Size based separation of microparticles using a dielectrophoretic activated system

This work describes the separation of polystyrene microparticles suspended in deionized (DI) water according to their dimensions using a dielectrophoretic (DEP) system. The DEP system utilizes curved microelectrodes integrated into a microfluidic system. Microparticles of 1, 6, and 15 μm are applied to the system and their response to the DEP field is studied at different frequencies of 100, 200, and 20 MHz. The microelectrodes act as a DEP barrier for 15 μm particles and retain them at all frequencies whereas the response of 1 and 6 μm particles depend strongly on the applied frequency. At 100 kHz, both particles are trapped by the microelectrodes. However, at 200 kHz, the 1 μm particles are trapped by the microelectrodes while the 6 μm particles are pushed toward the sidewalls. Finally, at 20 MHz, both particles are pushed toward the sidewalls. The experiments show the tunable performance of the system to sort the microparticles of various dimensions in microfluidic systems.

Reductions in nutrient discharge from aquaculture through recycling of water utilising floating media and activated carbon filtration

Nutrient discharge into coastal areas, such as the Great Barrier Reef can result in the degradation of coastal ecosystems. For example, excess nitrogen and phosphorus can damage corals through inducing algal bloom and subsequent shading. Excessive phosphorus can further weaken coral skeletons making them susceptible to damage. Land based industries such as aquaculture can contribute to such problems. This study set out to develop a system whereby water from aquaculture can be constantly reused resulting in minimized waste discharge. A three-stage filtration system utilizing floating media and activated carbon was designed to harness bacterial processes that could reduce both particulate and dissolved compounds to the extent whereby approximately 100% reuse of the wastewater became possible. This involved efficient and effective particulate and biological removal mechanisms in both aerobic and anaerobic zones of the filtration system. This design reduced dissolved nitrogen levels by up to 70% and maintained low phosphorus levels, which allowed the reuse of water for the successful culture of barramundi with a survival rate of 97% over 25 days. This pilot scale study demonstrated the potential of reusing aquaculture wastewater from the viewpoint of reducing nutrient input into coastal environments. Future research will refine these processes and assess the performance of the system at several commercial scale applications.

Powdered activated carbon for fouling reduction of membrane in a pilot-scale recirculation aquaculture system

Recirculating aquaculture systems (RAS) are essential for the reduction in fresh water usage as well as the discharge of nutrients along with aquaculture effluents. A RAS consisting of an anoxic reactor, a membrane bioreactor (MBR) and a UV-disinfection unit was used to process 10,000 L/d of aquaculture effluent providing high-quality treated water for recirculation to a Barramundi fish culture. The system maintained low levels of nitrate (<20 mg/L), nitrite (<3 mg/L) and ammonia (<0.6 mg/L) in the fish tank. Permeate from the membrane that was recirculated to the fish tank contained <21 mg/L of nitrate, <2 mg/L of nitrite and 0 mg/L of ammonia. However, the rate of fouling of the membrane in the MBR was around 1.47 kPa/d, and the membrane in the MBR required cleaning due to fouling after 16 days. Cleaning of the membrane was initiated when the TMP reached around 25 to 30 kPa. In order to reduce the rate of fouling, 500 mg of powdered activated carbon (PAC) per litre of MBR volume was introduced, which decreased the rate of fouling to 0.90 kPa/d. Cleaning of membrane was needed only after 31 days of operation while maintaining the treated effluent quality. Thus the frequency of cleaning could be halved due to the introduction of PAC into the MBR.

Granular Activated Carbon (GAC) adsorption in tertiary wastewater treatment : experiments and models

Wastewater treatment has always been a major concern in the developed countries. Over the last few decades, activated carbon adsorption has gained importance as an alternative tertiary wastewater treatment and purification process. In this study, granular activated carbon (GAC) adsorption was evaluated in terms of total organic carbon (TOC) removal from low strength synthetic wastewater. This paper provides details on adsorption experiments conducted on synthetic wastewater to develop suitable adsorption isotherms. Although the inorganics used in the synthetic wastewater solution had an overall unfavourable effect on adsorption of organics, the GAC adsorption system was found to be effective in removing TOC from the wastewater. This study showed that equation of state (EOS) theory was able to fit the adsorption isotherm results more precisely than the most commonly used Freundlich isotherm. Biodegradation of the organics with time was the most crucial and important aspect of the system and it was taken into account in determining the isotherm parameters. Initial organic concentration of the wastewater was the determining factor of the model parameters, and hence the isotherm parameters were determined covering a wide range of initial organic concentrations of the wastewater. As such, the isotherm parameters derived using the EOS theory could predict the batch adsorption and fixed bed adsorption results of the multi-component system successfully. The isotherm parameters showed a significant effect on the determination of the mass transfer coefficients in batch and fixed bed systems.

Ligand-enhanced expression and in-cell assay of human peroxisome proliferator-activated receptor alpha ligand binding domain

A human peroxisome proliferator-activated receptor alpha ligand binding domain (PPARαLBD)-maltose binding protein fusion construct was expressed in Escherichia coli. A codon optimized DNA sequence encoding human PPARαLBD (aa196–468) was synthesized and ligated into the pDEST17 E. coli expression vector downstream of a MBP solubility fusion tag and an intermittent TEV protease cleavage site. Following auto-induction at 28 °C, PPARαLBD protein was purified to electrophoretic homogeneity by a nickel affinity chromatographic step, on-column TEV protease cleavage followed by Sephacryl S200 size exclusion chromatography. The recombinant protein displayed cross-reactivity with goat anti-(human PPARα) polyclonal antibody and was identified as human PPARα by trypic peptide mass finger-printing. The addition of a PPARα specific ligand (fenofibric acid, GW7647 or GW590735) to the growth media significantly stabilized the PPARαLBD structure and enhanced the expression of soluble protein. In-cell ligand binding was examined by monitoring the enhancement of PPARαLBD expression as a function of the concentration of ligand in the growth media. The efficient expression and in-cell assay of the reported PPARαLBD construct make it amenable to high through-put screening assays in drug discovery programs.

Visible light activated TiO2/microcrystalline cellulose nanocatalyst to destroy organic contaminants in water

Hybrid TiO2/microcrystalline cellulose (MC) nanophotocatalyst was prepared in situ by a facile and simple synthesis utilizing benign precursors such as MC and TiCl4. The as-prepared nanocomposite was characterized by XRD, XPS, BET surface area analyzer, UV–vis DRS and TGA. Surface morphology was assessed by the means of SEM and HR-TEM. Statistics-based factorial design (FD) was adopted to investigate the effect of precursors concentrations and therefore to optimize the nanocomposite synthesis through catalytic adsorption of methylene blue (MB) from aqueous solutions. The results indicated that TiO₂/MC nanocomposites were photocatalytically active in diminishing 40–90% of MB in 4 h.