On the components of the dielectric constants of ionic liquids : ionic polarization?

According to dielectric spectroscopy measurements, ionic liquids (ILs) have rather modest dielectric constants that reflect contributions from distortion and electronic polarization caused by the molecular polarizability as well as the orientation polarization caused by the permanent dipole moment of the ions. To understand the relative importance of these various contributions, the electronic polarizabilities of 27 routinely used ionic liquid ions of different symmetry and size were calculated using ab initio-based methods such as HF and MP2. Using the Clausius–Mossotti equation, these polarizabilities were then used to obtain the electronic polarization contribution (ε_op) to the dielectric constants of six ionic liquids, [C₂mim][BF₄], [C₂mpyr][N(CN)₂], [C₂mim][CF₃SO₃], [EtNH₃][NO₃], [C₂mim][NTf₂] and [C₂mim][EtSO₄]. Theoretical ε_op values were compared to experimental refractive indices of these ionic liquids as well as to those of traditional molecular solvents such as water, tetrahydrofuran (THF), dimethylsulfoxide (DMSO) and formamide. The dipole moments of the ions were also calculated, and from these it is shown that the molecular reorientation component of the dielectric constants of the ionic liquids consisting of ions with small or negligible dipole moments is quite small. Thus it is concluded that a contribution from a form of “ionic polarization” must be present.

Composite cell components for elevated temperature all-solid-state Li-ion batteries

Application of Li-ion batteries with liquid electrolytes at elevated temperatures (above 60°C) is limited due to the decomposition of the electrolyte. Stable solid state electrolytes can solve this problem, but the conductivity of these electrolytes are relatively low, the interfacial contacts with the electrodes are poor, and the charge transfer kinetics in the electrodes are limited. Solutions for these problems by using composite electrodes and electrolytes have been investigated and the results are described. A new concept for making all-solid-state Li-ion batteries that can be applied in the temperature range between room temperature and about 150°C will be presented.

Carriers and components

Parametric modelling is a powerful means of geometric control. Within the field of architecture, there are wide ranging possibilities in form generation, self analysing structural systems and performative building facades. This thesis has investigated the potential of parametric modelling as a design tool, specifically in the exploration of architectural surfaces.

Partial least squares and principal components analysis of wine vintage by high performance liquid chromatography with chemiluminescence detection

HPLC with acidic potassium permanganate chemiluminescence detection was employed to analyse 17 Cabernet Sauvignon wines across a range of vintages (1971–2003). Partial least squares regression analysis and principal components analysis was used in order to investigate the relationship between wine composition and vintage. Tartaric acid, vanillic acid, catechin, sinapic acid, ethyl gallate, myricetin, procyanadin B and resveratrol were found to be important components in terms of differences between the vintages.

Influence of stocking rate and mixed grazing of Angora goats and Merino sheep on animal and pasture production in southern Australia : 1 : botanical composition, sward characteristics and availability of components of annual temperate pastures

The effects of animal species (AS; Angora goats, Merino sheep or goats and sheep mixed grazed together at ratio 1:1) and stocking rate (SR; 7.5, 10 and 12.5 animals/ha) on the availability, botanical composition and sward characteristics of annual temperate pastures under continuous grazing were determined in a replicated experiment from 1981 to 1984. AS and SR had significant effects on pasture availability and composition and many AS SR interactions were detected. The pastures grazed by sheep had significantly reduced content and proportion of subterranean clover and more undesirable grasses compared with those grazed by goats. There were no differences in dry matter availabilities between goat- and sheep-grazed pastures at 7.5/ha, but at 10 and 12.5/ha goat pastures had significantly increased availabilities of green grass, dead and green clover and less weeds compared with sheep pastures. There was a significant AS SR interaction for the density of seedlings in May following pasture germination. Between July and January, the height of pastures was greater under goats than sheep but from January to March pasture height declined more on goat-grazed than on sheep-grazed pastures. There was an AS SR interaction for incidence of bare ground. Increasing the SR increased bare ground in pastures grazed by sheep but no change occurred on pastures grazed by goats. Changes in pasture characteristics due to increased SR were minimised on pastures grazed by goats but the grazing of sheep caused larger and faster changes and the pastures were damaged at the highest SR. Goats did not always select the same herbage material as sheep, changed their selection between seasons and were not less selective than sheep. Angora goats were flexible grazers and continually adapted their grazing behaviour to changing herbage conditions. Goat grazing led to an increase in subterranean clover, an accumulation of dead herbage at the base of the sward, reduced bare ground, taller pastures in spring and a more stable botanical composition. Mixed-grazed pasture characteristics were altered with SR. With careful management Angora goats on sheep farms may be used to manipulate pasture composition, to speed up establishment of subterranean clover, to decrease soil erosion and to reduce weed invasion.

Assessing body condition and energy budget components by scoring abdominal profiles in free-ranging pink-footed geese Anser brachyrhynchus

An abdominal profile index (API) was developed for pink-footed geese Anser brachyrhynchus as a measure of body condition. On basis of carcass analysis of 56 adult geese with known API prior to collection, we found significant linear relationships between API against body mass, abdominal fat and total energy content. Hence, changes in API reflect net energy intake rates. As an example of the applicability of the calibration, we compared APIs of individually marked geese before and after long migration episodes and estimated the cost of flight at 8.9 kJ/km. In addition we estimated gain rates at three major staging sites along the spring flyway indicating an increase in fueling rates with latitude. Calibration of APIs and energy contents offers new opportunities for field studies of waterfowl energetics.

Role of Jak2/Stat5/Cis pathway components in zebrafish development

By utilizing the zebrafish as a research model, the function of specific cell signalling pathway components in development was investigated. This revealed new roles for the so-called Jak2/Stat5/Cis pathway in blood and sensory organ development, and a conserved prolactin pathway despite divergent functions between species.

Integrated fluid-thermal-structural numerical analysis for the quenching of metallic components

The quenching of a metal component with a channel section in a water tank is numerically simulated. Computational fluid dynamics (CFD) is used to model the multiphase flow and the heat transfer in film boiling, nucleate boiling and convective cooling processes to calculate the difference in heat transfer rate around the component and then combining with the thermal simulation and structure analysis of the component to study the effect of heat transfer rate on the distortion of the U-channel component. A model is also established to calculate the residual stress produced by quenching. The coupling fluid-thermal-structural simulation provides an insight into the deformation of the component and can be used to perform parameter analysis to reduce the distortion of the component. © 2011 Shanghai Jiaotong University and Springer-Verlag Berlin Heidelberg.