Dysregulation of granulosal bone morphogenetic protein receptor 1B density is associated with reduced ovarian reserve and the age-related decline in human fertility

Reproductive ageing is linked to the depletion of ovarian primordial follicles, which causes an irreversible change to ovarian cellular function and the capacity to reproduce. The current study aimed to profile the expression of bone morphogenetic protein receptor, (BMPR1B) in 53 IVF patients exhibiting different degrees of primordial follicle depletion. The granulosa cell receptor density was measured in 403 follicles via flow cytometry. A decline in BMPR1B density occurred at the time of dominant follicle selection and during the terminal stage of folliculogenesis in the 23-30 y good ovarian reserve patients. The 40+ y poor ovarian reserve patients experienced a reversal of this pattern. The results demonstrate an association between age-induced depletion of the ovarian reserve and BMPR1B receptor density at the two critical time points of dominant follicle selection and pre-ovulatory follicle maturation. Dysregulation of BMP receptor signalling may inhibit the normal steroidogenic differentiation required for maturation in older patients.

Prediction leaching of potassium using the convective-dispersive and the convective log-normal transfer function models

There is increasing concern about soil enrichment with K+ and subsequent potential losses following long-term application of poor quality water to agricultural land. Different models are increasingly being used for predicting or analyzing water flow and chemical transport in soils and groundwater. The convective-dispersive equation (CDE) and the convective log-normal transfer function (CLT) models were fitted to the potassium (K+) leaching data. The CDE and CLT models produced equivalent goodness of fit. Simulated breakthrough curves for a range of CaCl2 concentration based on parameters of 15 mmol l(-1) CaCl2 were characterised by an early peak position associated with higher K+ concentration as the CaCl2 concentration used in leaching experiments decreased. In another method, the parameters estimated from 15 mmol l(-1) CaCl2 solution were used for all other CaCl2 concentrations, and the best value of retardation factor (R) was optimised for each data set. A better prediction was found. With decreasing CaCl2 concentration the value of R is required to be more than that measured (except for 10 mmol l(-1) CaCl2), if the estimated parameters of 15 mmol l(-1) CaCl2 are used. The two models suffer from the fact that they need to be calibrated against a data set, and some of their parameters are not measurable and cannot be determined independently.

Soil fertility management in the mid-hills of Nepal: Practices and perceptions

Sustaining soil fertility is essential to the prosperity of many households in the mid-hills of Nepal, but there are concerns that the breakdown of the traditional linkages between forest, livestock, and cropping systems is adversely affecting fertility. This study used triangulated data from surveys of households, discussion groups, and key informants in 16 wards in eastern and western Nepal to determine the existing practices for soil fertility management, the extent of such practices, and the perception of the direction of changes in soil fertility. The two principal practices for maintaining soil fertility were the application of farmyard manure (FYM) and of chemical fertilizer (mainly urea and diammonium phosphate). Green manuring, in-situ manuring, slicing terrace risers, and burning plant residues are rarely practiced. FYM usage was variable with more generally applied to khet land (average 6053 kg fresh weight manure ha(-1)) than to bari land (average 4185 kg fresh weight manure ha-1) with manure from goats and poultry preferred above that from cows and buffaloes. Almost all households (98%) apply urea to khet land and 87% to bari land, with 45% applying diammonium phosphate to both types of land. Application rates and timings of applications varied considerably both within and between wards suggesting poor knowledge transfer between the research and farming communities. The benefits of chemical fertilizers in terms of ease of application and transportation in comparison with FYM, were perceived to outweigh the widely reported detrimental hardening of soil associated with their continued usage. Among key informants, FYM applied in conjunction with chemical fertilizer was the most popular amendment, with FYM alone preferred more than chemical fertilizer alone - probably because of the latter's long-term detrimental effects. Key informant and householder surveys differed in their perception of fertility changes in the last decade probably because of differences in age and site-specific knowledge. All key informants felt that fertility had declined but among households, only about 40% perceived a decline with the remainder about evenly divided between no change and an increase. Householders with small landholdings (< 0.5 ha) were more likely to perceive increasing soil fertility while those with larger landholdings (> 2 ha) were more likely to perceive declining fertility. Perceived changes in soil fertility were not related to food self-sufficiency. The reasons for the slow spread of new technologies within wards and the poor understanding of optimal use of chemical fertilizers in conjunction with improved quality FYM may repay further investigation in terms of sustaining soil fertility in this region.

Eddy current testing system with scanning probe head having parallel and normal sensing coils

An eddy current testing system consists of a multi-sensor probe, a computer and a special expansion card and software for data-collection and analysis. The probe incorporates an excitation coil, and sensor coils; at least one sensor coil is a lateral current-normal coil and at least one is a current perturbation coil.

Eddy current testing program with scanning probe head having parallel and normal sensing coils

An eddy current testing system consists of a multi-sensor probe, computer and a special expansion card and software for data collection and analysis. The probe incorporates an excitation coil, and sensor coils; at least one sensor coil is a lateral current-normal coil and at least one is a current perturbation coil.

