Acoustic and petrophysical relationships in low-shale sandstone reservoir rocks

This paper describes the measurements of the acoustic and petrophysical properties of two suites of low-shale sandstone samples from North Sea hydrocarbon reservoirs, under simulated reservoir conditions. The acoustic velocities and quality factors of the samples, saturated with different pore fluids (brine, dead oil and kerosene), were measured at a frequency of about 0.8 MHz and over a range of pressures from 5 MPa to 40 MPa. The compressional-wave velocity is strongly correlated with the shear-wave velocity in this suite of rocks. The ratio V-P/V-S varies significantly with change of both pore-fluid type and differential pressure, confirming the usefulness of this parameter for seismic monitoring of producing reservoirs. The results of quality factor measurements were compared with predictions from Biot-flow and squirt-flow loss mechanisms. The results suggested that the dominating loss in these samples is due to squirt-flow of fluid between the pores of various geometries. The contribution of the Biot-flow loss mechanism to the total loss is negligible. The compressional-wave quality factor was shown to be inversely correlated with rock permeability, suggesting the possibility of using attenuation as a permeability indicator tool in low-shale, high-porosity sandstone reservoirs.

Variation in dynamic elastic shear modulus of sandstone upon fluid saturation and substitution

Experimental acoustic measurements on sandstone rocks at both sonic and ultrasonic frequencies show that fluid saturation can cause a noticeable change in both the dynamic bulk and shear elastic moduli of sandstones. We observed that the change in dynamic shear modulus upon fluid saturation is highly dependent on the type of saturant, its viscosity, rock microstructure, and applied pressures. Frequency dispersion has some influence on dynamic elastic moduli too, but its effect is limited to the ultrasonic frequency ranges and above. We propose that viscous coupling, reduction in free surface energy, and, to a limited extent, frequency dispersion due to both local and global flow are the main mechanisms responsible for the change in dynamic shear elastic modulus upon fluid saturation and substitution, and we quantify influences.

Spatangoid-produced ichnofabrics (Bateig Limestone, Miocene, Spain) and the preservation of spatangoid trace fossils

A spatangoid-produced ichnofabric is described from the Miocene Bateig Limestone, SE Spain. This ichnofabric is characterized by the dominant presence of large meniscate burrows (Bichordites) produced by irregular echinoids. This constitutes an unusual mode of occurrence for spatangoid bioturbation, as their traces are most typically preserved in bases and tops of sandstone event beds. In fact, despite their important role as burrowers in modern settings (that can be extended back to the Early Cretaceous based on their body fossil record), spatangoid trace fossils (Scolicia and Bichordites) are comparatively rare. Several factors play an important role in their preservation: mechanism of burrowing, sediment characteristics, early diagenesis and presence/absence of deep-tier burrowers. Spatangoid-produced ichnofabrics, such as those from the Bateig Limestone, characterize depositional settings with intermittent deposition of event beds where there is an absence of deeper-tier bioturbation. (C) 2008 Elsevier B.V. All rights reserved