Polycyclic aromatic hydrocarbon emission loads and profiles from the burning of locally grown wood species in Victoria, Australia - Some pilot project results

A testing facility for combustion of biomass and sampling of emissions has been established at Deakin University. In this pilot project using this facility, four kinds of locally grown wood species were burned and the particle emissions sampled and analysed for Polycyclic Aromatic Hydrocarbons (PAHs). The selected wood species covering pine, red gum, yellow box and sugar gum, are the most popular domestic fuel wood in Australia. Particulate matter emissions from burning of each load of wood were sampled from the flue using a standard stack emission sampling train. The particle-laden filters were extracted and the .extract analysed to determine PAH concentrations by Gas Chromatographyl Mass Spectrometer (Gc/MS). The sampling was conducted under two different burning conditions with the air inlet of the combustion chamber fully open and with it half open. A suite of 15 PAHs, ranging from naphthalene (C IOHB) to dibenzolahlanthracene (C12H14), were selected for analysis. PAH profiles for the four wood species, under the different burning regimes, have been generated. Some preliminary emission factors for the different wood species have been derived as microgram of summed PAHs (rPAHs) emittedlkilogram of wood burned. Total Particulate Matter (TPM) emission factors were also obtained from gravimetric measurement of the sample filter before and after the combustion. Based on these emission factors, pine displayed the highest level of rPAHs emitted from the combustion of the four wood species, with sugar gum showing the lowest level of rPAHs emission. Emission factors associated with the slow burning condition clearly showed higher l:PAH levels compared to the faster burning condition. During the faster burning condition, red gum and pine show a higher percentage of rPAH to TPM than sugar gum or yellow box. Under the slower burning. the l:PAHlTPM ratio in every case was greater.

The characterisation of polycyclic aromatic hydrocarbons emissions from burning of different firewood species in Australia

Four kinds of woods used for residential heating in Australia were selected and burned under two burning conditions in a domestic wood heater installed in a laboratory. The selected wood species included pine (Pinus radiata), red gum (Eucalyptus camaldulensis), sugar gum (Eucalyptus cladocalyx) and yellow box (Eucalyptus melliodora). The two different burning conditions represented fast burning and slow burning, with the air inlet of the combustion chamber respectively ‘full open’ and ‘half open’. By sampling and analysing particulate and gaseous emissions from the burning of each load of wood under defined experimental conditions, PAHs emissions and their profiles in the particulate and gaseous phases were obtained. 16 species out of the 18 selected PAHs were detected. Of these, seven species were detected in the gaseous phase and most were lower molecular weight compounds. Similarly, more than 10 species of PAHs were detected in the particulate phase and these were mostly heavier molecular weight compounds. Under both burning conditions, emission levels for total PAHs and total genotoxic PAHs were the highest for pine and lowest for sugar gum, with red gum being the second highest, followed by yellow box. Using the specific sampling method, gaseous PAHs accounted for above 90% mass fraction of total PAHs in comparison to particulate PAHs (10%). The majority of the genotoxic PAHs were present in the particulate phase. PAHs emission levels in slow burning conditions were generally higher than those in fast burning conditions.

Characterising vehicle emissions from the burning of biodiesel made from vegetable oil

Biodiesel manufactured from canola oil was blended with diesel and used as fuel in two diesel vehicles. This study aimed to test the emissions of diesel engines using blends of 100%, 80%, 60%, 40% , 20% biodiesel and 100% petroleum diesel, and characterise the particulate matter and gaseous emissions, with particular attention to levels of polycyclic aromatic hydrocarbons (PAHs) which are harmful to humans. A real time dust monitor was also used to monitor the continuous dust emissions during the entire testing cycle. The ECE(Euro 2) drive cycle was used for all emission tests. It was found that the particle concentration was up to 33% less when the engine burnt 100% biodiesel, compared to 100% diesel. Particle emission reduced with increased percentages of biodiesel in the fuel blends. Reductions of NOx, HC and CO were limited to about 10% when biodiesel was burned. Levels of CO2 emissions from the use of biodiesel and diesel were similar. Eighteen EPA priority PAHs were targeted, with only 6 species detected in the gaseous phase from the samples . 9 PAHs were detected in particulate phases at much lower levels than gaseous PAHs. Some marked reductions were observed for less toxic gaseous PAHs such as naphthalene when burning 100% biodiesel, but the particulate PAH emissions, which have more implications to adverse health effects, were virtually unchanged and did not show a statistically significant reduction. These findings are useful to gain an understanding of the emissions and environmental impacts of biodiesel.

