An ultra-wide passband (5-30µm) filter for FTIR studies of Photosystem II

This paper reports on the design and manufacture of an ultra-wide (5-30µm) infrared edge filter for use in FTIR studies of the low frequency vibrational modes of metallo-proteins. We present details of the spectral design and manufacture of such a filter which meets the demanding bandwidth and transparency requirements of the application, and spectra that present the new data possible with such a filter. A design model of the filter and the materials used in its construction has been developed capable of accurately predicting spectral performance at both 300K and at the reduced operating temperature at 200K. This design model is based on the optical and semiconductor properties of a multilayer filter containing PbTe (IV-VI) layer material in combination with the dielectric dispersion of ZnSe (II-VI) deposited on a CdTe (II-VI) substrate together with the use of BaF2 (II-VII) as an antireflection layer. Comparisons between the computed spectral performance of the model and spectral measurements from manufactured coatings over a wavelength range of 4-30µm and temperature range 300-200K are presented. Finally we present the results of the FTIR measurements of Photosystem II showing the improvement in signal to noise ratio of the measurement due to using the filter, together with a light induced FTIR difference spectrum of Photosystem II.

The influence of powdery mildew infection on photosynthesis, chlorophyll fluorescence, leaf chlorophyll and carotenoid content of three woody plant species

The effect of powdery mildew development on photosynthesis, chlorophyll fluorescence, leaf chlorophyll and carotenoid concentrations on three woody plants frequently planted in urban environments was studied. Rates of photosynthetic CO2 fixation were rapidly reduced in two of the three genotypes tested prior to visible signs of infection. Effects on chlorophyll fluorescence (Fo, Fv/Fo, Fv/Fm), leaf chlorophyll and carotenoid content were not manifest until >25 per cent of the leaf area was observed to be covered by mycelial growth indicating reduced photo-synthetic rates during the early stages of infection were not due to degradation of the leaf chloroplast structure. Observation of the fluorescence transient (OJIP curves) showed powdery mildew infection impairs photosynthetic electron transport system by reducing the size but not heterogeneity of the plastoquninone pool, effecting both the acceptor and donor side of photosystem II. Impairment of the photosynthetic electron transport system was reflected by reduced values of a performance index used in this investigation as a measure of photochemical events within photosystem II electron transport. In addition interpretation of the fluorescence data indicated powdery mildew infection may impair the photo-protective process that facilitates the dissipation of excess energy within leaf tissue.

Measurement of the salinity and freezing tolerance of Crataegus genotypes using chlorophyll fluorescence

The effect of increasing salinity and freezing stress singly and in combination on a range of chlorophyll fluorescence parameters in foliar tissue of six Crataegus genotypes was examined. In general, increased stress reduced fluorescence values and absorption, trapping and electron transport energy fluxes per leaf reaction center and cross section, with decreased sigmoidicity of OJIP curves as a measure of the plastoquinone pool, reflecting decreased energy fluxes. Based on percentage reduction in a performance index from controls compared to stress-treated values, plants were ranked in order of tolerant > intermediate > sensitive. Use of this PIp ranking criteria enabled the distinguishing of marked differences in foliar salt/freezing hardiness between the Crataegus species used. Interpretation of the photochemical data showed that salinity and freezing affects both the acceptor and donor side of Photosystem II, while OJIP observations provided information regarding structural and functional changes in the leaf photosynthetic apparatus of the test species. It is concluded that chlorophyll fluorescence offers a rapid screening technique for assessing foliar salinity and freezing tolerance of woody perennials

Neocuproine-functionalized silica-coated magnetic nanoparticles for extraction of copper(II) from aqueous solution

Neocuproine has been covalently bound to silica-coated maghemite(c-Fe2O3) magnetic nanoparticles (MNPs) by a phenyl ether linkage. The resulting MNPs are able to remove Cu(II) from 12 ppm aqueous solution with an extraction efficiency of up to 99% at pH 2.

Adsorption, orientation and thermal decomposition of copper(II) hexafluoroacetylacetonate on rutile TiO2(110)

We have investigated the adsorption and thermal decomposition of copper hexafluoroacetylacetonate (Cu-11(hfaC)(2)) on single crystal rutile TiO2(110). Low energy electron diffraction shows that room temperature saturation coverage of the Cu-II(hfac)(2) adsorbate forms an ordered (2 x 1) over-layer. X-ray and ultra-violet photoemission spectroscopy of the saturated surface were recorded as the sample was annealed in a sequential manner to reveal decomposition pathways. The results show that the molecule dissociatively adsorbs by detachment of one of the two ligands to form hfac and Cu-1(hfac) which chemisorb to the substrate at 298 K. These ligands only begin to decompose once the surface temperature exceeds 473 K where Cu core level shifts indicate metallisation. This reduction from Cu(I) to Cu(0) takes place in the absence of an external reducing agent and without disproportionation and is accompanied by the onset of decomposition of the hfac ligands. Finally, C K-edge near edge X-ray absorption fine structure experiments indicate that both the ligands adsorb aligned in the < 001 > direction and we propose a model in which the hfac ligands adsorb on the 5-fold coordinated Ti atoms and the Cu-1(hfac) moiety attaches to the bridging O atoms in a square planar geometry. The calculated tilt angle for these combined geometries is approximately 10 degrees to the surface normal.

