Synthesis of high surface area amorphous tin-zinc oxides by a sol-gel method

A new method to synthesize conducting oxide nanoparticles with low photocatalytic activity was investigated. Initially, the preparation of amorphous ZnO-SnO2 solid solution nanoparticles was studied using a sol-gel technique. It was found that X-ray amorphous nanopowders with low photocatalytic activity were produced when the precipitates were heat treated below 500 °C. However, FT-IR data showed that the sample may not be an oxide semiconductor. A mixture of ZnO and SnO2 crystalline nanoparticles was also produced at 800 °C and found to have much reduced photoactivity than commercial ZnO nanoparticles having a similar specific surface area.

Characterization and evaluation of BaCo0.7Fe0.2Nb0.1O3−δ as a cathode for proton-conducting solid oxide fuel cells

This study characterizes BaCo0.7Fe0.2Nb0.1O3−δ (BCFN) perovskite oxide and evaluates it as a potential cathode material for proton-conducting SOFCs with a BaZr0.1Ce0.7Y0.2O3-δ (BZCY) electrolyte. A four-probe DC conductivity measurement demonstrated that BCFN has a modest electrical conductivity of 2–15 S cm−1 in air with p-type semiconducting behavior. An electrical conductivity relaxation test showed that BCFN has higher Dchem and Kchem than the well-known Ba0.5Sr0.5Co0.8Fe0.2O3−δ oxide. In addition, it has relatively low thermal expansion coefficients (TECs) with values of 18.2 × 10−6 K−1 and 14.4 × 10−6 K−1 at temperature ranges of 30–900 °C and 30–500 °C, respectively. The phase reaction between BCFN and BZCY was investigated using powder and pellet reactions. EDX and XRD characterizations demonstrated that BCFN had lower reactivity with the BZCY electrolyte than strontium-containing perovskite oxides such as SrCo0.9Nb0.1O3-δ and Ba0.6Sr0.4Co0.9Nb0.1O3−δ. The impedance of BCFN was oxygen partial pressure dependent. Introducing water into the cathode atmosphere reduced the size of both the high-frequency and low-frequency arcs of the impedance spectra due to facilitated proton hopping. The cathode polarization resistance and overpotential at a current density of 100 mA cm−2 were 0.85 Ω cm−2 and 110 mV in dry air, which decreased to 0.43 Ω cm−2 and 52 mV, respectively, in wet air (∼3% H2O) at 650 °C. A decrease in impedance was also observed with polarization time; this was possibly caused by polarization-induced microstructure optimization. A promising peak power density of ∼585 mW cm−2 was demonstrated by an anode-supported cell with a BCFN cathode at 700 °C.

Aging studies on conducting polypyrrole

Change of tensile properties, electrical conductivity and microwave shielding of electrochemically synthesized polypyrrole films with time are presented. Highly doped films had good electrical stability, retaining high microwave reflectivity throughout the aging period. Lightly doped films were less stable and partially reflective and absorptive of microwaves. FT-IR spectral observations revealed a progressive increase in intensity of an unsaturated conjugated carbonyl peak, which was not observed in the highly doped films, suggesting that the concentration of the dopant had an influence on the mechanism of degradation of conductivity.

GENESIS: an efficient, transparent and easy to use cluster operating system

Present operating systems are not built to support parallel computing––they do not provide services to manage parallelism, i.e., to globally manage parallel processes and computational resources. The cluster operating environments that are used to assist the execution of parallel applications do not provide support for both programming paradigms, message passing (MP) or distributed shared memory (DSM)––they are mainly offered as separate components implemented at the user level as library and independent server processes. Due to poor operating systems users must deal with clusters as a set of independent computers rather than to see this cluster as a single powerful computer. A single system image (SSI) of the cluster is not offered to users. There is a need for an operating system for clusters. We claim and demonstrate in this paper that it is possible to develop a cluster operating system that is able to efficiently manage parallelism; use cluster resources efficiently; support MP in the form of standard MP and PVM, and DSM; offer SSI; and make it easy to use. We show that to achieve these aims this operating system should inherit many features of a distributed operating system and provide new services which address the needs of parallel processes, cluster's resources, and application developers. In order to substantiate the claim the first version of a cluster operating system managing parallelism and offering SSI, called GENESIS, has been developed.

