Correlating the fineness and residual gum content of degummed hemp fibres

It is well known residual gum exists in degummed or retted hemp fibres. Gum removal results in improvement in fibre fineness and the properties of the resultant hemp yarns. However, it is not known what correlation if any exists between the residual gum content in retted hemp fibres and the fibre fineness, described in terms of fibre width in this paper. This study examined the mean width and coefficient of variation (CV) of fibre width of seventeen chemically retted hemp samples with reference to residual gum content. The mean and CV of fibre width were obtained from an Optical fibre diameter analyser (OFDA 100). The linear regression analysis results show that the mean fibre width is directly proportional to the residual gum content. A slightly weaker linear correlation also exists between the coefficient of variation of fibre width and the residual gum content. The strong linear co-relation between the mean of fibre width and the residual gum content is a significant outcome, since testing for fibre width using the OFDA is a much simpler and quicker process than testing the residual gum content. Scanning Electron Microscopy (SEM) reinforces the OFDA findings. SEM micrographs show a flat ribbon like fibre cross-section hence the term “fibre width” is used instead of fibre diameter. Spectral differences in the untreated dry decorticated skin samples and chemically treated and subsequently carded samples indicate delignification. The peaks at 1370 cm⁻¹, 1325 cm⁻¹, 1733 cm⁻¹, and 1600 cm⁻¹ attributed to lignin in the untreated samples are missing from the spectra of the treated samples. The spectra of the treated samples are more amine-dominated with some of the OH character lost.

Development of a cooling fabric from conducting polymer coated fibres: proof of concept

It is supposed that there should be a thermal electric effect if a dc current is applied across two dissimilar conducting polymers, similar to so called “Peltier effect” in metals or semiconductors. However, this hypothesis has not been tested on conducting polymers and using these materials to make cooling fabrics has never been attempted before. Polypyrrole coated fabrics were used to test the hypothesis in this preliminary study. Seebeck and the Peltier effects were proven to exist. However, thermoelectricity effect between two conducting polymer coated fabric samples was only about 10 μV/°C. Cooling effect by conductive polymer powder was achieved but performance was unsteady due to electrical degradation of the conducting polymer. Nevertheless, the concept was demonstrated and the development of a cooling fabric is possible.

FTIR and thermal analysis of cashmere and other animal fibres

In this paper, sereval varieties of animal fibres including cashmere and Australian fine Merino wool have been analysed by Fourier transform infrared microscope and differential scanning calorimeter. The results showed that both Chinese and Australian cashmere fibres started absorbing heat at a relatively higher temperature but were thermally degraded quicker than other animal fibres tested. However, the mass changes (within the temperature range of 200oC to 350oC) and associated onset temperatures varied among fibre varieties. From the attenuated total reflectance spectra, the Chinese cashmere was clearly different from Australian cashmere and wool in a peak near 1040 cm-1 wavelength for S-O stretching of cysteic acid residues. The Chinese cashmere presented a stronger absorption at 1019 cm-1 wavelength, while Australian cashmere and wool peaked at 1079 cm-1 wavelength and had a weaker absorption. Combined with thermal analysis, the normalised R-SO3 - content of cysteic acid residues to the amide II peak of the protein backbone may have potential use in identifying Australian fine Merino wool from Chinese cashmere.

Increase in S6K1 phosphorylation in human skeletal muscle following resistance exercise occurs mainly in type II muscle fibres

To investigate the in vivo effects of resistance exercise on translational control in human skeletal muscle, we determined the phosphorylation of AMP-activated kinase (AMPK), eukaryotic initiation factor 4E-binding protein (4E-BP1), p70/p85-S6 protein kinase (S6K1), and ribosomal S6 protein (S6). Furthermore, we investigated whether changes in the phosphorylation of S6K1 are muscle fiber type specific. Eight male subjects performed a single high-intensity resistance exercise session. Muscle biopsies were collected before and immediately after exercise and after 30 and 120 min of postexercise recovery. The phosphorylation statuses of AMPK, 4E-BP1, S6K1, and S6 were determined by Western blotting with phospho-specific and pan antibodies. To determine fiber type-specific changes in the phosphorylation status of S6K1, immunofluorescence microscopy was applied. AMPK phosphorylation was increased approximately threefold immediately after resistance exercise, whereas 4E-BP1 phosphorylation was reduced to 27 ± 6% of preexercise values. Phosphorylation of S6K1 at Thr421/Ser424 was increased 2- to 2.5-fold during recovery but did not induce a significant change in S6 phosphorylation. Phosphorylation of S6K1 was more pronounced in the type II vs. type I muscle fibers. Before exercise, phosphorylated S6K1 was predominantly located in the nuclei. After 2 h of postexercise recovery, phospho-S6K1 was primarily located in the cytosol of type II muscle fibers. We conclude that resistance exercise effectively increases the phosphorylation of S6K1 on Thr421/Ser424, which is not associated with a substantial increase in S6 phosphorylation in a fasted state.