On the relationship of normal modes to local modes in molecular vibrations

A simple model for the effective vibrational hamiltonian of the XH stretching vibrations in H2O, NH3 and CH4 is considered, based on a morse potential function for the bond stretches plus potential and kinetic energy coupling between pairs of bond oscillators. It is shown that this model can be set up as a matrix in local mode basis functions, or as a matrix in normal mode basis functions, leading to identical results. The energy levels obtained exhibit normal mode patterns at low vibrational excitation, and local mode patterns at high excitation. When the hamiltonian is set up in the normal mode basis it is shown that Darling-Dennison resonances must be included, and simple relations are found to exist between the xrs, gtt, and Krrss anharmonic constants (where the Darling-Dennison coefficients are denoted K) due to their contributions from morse anharmonicity in the bond stretches. The importance of the Darling-Dennison resonances is stressed. The relationship of the two alternative representations of this local mode/normal mode model are investigated, and the potential uses and limitations of the model are discussed.

The calculation of force constants and normal coordinates IV: XH4 and XH3 molecules

Normal coordinate calculations of XH4 and XH3 molecules are reviewed and discussed. It is shown that for most of these molecules the true values of the force constants in the most General Harmonic Force Field can be uniquely determined only by making use of vibration-rotation interaction constants. It is emphasized that without these extra data the GFF is not determined. The results are compared with various model force fields for these molecules.

The calculation of accurate normal coordinates I: general theory, and application to methane

The calculation of accurate and reliable vibrational potential functions and normal co-ordinates is discussed, for such simple polyatomic molecules as it may be possible. Such calculations should be corrected for the effects of anharmonicity and of resonance interactions between the vibrational states, and should be fitted to all the available information on all isotopic species: particularly the vibrational frequencies, Coriolis zeta constants and centrifugal distortion constants. The difficulties of making these corrections, and of making use of the observed data are reviewed. A programme for the Ferranti Mercury Computer is described by means of which harmonic vibration frequencies and normal co-ordinate vectors, zeta factors and centrifugal distortion constants can be calculated, from a given force field and from given G-matrix elements, etc. The programme has been used on up to 5 × 5 secular equations for which a single calculation and output of results takes approximately l min; it can readily be extended to larger determinants. The best methods of using such a programme and the possibility of reversing the direction of calculation are discussed. The methods are applied to calculating the best possible vibrational potential function for the methane molecule, making use of all the observed data.

Normal coordinates for the planar vibrations of benzene

Force constants and normal coordinates have been recalculated for all of the in-plane vibrations of benzene, making use of the recently observed data on one of the Coriolis constants in the E2g species from the work of Callomon et al. The extent to which the force field is uniquely determined by the data is reviewed for each symmetry species in turn, and the results of a force constant refinement calculation are reported in which a modified valency force field was used based on the hybrid orbital model. The results show considerable differences from Whiffen's normal coordinates for benzene, but somewhat smaller differences from Scherer's recent calculations.

The calculation of force constants and normal co-ordinates II: methyl fluoride

The mathematical difficulties which can arise in the force constant refinement procedure for calculating force constants and normal co-ordinates are described and discussed. The method has been applied to the methyl fluoride molecule, using an electronic computer. The best values of the twelve force constants in the most general harmonic potential field were obtained to fit twenty-two independently observed experimental data, these being the six vibration frequencies, three Coriolis zeta constants and two centrifugal stretching constants DJ and DJK, for both CH3F and CD3F. The calculations have been repeated both with and without anharmonicity corrections to the vibration frequencies. All the experimental data were weighted according to the reliability of the observations, and the corresponding standard errors and correlation coefficients of the force constants have been deduced. The final force constants are discussed briefly, and compared with previous treatments, particularly with a recent Urey-Bradley treatment for this molecule.

Normal coordinates in the methyl halides

The potential‐energy functions found by Chang for the methyl halides have been put into valence‐type form and revised to eliminate inconsistencies and to accord with the true (nontetrahedral) geometry and the normal frequencies (corrected for Fermi resonance and anharmonicity). The resulting valence‐type force constants and normal coordinates are given for light (CH3) and heavy (CD3) chlorides, bromides, and iodides.

The calculation of force constants and normal coordinates III: constrained force fields for the methyl halides

A method is discussed for imposing any desired constraint on the force field obtained in a force constant refinement calculation. The application of this method to force constant refinement calculations for the methyl halide molecules is reported. All available data on the vibration frequencies, Coriolis interaction constants and centrifugal stretching constants of CH3X and CD3X molecules were used in the refinements, but despite this apparent abundance of data it was found that constraints were necessary in order to obtain a unique solution to the force field. The results of unconstrained calculations, and of three different constrained calculations, are reported in this paper. The constrained models reported are a Urey—Bradley force field, a modified valence force field, and a constraint based on orbital-following bond-hybridization arguments developed in the following paper. The results are discussed, and compared with previous results for these molecules. The third of the above models is found to reproduce the observed data better than either of the first two, and additional reasons are given for preferring this solution to the force field for the methyl halide molecules.