Poly (vinyl alcohol) / silica nanocomposites: morphology and thermal degradation kinetics

The morphology of self-assembled poly(vinyl alcohol)/silica (PVA/SiO₂) nanocomposites is investigated with atomic force microscopy (AFM) and transmission electron microscopy (TEM). It is found that the SiO₂ nanoparticles are homogenously distributed throughout the PVA matrix in a form of spherical nano-cluster. The average size of the SiO₂ clusters is below 50 nm at the low contents (SiO₂ ≤ 5 wt%), while particle aggregations are clearly observed and their average size markedly increases to 110 nm when 10 wt% SiO₂ is loaded. The thermogravimetric analysis (TGA) shows that the nanocomposite significantly outperforms the pure PVA in the thermal resistance. By using a multi-heating-rate method, the thermal degradation kinetics of the nanocomposite with a SiO₂ content of 5 wt% is compared to the PVA host. The reaction activation energy (E) of the nanocomposite, similar to the pure PVA, is divided into two main stages corresponding to two degradation steps. However, at a given degradation temperature, the nanocomposite presents much lower reaction velocity constants (k), while its E is 20 kJ/mol higher than that of the PVA host.

In situ observation of the aggregated morphology and interaction of dialkyldimethylammonium bromide with DNA at air/water interface by Brewster angle microscopy

The adsorption of DNA on the Langmuir film of a cationic surfactant, dioctadecyldimethylammonium bromide (DODA·Br), and the change of the aggregation morphology of the composite monolayer with respect to surface pressure have been investigated by Brewster angle microscopy (BAM). In contrast with the case of DODA·Br on pure water subphase, when DNA was dispersed into subphase, its adsorption to the interface monolayer through electrostatic interaction decreases the charge density and therefore promotes the formation of domain at low surface pressure. In addition, the electrostatic interaction changed the phase morphology of DODA·Br Langmuir monolayer under different surface pressure, that is, from flower-shaped crystalline domain on the pure water subphase to circular domain on the subphase dispersed with DNA. The result also shows that the monolayer of the composite at air/water interface under the high pressure is not homogeneous, but consists of incompletely fused domains. For the Langmuir film of the surfactant with shorter alkyl-chains, similar morphology can be observed both under the high and low surface pressure. But the tight-stacked circular domain is no longer observed.

Biological properties of the Hendra virus envelope proteins

Outbreaks of Hendra virus in Queensland, during 1994-1999, resulted in the deaths of 17 horses and 2 humans from respiratory or neurological disease. Immunological, ultrastructural and expressional studies of the viral envelope proteins using recombinant poxviruses and DNA vectors contributed to improving our understanding of the biology of Hendra virus.

A processability approach to agreement morphology in Arabic L2

This thesis tests the processability theory (PT) (Pienemann 1998;2005) predictions for agreement morphology in the acquisition of Arabic L2. The thesis has demonstrated that, apart from a few cases, learners of Arabic L2 acquired the test structures according to the PT's predictions for L2 sequential development.

High-performance composite from epoxy and glass fibers : morphology, mechanical, dynamic mechanical, and thermal analysis

Diglycidyl ether of bisphenol-A type epoxy resin cured with diamino diphenyl sulfone was used as the matrix for fiber-reinforced composites to get improved mechanical and thermal properties for the resulting composites. E-glass fiber was used for fiber reinforcement. The morphology, tensile, flexural, impact, dynamic mechanical, and thermal properties of the composites were analyzed. The tensile, flexural, and impact properties showed dramatic improvement with the addition of glass fibers. Dynamic mechanical analysis was performed to obtain the Tg of the cured matrix as well as the composites. The improved thermal stability of the composites was clear from the thermogravimetric analysis. Scanning electron micrographs were taken to understand the interfacial adhesion between the fiber and the matrix. The values of mechanical properties were compared with modified epoxy resin composite system. Predictive models were applied using various equations to compare the mechanical data obtained theoretically and experimentally.

Ion transport in polymer electrolytes containing nanoparticulate TiO2 : The influence of polymer morphology

Recent studies have shown that composite polymer electrolytes, formed by dispersing nanosized ceramic particles in polyether-based electrolytes, have improved ion transport properties as compared to their unfilled analogues. In the present study polymer electrolytes with different loadings of nano-sized ceramic particles (TiO₂) and different polymer chemistry and morphology have been investigated. Of special interest are filler induced effects on polymer, solvent and cationic mobility. Partly crystalline polymer electrolytes based on poly(ethylene oxide) have been compared to fully amorphous polymer electrolytes based on a polyether urethane, as well as gel electrolytes based on PMMA. ⁷Li pfg-NMR, linewidth and spin–spin relaxation times as well as ¹H pfg-NMR and spin–spin relaxation times, were measured as a function of temperature and composition. The ¹H spin–spin relaxation measurements reveal increased average polymer mobility with the addition of filler up to a maximum at 4 and 8 wt.% TiO₂ for the fully amorphous and the partly crystalline electrolytes, respectively. The ⁷Li linewidth measurements for the fully amorphous system show a broadening of the linewidth with addition of filler. Based on variable temperature measurements this broadening is interpreted as a result of the inhomogeneity introduced by the filler particles. Pulsed field gradient (pfg) diffusion measurements were employed to determine ion and solvent self-diffusion coefficients. In the case of the PMMA-based gel electrolyte and the fully amorphous electrolytes enhanced cation self-diffusion was observed upon addition of TiO₂.

