Framework for a Residential Energy Information System (REMIS) to promote energy efficient behaviour in residential energy end users

Previous studies on residential energy end use behavior reported significant reduction in energy end use of 7% to 24% when feedback is used to modify behavior in an energy efficient manner. However, most feedback systems investigated in previous studies have not benefited from advanced information systems (IS). IS can shape energy efficiency behavior by providing real-time feedback on energy consumption, cost and environmental impact. Such systems represent a new and less-researched subfield of energy informatics. This paper provides a conceptual framework for showing the potential use of IS to modify residential energy use behavior towards better energy efficiency. The framework builds on research in residential energy end use, in particular energy end use behavioral model. It provides conceptual inputs for a blue-print to develop a residential energy management information system (REMIS) and also highlights the use of new information and communications technologies (ICT) that had not been widely used, setting the grounds for further research in this area.

Simulation of a novel piezoelectric energy harvester

This paper focuses on a novel piezoelectric energy harvester for nanofiber PVDF to capture energy from vibration environment. A Resembling CMOS(R-CMOS) circuit consisting of two pMOS transistors and two nMOS transistors is presented, which can greatly increase the energy efficiency and reduce the power dissipation tremendously. Meanwhile, the novel harvester supplies smooth direct current. Simulation result of MULTISIM has shown that by using this novel piezoelectric energy harvester the input voltage (5v) can be rectified to be an output voltage (4.24v). The voltage conversion rate of the novel harvester is as high as 84.8% which is much larger than the rate of traditional rectifier circuit. Its potential application is in micro sensors, wireless transducers, and sensor networks.

Australia's green economic potential

This Centre for Policy Development briefing paper looks at the issues raised in the Green Economy Report from an Australian perspective and provides a primer to the challenges involved in transforming our economy to operate within environmental limits. It also examines the opportunities of embracing sustainable economic policy solutions in four areas: water, energy, cities and urban transport, and waste management and recycling.

Enhanced mechanical energy harvesting using needleless electrospun poly(vinylidene fluoride) nanofibre web

Randomly oriented poly(vinylidene fluoride) (PVDF) nanofibre webs prepared by a needleless electrospinning technique were used as an active layer for making mechanical-to-electrical energy harvest devices. With increasing the applied voltage in the electrospinning process, a higher b crystal phase was formed in the resulting PVDF nanofibres, leading to enhanced mechanical-to-electrical energy conversion of the devices. The power generated by the nanofibre devices was able to drive a miniature Peltier cooler, which may be useful for the development of mechanically driven cooling textile. In addition, the needleless electrospinning also showed great potential in the production of nanofibres on a large scale.

Voltage regulation in renewable energy integration into the distribution network

Large-scale renewable energy (RE) integration into the distribution network (DN) causes uncertainties due to its intermittent nature and is a challenging task today. In general RE sources are mostly connected near the end user level, i.e., in the low voltage distribution network. RE integration introduces bi-directional power flows across distribution transformer (DT) and hence DN experiences with several potential problems that includes voltage fluctuations, reactive power compensation and poor power factor in the DN. This study identifies the potential effects causes due to large-scale integration of RE into the Berserker Street Feeder, Frenchville Substation under Rockhampton DN. From the model analyses, it has clearly evident that voltage of the Berserker Street Feeder fluctuates with the increased integration of RE and causes uncertainties in the feeder as well as the DN.

Key influences on office comfort and energy performance in different climates

This paper investigates the magnitude of influence of climate, architectural design and occupants on thermal comfort and final energy consumption in offices in different climates. A parametric study for a typical cellular office room has been conducted using the simulation software EnergyPlus. Two different occupant scenarios are each compared with three different architectural design variations and modelled in the context of three different locations for the IPCC climate change scenario A2 for 2030. The parameters evaluated in this study are final energy consumption and adaptive thermal comfort according to ASHRAE Standard 55. The study shows that the impact of occupants on final energy performance is larger than the impact of architectural design in all investigated climates, but the impact of architectural design is predominant concerning thermal comfort. Warmer climates show larger optimisation potential for comfort and energy performance in offices compared to colder climates.

Influences of wind energy integration into the distribution network

Wind energy is one of the most promising renewable energy sources due to its availability and climate-friendly attributes. Large-scale integration of wind energy sources creates potential technical challenges due to the intermittent nature that needs to be investigated and mitigated as part of developing a sustainable power system for the future. Therefore, this study developed simulation models to investigate the potential challenges, in particular voltage fluctuations, zone substation, and distribution transformer loading, power flow characteristics, and harmonic emissions with the integration of wind energy into both the high voltage (HV) and low voltage (LV) distribution network (DN). From model analysis, it has been clearly indicated that influences of these problems increase with the increased integration of wind energy into both the high voltage and low voltage distribution network, however, the level of adverse impacts is higher in the LV DN compared to the HV DN.

