Performance Evaluation of Different PV-Array Configurations under Weak Light Conditions and Partial Shadings

The paper analyses empirical performance data of five commercial PV-plants in Germany. The purpose was on one side to investigate the weak light performance of the different PV-modules used. On the other hand it was to quantify and compare the shading losses of different PV-array configurations. The importance of this study relies on the fact that even if the behavior under weak light conditions or the shading losses might seem to be a relatively small percentage of the total yearly output; in projects where a performance guarantee is given, these variation can make the difference between meeting or not the conditions.When analyzing the data, a high dispersion was found. To reduce the optical losses and spectral effects, a series of data filters were applied based on the angle of incidence and absolute Air Mass. To compensate for the temperature effects and translate the values to STC (25°C), five different methods were assessed. At the end, the Procedure 2 of IEC 60891 was selected due to its relative simplicity, usage of mostly standard parameters found in datasheets, good accuracy even with missing values, and its potential to improve the results when the complete set of inputs is available.After analyzing the data, the weak light performance of the modules did not show a clear superiority of a certain technology or technology group over the others. Moreover, the uncertainties in the measurements restrictive the conclusiveness of the results.In the partial shading analysis, the landscape mounting of mc-Si PV-modules in free-field showed a significantly better performance than the portrait one. The cross-table string using CIGS modules did not proved the benefits expected and performed actually poorer than a regular one-string-per-table layout. Parallel substrings with CdTe showed a proper functioning and relatively low losses. Among the two product generations of CdTe analyzed, none showed a significantly better performance under partial shadings.

COMPARISON OF PARTIAL SHADING LOSSES IN FREE FIELD PV-PLANTS WITH DIFFERENT ARRAY CONFIGURATIONS

A common problem when planning large free field PV-plants is optimizing the ground occupation ratio while maintaining low shading losses. Due to the complexity of this task, several PV-plants have been built using various configurations. In order to compare the shading losses of different PV technologies and array designs, empirical performance data of five free field PV-plants operating in Germany was analyzed. The data collected comprised 140 winter days from October 2011 until March 2012. The relative shading losses were estimated by comparing the energy output of selected arrays in the front rows (shading-free) against that of shaded arrays in the back rows of the same plant. The results showed that landscape mounting with mc-Si PV-modules yielded significantly better results than portrait one. With CIGS modules, making cross-table strings using the lower modules was not beneficial as expected and had more losses than a one-string-per-table layout. Parallel substrings with CdTe showed relatively low losses. Among the two CdTe products analyzed, none showed a significantly better performance.

A framework for ICT-based knowledge sharing in sustainable rural development : the case of Gilgit-Baltistan, Pakistan

Some 50% of the people in the world live in rural areas, often under harsh conditions and in poverty. The need for knowledge of how to improve living conditions is well documented. In response to this need, new knowledge of how to improve living conditions in rural areas and elsewhere is continuously being developed by researchers and practitioners around the world. People in rural areas, in particular, would certainly benefit from being able to share relevant knowledge with each other, as well as with stakeholders (e.g. researchers) and other organizations (e.g. NGOs). Central to knowledge management is the idea of knowledge sharing. This study is based on the assumption that knowledge management can support sustainable development in rural and remote regions. It aims to present a framework for knowledge management in sustainable rural development, and an inventory of existing frameworks for that. The study is interpretive, with interviews as the primary source for the inventory of stakeholders, knowledge categories and Information and Communications Technology (ICT) infrastructure. For the inventory of frameworks, a literature study was carried out. The result is a categorization of the stakeholders who act as producers and beneficiaries of explicit and indigenous development knowledge. Stakeholders are local government, local population, academia, NGOs, civil society and donor agencies. Furthermore, the study presents a categorization of the development knowledge produced by the stakeholders together with specifications for the existing ICT infrastructure. Rural development categories found are research, funding, agriculture, ICT, gender, institutional development, local infrastructure development, and marketing & enterprise. Finally, a compiled framework is presented, and it is based on ten existing frameworks for rural development that were found in the literature study, and the empirical findings of the Gilgit-Baltistan case. Our proposed framework is divided in four levels where level one consists of the identified stakeholders, level two consists of rural development categories, level three of the knowledge management system and level four of sustainable rural development based on the levels below. In the proposed framework we claim that the sustainability of rural development can be achieved through a knowledge society in which knowledge of the rural development process is shared among all relevant stakeholders.

Student Thesis Level: Master’s Thesis in Business Administration Corporate Social Responsibility (CSR) networking : A case study on why members join CSR network and why are they sharing their knowledge

Purpose – This research focuses on finding the reasons, why members from different sectors join a cross-sector/multi-stakeholder CSR network and what motivates them to share (or not to share) their knowledge of CSR and their best practices. Design/methodology/approach – Semi-structured interviews were conducted with members of the largest cross-sector CSR network in Sweden. The sample base of 15 people was chosen to be able to represent a wider variety of members from each participating sectors. As well as the CEO of the intermediary organization was interviewed. The interviews were conducted via email and telephone. Findings – The findings include several reasons linked to the business case of CSR such as stakeholder pressure, competitive advantage, legitimacy and reputation as well as new reasons like the importance of CSR, and the access of further knowledge in the field. Further reasons are in line with members wanting to join a network, such as access to contact or having personal contacts. As to why members are sharing their CSR knowledge, the findings indicate to inspire others, to show CSR commitment, to be visible, it leads to business opportunity and the access of others knowledge, and because it was requested. Reasons for not sharing their knowledge would be the lack of opportunity, lack of time and the lack of experience to do so. Originality/value – The research contributes to existing studies, which focused on Corporate Social Responsibility and cross-sector networking as well as to inter-organizational knowledge sharing in the field of CSR.

Barriers and facilitators in the provision of post-abortion care at district level in central Uganda : a qualitative study focusing on task sharing between physicians and midwives

Background: Abortion is restricted in Uganda, and poor access to contraceptive methods result in unwanted pregnancies. This leaves women no other choice than unsafe abortion, thus placing a great burden on the Ugandan health system and making unsafe abortion one of the major contributors to maternal mortality and morbidity in Uganda. The existing sexual and reproductive health policy in Uganda supports the sharing of tasks in post-abortion care. This task sharing is taking place as a pragmatic response to the increased workload. This study aims to explore physicians' and midwives' perception of post-abortion care with regard to professional competences, methods, contraceptive counselling and task shifting/sharing in post-abortion care. Methods: In-depth interviews (n = 27) with health care providers of post-abortion care were conducted in seven health facilities in the Central Region of Uganda. The data were organized using thematic analysis with an inductive approach. Results: Post-abortion care was perceived as necessary, albeit controversial and sometimes difficult to provide. Together with poor conditions post-abortion care provoked frustration especially among midwives. Task sharing was generally taking place and midwives were identified as the main providers, although they would rarely have the proper training in post-abortion care. Additionally, midwives were sometimes forced to provide services outside their defined task area, due to the absence of doctors. Different uterine evacuation skills were recognized although few providers knew of misoprostol as a method for post-abortion care. An overall need for further training in post-abortion care was identified. Conclusions: Task sharing is taking place, but providers lack the relevant skills for the provision of quality care. For post-abortion care to improve, task sharing needs to be scaled up and in-service training for both doctors and midwives needs to be provided. Post-abortion care should further be included in the educational curricula of nurses and midwives. Scaled-up task sharing in post-abortion care, along with misoprostol use for uterine evacuation would provide a systematic approach to improving the quality of care and accessibility of services, with the aim of reducing abortion-related mortality and morbidity in Uganda.