A comparison of reverse osmosis, nanofiltration and ultrafiltration as concentration processes for skim milk prior to drying

Skim milk was concentrated by reverse osmosis (RO), nanofiltration (NF) and ultrafiltration (UF) and the retentates were spray-dried. The resulting powders were reconstituted to 25% TS and sterilised to evaluate their heat stability. Reverse osmosis led to maximum retention of calcium, a fall in pH for its retentate and its reconstituted powder. All RO powders produced a weak gel on heating. Some calcium was lost during NF and a greater amount during UF. Their resulting reconstituted powders had a higher pH than those produced by RO. Powders produced by UF showed poor heat stability. Only one powder produced by NF showed good heat stability. This could be improved by addition of stabilisers at appropriate addition rates.

Chlorine tolerant, multilayer reverse-somosis membranes with high permeate flux and high salt rejection

A new class of high molecular weight polyethersulfone ionomers is described in which the ionic content can be varied, at will, over a very wide and fully-controllable range. A novel type of coating process enables these materials to be deposited from alcohol-type solvents as cohesive but very thin (50 – 250 nm) films on porous support-membranes, giving high-flux membranes (3.3 – 5.0 L m-2 h-1 bar-1) with very good, though not outstanding salt rejection (typically 92 - 96%). A secondary layer, of formaldehyde-cross-linked polyvinyl alcohol, can be deposited from aqueous solution on the surface of the ionomer membrane, and this layer increases salt rejection to greater than 99% without serious loss of water permeability. The final multi-layer membrane shows excellent chlorine tolerance in reverse-osmosis operation.

Bahrain's Formula-1 racing circuit: energy and environmental considerations

The Bahrain International Circuit (BIC) and complex, at latitude 26.00N and longitude 51.54E, was built in 483 days and cost 150 million US$. The circuit consists of six different individual tracks with a 3.66 km outer track (involving 10 turns) and a 2.55 km inner track (having six turns). The complex has been designed to host a variety of other sporting activities. Fifty thousand spectators, including 10,500 in the main grandstand, can be accommodated simultaneously. State-of-the art on-site media and broadcast facilities are available. The noise level emitted from vehicles on the circuit during the Formula-1 event, on April 4th 2004, was acceptable and caused no physical disturbance to the fans in the VIP lounges or to scholars studying at the University of Bahrain's Shakeir Campus, which is only 1.5 km away from the circuit. The sound-intensity level (SIL) recorded on the balcony of the VIP lounge was 128 dB(A) and was 80 dB(A) inside the lounge. The calculated SIL immediately outside the lecture halls of the University of Bahrain was 70 dB(A) and 65 dB(A) within them. Thus racing at BIC can proceed without significantly disturbing the academic-learning process. The purchased electricity demand by the BIC complex peaked (at 4.5 MW) during the first Formula-1 event on April 4th 2004. The reverse-osmosis (RO) plant at the BIC provides 1000 m(3) of desalinated water per day for landscape irrigation. Renewable-energy inputs, (i.e., via solar and wind power), at the BIC could be harnessed to generate electricity for water desalination, air conditioning, lighting as well as for irrigation. If the covering of the BIC complex was covered by adhesively fixed modern photovoltaic cells, then similar to 1.2 MW of solar electricity could be generated. If two horizontal-axis, at 150 m height above the ground, three 75m bladed, wind turbines were to be installed at the BIC, then the output could reach 4 MW. Furthermore, if 10,000 Jojoba trees (a species renowned for having a low demand for water, needing only five irrigations per year in Bahrain and which remain green throughout the year) are planted near the circuit, then the local micro-climate would be improved with respect to human comfort as well as the local environment becoming cleaner.

Development of a reverse genetics system enabling the rescue of recombinant avian influenza virus A/Turkey/England/50-92/91 (H5N1)

We previously described the use of an established reverse genetics system for the generation of recombinant human influenza A viruses from cloned cDNAs. Here, we have assembled a set of plasmids to allow recovery of the avian H5N1 influenza virus A/Turkey/England/50-92/91 entirely from cDNA. This system enables us to introduce mutations or truncations into the cDNAs to create mutant viruses altered specifically in a chosen gene. These mutant viruses can then be used in future pathogenesis studies in chickens and in studies to understand the host range restrictions of avian influenza viruses in humans.

Modeling the structure of amorphous MoS3: a neutron diffraction and reverse Monte Carlo study

A model for the structure of amorphous molybdenum trisulfide, a-MoS3, has been created using reverse Monte Carlo methods. This model, which consists of chains Of MoS6 units sharing three sulfurs with each of its two neighbors and forming alternate long, nonbonded, and short, bonded, Mo-Mo separations, is a good fit to the neutron diffraction data and is chemically and physically realistic. The paper identifies the limitations of previous models based on Mo-3 triangular clusters in accounting for the available experimental data.

A facile one step synthesis of N-2 substituted 3-phenyliminoisoindolinones from N-(2-carboxybenzoyl)-anthranilic acid and the design of reverse-turn mimetics

Stirring of N-(2-carboxybenzoyl) anthranilic acid with anilines and amines such as p-toluidine, benzylamine, methyl esters of Leu, Phe, Ile and Val in presence of DCC produces N- 2 substituted 3-phenyliminoisoindolinones in very good yields. Single crystal X-ray diffraction studies and solution phase NMR and CD studies reveal that the 3-phenyliminoisoindolinone moiety is a turn-inducing scaffold which should be useful for reverse-turn mimetics.

