Direct electro-deposition of graphene from aqueous suspensions

We describe the direct electro-chemical reduction of graphene oxide to graphene from aqueous suspension by applying reduction voltages exceeding -1.0 to -1.2 V. The conductivity of the deposition medium is of crucial importance and only values between 4-25 mS cm^-1 result in deposition. Above 25 mS cm^-1 the suspension de-stabilises while conductivities below 4 mS cm_^-1 do not show a measurable deposition rate. Furthermore, we show that deposition can be carried out over a wide pH region ranging from 1.5 to 12.5. The electro-deposition process is characterised in terms of electro-chemical methods including cyclic voltammetry, quartz crystal microbalance, impedance spectroscopy, constant amperometry and potentiometric titrations, while the deposits are analysed via Raman spectroscopy, infra-red spectroscopy, X-ray photoelectron spectroscopy and X-ray diffractometry. The determined oxygen contents are similar to those of chemically reduced graphene oxide, and the conductivity of the deposits was found to be ~20 S cm ^-1.

Continuous corrosion rate measurement by noise resistance calculation

A commonly employed method of corrosion rate measurement is to determine the electrochemical impedance of the corroding material. One technique for estimating the impedance is the noise impedance calculation. While it has been shown to yield useful results, there are a number of problems that require attention. This paper identifies some of those problems-specifically, those of detrending and resolution-and provides a solution that allows continuous, time-varying noise resistance and noise impedance calculations to be performed with known time, frequency, and magnitude resolutions. Applications to synthetic and experimental data are included as illustrations

High-pressure structural transitions of Sc2O3 by X-ray diffraction, raman spectra, and ab initio calculations

The high-pressure behavior of scandium oxide (Sc₂O₃) has been investigated by angle-dispersive synchrotron powder X-ray diffraction and Raman spectroscopy techniques in a diamond anvil cell up to 46.2 and 42 GPa, respectively. An irreversible structural transformation of Sc₂O₃ from the cubic phase to a monoclinic high-pressure phase was observed at 36 GPa. Subsequent ab initio calculations for Sc₂O₃ predicted the phase transition from the cubic to monoclinic phase but at a much lower pressure. The same calculations predicted a second phase transition at 77 GPa from the monoclinic to hexagonal phase.

Electrical characterization of new electrochromic devices

Electrochromic devices change their color and optical properties with applied voltage. A new symmetrical electrochromic configuration was constructed in previous works, where PEDOT acted as electrochromic layer or as counter electrode layer, depending on the polarity of the applied voltage. Devices of around 500mm2 and switching voltages from 0,5V to 2V are used in this work. Measured electrochemical impedance is fitted to an equivalent circuit based on a Randles cell, with Warburg impedance simulating ionic diffusion at low frequencies. Voltage dependence is analyzed for the first time in this kind of devices. Results show homogeneity problems in the contact layers, not seen in normal operation, and the voltage dependence on some construction parameters. This will be used to improve the devices construction, but improvements in the equivalent circuit should also be made. The proposed equivalent circuit is not valid after the redox reaction, from 1.5 to 2V.

Unexpected effect of tetraglyme plasticizer on lithium ion dynamics in PAMPS based ionomers

Li(+) cation conducting ionomers based on poly(2-acrylamido-2-methyl-1-propane sulphonic acid) (PAMPS) incorporating a low molecular weight plasticizer have been characterized. Previously we have observed an apparent decoupling of ionic conductivity and lithium ion dynamics from the Tg of this ionomer along with an increase in ionic conductivity obtained by incorporating a quaternary ammonium co-cation. The incorporation of tetraglyme as a coordinating plasticizer was investigated in order to further improve the ion dissociation and dynamics. Solid-state NMR, thermal analysis, impedance spectroscopy and infrared spectroscopy were used to characterize these systems. As expected, the glass transition temperature Tg decreased upon the addition of the plasticizer. However, in contrast to the previously reported Na-conducting systems, the ionic conductivity was also decreased by several orders of magnitude, indicating that the tetraglyme recouples the conductivity back to the polymer dynamics. Temperature dependent (7)Li NMR line width and T1 measurements were used to probe the Li(+) dynamics, which were found to be dependent on the Li(+) concentration, the nature of the co-cation and the presence or absence of tetraglyme.