The sediment trapping efficiency of the macro-tidal Daly Estuary, tropical Australia

Field studies were carried out on the water and sediment dynamics in the tropical, macro-tidal, Daly Estuary. The estuary is shallow, very-turbid, about 100 km long, and the entrance is funnel-shape. In the wet, high flow season, normal tidal ranges can be suppressed in the estuary, depending on inflow rates, and freshwater becomes dominant up to the mouth. At that time a fraction of the fine sediment load is exported offshore as a bottom-tagging nepheloid layer after the sediment falls out of suspension of the thin, near-surface, river plume. The remaining fraction and the riverine coarse sediment form a large sediment bar 10 km long, up to 6 m in height and extending across the whole width of the channel near the mouth. This bar, as well as shoals in the estuary, partially pond the mid- to upper-estuary. This bar builds up from the deposition of riverine sediment during a wet season with high runoff and can raise mean water level by up to 2 m in the upper estuary in the low flow season. This ponding effect takes about three successive dry years to disappear by the sediment forming the bar being redistributed all over the estuary by tidal pumping of fine and coarse sediment in the dry season, which is the low flow season. The swift reversal of the tidal currents from ebb to flood results in macro-turbulence that lasts about 20 min. Bed load transport is preferentially landward and occurs only for water currents greater than 0.6 m s(-1). This high value of the threshold velocity suggests that the sand may be cemented by the mud. The Daly Estuary thus is a leaky sediment trap with an efficiency varying both seasonally and inter-annually. (c) 2006 Elsevier Ltd. All rights reserved.

Structural diversity in supramolecular architectures of Mn(II) through non-covalent interactions

Two mononuclear complexes of manganese(II), [Mn(OCN)(2)(phen)(2)] 1 and [Mn(NCO)(2)(bpy)(2)] 2 [1,10-phenanthroline (phen); 2,2'-bipyridine (bpy)], have been synthesized and characterized by single crystal X-ray analysis, infra-red spectroscopy and magnetic studies. The coordination structure of complex 2 is already reported. The cyanate anions are pendent in both the complexes. In 1, cyanate anion links manganese(II) through O-atom, whereas in 2 it coordinates through N-atom. The mononuclear fragments of 1 are built up to a supramolecular lamellar 3D architecture by pi-pi interactions only. On the other hand, mononuclear fragments of 2 are assembled to a 2D supramolecular brick-wall architecture by C-H-... pi interactions.

4,4 '-Dipyridyl-N,N '-dioxide complexes of metal-thiocyanate/selenocyanate: pi-stacked molecular rods as three-dimensional support for two-dimensional polymeric sheets and intra/interchain S center dot center dot center dot S interaction dependent architecture of the R-2(2)(8) synthon driven assembly of one-dimensional polymeric chains

Three supramolecular complexes of Co(II) using SCN-/SeCN- in combination with 4,4'-dipyridyl-N,N'-dioxide (dpyo), i.e., {[Co(SCN)(2)(dpyo)(2)].(dpyo)}(n) ( 1), {[Co(SCN)(2)(dpyo)(H2O)(2)].(H2O)}(n) ( 2), {[Co(SeCN)(2)(dpyo)(H2O)(2)]center dot(H2O)}(n) ( 3), have been synthesized and characterized by single-crystal X-ray analysis. Complex 1 is a rare example of a dpyo bridged two-dimensional (2D) coordination polymer, and pi-stacked dpyo supramolecular rods are generated by the lattice dpyo, passing through the rhombic grid of stacked layers, resulting in a three-dimensional (3D) superstructure. Complexes 2 and 3 are isomorphous one-dimensional (1D) coordination polymers [-Co-dpyo-Co-] that undergo self-assembly leading to a bilayer architecture derived through an R-2(2)(8) H-bonding synthon between coordinated water and dpyo oxygen. A reinvestigation of coordination polymers [Mn(SCN)(2)(dpyo)( H2O)(MeOH)](n) ( 4) and {[Fe(SCN)(2)(dpyo)(H2O)(2)]center dot(H2O)}(n) ( 5) reported recently by our group [ Manna et al. Indian J. Chem. 2006, 45A, 1813] reveals brick wall topology rather than bilayer architecture is due to the decisive role of S center dot center dot center dot S/Se center dot center dot center dot Se interactions in determining the helical nature in 4 and 5 as compared to zigzag polymeric chains in 2 and 3, although the same R-2(2)(8) synthon is responsible for supramolecular assembly in these complexes.

Simulation models in farming systems research : potential and challenges

Integrated simulation models can be useful tools in farming system research. This chapter reviews three commonly used approaches, i.e. linear programming, system dynamics and agent-based models. Applications of each approach are presented and strengths and drawbacks discussed. We argue that, despite some challenges, mainly related to the integration of different approaches, model validation and the representation of human agents, integrated simulation models contribute important insights to the analysis of farming systems. They help unravelling the complex and dynamic interactions and feedbacks among bio-physical, socio-economic, and institutional components across scales and levels in farming systems. In addition, they can provide a platform for integrative research, and can support transdisciplinary research by functioning as learning platforms in participatory processes.

