Influence of hardwood, softwoodand fractionated pulp in a stratifiedthree-layered fine paper : Lövved, barrved och fraktionerad massa ochdess inverkan på ett treskiktat finpapper

Four different trials of stratified three-layered fine paper, of sulphate pulp, were performed to investigate if stratified fine fraction or fibres from birch can improve the properties of a paper compared to a reference sheet. All trials had five different scenarios and each scenario was calendered with different linear load. All sheets had a grammage of 80 g/m2.In the first trial, the paper contained birch, pine and filler of calciumcarbonate (marble), and was manufactured with the pilot paper machine XPM and the stratified headbox Formator at RCF (Stora Enso Research Center in Falun). The furnish consisted of 75% birch and 25% pine.The second trial contained coated sheets with paper from trial one as the base paper. The coating slip contained calciumcarbonate and clay and the amount was approximately 10-12 g/m2.The third trial, also with birch and pine but without filler, was performed at STFI (Skogsindustrins Tekniska Forskningsinstitut in Stockholm) with the laboratory scaled paper machine StratEx and the stratified headbox AQ-vanes. The furnish consisted of 75% birch and 25% pine, except for one scenario which contained of 75% pine and 25% birch.The last trial contained fractionated pulp of birch and pine and was performed at STFI. 50% was fine fraction and 50% was coarse fraction.This test does not show any clear benefits of making stratified sheets of birch and pine when it comes to properties such as bending stiffness, tensile index and surface smoothness. The retention can be improved with birch in the surface plies. It is possible that the formation can be improved with birch in the surface plies and pine in the middle ply. It is also possible that fine fraction in the surface plies and coarse fraction in the middle ply can improve both surface smoothness and bending stiffness. The results in this test are shown with confidence intervals which points out the difficulties of analysing sheets manufactured with a pilot paper machine or a laboratory scaled paper machine.

Björk på åkermark : - beståndsetablering eller betesbeskogning

I ett bestånd med björk, planterad 1990 på nedlagd åkermark i 3x1 m förband har en jämförande studie gjorts. Halva arealen har traditionell skogsproduktion, vilken jämförts med en del med skötsel för kombinerad betesdrift och skogsproduktion. I arbetet redovisas utnyttjad metodik vid anläggning, markbehandling, ogräsbekämpning, stängsling och djurhållning, röjning och gallring, nuvarande och beräknad total produktion, grenrensning samt skador. Tre viktiga regler som har bidragit till den lyckosamma etableringen vid beskogningen av denna betesmark är kontinuerlig ogräsbekämpning, tidig och kraftfull röjning/gallring samt stängsling.In a birch stand established in 1990 on former agricultural land in a 3x1 m spacing a comparative study was made. Half the accerage has ad a traditional silviculture while the other half has been managed aiming at future grace land combined with wood production. In this paper we describe the establishment method used, soil treatment, weed protection, fencing and animal treatment, thinning, productivity and yield, furthermore pruning and occurrence of damages. Three important rules for establishment of silvipastures are continuous weed elimination, early, forceful thinning and good fencing.

Färg och missfärgning hos sågad björk : - Variation samt effekter av avverkningstidpunkt, lagring av timmer och torkning av sågad vara

Variation i björkvirkets färg beror på art, läge i träd, ursprung och lagringstid. Vårtbjörk har en mörkare färg än glasbjörk, men livligare struktur och glans. Timmer hugget under tillväxtsäsongen bör sågas färskt eller lagras högst en månad. Vid brädgårdstorkning är god luftcirkulation och skydd för väta och direkt solljus väsentligt. Strövirkets färskhet är av stor betydelse för att undvika fuktfärgning av virket.Variation in birch colours depend on species, position in tree, origin and the storage period. White birch is darker than hairy birch but with a lively structure and shine. During vegetation period timber storage exceeding one month should be avoided. Air circulation, protection from rain and direct sunlight are essential for yard drying. Freshness of stickers used for stacking is important to avoid water marks on wood surface.

Reforestation challenges in Scandinavia

In the keynote, major reforestation challenges in Scandinavia will be highlighted. The following countries make up Scandinavia: Iceland, Norway, Sweden, Finland and Denmark. For Iceland, with only a forest cover of 2%, a major reforestation challenge is the deforestation and overgrazing in combination with land degradation and extensive soil erosion. The challenges include the conflicts with livestock farmers. For centuries the commons were used for sheep and horse grazing. However, more and more of farmer grazing land have been fenced up, allowing the regeneration of birch and plantations of other species to increase. With a forest cover of 37% and 69% respectively, for decades a major reforestation challenge in Norway and Sweden has been the risk of seedling damages from the pine weevil. Unprotected seedlings can have a survival rate of less than 25% after being planted. Pine weevils feed on the bark of planted young seedlings at regeneration sites. If the seedling is girdled, it will not survive. In Sweden, and soon in Norway, pesticides have been forbidden. In the keynote, new methods and technology will be presented based on non-chemical protection. In Finland, with a forest cover of 75%, a major reforestation challenge is linked to the forest structure. The structure of Finnish forestry includes many private forests in combination with small regeneration sites. This implies a situation where logistics and methods for lifting and field storage provide a major challenge in order to preserve seedling quality until the planting date. Due to this situation, new logistic systems and technologies are being developed in Finland, including new seedling cultivation programs (including cultivation under Light Emitting Diodes (LEDs)) to match the access of fresh planting stock to different planting dates. In Denmark, with a forest cover of 13%, a major reforestation challenge is the possibility of future plantations based on a wide range of relevant species. For this to become a realistic option, new methods and technology have to be developed in reforestation activities that support this possibility. These methods and technology should make it possible to not be limited to certain species due to problems and restrictions during field establishment. This due to the prospect of establishing stable, healthy, and productive stands of various forest species that can be adapted to future climate change.

A machine learning approach for recognising woody plants on railway trackbeds

The purpose of this work in progress study was to test the concept of recognising plants using images acquired by image sensors in a controlled noise-free environment. The presence of vegetation on railway trackbeds and embankments presents potential problems. Woody plants (e.g. Scots pine, Norway spruce and birch) often establish themselves on railway trackbeds. This may cause problems because legal herbicides are not effective in controlling them; this is particularly the case for conifers. Thus, if maintenance administrators knew the spatial position of plants along the railway system, it may be feasible to mechanically harvest them. Primary data were collected outdoors comprising around 700 leaves and conifer seedlings from 11 species. These were then photographed in a laboratory environment. In order to classify the species in the acquired image set, a machine learning approach known as Bag-of-Features (BoF) was chosen. Irrespective of the chosen type of feature extraction and classifier, the ability to classify a previously unseen plant correctly was greater than 85%. The maintenance planning of vegetation control could be improved if plants were recognised and localised. It may be feasible to mechanically harvest them (in particular, woody plants). In addition, listed endangered species growing on the trackbeds can be avoided. Both cases are likely to reduce the amount of herbicides, which often is in the interest of public opinion. Bearing in mind that natural objects like plants are often more heterogeneous within their own class rather than outside it, the results do indeed present a stable classification performance, which is a sound prerequisite in order to later take the next step to include a natural background. Where relevant, species can also be listed under the Endangered Species Act.