Common black coatings - reflectance and ageing characteristics in the 0.32-14.3 mu m wavelength range

The diffuse and regular reflectances of five optically absorbing coatings frequently used in optical systems, were measured over the 0.32-14.3 mu m wavelength range, before and after exposure to heat and intense optical radiation. The measured coatings included Nextel Velvet Black, an anodised coating and NPL Super Black. The anodised coating exhibited substantial variations in its diffuse and regular reflectance values after thermal and simulated solar ageing. Solar and thermal ageing of the Nextel Velvet Black resulted in increases of its reflectance. However, thermal ageing tended to decrease the reflectance of the other paint samples examined. Thermal and solar ageing of the NPL Super Black resulted in only minor changes in its reflectance characteristics. All measurements are traceable to the UK National Standards.

Biological and chemical assessment of zinc ageing in field soils

As zinc (Zn) is both an essential trace element and potential toxicant, the effects of Zn fixation in soil are of practical significance. Soil samples from four field sites amended with ZnSO4 were used to investigate ageing of soluble Zn under field conditions over a 2-year period. Lability of Zn measured using 65Zn radioisotope dilution showed a significant decrease over time and hence evidence of Zn fixation in three of the four soils. However, 0.01 M CaCl2 extractions and toxicity measurements using a genetically modified lux-marked bacterial biosensor did not indicate a decrease in soluble/bioavailable Zn over time. This was attributed to the strong regulatory effect of abiotic properties such as pH on these latter measurements. These results also showed that Zn ageing occurred immediately after Zn spiking, emphasising the need to incubate freshly spiked soils before ecotoxicity assessments. Ageing effects were detected in Zn-amended field soils using 65Zn isotopic dilution as a measure of lability, but not with either CaCl2 extractions or a lux-marked bacterial biosensor.

What is the new medicines use review ‘patient survey’ attempting to capture in the context of existing patient satisfaction with pharmacy questionnaires and a new conceptual framework?

The community pharmacy service medicines use review (MUR) was introduced in 2005 ‘to improve patient knowledge, concordance and use of medicines’ through a private patient–pharmacist consultation. The MUR presents a fundamental change in community pharmacy service provision. While traditionally pharmacists are dispensers of medicines and providers of medicines advice, and patients as recipients, the MUR considers pharmacists providing consultation-type activities and patients as active participants. The MUR facilitates a two-way discussion about medicines use. Traditional patient–pharmacist behaviours transform into a new set of behaviours involving the booking of appointments, consultation processes and form completion, and the physical environment of the patient–pharmacist interaction moves from the traditional setting of the dispensary and medicines counter to a private consultation room. Thus, the new service challenges traditional identities and behaviours of the patient and the pharmacist as well as the environment in which the interaction takes place. In 2008, the UK government concluded there is at present too much emphasis on the quantity of MURs rather than on their quality.[1] A number of plans to remedy the perceived imbalance included a suggestion to reward ‘health outcomes’ achieved, with calls for a more focussed and scientific approach to the evaluation of pharmacy services using outcomes research. Specifically, the UK government set out the main principal research areas for the evaluation of pharmacy services to include ‘patient and public perceptions and satisfaction’as well as ‘impact on care and outcomes’. A limited number of ‘patient satisfaction with pharmacy services’ type questionnaires are available, of varying quality, measuring dimensions relating to pharmacists’ technical competence, behavioural impressions and general satisfaction. For example, an often cited paper by Larson[2] uses two factors to measure satisfaction, namely ‘friendly explanation’ and ‘managing therapy’; the factors are highly interrelated and the questions somewhat awkwardly phrased, but more importantly, we believe the questionnaire excludes some specific domains unique to the MUR. By conducting patient interviews with recent MUR recipients, we have been working to identify relevant concepts and develop a conceptual framework to inform item development for a Patient Reported Outcome Measure questionnaire bespoke to the MUR. We note with interest the recent launch of a multidisciplinary audit template by the Royal Pharmaceutical Society of Great Britain (RPSGB) in an attempt to review the effectiveness of MURs and improve their quality.[3] This template includes an MUR ‘patient survey’. We will discuss this ‘patient survey’ in light of our work and existing patient satisfaction with pharmacy questionnaires, outlining a new conceptual framework as a basis for measuring patient satisfaction with the MUR. Ethical approval for the study was obtained from the NHS Surrey Research Ethics Committee on 2 June 2008. References 1. Department of Health (2008). Pharmacy in England: Building on Strengths – Delivering the Future. London: HMSO. www. official-documents.gov.uk/document/cm73/7341/7341.pdf (accessed 29 September 2009). 2. Larson LN et al. Patient satisfaction with pharmaceutical care: update of a validated instrument. JAmPharmAssoc 2002; 42: 44–50. 3. Royal Pharmaceutical Society of Great Britain (2009). Pharmacy Medicines Use Review – Patient Audit. London: RPSGB. http:// qi4pd.org.uk/index.php/Medicines-Use-Review-Patient-Audit. html (accessed 29 September 2009).

