Interventions to promote healthy eating habits: evaluation and recommendations

Although in several EU Member States many public interventions have been running for the prevention and/or management of obesity and other nutrition-related health conditions, few have yet been formally evaluated. The multidisciplinary team of the EATWELL project will gather benchmark data on healthy eating interventions in EU Member States and review existing information on the effectiveness of interventions using a three-stage procedure (i) Assessment of the intervention's impact on consumer attitudes, consumer behaviour and diets; (ii) The impact of the change in diets on obesity and health and (iii) The value attached by society to these changes, measured in life years gained, cost savings and quality-adjusted life years. Where evaluations have been inadequate, EATWELL will gather secondary data and analyse them with a multidisciplinary approach incorporating models from the psychology and economics disciplines. Particular attention will be paid to lessons that can be learned from private sector that are transferable to the healthy eating campaigns in the public sector. Through consumer surveys and workshops with other stakeholders, EATWELL will assess the acceptability of the range of potential interventions. Armed with scientific quantitative evaluations of policy interventions and their acceptability to stakeholders, EATWELL expects to recommend more appropriate interventions for Member States and the EU, providing a one-stop guide to methods and measures in interventions evaluation, and outline data collection priorities for the future.

Evaluation and management of the impact of land use change on the nitrogen and phosphorus load delivered to surface waters: the export coefficient modelling approach

A manageable, relatively inexpensive model was constructed to predict the loss of nitrogen and phosphorus from a complex catchment to its drainage system. The model used an export coefficient approach, calculating the total nitrogen (N) and total phosphorus (P) load delivered annually to a water body as the sum of the individual loads exported from each nutrient source in its catchment. The export coefficient modelling approach permits scaling up from plot-scale experiments to the catchment scale, allowing application of findings from field experimental studies at a suitable scale for catchment management. The catchment of the River Windrush, a tributary of the River Thames, UK, was selected as the initial study site. The Windrush model predicted nitrogen and phosphorus loading within 2% of observed total nitrogen load and 0.5% of observed total phosphorus load in 1989. The export coefficient modelling approach was then validated by application in a second research basin, the catchment of Slapton Ley, south Devon, which has markedly different catchment hydrology and land use. The Slapton model was calibrated within 2% of observed total nitrogen load and 2.5% of observed total phosphorus load in 1986. Both models proved sensitive to the impact of temporal changes in land use and management on water quality in both catchments, and were therefore used to evaluate the potential impact of proposed pollution control strategies on the nutrient loading delivered to the River Windrush and Slapton Ley

The integrated WRF/urban modelling system: development, evaluation, and applications to urban environmental problems

To bridge the gaps between traditional mesoscale modelling and microscale modelling, the National Center for Atmospheric Research, in collaboration with other agencies and research groups, has developed an integrated urban modelling system coupled to the weather research and forecasting (WRF) model as a community tool to address urban environmental issues. The core of this WRF/urban modelling system consists of the following: (1) three methods with different degrees of freedom to parameterize urban surface processes, ranging from a simple bulk parameterization to a sophisticated multi-layer urban canopy model with an indoor–outdoor exchange sub-model that directly interacts with the atmospheric boundary layer, (2) coupling to fine-scale computational fluid dynamic Reynolds-averaged Navier–Stokes and Large-Eddy simulation models for transport and dispersion (T&D) applications, (3) procedures to incorporate high-resolution urban land use, building morphology, and anthropogenic heating data using the National Urban Database and Access Portal Tool (NUDAPT), and (4) an urbanized high-resolution land data assimilation system. This paper provides an overview of this modelling system; addresses the daunting challenges of initializing the coupled WRF/urban model and of specifying the potentially vast number of parameters required to execute the WRF/urban model; explores the model sensitivity to these urban parameters; and evaluates the ability of WRF/urban to capture urban heat islands, complex boundary-layer structures aloft, and urban plume T&D for several major metropolitan regions. Recent applications of this modelling system illustrate its promising utility, as a regional climate-modelling tool, to investigate impacts of future urbanization on regional meteorological conditions and on air quality under future climate change scenarios. Copyright © 2010 Royal Meteorological Society

Climate change and heat-related mortality in six cities Part 2: climate model evaluation and projected impacts from changes in the mean and variability of temperature with climate change