New insights into the structures of diorganotellurium Oxides. The first polymeric diorganotelluroxane[(p-MeOC6H4)2TEO]n

The characterization of the previously reported diorganotellurium oxides R₂TeO (R = Ph (1) and p-MeOC₆H₄ (2)) was revisited by osmometric molecular weight determinations, ¹²⁵Te NMR spectroscopy, and electrospray spectrometry (ESMS) in solution and by 125Te MAS NMR spectroscopy in the solid state. The single-crystal X-ray structure of 2 revealed a polymeric arrangement that features a zigzag configured Te-O backbone without any secondary Te···O interactions. In solution 1 and 2 exist predominantly as monomers but appear to be in equilibrium with higher oligomers to a minor extent.

Characterization of conducting polymer coated synthetic fabrics for heat generation

Heat generation in fabrics coated with the conductive polymer polypyrrole was investigated. The PET fabrics were coated by chemical synthesis using four different oxidizing agent–dopant combinations. The samples from the four different dopant systems all show an increase in temperature when a fixed voltage is applied to the fabric. The antraquinone-2-sulfonic acid (AQSA) sodium salt doped polypyrrole coating was the most effective in heat generation whereas the sodium perchlorate dopant system was the least effective. The power density per unit area achieved in polypyrrole coated polyester–Lycra® fabric with 0.027 mol/l of AQSA acting as dopant was 430 W/m². The power density per unit area achieved for the sodium perchlorate system, using the same synthesis conditions, was 55 W/m².

Generating heat from conducting polypyrrole-coated PET fabrics

Heating effects in polypyrrole-coated polyethyleneterephthalate (PET)-Lycra® fabrics were studied. Chemical synthesis was employed to coat the PET fabrics by polypyrrole using ferric chloride as oxidant and antraquinone- 2-sulfonic acid (AQSA) and naphthalene sulfonic acid (NSA) as dopants. The coated fabrics exhibited reasonable electrical stability, possessed high electrical conductivity, and were effective in heat generation. Surface resistance of polypyrrole-coated fabrics ranged from approximately 150 to 500 /square. Different connections between conductive fabrics and the power source were examined. When subjected to a constant voltage of 24 V, the current transmitted through the fabric decreased about 10% in 72 h. An increase in resistance of conductive fabrics subjected to constant voltage was observed

Development of a cooling fabric from conducting polymer coated fibres: proof of concept

It is supposed that there should be a thermal electric effect if a dc current is applied across two dissimilar conducting polymers, similar to so called “Peltier effect” in metals or semiconductors. However, this hypothesis has not been tested on conducting polymers and using these materials to make cooling fabrics has never been attempted before. Polypyrrole coated fabrics were used to test the hypothesis in this preliminary study. Seebeck and the Peltier effects were proven to exist. However, thermoelectricity effect between two conducting polymer coated fabric samples was only about 10 μV/°C. Cooling effect by conductive polymer powder was achieved but performance was unsteady due to electrical degradation of the conducting polymer. Nevertheless, the concept was demonstrated and the development of a cooling fabric is possible.

Frictional and tensile properties of conducting polymer coated wool and alpaca fibers

Wool and alpaca fibers were coated with polypyrrole by vapor-phase polymerisation method. The changes in frictional and tensile properties of the single fibers upon coating with the conductive polymer are presented. Coating a thin layer of polypyrrole on the alpaca and wool fibers results in a significant reduction in the fiber coefficient of friction, as the conducting polymer layer smooths the protruding edges of the fiber scales. It also reduces the directional friction effect of the fibers. Depending on the type of fiber, the coating may slightly enhance the tensile properties of the coated fibers.

It's in your hands : the value of handsearching in conducting systematic reviews of public health interventions

Background While there is an emerging evidence base in public health, the evidence can often be difficult to find. Indexing of journals in MEDLINE has assisted those conducting systematic reviews to more easily identify published studies. However, information technology and the processes associated with indexing are not infallible. Studies may not be correctly marked by study design which may mean they are missed in the electronic searching process. Handsearching for evidence of intervention effectiveness has therefore become a recognized tool in the systematic review process.

Methods Resources to guide handsearching activity currently are clinically focused, and may not be sensitive to the characteristics of public health studies where study terminology may differ. In response to this issue, the Cochrane Health Promotion and Public Health Field (the Field) developed and implemented a small study to recruit and support handsearchers from around the world to identify health promotion and public health trials and systematic reviews. A strategic framework was developed to recruit and support handsearchers to search six public health-related journals.