The effect of solvent uptake on the relaxation behaviour, morphology and mechanical properties of a poly(ether ether ketone)/poly(etherimide) blend

The effects of solvent uptake on the relaxation behaviour, morphology and mechanical properties of poly(ether ether ketone) (PEEK), poly(etherimide) (PEI) and a 50/50 PEEK/PEI blend have been investigated. Amorphous films were immersed in acetone at 25°C, 35°C and 45°C until equilibrium uptake was achieved. The films were then examined by wide angle X-ray scattering (WAXS), differential scanning calorimetry (d.s.c.), dynamic mechanical relaxation spectroscopy and mechanical testing. WAXS and d.s.c. revealed that the degree of solvent induced crystallinity in PEEK is constant with immersion temperature, whereas the degree of induced crystallinity in the 50/50 blend is strongly temperature dependent. The dynamic mechanical studies confirmed that a significant decrease in glass transition temperature results from the plasticizing effect of the solvent and that solvent and thermally crystallized samples have different relaxation characteristics. Mechanical property tests showed that the yield stress and tensile strength of the blend are dominated by PEEK and the degree of crystallinity, while the modulus is more sensitive to the extent of plasticization.

Conducting polymers with fibrillar morphology synthesized in a biphasic ionic liquid/water system

The synthesis of poly(pyrrole), poly(terthiophene), and poly(3,4-ethylenedioxythiophene) with unusual fibrillar morphologies has been achieved by chemical polymerization in a biphasic ionic liquid/water system. Use of aqueous gold chloride as the oxidant, with the monomers dissolved in a hydrophobic ionic liquid, allows the polymerization to occur at the ionic liquid/water interface. The resultant conducting polymer fibrils are, on average, 50−100 nm wide and can be thousands of nanometers long. The polymers produced in this ionic liquid system are compared to those synthesized in a biphasic chloroform/water system.

Enhanced thermal properties and morphology of ion-exchanged polypyrrole films

The thermal stability of electrochemically prepared polypyrrole (PPy) films with p-toluenesulfonate (pTS) or perchlorate (ClO₄⁻) counterion (PPy/pTS and PPy/ClO₄⁻) is improved by simple treatment with aqueous sulfuric acid, sodium sulfate or sodium bisulfate. The degree of stabilization achieved depends on the solution, temperature and duration of treatment. Although the mechanism for improved stability is not yet clear, it is apparent that the level of ion exchange and the original polymer microstructure are important. A model for the conductivity decay as a function of thickness has been proposed. The early stages of ion exchange are not symmetrical, and diffusion is facilitated at the electrode side of the film. Furthermore, X-ray diffraction shows no evidence of morphological change after treatment of PPy/pTS (43 μm), but in PPy/pTS (12 μm) and PPy/ClO₄⁻ (41 μm) films an additional peak is indicative of more ordered structure following treatment. The glass transition temperature, T_g, of PPy/pTS and PPy/ClO₄⁻ films obtained by modulated differential scanning calorimetry is approximately 155°C.

The effect of seed morphology on the potential dispersal of aquatic macrophytes by the common carp (Cyprinus carpio)

1. The potential for seed dispersal by fish (ichthyochory) will vary among aquatic plants because of differences in seed size and morphology.

2. To examine how seed morphology influences the probability of dispersal by the common carp (Cyprinus carpio), we studied seed ingestion, retention time and subsequent egestion and germination of seeds of Sparganium emersum and Sagittaria sagittifolia, two aquatic plant species with similar sized but morphologically different seeds.

3. We compared dispersal probabilities between the two plant species, in which the probability of dispersal is assumed to be a function of the probabilities of seed ingestion, egestion and germination, and the dispersal distance is assumed to be a function of seed egestion rate over time.

4. We found that, although the soft seeds of S. sagittifolia had an approximately 1.5 times higher probability of being ingested by the carp than the hard seeds of S. emersum (83.15% ± 1.8% versus 56.16% ± 2.7%, respectively), the latter had an almost twofold higher probability of surviving the passage through the digestive tract (38.58% ± 2.7% versus 20.97% ± 1.5%, respectively). Patterns of seed egestion over time did not differ between the two plant species, despite the difference in seed morphology. Gut passage had a different effect on seed germination between plant species. Compared with non-ingested controls, seeds of S. emersum showed a 12.6% increase in germination and a 2.1 day acceleration in germination rate, whereas seeds of S. sagittifolia displayed a 47.3% decrease and 5.1 day delay, respectively.

5. Our results suggest that seed morphology affects the dispersal probability and postdispersal establishment, but not the dispersal distance, of aquatic plants that are dispersed by fish.