Wall materials and techniques available for low cost housing in Khartoum from a sustainability point of view

Khartoum like many cities in least developing countries (LDCs) still witnesses huge influx of people. Accommodation of the new comers leads to encroachment on the cultivation land leads to sprawl expansion of Greater Khartoum. The city expanded in diameter from 16.8 km in 1955 to 802.5 km in 1998. Most of this horizontal expansion was residential. In 2008 Khartoum accommodated 29% of the urban population of Sudan. Today Khartoum is considered as one of 43 major cities in Africa that accommodates more than 1 million inhabitants. Most of new comers live in the outskirts of the city e.g. Dar El-Salam and Mayo neighbourhoods. The majority of those new comers built their houses especially the walls from mud, wood, straw and sacks. Selection of building materials usually depends on its price regardless of the environmental impact, quality, thermal performance and life of the material. Most of the time, this results in increasing the cost with variables of impacts over the environment during the life of the building. Therefore, consideration of the environmental impacts, social impacts and economic impacts is crucial in the selection of any building material. Decreasing such impacts could lead to more sustainable housing. Comparing the sustainability of the available wall building materials for low cost housing in Khartoum is carried out through the life cycle assessment (LCA) technique. The purpose of this paper is to compare the most available local building materials for walls for the urban poor of Khartoum from a sustainability point of view by going through the manufacturing of the materials, the use of these materials and then the disposal of the materials after their life comes to an end. Findings reveal that traditional red bricks couldn’t be considered as a sustainable wall building material that will draw the future of the low cost housing in Greater Khartoum. On the other hand, results of the comparison lead to draw attention to the wide range of the soil techniques and to its potentials to be a promising sustainable wall material for urban low cost housing in Khartoum.

Roman public libraries

This thesis aims to investigate the development and functions of public libraries in Rome and the Roman world. After a preface with maps of libraries in Rome, Section I discusses the precursors for public library provision in the private book collections of Republican Rome, and their transfer into the public domain with the first public libraries of Asinius Pollio and Augustus. Section II contains three 'case studies' of public libraries' different roles. The Augustan library programme is used in Ch.II.l to examine the role of imperial public libraries in literary life and the connections between Rome's libraries and those of Alexandria. Chapter II.2 concentrates on the libraries of Trajan's Forum to explore the intersection of imperial public libraries and monumental public architecture. This chapter responds to an important recent article by arguing for the continued identification of the Forum's libraries with twin brick buildings at its northern end, and suggests a series of correspondences between these libraries and its other monumental components. The conclusions of this chapter are important when considering the public libraries of the wider empire, several of which seem to have been inspired by the Trajanic libraries. Chapter II.3 considers imperial public libraries and leisure by looking at the evidence for libraries within bath-house complexes, concluding that their presence there is consistent with the archaeological and epigraphic evidence and fits in well with what we know of the intellectual and cultural life of these structures. Section III examines various aspects of the practical function of Roman public libraries: their contents (books and archives), division into Latin and Greek sections, provisions for shelving and cataloguing, staff, usership, architectural form, decoration, and housing of works of art. The picture that emerges is of carefully designed and functional buildings intended to sustain public, monumental, and practical functions. Section IV uses a variety of texts to examine the way in which libraries were viewed and used. Ch. IV. 1 discusses the evidence for use of libraries by scholars and authors such as Gellius, Galen, Josephus, and Apuleius. Ch. IV.2 examines parallels between library collections and compendious encyclopaedic elements within Roman literature and considers how library collections came to be canon-forming institutions and vehicles for the expression of imperial approval or disapproval towards authors. The channels through which this imperial influence flowed are investigated in Ch. IV.3, which looks at the directors and staff of the public libraries of Rome. The final section (V) of the thesis concerns public libraries outside the city of Rome. Provincial libraries provide a useful case study in 'Romanisation': they reveal a range of influences and are shown to embody local, personal, and metropolitan imperial identities. There follows a brief conclusion, and a bibliography. There are also five appendices of numismatic and epigraphic material discussed in the text. This material has not been adequately or completely gathered elsewhere and is intended to assist the reader; where appropriate it includes illustrations, transcriptions, and translations.

Building WF16: construction of a PPNA pisé structure in Southern Jordan

The Pre-Pottery Neolithic A (PPNA) period in Southwest Asia is essential for our understanding of the transition to sedentary, agricultural communities. Developments in architecture are key to understanding this transition, but many aspects of PPNA architecture remain elusive, such as construction techniques, the selection of building materials, and the functional use of space. The primary aim of the research described within this contribution was to build a PPNA-like structure in order to answer questions about PPNA architecture in general, while specifically addressing issues raised by the excavation of structures at the site of WF16, Southern Jordan. The second aim was to display a ‘PPNA’ building to visitors in Wadi Faynan to enhance their understanding of the period. The experimental construction based on one of the WF16 structures showed that 1) required materials can be acquired locally; 2) a construction technique using mud layers as described in this paper was likely used; 3) flat, or very slightly dome-shaped, roofs are functional and can also be used as a solid working platform; 4) the WF16 small semi-subterranean buildings appear inappropriate for housing a nuclear family unit.