Differences in phosphorus retention and release in soils amended with animal manures and sewage sludge

Excessive levels of P in agricultural soils pose a threat to local water quality. This study evaluated (i) time-dependent changes in soil P sorption (expressed as a phosphorus sorption index, PSI) and P availability (as resin P) during incubation (100 d) with poultry litter, cattle slurry, sewage sludge, or KH2PO4, added on a P-equivalent basis (100 mg P kg(-1)), and (ii) the subsequent kinetics of P release, measured by repeated extractions with a mixed cation-anion exchange resin. Soil exchangeable Ca and ammonium oxalate-extractable Fe and Al were also determined at 100 d of incubation. The small decrease in P sorption in the litter and sludge treatments (25%), compared with that in the slurry and KH2PO4 treatments (52%) between 20 and 100 d of incubation was attributed partly to the formation of new adsorption sites for P. Subsequent P release was described by a power equation: Resin P = a(extraction number)(b), where the constants a and b represent resin P obtained with a single extraction and the rate of P release per resin extraction, respectively. On average, the rate of P release decreased in the order: KH2PO4 and slurry > litter > sludge, and was inversely related to exchangeable Ca content of the incubated soils (R-2 = 0.57). The slower rates of P release in the litter and sludge treatments (P < 0.001) are attributed to the large values for exchangeable Ca (1050-2640 and 1070-2710 mg kg(-1), respectively) in these amended soils. Future research concerned with short-term declines in environmentally harmful levels of P in recently amended soils should consider the differential effects of the amendments on soil P dynamics.

The soil-dwelling earthworm Allolobophora chlorotica modifies its burrowing behaviour in response to carbendazim applications

Carbendazim-amended soil was placed above or below unamended soil. Control tests comprised two layers of unamended soil. Allolobophora chlorotica earthworms were added to either the upper or the unamended soil. After 72 h vertical distributions of earthworms were compared between control and carbendazim-amended experiments. Earthworm distributions in the carbendazim-amended test containers differed significantly from the ‘normal’ distribution observed in the control tests. In the majority of the experiments, earthworms significantly altered their burrowing behaviour to avoid carbendazim. However, when earthworms were added to an upper layer of carbendazim-amended soil they remained in this layer. This non-avoidance is attributed to (1) the earthworms’ inability to sense the lower layer of unamended soil and (2) the toxic effect of carbendazim inhibiting burrowing. Earthworms modified their burrowing behaviour in response to carbendazim in the soil. This may explain anomalous results observed in pesticide field trials when carbendazim is used as a control substance.

Physiological mechanisms mediating aspartame-induced satiety

Aspartame has been previously shown to increase satiety. This study aimed to investigate a possible role for the satiety hormones cholecystokinin (CCK) and glucagon-like peptide-1 (GLP-1) in this effect. The effects of the constituents of aspartame, phenylalanine and aspartic acid, were also examined. Six subjects consumed an encapsulated preload consisting of either 400 mg aspartame, 176 mg aspartic acid + 224 mg phenylalanine, or 400 mg corn flour (control), with 1.5 g paracetamol dissolved in 450 ml water to measure gastric emptying. A 1983-kJ liquid meal was consumed 60 min later. Plasma CCK, GLP-1, glucose-dependent insulinotropic polypeptide (GIP), glucose, and insulin were measured over 0-120 min. Gastric emptying was measured from 0 to 60 min. Plasma GLP-1 concentrations decreased following the liquid meal (60-120 min) after both the aspartame and amino acids preloads (control, 2096.9 pmol/l min; aspartame, 536.6 pmol/l min; amino acids, 861.8 pmol/l min; incremental area under the curve [AUC] 60-120 min, P<.05). Desire to cat was reduced from 60 to 120 min following the amino acids preload (control, -337.1 mm min; aspartame, -505.4 mm min; amino acids, -1497.1 mm min; incremental AUC 60-120 min, P<.05). However, gastric emptying rates, plasma CCK, GIP, insulin, and glucose concentrations were unaffected. There was a correlation between the increase in plasma phenylalanine and decrease in desire to eat after the liquid meal following the constituent amino acids (r = -.9774, P=.004). In conclusion, it is unlikely that aspartame increases satiety via CCK- or GLP-1-mediated mechanisms, but small changes in circulating phenylalanine concentrations may influence appetite. (C) 2003 Elsevier Science Inc. All rights reserved.

Characterisation of blends based on hydroxyethylcellulose and maleic acid-alt-methyl vinyl ether

Hydrophilic polymeric films based on blends of hydroxyethylcellulose and maleic acid-co-methyl vinyl ether were produced by casting from aqueous solutions. The physicochemical properties of the blends have been assessed using Fourier transform infrared spectroscopy, thermal gravimetric analysis, differential scanning calorimetry, dielectric spectroscopy, etc. The pristine films exhibit complete miscibility due to the formation of intermacromolecular hydrogen bonding. The thermal treatment of the blend films leads to cross-linking via intermacromolecular esterification and anhydride formation. The cross-linked materials are able to swell in water and their swelling degree can be easily controlled by temperature and thermal treatment time. The formation of the crosslinks is apparent in the dynamic properties of the blends as observed through the mechanical relaxation and dielectric relaxation spectra. The dielectric characteristics of the material are influenced by the effects of change in the local structure of the blend on the ionic conduction processes and the rate of dipolar relaxation. Separation of these processes is attempted using the dielectric modulus method. Significant deviations from a simple additive rule of mixing on the activation energy are observed consistent with hydrogen bonding and crosslinking of the matrix. This paper indicates a method for the creation of films with good mechanical and physical characteristics by exposing the blends to a relatively mild thermal treatment.

On the recursive sequence Xn = axn-1+bxn-2/c+dxn-1xn-2

In this Paper, we study the invariant intervals, the global attractivity of the equilibrium points, and the asymptotic behavior of the solutions of the difference equation x(n) = ax(n-1) + bx(n-2) / c + dx(n-1)x(n-2), n =1, 2, ..., where a greater than or equal to 0, b, c, d > 0. (C) 2004 Elsevier Inc. All rights reserved.

Optical sensors for monitoring water uptake in plants

The monitoring of water uptake in plants is becoming increasingly important. Optical sensors offer considerable advantages over conventional methods and several sensors have been developed including an optical potometer that monitors water uptake from individual roots, the detection of xylem cavitation using audio acoustic emissions with an interferometric force feedback microphone, and an optical fiber displacement transducer that detects changes in leaf thickness in relation to leaf-water potential.

Thesaurus

Encyclopedia entry on lexical and conceptual "thesauri"

The study of chiral adsorption systems using synchrotron- based structural and spectroscopic techniques: stereospecific adsorption of serine on Au-modified chiral Cu{531} surfaces

We apply modern synchrotron-based structural techniques to the study of serine adsorbed on the pure andAumodified intrinsically chiral Cu{531} surface. XPS and NEXAFS data in combination with DFT show that on the pure surface both enantiomers adsorb in l4 geometries (with de-protonated b-OH groups) at low coverage and in l3 geometries at saturation coverage. Significantly larger enantiomeric differences are seen for the l4 geometries, which involve substrate bonds of three side groups of the chiral center, i.e. a three-point interaction. The l3 adsorption geometry, where only the carboxylate and amino groups form substrate bonds, leads to smaller but still significant enantiomeric differences, both in geometry and the decomposition behavior. When Cu{531} is modified by the deposition of 1 and 2ML Au the orientations of serine at saturation coverage are significantly different from those on the clean surface. In all cases, however, a l3 bond coordination is found at saturation involving different numbers of Au atoms, which leads to relatively small enantiomeric differences.