Results In total, 131 trials and 21 systematic reviews were identified. The greatest value of handsearching was found to be in supplement editions and abstract sections of journals

Conclusions The study focused exclusively on indexed journals with the intention that tools and methods developed could be used to explore the potential for handsearching in non-indexed journals and for unpublished studies. The findings from this study will continue to support handsearching efforts and in doing so contribute to high quality systematic reviews of public health interventions.

Synthesis and structure of bis(para-methoxyphenyl)selenoxide and its monohydrate. theoretical considerations of the hydration of diorganoselenium oxides

The title compound was prepared by base hydrolysis of (p-MeOC₆H₄)₂SeCl₂ in water and isolated as the crystalline monohydrate, (p-MeOC₆H₄)₂SeO·H₂O, in which the water molecule is associated via hydrogen-bonding. Water-free (p-MeOC₆H₄)₂SeO was obtained crystalline after drying and recrystallisation from toluene. Both crystal phases were investigated by single crystal X-ray diffraction. Preliminary DFT calculations at the B3LYP/LANL2DZdp level of theory suggest that the hydrogen bonded complexes R₂SeO·H₂O (R = H, Me, Ph) are by 2.79, 3.36 and 11.10 kcal mol^-1 more stable than the corresponding elusive diorganoselenium dihydroxides R₂Se(OH)₂. The hydrogen bond energies of R₂SeO·H₂O (R = H, Me, Ph) are 5.98, 7.18 and 5.89 kcal mol^-1.

Understanding ring strain and ring flexibility in six - and eight-membered cyclic organometallic group 14 oxides

A simple model was developed for the approximation of ring strain energies of homo- and heterometallic, six- and eight-membered cyclic organometallic group 14 oxides and the degree of puckering of their ring conformations. The conformational energy of a ring is modelled as the sum of its angular strain components. The bending potential energy functions for the various endocyclic M–O–M′ and O–M–O linkages (M, M′=Si, Ge, Sn) were calculated at the B3LYP/(v)TZ level of theory using H3MOM′H3 and H2M(OH)2 as model compounds. For the six-membered rings, the minimum total angular contribution to ring strain, ERSGmin was calculated to decrease in the order: cyclo-(H2SiO)3 (13.0 kJ mol−1)>cyclo-H2Sn(OSiH2)2O (7.0 kJ mol−1)>cyclo-H2Ge(OSiH2)2O (4.9 kJ mol−1)>cyclo-H2Si(OSnH2)2O (3.4 kJ mol−1)>cyclo-(H2SnO)3 (1.7 kJ mol−1)>cyclo-H2Si(OGeH2)2O (0.8 kJ mol−1)≈cyclo-H2Ge(OSnH2)2O (0.7 kJ mol−1)>cyclo-H2Sn(OGeH2)2O (0.1 kJ mol−1)≈cyclo-(H2GeO)3 (0 kJ mol−1). All of the six-membered rings were predicted to adopt (nearly) planar conformations (a=0.996<a<1). By contrast, all eight-membered rings were predicted to adopt strainless, but puckered conformations. The degree of puckering was predicted to increase in the order: cyclo-(H2SiO)4 (a=0.983)<cyclo-H2Sn(OSiH2O)2SiH2 (a=0.959)<cyclo-(H2SiO)2(H2SnO)2 (a=0.942)< cyclo-H2Si(OSnH2O)2SiH2 (a=0.935)<cyclo-(H2SnO)4 (a=0.916)<cyclo-(H2GeO)4 (a=0.885). The differences in ring strain and the degree of puckering were linked to the different electronegativities of Si, Ge and Sn. The results obtained are consistent with experimental ring strain energies; reactivities towards ring opening polymerizations or ring expansion reactions and observed ring conformations of cyclic organometallic group 14 oxides.

Reflections of a research inside conducting qualitative research in sign language

Deaf people who use sign language are potential users of emerging telecommunications innovations such as videotelephony There has been little research that explores their thoughts and experiences in the use of this technology. In this paper, the experiences of a Deaf person as a research insider in a current telecommunications study are described and issues of researcher-participant relationship, data integrity, interview and interpreter skills, communication and cultural aspects of the participating community and the impact of this type of research are explored.