Motor imagery data classification for BCI application using wavelet packet feature extraction

The noninvasive brain imaging modalities have provided us an extraordinary means for monitoring the working brain. Among these modalities, Electroencephalography (EEG) is the most widely used technique for measuring the brain signals under different tasks, due to its mobility, low cost, and high temporal resolution. In this paper we investigate the use of EEG signals in brain-computer interface (BCI) systems.

Determination of embedment depth of timber poles and piles using wavelet transform

This paper presents an investigation on the wave propagation in timber poles with Wavelet Transform (WT) analysis for identification of the condition and underground depth of embedded timber poles in service. Most of non-destructive testing (NDT) applications for timber poles using wave-based methods consider only single wave mode and no dispersion. However, for wave propagations in timber poles (damaged/undamaged), such simplification may not be correct, especially for broad band excitation using impulse impact. To investigate the problem, a 5m timber pole was investigated numerically and experimentally. A dispersion curve is generated from the numerical results to provide guidance on the velocity and wave mode selection. Continuous wavelet transform (CWT) is applied on the same signal to verify the presence of modes and to process data from experimental testing. The results are presented in both time domain and time-frequency domain for comparison. The results of the investigation showed that, wavelet transform analysis can be a reliable signal processing tool for NDT in terms of condition and embedment length determination.

Determinations of stress wave velocity in a timber pole using wavelet transform

This paper presents an application of Wavelet Transfonn (WT) for determination of stress wave velocity for Non-destructive Testing of timber utility poles in service. For surface Non-destructive Testing (NDT), the hammer impact, which produces generally broadband frequency excitation, is used to generate stress wave. Moreover, due to practicality the impact location for field testing of a utility pole is on the side of the pole and 1.5 m above ground level. And the geometry of utility pole could not guarantee non-dispersive longitudinal wave. All of these issues have resulted in lack of accuracy and reliability of results from surface NDT in field testing. In recognition of such problem, this research explores methods to reliably calculate desired wave velocity by isolating wave mode and studying dispersive nature of utility pole. Fast Fourier Transfonn (FFT) is firstly conducted to determine the suitable frequency from a stress wave data. Then WT is applied on the wave data mentioned to perfonn time-frequency analysis. Velocity can be detennined by time history data of desired frequency from WT results which will be compared with the available analytical solution for longitudinal wave velocity. The results of the investigation showed that wavelet transfonn analysis can be a reliable signal processing tool for non-destructive testing in tenns of velocity detennination, which in tum also helps to detennine the embedded length of the timber pole.

Ranking of fibre-reinforced composite plate surface finish quality by wavelet texture analysis

In the automotive and other industries, the visual appearance of external surfaces is a key factor in perceived product quality. Traditionally, the quality of an automotive surface finish has been judged by expert human auditors. A set of 17 fibre-reinforced composite plates was previously manufactured to have a range of surface finish qualities and these plates were ranked by three expert observers and also optically digitally imaged. Following validation of the previous rankings, the wavelet texture analysis (WTA) technique was applied to the digital photographs to derive an instrumental measure of surface finish quality based on the panel images. The rank correlation between the human expert surface finish quality ratings and those from the W TA image analysis process was found to be positive, large and statistically significant. This finding indicates that WTA could form the basis of an inexpensive and practical instrumental method for the ranking of fibre-reinforced composite surface finish quality.