Energy Efficiency through Thermal Energy Storage : Possibilities for the Swedish Building Stock

The need for heating and cooling in buildings constitutes a considerable part of the total energy use in a country and reducing this need is of outmost importance in order to reach national and international goals for reducing energy use and emissions. One important way of reaching these goals is to increase the proportion of renewable energy used for heating and cooling of buildings. Perhaps the largest obstacle with this is the often occurring mismatch between the availability of renewable energy and the need for heating or cooling, hindering this energy to be used directly. This is one of the problems that can be solved by using thermal energy storage (TES) in order to save the heat or cold from when it is available to when it is needed. This thesis is focusing on the combination of TES techniques and buildings to achieve increased energy efficiency for heating and cooling. Various techniques used for TES as well as the combination of TES in buildings have been investigated and summarized through an extensive literature review. A survey of the Swedish building stock was also performed in order to define building types common in Sweden. Within the scope of this thesis, the survey resulted in the selection of three building types, two single family houses and one office building, out of which the two residential buildings were used in a simulation case study of passive TES with increased thermal mass (both sensible and latent). The second case study presented in the thesis is an evaluation of an existing seasonal borehole storage of solar heat for a residential community. In this case, real measurement data was used in the evaluation and in comparisons with earlier evaluations. The literature reviews showed that using TES opens up potential for reduced energy demand and reduced peak heating and cooling loads as well as possibilities for an increased share of renewable energy to cover the energy demand. By using passive storage through increased thermal mass of a building it is also possible to reduce variations in the indoor temperature and especially reduce excess temperatures during warm periods, which could result in avoiding active cooling in a building that would otherwise need it. The analysis of the combination of TES and building types confirmed that TES has a significant potential for increased energy efficiency in buildings but also highlighted the fact that there is still much research required before some of the technologies can become commercially available. In the simulation case study it was concluded that only a small reduction in heating demand is possible with increased thermal mass, but that the time with indoor temperatures above 24 °C can be reduced by up to 20%. The case study of the borehole storage system showed that although the storage system worked as planned, heat losses in the rest of the system as well as some problems with the system operation resulted in a lower solar fraction than projected. The work presented within this thesis has shown that TES is already used successfully for many building applications (e.g. domestic hot water stores and water tanks for storing solar heat) but that there still is much potential in further use of TES. There are, however, barriers such as a need for more research for some storage technologies as well as storage materials, especially phase change material storage and thermochemical storage.

Power Management Controls

In an office building in the US the office equipment uses about 7% of the total electricity use. Eventhough this is a low number, there is still a reason to save more energy, especially since one third of theenergy savings are lost when power management is not enabled.The core in the project ”Power Management Controls” is to develop a voluntary standard, The UserInterface Standard, that manufacturers of office equipment can use as a reference when they developnew equipment and design new interfaces. The interface is an important part of the use of powermanagement and doing this should increase the use of power management and save more energy. Theinterfaces are ofter hidden or inconsistent and confusing, which makes it harder for the user tounderstand power management. A more consistent interface makes it easier for the user to understandthe meaning of an interface and power management itselfThe standard consists of six different parts, which describe what can be done to achieve a consistentinterface. The standard also describes the part of the project called Dynamic Behavior. This part isconcentrating on the interfaces and the behavior of the device over time, which is important for the userto understand.The purpose of this degree project is to study and participate in the project ”Power ManagementControls”, and to understand what is being done to save more energy.

