A Bayesian approach to the determination of ignition delay

A novel in-cylinder pressure method for determining ignition delay has been proposed and demonstrated. This method proposes a new Bayesian statistical model to resolve the start of combustion, defined as being the point at which the band-pass in-cylinder pressure deviates from background noise and the combustion resonance begins. Further, it is demonstrated that this method is still accurate in situations where there is noise present. The start of combustion can be resolved for each cycle without the need for ad hoc methods such as cycle averaging. Therefore, this method allows for analysis of consecutive cycles and inter-cycle variability studies. Ignition delay obtained by this method and by the net rate of heat release have been shown to give good agreement. However, the use of combustion resonance to determine the start of combustion is preferable over the net rate of heat release method because it does not rely on knowledge of heat losses and will still function accurately in the presence of noise. Results for a six-cylinder turbo-charged common-rail diesel engine run with neat diesel fuel at full, three quarters and half load have been presented. Under these conditions the ignition delay was shown to increase as the load was decreased with a significant increase in ignition delay at half load, when compared with three quarter and full loads.

Partial state estimation of time-delay systems.

This thesis broadly studies three crucial and rigorous inter-related control theoretical subjects: (i) Partial state estimation of linear systems; (ii) Stability analysis of time-delay systems with interval time-varying delays; and (iii) Functional observer design for time-delay systems.

Design of reduced-order positive linear functional observers for positive time-delay systems

This brief considers a new problem of designing reduced-order positive linear functional observers for positive time-delay systems. The order of the designed functional observers is equal to the dimension of the functional state vector to be estimated. The designed functional observers always nonnegative at any time and they converge asymptotically to the true functional state vector. Moreover, conditions for the existence of such positive linear functional observers are formulated in terms of linear programming (LP). Numerical examples and simulation results are given to illustrate the effectiveness of the proposed design method.

Reachable sets bounding for generalized neural networks with interval time-varying delay and bounded disturbances

This paper deals with the problem of finding outer bound of forwards reachable sets and interbound of backwards reachable sets of generalized neural network systems with interval nondifferentiable time-varying delay and bounded disturbances. Based on constructing a suitable Lyapunov–Krasovskii functional and utilizing some improved Jensen integral-based inequalities, two sufficient conditions are derived for the existence of: (1) the smallest possible outer bound of forwards reachable sets and (2) the largest possible interbound of backwards reachable sets. These conditions are delay dependent and in the form of matrix inequalities, which therefore can be efficiently solved by using existing convex algorithms. Three numerical examples with simulation results are provided to demonstrate the effectiveness of our results.

Optimizing time delay feedback for active vibration control of a cantilever beam using a genetic algorithm

Active vibration control using time delay for a cantilever beam is developed in this paper. The equation of motion of the system is developed using the discrete standard formulation, and the discrete quadratic function is used to design the controller. The original contribution in this paper is using a genetic algorithm to determine the optimal time delay feedback for active vibration control of a cantilever beam. Simulations of the beam demonstrated that the genetic algorithm correctly identified the time delay which produced the quickest attenuation of unwanted vibrations for both mode one and mode two. In terms of frequency response, the optimal time delay for both modes reduced the resonant amplitude. In a mixed mode situation, the simulation demonstrated that an optimal time delay could be identified.

Static output feedback frequency stabilization of time-delay power systems with coordinated electric vehicles state of charge control

In this paper, for the first time, electric vehicles are used for both the primary and secondary frequency controls to support power plants to rapidly suppress fluctuations in the system frequency due to load disturbances. Via networked control and wide-area communication infrastructures, multiple interval time-varying delays exist in the communication channels between the control center, power plant, and an aggregation of electric vehicles. By coordinating batteries’ state of charge control, the behaviors of the vehicle owners and the uncertainties imposed by the changes of the batteries’ state of charge are taken intoconsideration. A power system model incorporating multiple time-varying delays and uncertainties is first proposed. Then, a robust static output feedback frequency controller is designed to guarantee the resulting closed-loop system stable with an H∞ attenuation level. By utilizing a novel integral inequality, namely refined-Jensen inequality, and an improved reciprocally convex combination, the design conditions are formulated in terms of tractable linear matrix inequalities which can be efficiently solved by various computational tools. The effectiveness of the proposed control scheme is verified by extensive simulations.

On global exponential stability of positive neural networks with time-varying delay

This paper presents a new result on the existence, uniqueness and global exponential stability of a positive equilibrium of positiveneural networks in the presence of bounded time-varying delay. Based on some novel comparison techniques, a testable conditionis derived to ensure that all the state trajectories of the system converge exponentially to a unique positive equilibrium. Theeffectiveness of the obtained results is illustrated by a numerical example.