Surface wrinkling of the twinning induced plasticity steel during the tensile and torsion tests

'Heterogeneous twinning' is defined as plastic deformation due to the formation and progress of twins resulting in surface wrinkles on the deforming part when the initial grain size is relatively large compared to the typical size of the part. In the case of a Twinning Induced Plasticity (TWIP) steel with an initial grain size of ~160. m, the heterogeneous twinning generated visible wrinkles, an orange peel effect, under medium uni-axial strains. The heterogeneous twinning did not occur in the material subjected to high shear strains. The complications resulting from this phenomenon on strain hardening characterization of the TWIP steels using two commonly used mechanical tests, tensile and torsion are discussed along with some experimental aspects of heterogeneous twinning. © 2014.

A comprehensive method to identify the kinetics of static recrystallization using the hot torsion test results with an inverse solution

Many difficulties exist in directly following the static recrystallization of metals, particularly during hotworking. Indirect measurement of static recrystallization has been extensively performed in the literature where, for example, the recrystallization behavior of austenite in steels has commonly been measured indirectly using the fractional softening method. This method relies on the yield stress changes during recrystallization which are physically simulated by hot torsion or compression tests. However, the inherent heterogeneity of deformation during a mechanical test leads to a non-uniform static recrystallization distribution in the test sample. This, in turn, poses a serious question concerning the reliability of the measurement since the stress calculation techniques during recrystallization are not adequately developed in the existing literature. This paper develops a computer-based method to account for heterogeneous deformation during fractional softening measurements based on the hot torsion test data. The importance of the fractional softening gradient in determining the kinetics is emphasized and deficiencies in our understanding of the basic mechanisms are highlighted. A computer-based method is introduced to generate the experimental and computational components in a cost function. The cost function is then utilized by an inverse solution to calibrate the design parameters in a static recrystallization model.

Sizing up the effect of portion size on consumption: A meta-analytic review

Food marketing is facing increasing challenges in using portion size (e.g., “supersizing”) as a marketing tool.Marketers have used portion size to attract customers and encourage purchase, but social agencies areexpressing concern that larger portion sizes encourage greater consumption, which can cause excessiveconsumption and obesity. This article addresses two questions that are central to this debate: (1) How much effectdoes portion size have on consumption? and (2) Are there limits to this effect? A meta-analytic review reveals that,for a doubling of portion size, consumption increases by 35% on average. However, the effect has limits. Anextended analysis shows that the effect of portion size is curvilinear: as portions become increasingly larger, theeffect diminishes. In addition, although the portion-size effect is widespread and robust across a range of individualand environmental factors, the analysis shows that it is weaker among children, women, and overweightindividuals, as well as for nonsnack food items and in contexts in which more attention is given to the food beingeaten.

Does gender explain the relationship between occupation and suicide? Findings from a meta-analytic study

This report investigated whether suicide risk by occupational groups differed for males and females. We examined this using a sub-set of articles examined in a recent meta-analysis and stratified by gender. For certain occupational groups, males and females had a similar risk of suicide (the military, community service occupations, managers, and clerical workers). There was some indication of gender differences for other occupations (technicians, plant and machine operators and ship’s deck crew, craft and related trades workers, and professionals), although these did not reach statistical significance. These findings highlight the complexity of the relationship between occupation and suicide and suggest the possible role of a range of individual, work-related and social-environmental risk factors that may differ for males and females.

Letters, green cards, telephone calls and postcards: systematic and meta-analytic review of brief contact interventions for reducing self-harm, suicide attempts and suicide

BACKGROUND: There is growing interest in brief contact interventions for self-harm and suicide attempt. AIMS: To synthesise the evidence regarding the effectiveness of brief contact interventions for reducing self-harm, suicide attempt and suicide. METHOD: A systematic review and random-effects meta-analyses were conducted of randomised controlled trials using brief contact interventions (telephone contacts; emergency or crisis cards; and postcard or letter contacts). Several sensitivity analyses were conducted to examine study quality and subgroup effects. RESULTS: We found 14 eligible studies overall, of which 12 were amenable to meta-analyses. For any subsequent episode of self-harm or suicide attempt, there was a non-significant reduction in the overall pooled odds ratio (OR) of 0.87 (95% CI 0.74-1.04, P = 0119) for intervention compared with control. The number of repetitions per person was significantly reduced in intervention v. control (incidence rate ratio IRR = 066, 95% CI 0.54-0.80, P<0001). There was no significant reduction in the odds of suicide in intervention compared with control (OR = 0.58, 95% CI 0.24-1.38). CONCLUSIONS: A non-significant positive effect on repeated self-harm, suicide attempt and suicide and a significant effect on the number of episodes of repeated self-harm or suicide attempts per person (based on only three studies) means that brief contact interventions cannot yet be recommended for widespread clinical implementation. We recommend further assessment of possible benefits in well-designed trials in clinical populations.

Strain gradient plasticity modelling of high-pressure torsion

Gradient plasticity modelling combining a micro-structure-related constitutive description of the local material behaviour with a particular gradient plasticity frame is presented. The constitutive formulation is based on a phase mixture model in which the dislocation cell walls and the cell interiors are considered as separate 'phases', the respective dislocation densities entering as internal variables. Two distinct physical mechanisms, which give rise to gradient plasticity, are considered. The first one is associated with the occurrence of geometrically necessary dislocations leading to first-order strain gradients; the second one is associated with the reaction stresses due to plastic strain incompatibilities between neighbouring grains, which lead to second-order strain gradients. These two separate variants of gradient plasticity were applied to the case of high-pressure torsion: a process known to result in a fairly uniform, ultrafine grained structure of metals. It is shown that the two complementary variants of gradient plasticity can both account for the experimental results, thus resolving a controversial issue of the occurrence of a uniform micro-structure as a result of an inherently non-uniform process. © 2007 Elsevier Ltd. All rights reserved.

