed here mainly objectives at determining the coefficient of discharge for flow-over trapezoidal labyrinth weir by performing tests at wide range of values of side wall angles (α) from 6° to 35° and compound linear weir to be compared.

Determination of astaxanthin steroisomers and colour attributes in flesh of rainbow trout (Oncorhynchus mykiss) as a tool to distinguish the dietary pigmentation source

The presence of carotenoids in animal tissue reflects their sources along the food chain. Astaxanthin, the main carotenoid used for salmonid pigmentation, is usually included in the feed as a synthetic product. However, other dietary sources of astaxanthin such as shrimp or krill wastes, algae meal or yeasts are also available on the market. Astaxanthin possesses two identical asymmetric atoms at C-3 and C-3' making possible three optical isomers with all-trans configuration of the chain: 3S,3'S, 3R,3'S, and 3R,3'R. The distribution of the isomers in natural astaxanthin differs from that of the synthetic product. This latter is a racemic mixture, with a typical ratio of 1:2:1 (3S,3'S:3R,3'S:3R,3'R), while astaxanthin from natural sources has a variable distribution of the isomers deriving from the different biological organism that synthesized it. The high-performance liquid chromatographic (HPLC) analysis of all-trans isomers of astaxanthin was performed in different pigment sources, such as red yeast Phaffia rhodozyma, alga meal Haematococcus pluvialis, krill meal and oil, and shrimp meal. With the aim to investigate astaxanthin isomer ratios in flesh of fish fed different carotenoid sources, three groups of rainbow trout were fed for 60 days diets containing astaxanthin from synthetic source, H. pluvialis algae meal and P. rhodozyma red yeast. Moreover, the distribution of optical isomers of astaxanthin in trout purchased on the Italian market was investigated. A characteristic distribution of astaxanthin stereoisomers was detected for each pigment sources and such distribution was reproduced in the flesh of trout fed with that source. Colour values measured in different sites of fillet of rainbow trout fed with different pigment sources showed no significant differences. Similarly, different sources of pigment (natural or synthetic) produced colour values of fresh fillet with no relevant or significant differences. The coefficient of distance computed amongst the feed ingredient and the trout fillet astaxanthin stereoisomers was a useful tool to identify the origin of the pigment used on farm.

Determination of lung volume by hydrogen dilution at the time of underwater weighing

A method for measuring the volume of air in the lungs at the time of underwater weighing is described. A low concentration of hydrogen is used as a tracer gas in a closed-circuit rebreathing system. At the end of a normal exhalation the subject is connected to a respiratory bladder containing 2 L of air with a small admixture of hydrogen. After an equilibration period of five breaths the subject submerges completely, together with the bladder, and underwater weight is measured. Lung volume, at the time of weighing, is determined by hydrogen dilution. Using this method, the coefficient of variation for body density in the same individual was 0.23%.

Sample size determination for kernel regression estimation using sequential fixed-width confidence bands

We consider a random design model based on independent and identically distributed pairs of observations (Xi, Yi), where the regression function m(x) is given by m(x) = E(Yi|Xi = x) with one independent variable. In a nonparametric setting the aim is to produce a reasonable approximation to the unknown function m(x) when we have no precise information about the form of the true density, f(x) of X. We describe an estimation procedure of non-parametric regression model at a given point by some appropriately constructed fixed-width (2d) confidence interval with the confidence coefficient of at least 1−. Here, d(> 0) and 2 (0, 1) are two preassigned values. Fixed-width confidence intervals are developed using both Nadaraya-Watson and local linear kernel estimators of nonparametric regression with data-driven bandwidths. The sample size was optimized using the purely and two-stage sequential procedures together with asymptotic properties of the Nadaraya-Watson and local linear estimators. A large scale simulation study was performed to compare their coverage accuracy. The numerical results indicate that the confi dence bands based on the local linear estimator have the better performance than those constructed by using Nadaraya-Watson estimator. However both estimators are shown to have asymptotically correct coverage properties.