Integration of resident's energy costs in short stay accommodation billing system

This paper presents an energy management software package and the supporting energy information automation system to enable the short stay accommodation industry to determine actual residents' energy consumption. The proposed energy management system is used to develop a 'novel deal' method in short stay accommodation based on integration of the room level energy costs into the billing system. This system has the potential to increase energy efficiency in the short stay accommodation industry by actively engaging the residents in the energy saving process. The system is economically and environmentally sustainable and can achieve a high level of energy efficiency with low expenses. The proposed model is also effective for carbon mitigation, and offers a value proposition for all the parties in the short stay accommodation industry, including owners and residents. The paper presents a software system to capture room level energy consumption information and to present the detail of consumed energy information in the resident's accommodation bill. The presented information includes energy consumption profile, the greenhouse gas emission profile, and the cost associated to the energy related services.

Potential of 129Xe NMR spectroscopy of adsorbed xenon for testing the chemical state of the surface of mesoporous carbon materials illustrated by the example of aggregates of diamond and onion-like carbon nanoparticles

The chemical shift in the 129Xe NMR spectrum of adsorbed xenon is very sensitive to the presence of oxygen-containing functional groups on the surface of mesoporous carbon materials. Well-characterized, structurally similar nanodiamond and onion-like carbon samples are considered here as model objects.

Potentialities of renewable energy in Victoria, Australia

In utility power system, electricity demand is being covered largely by fossil fueled power generation, which contributes high level of GHG (greenhouse gas) emission and causes global warming worldwide. In order to reduce GHG emission level, most of the countries in the world targeting towards green energy that is power generation from RE (renewable energy) sources. In this paper, it is considered to study prospects of RE sources in particular, solar and wind in Victoria State which are abundant as compared to other sources of renewable. The wind and solar energy feasibility study and sensitivity analysis has been done for Victoria with the aid of HOMER (hybrid optimization model of electric renewable) simulation software. From the study, it has clearly evicted that wind energy combinational HPS (hybrid power system) has more contribution, and high potential than solar PV (photovoltaic) systems for a particular location. This study also investigates the influences of energy storage in the proposed HPS.

The Dutch Obesity Intervention in Teenagers (DOiT) cluster controlled implementation trial: intervention effects and mediators and moderators of adiposity and energy balance-related behaviours

 Background: The Dutch Obesity Intervention in Teenagers (DOiT) programme is an evidence-based obesity prevention programme tailored to adolescents attending the first two years of prevocational education in the Netherlands. The initial programme showed promising results during an effectiveness trial. The programme was adapted and prepared for nationwide dissemination. To gain more insight into the process of translating evidence-based approaches into ‘real world’ (i.e., ‘natural’) conditions, our research aims were to evaluate the impact of the DOiT-implementation programme on adolescents’ adiposity and energy balance-related behaviours during natural dissemination and to explore the mediating and moderating factors underlying the DOiT intervention effects.
Methods: We conducted a cluster-controlled implementation trial with 20 voluntary intervention schools (n=1002 adolescents) and 9 comparable control schools (n = 484 adolescents). We measured adolescents’ body height and weight, skinfold thicknesses, and waist circumference. We assessed adolescents’ dietary and physical activity behaviours by means of self-report. Data were collected at baseline and at 20-months follow-up. We used multivariable multilevel linear or logistic regression analyses to evaluate the intervention effects and to test the hypothesised behavioural mediating factors. We checked for potential effect modification by gender, ethnicity and education level.
Results: We found no significant intervention effects on any of the adiposity measures or behavioural outcomes. Furthermore, we found no mediating effects by any of the hypothesised behavioural mediators. Stratified analyses for gender showed that the intervention was effective in reducing sugar-containing beverage consumption in girls (B = -188.2 ml/day; 95% CI = -344.0; -32.3). In boys, we found a significant positive intervention effect on breakfast frequency (B = 0.29 days/week; 95% CI = 0.01; 0.58). Stratified analyses for education level showed an adverse intervention effect (B = 0.09; 95% CI = 0.02; 0.16) on BMI z-scores for adolescents attending the vocational education track.
Conclusions: Although not successful in changing adolescents’ adiposity, the DOiT-implementation programme had some beneficial effects on specific obesity-related behaviours in subgroups. This study underlines the difficulty of translating intervention effectiveness in controlled settings to real world contexts. Adaptations to the implementation strategy are needed in order to promote implementation as intended by the teachers.