The effects of land use on leaf-litter processing by macro-invertebrates in an Australian temperate coastal stream

Replacement of riparian vegetation by pasture has occurred worldwide and is predicted to have strong effects on macroinvertebrate community structure and function in streams, but this has rarely been examined. In this study, leaf processing and macroinvertebrate community structure were examined in a single stream using experimental leaf-packs and surveys of natural leaf-packs. Two sites in each of three land use categories were selected to represent reaches in forest, pasture and forest-pasture boundary regions. In two experiments using tethered leaf-packs, no differences were found in mean leaf breakdown between land use types. However, shredding invertebrates were absent from the pasture sites, so leaf breakdown in pasture resulted from chemical, physical and microbial processes only. Amounts of fine particulate organic matter in experimental leaf-packs were higher in pasture reaches than the forest and boundary reaches but did not influence leaf breakdown. Macroinvertebrate species richness did not differ between land uses. A predictive model developed for species richness and total abundance enabled direct comparison of assemblages on experimental packs to natural leaf-packs. In the forest reach and at the forest-pasture boundary, macroinvertebrate species richness and total abundance increased proportionally with the number of leaves within a pack, but this relationship was not observed in the pasture reach. Pasture land use on Skenes Creek was therefore associated with weakened relationships between allochthonous inputs and macroinvertebrate communities, but this did not alter leaf breakdown.

The consequences of land use change on nutrient exports: a regional scale assessment in south-west Victoria, Australia

Estimation of nutrient load production based on multi-temporal remotely sensed land use data for the Glenelg–Hopkins region in south-west Victoria, Australia, is discussed. Changes in land use were mapped using archived Landsat data and computerised classification techniques. Land use change has been rapid in recent history with 16% of the region transformed in the last 22 years. Total nitrogen and phosphorus loads were estimated using an export coefficient model. The analysis demonstrates an increase in modelled nitrogen and phosphorus loadings from 1980 to 2002. Whilst such increases were suspected from past anecdotal and ad-hoc evidence, our modelling estimated the magnitude of such increases and thus demonstrated the enormous potential of using remote sensing and GIS for monitoring regional scale environmental processes.

Study of polycyclic aromatic hydrocarbons emissions from burning of local wood species in Australia

Four kinds of Australian local wood species were burned in a domestic wood heater installed in a laboratory. The selected wood species include pine, red gum, yellow box and sugar gum, that are the most popular domestic fuel wood in Australia. Particulate matter emissions from burning of each load of wood were sampled isokinetically on filter media from the flue by standard stack emission sampling train. The particle laden filters then went for Gas Chromatography/ Mass Spectrometer (GC/MS) analysis to determine polycyclic aromatic hydrocarbons (PAHs) concentrations. The sampling was conducted under two different burning conditions – air inlet of the combustion chamber fully open and half open. Approximately 15 types of PAHs were detected. Emission factors were derived as microgram of PAHs /kg of wood burned. Total particulate emission factors were also obtained from gravimetric measurement before and after the sampling. PAH emission profiles for four species were generated from the results. Comparisons of emission factors have been conducted among different species of wood, as well as under different burning conditions, ie. fast burning and slowing burning. According to the derived emission factors, pine displayed the highest level of PAHs among the four species, followed by red gum and yellow box, whereas sugar gum showed the lowest level of PAHs. Emission factors were compared between each type of wood under two different burning conditions, the slow burning condition, which was air inlet half open, clearly showed higher PAH levels compared to the fast burning condition. Total PAH fractions on particulate matter were calculated and compared among wood types under two burning conditions. During the fast burning condition, red gum and pine have the higher percentage of PAH to total particulate matter emission than sugar gum and yellow box. When changed to slow burning, the PAH fraction on particulate matter are all increased with sugar gum having the largest increase.

Perceptions and attitudes of land managers in multi-tenure reserve networks and the implications for conservation

Multi-tenure reserve networks aim to connect areas managed for biodiversity conservation across public and private land and address the impacts of fragmentation on both biotic and social systems. The operation and function of Australian multi-tenure reserve networks as perceived by their land managers was investigated. Overall, the conservation of natural assets was the most frequently reported primary reason for involvement in a network. The perceived aims of the respective networks largely reflected the response identified for involvement and management. Over 88% of managers considered their involvement in multi-tenure reserve networks to be a positive or very positive experience. A lack of resources and time for management were considered major limitations of these networks. The majority (80%) of private land managers within networks were willing to be included in a national reserve system of conservation lands. As the Australian National Reserve System currently incorporates mostly public land, these findings have important and potentially positive implications for a greater role for protected private land.

Ecosystem conservation in multi-tenure reserve networks : the contribution of land outside of publicly protected areas

Multi-tenure reserve networks have been developed as a mechanism to improve cross tenure management and protection of biodiversity, but also as a means of accounting for biodiversity assets managed for conservation outside of protected areas on public land. We evaluated the contribution of multi-tenure reserve networks to enhancing the comprehensiveness and representativeness of ecosystems in publicly protected areas, using three Australian case studies. All networks contributed to enhancing comprehensiveness and representativeness, but this contribution varied between networks and between components of those networks. Significantly, components on private land and "other public land" in all three networks greatly enhanced the protection of some ecosystems at a subregional scale. The Grassy Box Woodlands Conservation Management Network, in particular made a substantial contribution to conservation, with most components protecting remnants of an endangered and under-represented ecosystem. Multi-reserve conservation networks not only act to protect threatened and under-reserved ecosystems, but they also provide a mechanism to account for this protection. Thus, multi-tenure reserve networks have the potential to provide increased knowledge and understanding to conservation planning decision making processes.