Aplicacao do geoprocessamento no estudo da impermeabilidade urbana

The environmental impact of urbanization due to the surface impervious growing and inadequacy of urban occupation induces to a significant increase of inundation events in every urban center. Hence, this paper focuses the concept of impervious surface as an indicator of environment impact, expressed through the changing of pervious areas in impervious areas by paving cover or building occupation. It is taken as a case study 13 areas pertaining to Canoas City, Rio Grande do Sul – Metropolitan area of Porto Alegre, Brazil. The main goal of the methodology process is to achieve information about types of land cover for studying the association with urban impermeability level. Therefore, the manipulation of municipal digital cartographic base of Canoas City with aerial photographs, through the geoprocessing applied in geographic information system toolbox (GIS), allows this research to produce data about of urban impervious areas generation. These results could help the urban settlement planning to reduce the impervious cover and the hydrological impact in its implementation.

Quantifying changes in building footprint in the historic coastal town of Queenscliff

The sea change phenomenon has attracted new residents to Australian coastal towns and brought with it expectations of residential housing formed in metropolitan settings. Consequently, the traditional ‘identifying’ neighbourhood character of these towns is changing. Much larger houses are now being built and site coverage has increased. To date, changes in character have been measured using data based on the subjective judgement of residents through surveys and interviews. More objective information would be beneficial in understanding change. This paper describes a methodology that has been developed to quantify the change in the building footprint in the historic coastal town of Queenscliff in Victoria. Using selected aerial photographs, the building footprint of the town's residential buildings has been estimated at four intervals from 1957 until 2006. This footprint has been compared to the block size at each interval so that changes in house-to-block ratio may be compared. Over 20% of the residential homes were assessed. Building footprint has risen from 30% to over 38% in the documented 50 years. The method developed here is a low-cost method of tracking footprint change over an extended period and informing local planners and residents of when and where the changes have occurred.

The rough sets feature selection for trees recognition in color aerial images using genetic algorithms

Selecting a set of features which is optimal for a given task is the problem which plays an important role in a wide variety of contexts including pattern recognition, images understanding and machine learning. The concept of reduction of the decision table based on the rough set is very useful for feature selection. In this paper, a genetic algorithm based approach is presented to search the relative reduct decision table of the rough set. This approach has the ability to accommodate multiple criteria such as accuracy and cost of classification into the feature selection process and finds the effective feature subset for texture classification . On the basis of the effective feature subset selected, this paper presents a method to extract the objects which are higher than their surroundings, such as trees or forest, in the color aerial images. The experiments results show that the feature subset selected and the method of the object extraction presented in this paper are practical and effective.

Neck muscle activation and head postures in common high performance aerial combat maneuvers

Introduction: Neck injuries are common in high performance combat pilots and have been attributed to high gravitational forces and the non-neutral head postures adopted during aerial combat maneuvers. There is still little known about the pathomechanics of these injuries.

Methods: Six Royal Australian Air Force Hawk pilots flew a sortie that included combinations of three +Gz levels (1, 3, and 5) and four head postures (Neutral, Turn, Extension, and Check-6). Surface electromyography from neck and shoulder muscles was recorded in flight. Three-dimensional measures of head postures adopted in flight were estimated postflight with respect to end-range of the cervical spine using an electromagnetic tracking device.

Results: Mean muscle activation increased significantly with both increasing +Gz and non-neutral head postures. Check-6 at +5 Gz (mean activation of all muscles = 51% MVIC) elicited significantly greater muscle activation in most muscles when compared with Neutral, Extension, and Turn head postures. High levels of muscle co-contraction were evident in high acceleration and non-neutral head postures. Head kinematics showed Check-6 was closest to end-range in any movement plane (86% ROM in rotation) and produced the greatest magnitude of rotation in other planes. Turn and Extension showed a large magnitude of rotation with reference to end-range in the primary plane of motion but displayed smaller rotations in other planes.

Discussion: High levels of neck muscle activation and co-contraction due to high +Gz and head postures close to end range were evident in this study, suggesting the major influence of these factors on the pathomechanics of neck injuries in high performance combat pilots.

Neck exercises compared to muscle activation during aerial combat maneuvers

Introduction: Performing specific neck strengthening exercises has been proposed to decrease the incidence of neck injury and pain in high performance combat pilots. However, there is little known about these exercises in comparison to the demands on the neck musculature in flight.

Methods: Eight male non-pilots performed specific neck exercises using two different modalities (elastic band and resistance machine) at six different intensities in flexion, extension, and lateral bending. Six Royal Australian Air Force Hawk pilots flew a sortie that included combinations of three +Gz levels and four head positions. Surface electromyography (EMG) from selected neck and shoulder muscles was recorded in both activities.

Results: Muscle activation levels recorded during the three elastic band exercises were similar to in-flight EMG collected at +1 Gz (15% MVIC). EMG levels elicited during the 50% resistance machine exercises were between the +3 Gz (9-40% MVIC) and +5 Gz (16-53% MVIC) ranges of muscle activations in most muscles. EMG recorded during 70% and 90% resistance machine exercises were generally higher than in-flight EMG at +5 Gz.

Discussion: Elastic band exercises could possibly be useful to pilots who fly low +Gz missions while 50% resistance machine mimicked neck loads experienced by combat pilots flying high +Gz ACM. The 70% and 90% resistance machine intensities are known to optimize maximal strength but should be administered with care because of the unknown spinal loads and diminished muscle force generating capacity after exercise.

Detection of endocrine disrupting chemicals in aerial invertebrates at sewage treatment works

Endocrine disrupting chemicals (EDCs) constitute a diverse group of chemical compounds which can alter endocrine function in exposed animals. Whilst most studies have focussed on exposure of wildlife to EDCs via aquatic routes, there is the potential for transfer into the terrestrial food chain through consumption of contaminated prey items developing in sewage sludge and waste water at sewage treatment works. In this study, we determine levels of EDCs in aerial insects whose larval stages develop on percolating filter beds at sewage treatment works. We compare absolute concentrations of known EDCs with those collected from aquatic environments not exposed to sewage effluent outflow. Our findings document for the first time that aerial invertebrates developing on sewage filter beds take up a range of chemicals thought to be incorporated from the sewage effluent, which act as endocrine disruptors. For two synthetic chemicals (17α-ethinylestradiol and butylated hydroxy aniline), concentrations were significantly higher in insects captured around percolating filter beds than sites over 2 km from the nearest sewage works. A number of species of insectivorous bats and birds, some of which are declining or threatened, use sewage works as principle foraging sites. We calculate approximate exposure levels for a species of bat known to forage within sewage works and suggest that further research is warranted to assess the ecological implications of consuming contaminated invertebrate prey