Chemical, physical and electrical properties of aged dodecylbenzene 3: thermal ageing of mixed isomers in nitrogen and under sealed conditions

Commercial dodecylbenzene cable fluid was aged at temperatures of 105 and 135 degrees C in dry oxygen-free nitrogen. In addition, selected samples were aged at 135 degrees C under sealed conditions where air was excluded from the headspace above the oil. A variety of analytical techniques, such as ultra-violet visible and infra-red spectroscopy, acid number and water content measurements, were then used to characterize the aged oils. In addition, their electrical properties were assessed by dielectric spectroscopy. Compared with ageing in air, the ageing rate was reduced significantly and, as expected, no major oxidation peaks were detected in the infrared spectrometer. Significantly, very little absorbance at 680 nm ("red absorbers") was detected in samples aged with copper and, consequentially, no large increases in dielectric loss were recorded within the ageing times considered here. This study compliments previous investigations on cable fluid and 1-phenyldodecane aged in air and show that the same ageing indicators are valid in oils aged under conditions which more closely resemble those found in high voltage plant.

Chemical, physical and electrical properties of aged dodecylbenzene: thermal ageing of mixed isomers in air

A commercial dodecylbenzene (DDB) cable oil was aged at temperatures between 90 and 135 degrees C in air and was analyzed using various analytical techniques including optical and infra-red spectroscopy and dielectric analysis. On ageing, the oil darkened, significant oxidation features were found by infra-red spectroscopy and the acid number, water content and dielectric loss all increased. Ageing in the presence of paper or aluminum did not affect the ageing process, whereas ageing was significantly modified by the presence of copper. An absorption at 680 nm ("red absorbers") was detected by ultra-violet/visible spectroscopy followed by the production of an opaque precipitate. A reaction between copper and the acid generated on ageing is thought to produce copper carboxylates, and X-ray fluorescence confirmed that copper was indeed present in both the aged oil and the precipitate. Significantly, once red absorbers were detected, the dielectric loss increased to catastrophically high values and, therefore, the appearance of these compounds may serve as a useful diagnostic indicator. The development of acidity on ageing appears to be key in initiating the destructive copper conversion reaction and hence the control of oil acidity may be key to prolonging the life of DDB cable oils.

Chemical, physical and electrical properties of aged dodecylbenzene 2: thermal ageing of single isomers in air

The linear isomer of dodecylbenzene (DDB), 1-phenyldodecane, was aged at temperatures of 105 and 135 degrees C in air and the resultant products were analyzed using a range of analytical techniques. On ageing, the 1-phenyldodecane darkened, the acid number, dielectric loss and water content increased and significant oxidation peaks were detected in the infrared spectrum. When aged in the presence of copper, a characteristic peak at 680 nm was also detected by UV/visible spectroscopy but, compared with previous studies of a cable-grade DDB, the strength of this peak was much increased and no appreciable precipitate formation occurred. At the same time, very high values of dielectric loss were recorded. On ageing in the absence of copper, an unusually strong infrared carbonyl band was seen, which correlates well with the detection of dodecanophenone by gas chromatography / mass spectrometry and nuclear magnetic resonance spectroscopy. It was therefore concluded that the ageing process proceeds via the initial production of aromatic ketones, which may then be further oxidized to carboxylic acids. In the presence of copper, these oxidation products are present in lower quantities, most of these oxidation products being combined with the copper present in the oil to give copper carboxylates. The behavior is described in terms of a complex autoxidation mechanism, in which copper acts as both an oxidizing and a reducing agent, depending on its oxidation state and, in particular, promotes elimination via the oxidation of intermediate alkyl radical species to carbocations.

EQUAL: New horizons for ageing research

The Engineering and Physical Sciences Research Council (EPSRC) extending quality of life (EQUAL) initiative, specifically supports interdisciplinary user-focused design, engineering and technology research concerned with enhancing the independence and quality of life of older and disabled people. This paper briefly describes a recent programme to encourage the adoption of a broader perspective on the lives and needs of older people that have been pursued by EPSRC through its extending quality life (EQUAL) initiative. EPSRC is the principle supporter design, engineering and technology research in UK universities. The paper illustrates the scope of EQUAL.

Building capacity for ageing and disability-related research

Since 1997, EQUAL has supported over forty ageing and disability-related research projects, many of which demonstrating an inclusive design dimension. Some of these projects have had a significant influence on policy and practice. However, less progress has been made in promoting ageing-related research in scientific areas. Building on the experience gained in developing the inclusive design research community, SPARC was created with the aim to provide opportunities for introducing newcomers across a wide range of engineering and biological fields to ageing and disability-related research. Through an awards scheme, SPARC provides financial support, mentoring, editorial assistance and a platform for dissemination and access to international activities. In addition, SPARC organises national and international workshops that showcase the latest research and educates individuals, society and government about the value of ageing and disability-related research.