Enhanced ductility and reduced asymmetry of Mg-2Al-1Zn alloy plate processed by torsion and annealing

The ductility and plastic asymmetry of an as-annealed magnesium alloy plate were studied in compression through combined process of torsion and subsequent annealing by optical microscope and EBSD. The yield strength (YS) and ultimate compression strength (UCS) as well as the compression ductility (CD) were simultaneously raised by prior torsion at room temperature. The CD was further enhanced by subsequent annealing. Also, the torqued sample followed by annealing experienced a rising CD with the increase in prior strain, leading to the maximum true strain of 0.279, which is twice that of the as-annealed original one. The sample showed a largely reduced tension-compression yield asymmetry by subjecting to pre-torsion alone or combined with a subsequent annealing. The enhanced ductility and reduced asymmetry are attributed to the development of a gradient microstructure with refined grains, and also randomization of the weakened texture due to torsion and subsequent annealing.

Does the theory of planned behaviour explain condom use behaviour among men who have sex with men? A meta-analytic review of the literature

The aim of this meta-analysis was to explore whether the constructs in the theory of planned behaviour (TPB; i.e., attitude, subjective norm, perceived behavioural control, intention) explain condom use behaviour among men who have sex with men (MSM). Electronic databases were searched for studies that measured TPB variables and MSM condom use. Correlations were meta-analysed using a random effects model and path analyses. Moderation analyses were conducted for the time frame of the behavioural measure used (retrospective versus prospective). Attitude, subjective norm and perceived behavioural control accounted for 24.0 % of the variance in condom use intention and were all significant correlates. Intention and PBC accounted for 12.4 % of the variance in condom use behaviour. However, after taking intention into account, PBC was no longer significantly associated with condom use. The strength of construct relationships did not differ between retrospective and prospective behavioural assessments. The medium to large effect sizes of the relationships between the constructs in the TPB, which are consistent with previous meta-analyses with different behaviours or target groups, suggest that the TPB is also a useful model for explaining condom use behaviour among MSM. However, the research in this area is rather small, and greater clarity over moderating factors can only be achieved when the literature expands.

A cluster analytic approach to identifying predictors and moderators of psychosocial treatment for bipolar depression: results from STEP-BD

Background We sought to address how predictors and moderators of psychotherapy for bipolar depression - identified individually in prior analyses - can inform the development of a metric for prospectively classifying treatment outcome in intensive psychotherapy (IP) versus collaborative care (CC) adjunctive to pharmacotherapy in the Systematic Treatment Enhancement Program (STEP-BD) study. Methods We conducted post-hoc analyses on 135 STEP-BD participants using cluster analysis to identify subsets of participants with similar clinical profiles and investigated this combined metric as a moderator and predictor of response to IP. We used agglomerative hierarchical cluster analyses and k-means clustering to determine the content of the clinical profiles. Logistic regression and Cox proportional hazard models were used to evaluate whether the resulting clusters predicted or moderated likelihood of recovery or time until recovery. Results The cluster analysis yielded a two-cluster solution: 1) "less-recurrent/severe" and 2) "chronic/recurrent." Rates of recovery in IP were similar for less-recurrent/severe and chronic/recurrent participants. Less-recurrent/severe patients were more likely than chronic/recurrent patients to achieve recovery in CC (p=.040, OR=4.56). IP yielded a faster recovery for chronic/recurrent participants, whereas CC led to recovery sooner in the less-recurrent/severe cluster (p=.034, OR=2.62). Limitations Cluster analyses require list-wise deletion of cases with missing data so we were unable to conduct analyses on all STEP-BD participants. Conclusions A well-powered, parametric approach can distinguish patients based on illness history and provide clinicians with symptom profiles of patients that confer differential prognosis in CC vs. IP.

Persistent and contemporaneous effects of job stressors on mental health: a study testing multiple analytic approaches across 13 waves of annually collected cohort data

OBJECTIVES: This study investigated the extent that psychosocial job stressors had lasting effects on a scaled measure of mental health. We applied econometric approaches to a longitudinal cohort to: (1) control for unmeasured individual effects; (2) assess the role of prior (lagged) exposures of job stressors on mental health and (3) the persistence of mental health.

METHODS: We used a panel study with 13 annual waves and applied fixed-effects, first-difference and fixed-effects Arellano-Bond models. The Short Form 36 (SF-36) Mental Health Component Summary score was the outcome variable and the key exposures included: job control, job demands, job insecurity and fairness of pay.

RESULTS: Results from the Arellano-Bond models suggest that greater fairness of pay (β-coefficient 0.34, 95% CI 0.23 to 0.45), job control (β-coefficient 0.15, 95% CI 0.10 to 0.20) and job security (β-coefficient 0.37, 95% CI 0.32 to 0.42) were contemporaneously associated with better mental health. Similar results were found for the fixed-effects and first-difference models. The Arellano-Bond model also showed persistent effects of individual mental health, whereby individuals' previous reports of mental health were related to their reporting in subsequent waves. The estimated long-run impact of job demands on mental health increased after accounting for time-related dynamics, while there were more minimal impacts for the other job stressor variables.

CONCLUSIONS: Our results showed that the majority of the effects of psychosocial job stressors on a scaled measure of mental health are contemporaneous except for job demands where accounting for the lagged dynamics was important.