Enzyme glycation influences product yields during oligosaccharide synthesis by reverse hydrolysis

Possible evidence is presented for Maillard glycation of enzymes during oligosaccharide synthesis by reverse hydrolysis. In 70% (w/v) mannose solutions, 1,2-alpha-mannosidase from Penicillium citrinum lost 40% and alpha-mannosidase from almonds lost 60% activity at 55 degreesC over 2 weeks. Oligosaccharide yields were 15 and 45% respectively. Higher molecular weight glycation adducts were formed in a time-dependent manner as seen by MALDI-TOF. Inhibitors of the Maillard. reaction were able to partially alleviate these effects resulting in reduced loss of enzyme activity and oligosaccharide yield increases of 27-53% relative to the control. (C) 2004 Elsevier B.V. All rights reserved.

Synthesis of FimH receptor-active manno-oligosaccharides by reverse hydrolysis using alpha-mannosidases from Penicillium citrinum, Aspergillus phoenicis and almond

Recombinant Penicillium citrinum alpha-1,2-mannosidase, expressed in Aspergillus oryzae, was employed to carry out regioselective synthesis of alpha-D-mannopyranosyl-(1-->2)-D-mannose. Yields (w/w) of 16.68% disaccharide, 3.07% trisaccharide and 0.48% tetrasaccharide were obtained, with alpha1-->2 linkages present at 98.5% of the total linkages formed. Non-specific alpha-mannosidase from almond was highly efficient in reverse hydrolysis and oligosaccharide yields of 45-50% were achieved. The products of the almond mannosidase were a mixture of disaccharides (30.75%, w/w), trisaccharides (12.26%, w/w) and tetrasaccharides (1.89%, w/w) with 1-->2, 1-->3 and 1-->6 isomers. alpha-1,2-linkage specific mannosidase from P. citrinum and alpha-1,6-linkage-specific mannosidase from Aspergillus phoenicis were used in combination to hydrolyse the respective linkages from the mixture of isomers, resulting in alpha-D-mannopyranosyl-(1-->3)-D-mannose in 86.4% purity. The synthesised oligosaccharides can potentially inhibit the adhesion of pathogens by acting as 'decoys' of receptors of type-1 fimbriae carried by enterobacteria.

Regioselective synthesis of mannobiose and mannotriose by reverse hydrolysis using a novel 1,6-alpha-D-mannosidase from Aspergillus phoenicis

A novel 1,6-alpha-D-mannosidase was produced by Aspergillus phoenicis grown on a commercial manno-oligosaccharide preparation in liquid culture. The enzyme hydrolysed only alpha-D-Manp-(1 --> 6)-D-Manp and did not act on alpha-D-Manp-(1 --> 2)-D-Manp, or alpha-D-Manp-(1 --> 3)-D-Manp. The 1,6-alpha-D-mannosidase was used for synthesis of manno-oligosaccharides by reverse hydrolysis reaction. The highest yields, expressed as percentages (w/w) of total sugar, were similar to21% mannobiose and similar to5% mannotriose, and they were obtained with 45% (w/w) initial mannose concentration at pH 4.5 after 12 days incubation at 55 degreesC. The disaccharide and trisaccharide products were separated and their structures determined by methylation analysis. Only 1-6 linkages were found in both of them. (C) 2003 Elsevier B.V. All rights reserved.

An optimized reverse-phase high performance liquid chromatographic method for evaluating percutaneous absorption of glucosamine hydrochloride

A relatively simple, selective, precise and accurate high performance liquid chromatography (HPLC) method based on a reaction of phenylisothiocyanate (PITC) with glucosamine (GL) in alkaline media was developed and validated to determine glucosamine hydrochloride permeating through human skin in vitro. It is usually problematic to develop an accurate assay for chemicals traversing skin because the excellent barrier properties of the tissue ensure that only low amounts of the material pass through the membrane and skin components may leach out of the tissue to interfere with the analysis. In addition, in the case of glucosamine hydrochloride, chemical instability adds further complexity to assay development. The assay, utilising the PITC-GL reaction was refined by optimizing the reaction temperature, reaction time and PITC concentration. The reaction produces a phenylthiocarbarnyl-glucosamine (PTC-GL) adduct which was separated on a reverse-phase (RP) column packed with 5 mu m ODS (C-18) Hypersil particles using a diode array detector (DAD) at 245 nm. The mobile phase was methanol-water-glacial acetic acid (10:89.96:0.04 v/v/v, pH 3.5) delivered to the column at 1 ml min(-1) and the column temperature was maintained at 30 degrees C Using a saturated aqueous solution of glucosamine hydrochloride, in vitro permeation studies were performed at 32 +/- 1 degrees C over 48 h using human epidermal membranes prepared by a heat separation method and mounted in Franz-type diffusion cells with a diffusional area 2.15 +/- 0.1 cm(2). The optimum derivatisation reaction conditions for reaction temperature, reaction time and PITC concentration were found to be 80 degrees C, 30 min and 1 % v/v, respectively. PTC-Gal and GL adducts eluted at 8.9 and 9.7 min, respectively. The detector response was found to be linear in the concentration range 0-1000 mu g ml(-1). The assay was robust with intra- and inter-day precisions (described as a percentage of relative standard deviation, %R.S.D.) < 12. Intra- and inter-day accuracy (as a percentage of the relative error, %RE) was <=-5.60 and <=-8.00, respectively. Using this assay, it was found that GL-HCI permeates through human skin with a flux 1.497 +/- 0.42 mu g cm(-2) h(-1), a permeability coefficient of 5.66 +/- 1.6 x 10(-6) cm h(-1) and with a lag time of 10.9 +/- 4.6 h. (c) 2005 Elsevier B.V. All rights reserved.