Previous assessments of the impacts of climate change on heat-related mortality use the "delta method" to create temperature projection time series that are applied to temperature-mortality models to estimate future mortality impacts. The delta method means that climate model bias in the modelled present does not influence the temperature projection time series and impacts. However, the delta method assumes that climate change will result only in a change in the mean temperature but there is evidence that there will also be changes in the variability of temperature with climate change. The aim of this paper is to demonstrate the importance of considering changes in temperature variability with climate change in impacts assessments of future heat-related mortality. We investigate future heatrelated mortality impacts in six cities (Boston, Budapest, Dallas, Lisbon, London and Sydney) by applying temperature projections from the UK Meteorological Office HadCM3 climate model to the temperature-mortality models constructed and validated in Part 1. We investigate the impacts for four cases based on various combinations of mean and variability changes in temperature with climate change. The results demonstrate that higher mortality is attributed to increases in the mean and variability of temperature with climate change rather than with the change in mean temperature alone. This has implications for interpreting existing impacts estimates that have used the delta method. We present a novel method for the creation of temperature projection time series that includes changes in the mean and variability of temperature with climate change and is not influenced by climate model bias in the modelled present. The method should be useful for future impacts assessments. Few studies consider the implications that the limitations of the climate model may have on the heatrelated mortality impacts. Here, we demonstrate the importance of considering this by conducting an evaluation of the daily and extreme temperatures from HadCM3, which demonstrates that the estimates of future heat-related mortality for Dallas and Lisbon may be overestimated due to positive climate model bias. Likewise, estimates for Boston and London may be underestimated due to negative climate model bias. Finally, we briefly consider uncertainties in the impacts associated with greenhouse gas emissions and acclimatisation. The uncertainties in the mortality impacts due to different emissions scenarios of greenhouse gases in the future varied considerably by location. Allowing for acclimatisation to an extra 2°C in mean temperatures reduced future heat-related mortality by approximately half that of no acclimatisation in each city.

Microbial and biochemical soil quality indicators and their potential for differentiating areas under contrasting agricultural management regimes

The aim of this study was to examine interrelationships between functional biochemical and microbial indicators of soil quality, and their suitability to differentiate areas under contrasting agricultural management regimes. The study included five 0.8 ha areas on a sandy-loam soil which had received contrasting fertility and cropping regimes over a 5 year period. These were organically managed vegetable, vegetable -cereal and arable rotations, an organically managed grass clover ley, and a conventional cereal rotation. The organic areas had been converted from conventional cereal production 5 years prior to the start of the study. All of the biochemical analyses, including light fraction organic matter (LFOM) C and N, labile organic N (LON), dissolved organic N and water-soluble carbohydrates showed significant differences between the areas, although the nature of the relationships between the areas varied between the different parameters, and were not related to differences in total soil organic matter content. The clearest differences were seen in LFOM C and N and LON, which were higher in the organic arable area relative to the other areas. In the case of the biological parameters, there were differences between the areas for biomass-N, ATP, chitin content, and the ratios of ATP: biomass and basal respiration: biomass. For these parameters, the precise relationships between the areas varied. However, relative to the conventionally managed area, areas under organic management generally had lower biomass-N and higher ATP contents. Arbuscular mycorrhizal fungus colonization potential was extremely low in the conventional area relative to the organic areas. Further, metabolic diversity and microbial community level physiological profiles, determined by analysis of microbial community metabolism using Biolog GN plates and the activities of eight key nutrient cycling enzymes, grouped the organic areas together, but separated them from the conventional area. We conclude that microbial parameters are more effective and consistent indicators of management induced changes to soil quality than biochemical parameters, and that a variety of biochemical and microbial analyses should be used when considering the impact of management on soil quality. (C) 2004 Elsevier Ltd. All rights reserved.

A review of currently available in-stream water-quality models and their applicability for simulating dissolved oxygen in lowland rivers

In this paper, a review is undertaken of the major models currently in use for describing water quality in freshwater river systems. The number of existing models is large because the various studies of water quality in rivers around the world have often resulted in the construction of new 'bespoke' models designed for the particular situation of that study. However, it is worth considering models that are already available, since an existing model, suitable for the purposes of the study, will save a great deal of work and may already have been established within regulatory and legal frameworks. The models chosen here are SIMCAT, TOMCAT, QUAL2E, QUASAR, MIKE-11 and ISIS, and the potential for each model is examined in relation to the issue of simulating dissolved oxygen (DO) in lowland rivers. These models have been developed for particular purposes and this review shows that no one model can provide all of the functionality required. Furthermore, all of the models contain assumptions and limitations that need to be understood if meaningful interpretations of the model simulations are to. be made. The work is concluded with the view that it is unfair to set one model against another in terms of broad applicability, but that a model of intermediate complexity, such as QUASAR, is generally well suited to simulate DO in river systems. (C) 2003 Elsevier Science B.V. All rights reserved.

Autopoiesis vs. social autopoiesis: critical evaluation and implications for understanding firms as autopoietic social systems

The main objective of this study is to revisit the fundamental postulations of autopoietic self-production wrapped within the autopoietic six-point key and to investigate whether or not firms as specific social systems can be treated as autopoietic unities. In order to do so firms have to be defined as simple and composite unities whereupon their boundaries have to be clearly identifiable. The test of social autopoiesis reveals that firms can be viewed as autopoietic social systems that exist in the communicative space with employees' firm-specific communicative sub-domains as their components. Furthermore, it is argued that the social reification of autopoiesis (autokoinopoiesis) in firms is quintessentially interconnected with physical autopoiesis of their employees (autophysiopoiesis). Discontiguous focus on productivity as firms' obvious physical implication may thus be upgraded by a very social nature of ideactivity, firms' only real survival force.