The sediment trapping efficiency of the macro-tidal Daly Estuary, tropical Australia

Field studies were carried out on the water and sediment dynamics in the tropical, macro-tidal, Daly Estuary. The estuary is shallow, very-turbid, about 100 km long, and the entrance is funnel-shape. In the wet, high flow season, normal tidal ranges can be suppressed in the estuary, depending on inflow rates, and freshwater becomes dominant up to the mouth. At that time a fraction of the fine sediment load is exported offshore as a bottom-tagging nepheloid layer after the sediment falls out of suspension of the thin, near-surface, river plume. The remaining fraction and the riverine coarse sediment form a large sediment bar 10 km long, up to 6 m in height and extending across the whole width of the channel near the mouth. This bar, as well as shoals in the estuary, partially pond the mid- to upper-estuary. This bar builds up from the deposition of riverine sediment during a wet season with high runoff and can raise mean water level by up to 2 m in the upper estuary in the low flow season. This ponding effect takes about three successive dry years to disappear by the sediment forming the bar being redistributed all over the estuary by tidal pumping of fine and coarse sediment in the dry season, which is the low flow season. The swift reversal of the tidal currents from ebb to flood results in macro-turbulence that lasts about 20 min. Bed load transport is preferentially landward and occurs only for water currents greater than 0.6 m s(-1). This high value of the threshold velocity suggests that the sand may be cemented by the mud. The Daly Estuary thus is a leaky sediment trap with an efficiency varying both seasonally and inter-annually. (c) 2006 Elsevier Ltd. All rights reserved.

Endgame table testing of studies - II

The van der Heijden Studies Database (Version III) has been reviewed to identify 'Win Studies' with sub-7-man positions in the main line which are not wins for White. Some studies were faulted, A number for the first time: 21 of the more interesting escapes by Black are highlighted, themed and discussed.

Estimating technical efficiency of Australian dairy farms using alternative frontier methodologies

Technical efficiency is estimated and examined for a cross-section of Australian dairy farms using various frontier methodologies; Bayesian and Classical stochastic frontiers, and Data Envelopment Analysis. The results indicate technical inefficiency is present in the sample data. Also identified are statistical differences between the point estimates of technical efficiency generated by the various methodologies. However, the rank of farm level technical efficiency is statistically invariant to the estimation technique employed. Finally, when confidence/credible intervals of technical efficiency are compared significant overlap is found for many of the farms' intervals for all frontier methods employed. The results indicate that the choice of estimation methodology may matter, but the explanatory power of all frontier methods is significantly weaker when interval estimate of technical efficiency is examined.

Examining the technical efficiency of rice producers in Bangladesh

Despite record national output in the early years of this decade there is widespread concern that rice yields in Bangladesh are below those attainable, and that given future population growth this may constrain achievement of food security and poverty reduction objectives. A frequent response to this problem is that farmers could close the gap between actual farm yields and potential yields identified in field trials if farmers who are technically inefficient could improve their current farming practices. This paper estimates and explains technical efficiency for a sample of rice farmers in Bangladesh employing Bayesian methods. The results provide insights into the distribution of technical efficiency and identify important influences on rice growing.

Profitability and technical efficiency of aquaculture systems in Pampanga, Philippines

We evaluate the profitability and technical efficiency of aquaculture in the Philippines. Farm-level data are used to compare two production systems corresponding to the intensive monoculture of tilapia in freshwater ponds and the extensive polyculture of shrimps and fish in brackish water ponds. Both activities are very lucrative, with brackish water aquaculture achieving the higher level of profit per farm. Stochastic frontier production functions reveal that technical efficiency is low in brackish water aquaculture, with a mean of 53%, explained primarily by the operator's experience and by the frequency of his visits to the farm. In freshwater aquaculture, the farms achieve a mean efficiency level of 83%. The results suggest that the provision of extension services to brackish water fish farms might be a cost-effective way of increasing production and productivity in that sector. By contrast, technological change will have to be the driving force of future productivity growth in freshwater aquaculture.

Application of a double bootstrap to investigation of determinants of technical efficiency of farms in Central Europe

The paper provides one of the first applications of the double bootstrap procedure (Simar and Wilson 2007) in a two-stage estimation of the effect of environmental variables on non-parametric estimates of technical efficiency. This procedure enables consistent inference within models explaining efficiency scores, while simultaneously producing standard errors and confidence intervals for these efficiency scores. The application is to 88 livestock and 256 crop farms in the Czech Republic, split into individual and corporate.

Application of a double bootstrap to investigation of determinants of technical efficiency of farms in Central Europe

The paper provides one of the first applications of the double bootstrap procedure (Simar and Wilson 2007) in a two-stage estimation of the effect of environmental variables on non-parametric estimates of technical efficiency. This procedure enables consistent inference within models explaining efficiency scores, while simultaneously producing standard errors and confidence intervals for these efficiency scores. The application is to 88 livestock and 256 crop farms in the Czech Republic, split into individual and corporate.