Control of porosity and pore size of metal reinforced carbon nanotube membranes

Membranes are crucial in modern industry and both new technologies and materials need to be designed to achieve higher selectivity and performance. Exotic materials such as nanoparticles offer promising perspectives, and combining both their very high specific surface area and the possibility to incorporate them into macrostructures have already shown to substantially increase the membrane performance. In this paper we report on the fabrication and engineering of metal-reinforced carbon nanotube (CNT) Bucky-Paper (BP) composites with tuneable porosity and surface pore size. A BP is an entangled mesh non-woven like structure of nanotubes. Pure CNT BPs present both very high porosity (>90%) and specific surface area (>400 m2/g). Furthermore, their pore size is generally between 20–50 nm making them promising candidates for various membrane and separation applications. Both electro-plating and electroless plating techniques were used to plate different series of BPs and offered various degrees of success. Here we will report mainly on electroless plated gold/CNT composites. The benefit of this method resides in the versatility of the plating and the opportunity to tune both average pore size and porosity of the structure with a high degree of reproducibility. The CNT BPs were first oxidized by short UV/O3 treatment, followed by successive immersion in different plating solutions. The morphology and properties of these samples has been investigated and their performance in air permeation and gas adsorption will be reported.

Influence of non-hydrolysable groups in silane precursor on pore dimension and photochromic properties of sol-gel silica embedded with a spirooxazine dye

In this work, silica embedded with a spirooxazine dye was prepared by hydrolysis of silanes that bear a nonhydrolyzable group of different structures through a sol-gel route in the presence of a spirooxazine dye, and the pore dimension and photochromic properties of photochromic silica coatings on fabric were studied. The pore dimension in the silica was examined by small angle X-ray scattering (SAXS), transmission electron microscopy (TEM), and nitrogen adsorption porosimetry. The SAXS results revealed that the distance between pores was in the range between 0.8 nm and 1.9 nm and it increased with increasing the size of the non-hydrolyzable group. Pore size measured by nitrogen adsorption porosimetry was in the range of 2.1-2.7 nm. The photochromic optical absorption was influenced mainly by the hydrophobicity of the non-hydrolyzable groups, while the color changing rates were influenced by the steric effect of the non-hydrolyzable groups and their interaction with the dye.

Pore pressure effect on slope stability assessment

Slope stability assessment has been an integral problem for geotechnical engineering all these years. While stability of slopes is affected by various factors, pore pressure is one of the common naturalelements that influence slope stability analysis. This paper studies the effect of pore pressure on slope stability assessment by using Limit Equilibrium Method (LEM). The results will be compared to the solutions of Hoek and Bray charts. In this study, slopes with different levels of water table corresponding to those of Hoek and Bray charts are investigated. It’s interesting to observe that the results obtained from the Hoek and Bray charts yielded different factor of safety compare to those in the study here-in. In fact, the different between the factors of safety could be up to 30%. Hence this issue should be taken into consideration during slope design.