Differential effects of arginine, glutamate and phosphoarginine on Ca2+-activation properties of muscle fibres from crayfish and rat

The effects of two amino acids, arginine which has a positively charged side-chain and glutamate which has a negatively charged side-chain on the Ca²⁺-activation properties of the contractile apparatus were examined in four structurally and functionally different types of skeletal muscle; long- and short-sarcomere fibres from the claw muscle of the yabby (a freshwater decapod crustacean), and fast- and slow-twitch fibres from limb muscles of the rat. Single skinned fibres were activated in carefully balanced solutions of different pCa (-log₁₀[Ca²⁺]) that either contained the test solute (“test”) or not (“control”). The effect of phosphoarginine, a phosphagen that bears a nett negative charge, was also compared to the effects of arginine. Results show that (i) arginine (33-36 mmol l^-1) significantly shifted the force–pCa curve by 0.08–0.13 pCa units in the direction of increased sensitivity to Ca²⁺-activated contraction in all fibre types; (ii) phosphoarginine (9–10 mmol l^-1) induced a significant shift of the force–pCa curve by 0.18–0.24 pCa units in the direction of increased sensitivity to Ca²⁺ in mammalian fast- and slow-twitch fibres, but had no significant effects on the force–pCa relation in either long- or short-sarcomere crustacean fibres; (iii) glutamate (36–40 mmol l^-1), like arginine affected the force–pCa relation of all fibre types investigated, but in the opposite direction, causing a significant decrease in the sensitivity to Ca²⁺-activated contraction by 0.08–0.19 pCa units; (iv) arginine, phosphoarginine and glutamate had little or no effect on the maximum Ca²⁺-activated force of crustacean and mammalian fibres. The results suggest that the opposing effects of glutamate and arginine are not related to simply their charge structure, but must involve complex interactions between these molecules, Ca²⁺ and the regulatory and other myofibrillar proteins.

Properties of slow- and fast-twitch muscle fibres in a mouse model of amyotrophic lateral sclerosis

This investigation was undertaken to determine if there are altered histological, pathological and contractile properties in presymptomatic or endstage diseased muscle fibres from representative slow-twitch and fast-twitch muscles of SOD1 G93A mice in comparison to wildtype mice. In presymptomatic SOD1 G93A mice, there was no detectable peripheral dysfunction, providing evidence that muscle pathology is secondary to motor neuronal dysfunction. At disease endstage however, single muscle fibre contractile analysis demonstrated that fast-twitch muscle fibres and neuromuscular junctions are preferentially affected by amyotrophic lateral sclerosis-induced denervation, being unable to produce the same levels of force when activated by calcium as muscle fibres from their age-matched controls. The levels of transgenic SOD1 expression, aggregation state and activity were also examined in these muscles but there no was no preference for muscle fibre type. Hence, there is no simple correlation between SOD1 protein expression/activity, and muscle fibre type vulnerability in SOD1 G93A mice.

A new method of evaluating the fineness and residual gum content of hemp fibres

The demand for eco-friendly apparel and technical textiles has led to a resurgence of interests in bast fibres such as hemp. The lack of fast and objective evaluation of the quality attributes of bast fibres has been a major barrier to the advancement of the bast fibre industry. One of the most important quality attributes of a fibre is its fineness. For bast fibres, the fibre fineness measurement can also reflect the degree of fibre separation during retting or degumming. The traditional method of evaluating the fineness and residual gum content of bast fibres is a very tedious process. In this paper, degummed hemp fibres have been measured for fineness on an Optical Fibre Diameter Analyser (OFDA), and the results have been co-related with the residual gum content in the fibre samples. Since hemp fibres do not have a circular cross section, it is the width of the fibre that gets measured by the OFDA instrument, and this width has been used as an indication of the fibre fineness in this paper. The findings from this study suggest that the optical method can provide a fast and objective way of evaluating the fineness of hemp fibres, and that there is a good correlation between the fibre „width‟ measurement and the residual gum content.

The softness of alpaca fibres

Softness is a unique selling point for luxury fibres such as alpaca. However, there is very little objective data on the softness of animal fibres. This study first establishes that the resistance to compression (RtC) behaviour of alpaca and wool fibres is quite different, and that the RtC method can not be used to examine the softness of different animal fibres. It then reports a new method for evaluating fibre softness. This method is based on the measurement of the force required to pull a fibre bundle through a series of parallel pins. This force, reflecting the combined effect of fibre surface properties, fibre diameter and rigidity, can achieve reasonable discrimination between fibres of varying levels of softness, such as alpaca and wool. Mechanisms responsible for the superior softness of alpaca fibres are discussed also.

Determining residual gum content of bast fibres

The measurement of fibre quality in bast fibres is related to the amount of gum (lignin, hemicellulose, wax and pectin) left in the fibre after the retting process. Large amounts of gums present represent poor separation of fibre. Efficiency of retting can be monitored by measuring the residual gum content of the retted fibre.

This paper investigated the use of ultrasonic vibration combined with chemical retting as a pre-treatment to improve accuracy of traditional residual gum content test. Work was conducted on chemically retted hemp fibre. Pre-treatment conditions were analysed by determining the best chemical combination, chemical concentration and treatment time. Fibres were examined for successful separation using optical microscopy and optical fibre diameter analysis (OFDA). The work proposed a new method for determining the residual gum content of hemp fibre.