Gaze fixations predict brain activation during the voluntary regulation of picture-induced negative affect

Recent studies have identified a distributed network of brain regions thought to support cognitive reappraisal processes underlying emotion regulation in response to affective images, including parieto-temporal regions and lateral/medial regions of prefrontal cortex (PFC). A number of these commonly activated regions are also known to underlie visuospatial attention and oculomotor control, which raises the possibility that people use attentional redeployment rather than, or in addition to, reappraisal as a strategy to regulate emotion. We predicted that a significant portion of the observed variance in brain activation during emotion regulation tasks would be associated with differences in how participants visually scan the images while regulating their emotions. We recorded brain activation using fMRI and quantified patterns of gaze fixation while participants increased or decreased their affective response to a set of affective images. fMRI results replicated previous findings on emotion regulation with regulation differences reflected in regions of PFC and the amygdala. In addition, our gaze fixation data revealed that when regulating, individuals changed their gaze patterns relative to a control condition. Furthermore, this variation in gaze fixation accounted for substantial amounts of variance in brain activation. These data point to the importance of controlling for gaze fixation in studies of emotion regulation that use visual stimuli.

The effect of wilting and soaking Eupatorium adenophorum on its digestibility in vitro and voluntary intake by goats

An experiment was conducted to determine what effect simple treatments might have on the voluntary intake by goats in Nepal of Eupatorium adenophorum, an invasive weed that is usually only consumed by goats to a very limited extent. Samples of E. adenophorum were collected and either untreated, soaked for 2 h or wilted for 2 h before being oven dried (60 degrees C) and ground. Soaking and wilting had little effect on the chemical composition of E. adenophorum, but did increase (P=0.036) its in vitro organic matter degradability, by approximately 8%. The short-term intake rate (STIR) of treated and untreated E. adenophorum was then estimated with eight goats. Soaking time (from 2 to 24 h) was not related to STIR (r = -0.111, P=0.198), but the time E. adenophorum was left to wilt (from 2 to 48h), was positively related to STIR (r=0.521, P<0.001), with values of STIR (g dry matter/min kg goat liveweight(0.75)) being 0.405, 0.649,1.058, S.E.M. 0.088 for E. adenophorum, that had been wilted for 0, 24 and 48 h respectively (P<0.001). Liveweight change of goats and voluntary intake of E. adenophorum by goats was then estimated with 24 goats. E. adenophorum was fed either unwilted, or wilted for 24 or 48 h. It was fed as the sole forage or as a 3:1 mixture (dry matter basis) with Ficus cunia. There was a linear (P<0.001) and quadratic (P<0.01) increase in the intake of total forage and E. adenophorum with wilting time of E. adenophorum. Offering Ficus cunia increased total forage intake, but decreased E. adenophorum intake (P<0.05). After four weeks, there was virtually no change in goat liveweight and no significant difference between treatments. The results suggest that wilting E adenophorum for 24 h could increase its intake by goats, and thereby increase its usefulness, as a potential source of forage in the dry season of Nepal, when forage scarcity is a common constraint to livestock production. (C) 2007 Elsevier B.V. All rights reserved.

The parallel programming of voluntary and reflexive saccades

A novel two-step paradigm was used to investigate the parallel programming of consecutive, stimulus-elicited ('reflexive') and endogenous ('voluntary') saccades. The mean latency of voluntary saccades, made following the first reflexive saccades in two-step conditions, was significantly reduced compared to that of voluntary saccades made in the single-step control trials. The latency of the first reflexive saccades was modulated by the requirement to make a second saccade: first saccade latency increased when a second voluntary saccade was required in the opposite direction to the first saccade, and decreased when a second saccade was required in the same direction as the first reflexive saccade. A second experiment confirmed the basic effect and also showed that a second reflexive saccade may be programmed in parallel with a first voluntary saccade. The results support the view that voluntary and reflexive saccades can be programmed in parallel on a common motor map. (c) 2006 Elsevier Ltd. All rights reserved.

Development and experimental identification of a biomechanical model of the trunk for functional electrical stimulation control in paraplegia

Objectives. Theoretic modeling and experimental studies suggest that functional electrical stimulation (FES) can improve trunk balance in spinal cord injured subjects. This can have a positive impact on daily life, increasing the volume of bimanual workspace, improving sitting posture, and wheelchair propulsion. A closed loop controller for the stimulation is desirable, as it can potentially decrease muscle fatigue and offer better rejection to disturbances. This paper proposes a biomechanical model of the human trunk, and a procedure for its identification, to be used for the future development of FES controllers. The advantage over previous models resides in the simplicity of the solution proposed, which makes it possible to identify the model just before a stimulation session ( taking into account the variability of the muscle response to the FES). Materials and Methods. The structure of the model is based on previous research on FES and muscle physiology. Some details could not be inferred from previous studies, and were determined from experimental data. Experiments with a paraplegic volunteer were conducted in order to measure the moments exerted by the trunk-passive tissues and artificially stimulated muscles. Data for model identification and validation also were collected. Results. Using the proposed structure and identification procedure, the model could adequately reproduce the moments exerted during the experiments. The study reveals that the stimulated trunk extensors can exert maximal moment when the trunk is in the upright position. In contrast, previous studies show that able-bodied subjects can exert maximal trunk extension when flexed forward. Conclusions. The proposed model and identification procedure are a successful first step toward the development of a model-based controller for trunk FES. The model also gives information on the trunk in unique conditions, normally not observable in able-bodied subjects (ie, subject only to extensor muscles contraction).

On the maximal connected component of hypercube with faulty vertices

In evaluating an interconnection network, it is indispensable to estimate the size of the maximal connected components of the underlying graph when the network begins to lose processors. Hypercube is one of the most popular interconnection networks. This article addresses the maximal connected components of an n -dimensional cube with faulty processors. We first prove that an n -cube with a set F of at most 2n - 3 failing processors has a component of size greater than or equal to2(n) - \F\ - 1. We then prove that an n -cube with a set F of at most 3n - 6 missing processors has a component of size greater than or equal to2(n) - \F\ - 2.

On the maximal connected component of hypercube with faulty vertices (II)

evaluating the fault tolerance of an interconnection network, it is essential to estimate the size of a maximal connected component of the network at the presence of faulty processors. Hypercube is one of the most popular interconnection networks. In this paper, we prove that for ngreater than or equal to6, an n-dimensional cube with a set F of at most (4n-10) failing processors has a component of size greater than or equal to2"-\F-3. This result demonstrates the superiority of hypercube in terms of the fault tolerance.

On the maximal connected component of a hypercube with faulty vertices III

Hypercube is one of the most popular topologies for connecting processors in multicomputer systems. In this paper we address the maximum order of a connected component in a faulty cube. The results established include several known conclusions as special cases. We conclude that the hypercube structure is resilient as it includes a large connected component in the presence of large number of faulty vertices.