Development of novel brush-type chiral stationary phases based on terpenoid selectors: HPLC evaluation and theoretical investigation of enantioselective binding interactions

The terpenoid chiral selectors dehydroabietic acid, 12,14-dinitrodehydroabietic acid and friedelin have been covalently linked to silica gel yielding three chiral stationary phases CSP 1, CSP 2 and CSP 3, respectively. The enantiodiscriminating capability of each one of these phases was evaluated by HPLC with four families of chiral aromatic compounds composed of alcohols, amines, phenylalanine and tryptophan amino acid derivatives and beta-lactams. The CSP 3 phase, containing a selector with a large friedelane backbone is particularly suitable for resolving free alcohols and their derivatives bearing fluorine substituents, while CSP 2 with a dehydroabietic architecture is the only phase that efficiently discriminates 1, 1'-binaphthol atropisomers. CSP 3 also gives efficient resolution of the free amines. All three phases resolve well the racemates of N-trifluoracetyl and N-3,5-dinitrobenzoyl phenylalanine amino acid ester derivatives. Good enantioseparation of beta-lactams and N-benzoyl tryptophan amino acid derivatives was achieved on CSP 1. In order to understand the structural factors that govern the chiral molecular recognition ability of these phases, molecular dynamics simulations were carried out in the gas phase with binary diastereomeric complexes formed by the selectors of CSP 1 and CSP 2 and several amino acid derivatives. Decomposition of molecular mechanics energies shows that van der Waals interactions dominate the formation of the diastereomeric transient complexes while the electrostatic binding interactions are primarily responsible for the enantioselective binding of the (R)- and (S)-analytes. Analysis of the hydrogen bonds shows that electrostatic interactions are mainly associated with the formation of N-(HO)-O-...=C enantio selective hydrogen bonds between the amide binding sites from the selectors and the carbonyl groups of the analytes. The role of mobile phase polarity, a mixture of n-hexane and propan-2-ol in different ratios, was also evaluated through molecular dynamics simulations in explicit solvent. (c) 2006 Elsevier Ltd. All rights reserved.

The graduate teacher programme in England: mentor training, quality assurance and the findings of inspection

In its recent report on the Graduate Teacher Programme (GTP), an employment-based route to Qualified Teacher Status (QTS) in England, the Government's Office for Standards in Education found that, although almost all trainees meet the standards required to qualify, too often they do so at an adequate level, rather than achieving the high levels of which they should be capable. The underlying reason for this is the quality of mentoring provided in the schools. The inspectors concluded that schoolbased trainers are often not adequately prepared for their role in implementing wide-ranging training programmes for trainee teachers. Despite this generally bleak picture, Ofsted concluded that 'the minority of cases of good practice in the training programmes and of high quality teaching by trainees indicate that the GTP can be an effective alternative route for training teachers'™. This article considers the strengths and weaknesses of the Graduate Teacher Programme, introduced in January 1998, and also reports on a small-scale project, funded by the Teacher Training Agency (TTA), the key objective of which was to strengthen the existing partnerships by improving the quality of school-based tutor training and continuous professional development of staff.

Rice seed quality development and temperature during late development and maturation

The potential longevity of japonica rice (Oryza sativa L. subsp. japonica) seed is particularly sensitive to high temperature – and thus climate change – during development and maturation. Cultivar Taipei 309 was grown at 28/208C (12 h/12 h) and then from 19 DAA (days after 50% anthesis), when seeds were just over half filled, at 28/208C, 30/228C, 32/248C or 34/268C (12 h/12 h). Whereas ability to germinate ex planta had been achieved in almost all seeds by 24 DAA, only half the population were desiccation tolerant. Desiccation tolerance continued to increase over the subsequent 28 d, similarly at all four temperatures. Subsequent longevity, assessed by p50 (period in days to reduce viability to 50% in hermetic storage at 408C with c. 15% moisture content), increased progressively at 28/208C until 38 DAA, and remained constant until the final harvest (52 DAA). The three warmer temperature regimes provided similar longevity to 28/208C at any one harvest, except at 38 DAA where the warmest (34/268C) was poorer. That temperature regime also provided greater seed-to-seed variability within each survival curve. The results confirm that appreciable improvement in seed quality occurs during seed development and also subsequent maturation in japonica rice, but that increase in temperature from 28/208C to 34/268C during late seed filling onwards has comparatively little effect thereon. Comparison with previous investigations suggests that seed quality development may be less sensitive to high temperatures during late development and maturation than during the early seed development that precedes it.