Problems in seawater industrial desalination processes and potential sustainable solutions: a review

Seawater desalination has significantly developed towards membrane technology than phase change process during last decade. Seawater reverse osmosis (SWRO) in general is the most familiar process due to higher water recovery and lower energy consumption compared to other available desalination processes. Despite major advancements in SWRO technology, desalination industry is still facing significant amount of practical issues. Therefore, the potentials and problems faced by current SWRO industries and essential study areas are discussed in this review for the benefit of desalination industry. It is important to consider all the following five components in SWRO process i.e. (1) intake (2) pre-treatment (3) high pressure pumping (4) membrane separation (performance of membranes and brine disposal) and (5) product quality. Development of higher corrosion resistant piping materials or coating materials, valves, and pumps is believed to be in higher research demand. Furthermore, brine management, that includes brine disposal and resource recovery need further attention. Pre-treatment sludge management and reduced cleaning in place flush volume will reduce the capital costs associated with evaporation ponds and the maintenance costs associated with disposal and transportation reducing the unit cost of water. © 2013 Springer Science+Business Media Dordrecht.

Towards a BIM-based energy rating system

Governments in Australia are faced with policy implementation that mandates higher energy efficient housing (Foran, Lenzen & Dey 2005). To this effect, the National Construction Code (NCC) 2013 stipulates the minimum energy performance for residential buildings as 114MJ/m2 per annum or 6 stars on an energy rating scale. Compliance with this minimum is mandatory but there are several methods through which residential buildings can be rated to comply with the deemed to satisfy provisions outlined in the NCC. FirstRate5 is by far the most commonly used simulation software used in Victoria, Australia. Meanwhile, Building Information Modelling (BIM), using software such as ArchiCAD has gained a foothold in the industry. The energy simulation software within ArchiCAD, EcoDesigner, enables the reporting on the energy performance based on BIM elements that contain thermal information. This research is founded on a comparative study between FirstRate5 and EcoDesigner. Three building types were analysed and compared. The comparison finds significant differences between simulations, being, measured areas, thermal loads and potentially serious shortcomings within FirstRate5, that are discussed along with the future potential of a fully BIM-integrated model for energy rating certification in Victoria. © 2014, The Association for Computer-Aided Architectural Design Research in Asia (CAADRIA), Hong Kong.

'High' risk? A systematic review of the acute outcomes of mixing alcohol with energy drinks

Alcohol mixed with energy drinks (AmED) is a relatively new consumption trend generating increasing concern regarding potential adverse effects. Despite the political and health imperative, there has been no systematic and independent synthesis of the literature to determine whether or not AmED offers additional harms relative to alcohol. The aim of this study was to review the evidence about whether co-consumption of energy drinks and alcohol, relative to alcohol alone, alters: (i) physiological, psychological, cognitive and psychomotor outcomes; (ii) hazardous drinking practices; and (iii) risk-taking behaviour.

Flight altitude of trans-Sahara migrants in autumn: a comparison of radar observations with predictions from meteorological conditions and water and energy balance models

Radar observations on the altitude of bird migration and altitudinal profiles of meteorological conditions over the Sahara desert are presented for the autumn migratory period. Migratory birds fly at an average altitude of 1016 m (a.s.l.) during the day and 571 m during the night. Weather data served to calculate flight range using two models: an energy model (EM) and an energy-and-water model (EWM). The EM assumes that fuel supply limits flight range whereas the EWM assumes that both fuel and water may limit flight range. Flight ranges estimated with the EM were generally longer than those with the EWM. This indicates that trans-Sahara migrants might have more problems balancing their water than their energy budget. However, if we assume fuel stores to consist of 70% instead of 100% fat (the remainder consisting of 9% protein and 21% water), predicted flight ranges of the EM and EWM largely overlap. Increased oxygen extraction, reduced flight costs, reduced exhaled air temperature, reduced cutaneous water loss and increased tolerance to water loss are potential physiological adaptations that would improve the water budget in migrants. Both the EM and EWM predict optimal flight altitudes in agreement with radar observations in autumn. Optimal flight altitudes are differently predicted by the EM and EWM for nocturnal spring migration. During spring, the EWM predicts moderately higher and the EM substantially higher flight altitudes than during autumn. EWM predictions are therefore in better agreement with radar observations on flight altitude of migrants over the Negev desert in spring than EM predictions.