System Integration of PV/T Collectors in Solar Cooling Systems

The demand for cooling and air-conditioning of building is increasingly ever growing. This increase is mostly due to population and economic growth in developing countries, and also desire for a higher quality of thermal comfort. Increase in the use of conventional cooling systems results in larger carbon footprint and more greenhouse gases considering their higher electricity consumption, and it occasionally creates peaks in electricity demand from power supply grid. Solar energy as a renewable energy source is an alternative to drive the cooling machines since the cooling load is generally high when solar radiation is high. This thesis examines the performance of PV/T solar collector manufactured by Solarus company in a solar cooling system for an office building in Dubai, New Delhi, Los Angeles and Cape Town. The study is carried out by analyzing climate data and the requirements for thermal comfort in office buildings. Cooling systems strongly depend on weather conditions and local climate. Cooling load of buildings depend on many parameters such as ambient temperature, indoor comfort temperature, solar gain to the building and internal gains including; number of occupant and electrical devices. The simulations were carried out by selecting a suitable thermally driven chiller and modeling it with PV/T solar collector in Polysun software. Fractional primary energy saving and solar fraction were introduced as key figures of the project to evaluate the performance of cooling system. Several parametric studies and simulations were determined according to PV/T aperture area and hot water storage tank volume. The fractional primary energy saving analysis revealed that thermally driven chillers, particularly adsorption chillers are not suitable to be utilizing in small size of solar cooling systems in hot and tropic climates such as Dubai and New Delhi. Adsorption chillers require more thermal energy to meet the cooling load in hot and dry climates. The adsorption chillers operate in their full capacity and in higher coefficient of performance when they run in a moderate climate since they can properly reject the exhaust heat. The simulation results also indicated that PV/T solar collector have higher efficiency in warmer climates, however it requires a larger size of PV/T collectors to supply the thermally driven chillers for providing cooling in hot climates. Therefore using an electrical chiller as backup gives much better results in terms of primary energy savings, since PV/T electrical production also can be used for backup electrical chiller in a net metering mechanism.

Immigration, security and the public debate on US language policy : a critical discourse analysis of language attitudes in the United States of America

The narrative of the United States is of a "nation of immigrants" in which the language shift patterns of earlier ethnolinguistic groups have tended towards linguistic assimilation through English. In recent years, however, changes in the demographic landscape and language maintenance by non-English speaking immigrants, particularly Hispanics, have been perceived as threats and have led to calls for an official English language policy.This thesis aims to contribute to the study of language policy making from a societal security perspective as expressed in attitudes regarding language and identity originating in the daily interaction between language groups. The focus is on the role of language and American identity in relation to immigration. The study takes an interdisciplinary approach combining language policy studies, security theory, and critical discourse analysis. The material consists of articles collected from four newspapers, namely USA Today, The New York Times, Los Angeles Times, and San Francisco Chronicle between April 2006 and December 2007.Two discourse types are evident from the analysis namely Loyalty and Efficiency. The former is mainly marked by concerns of national identity and contains speech acts of security related to language shift, choice and English for unity. Immigrants are represented as dehumanised, and harmful. Immigration is given as sovereignty-related, racial, and as war. The discourse type of Efficiency is mainly instrumental and contains speech acts of security related to cost, provision of services, health and safety, and social mobility. Immigrants are further represented as a labour resource. These discourse types reflect how the construction of the linguistic 'we' is expected to be maintained. Loyalty is triggered by arguments that the collective identity is threatened and is itself used in reproducing the collective 'we' through hegemonic expressions of monolingualism in the public space and semi-public space. The denigration of immigrants is used as a tool for enhancing societal security through solidarity and as a possible justification for the denial of minority rights. Also, although language acquisition patterns still follow the historical trend of language shift, factors indicating cultural separateness such as the appearance of speech communities or the use of minority languages in the public space and semi-public space have led to manifestations of intolerance. Examples of discrimination and prejudice towards minority groups indicate that the perception of worth of a shared language differs from the actual worth of dominant language acquisition for integration purposes. The study further indicates that the efficient working of the free market by using minority languages to sell services or buy labour is perceived as conflicting with nation-building notions since it may create separately functioning sub-communities with a new cultural capital recognised as legitimate competence. The discourse types mainly represent securitising moves constructing existential threats. The perception of threat and ideas of national belonging are primarily based on a zero-sum notion favouring monolingualism. Further, the identity of the immigrant individual is seen as dynamic and adaptable to assimilationist measures whereas the identity of the state and its members are perceived as static. Also, the study shows that debates concerning language status are linked to extra-linguistic matters. To conclude, policy makers in the US need to consider the relationship between four factors, namely societal security based on collective identity, individual/human security, human rights, and a changing linguistic demography, for proposed language intervention measures to be successful.