Polymer − surfactant vesicular complexes in aqueous medium

The introduction of ionic single-tailed surfactants to aqueous solutions of EO18BO10 [EO = poly(ethylene oxide), BO = poly(1,2-butylene oxide), subscripts denote the number of repeating units] leads to the formation of vesicles, as probed by laser scanning confocal microscopy. Dynamic light scattering showed that the dimensions of these aggregates at early stages of development do not depend on the sign of the surfactant head group charge. Small-angle X-ray scattering (SAXS) analysis indicated the coexistence of smaller micelles of different sizes and varying polymer content in solution. In strong contrast to the dramatic increase of size of dispersed particles induced by surfactants in dilute solution, the d-spacing of corresponding mesophases reduces monotonically upon increasing surfactant loading. This effect points to the suppression of vesicles as a consequence of increasing ionic strength in concentrated solutions. Maximum enhancements of storage modulus and thermal stability of hybrid gels take place at different compositions, indicating a delicate balance between the number and size of polymer-poor aggregates (population increases with surfactant loading) and the number and size of polymer−surfactant complexes (number and size decrease in high surfactant concentrations).

The role of dust in climate changes today, at the last glacial maximum and in the future.

Natural mineral aerosol (dust) is an active component of the climate system and plays multiple roles in mediating physical and biogeochemical exchanges between the atmosphere, land surface and ocean. Changes in the amount of dust in the atmosphere are caused both by changes in climate (precipitation, wind strength, regional moisture balance) and changes in the extent of dust sources caused by either anthropogenic or climatically induced changes in vegetation cover. Models of the global dust cycle take into account the physical controls on dust deflation from prescribed source areas (based largely on soil wetness and vegetation cover thresholds), dust transport within the atmospheric column, and dust deposition through sedimentation and scavenging by precipitation. These models successfully reproduce the first-order spatial and temporal patterns in atmospheric dust loading under modern conditions. Atmospheric dust loading was as much as an order-of-magnitude larger than today during the last glacial maximum (LGM). While the observed increase in emissions from northern Africa can be explained solely in terms of climate changes (colder, drier and windier glacial climates), increased emissions from other regions appear to have been largely a response to climatically induced changes in vegetation cover and hence in the extent of dust source areas. Model experiments suggest that the increased dust loading in tropical regions had an effect on radiative forcing comparable to that of low glacial CO2 levels. Changes in land-use are already increasing the dust loading of the atmosphere. However, simulations show that anthropogenically forced climate changes substantially reduce the extent and productivity of natural dust sources. Positive feedbacks initiated by a reduction of dust emissions from natural source areas on both radiative forcing and atmospheric CO2 could substantially mitigate the impacts of land-use changes, and need to be considered in climate change assessments.

Dust sources and deposition during the last glacial maximum and current climate: a comparison of model results with paleodata from ice cores and marine sediments

Mineral dust aerosols in the atmosphere have the potential to affect the global climate by influencing the radiative balance of the atmosphere and the supply of micronutrients to the ocean. Ice and marine sediment cores indicate that dust deposition from the atmosphere was at some locations 2–20 times greater during glacial periods, raising the possibility that mineral aerosols might have contributed to climate change on glacial-interglacial time scales. To address this question, we have used linked terrestrial biosphere, dust source, and atmospheric transport models to simulate the dust cycle in the atmosphere for current and last glacial maximum (LGM) climates. We obtain a 2.5-fold higher dust loading in the entire atmosphere and a twenty-fold higher loading in high latitudes, in LGM relative to present. Comparisons to a compilation of atmospheric dust deposition flux estimates for LGM and present in marine sediment and ice cores show that the simulated flux ratios are broadly in agreement with observations; differences suggest where further improvements in the simple dust model could be made. The simulated increase in high-latitude dustiness depends on the expansion of unvegetated areas, especially in the high latitudes and in central Asia, caused by a combination of increased aridity and low atmospheric [CO2]. The existence of these dust source areas at the LGM is supported by pollen data and loess distribution in the northern continents. These results point to a role for vegetation feedbacks, including climate effects and physiological effects of low [CO2], in modulating the atmospheric distribution of dust.