Growth, yield and development of strawberry cv. 'Elsanta' under novel photoselective film clad greenhouses

Film greenhouse claddings are typically used to protect horticultural crops from low temperature and high rainfall conditions. However, a range of novel plastic films have been developed which filter specific radiation wavelengths with the aim of providing the grower with greater control of crop growth and development. A replicated experiment was conducted in 8 small experimental greenhouses, covered with different photoselective films characterised by a range of red/far-red ratios and PAR transmissions to study their effects on the growth, yield and quality of the strawberry cv. 'Elsanta'. Marketable yield per plant was 51% greater under the film with the highest light transmission (control) compared with the lower light transmission films. Similarly, unmarketable fruit number and average non-marketable individual fruit weight per plant was lowest under films with higher light transmissions and higher under lower light transmission films. Cropping duration was longer under films with high R/FR. Also plants under high R/FR were more compact (due to shorter petiole lengths) compared to plants grown under low R/FR. The results are discussed in relation to the increased use of photoselective films in protected horticulture and the need for higher quality fruit and vegetables.

Analysis of physiological data from the International Clonal Trial (CFC)

A range of physiological parameters (canopy light transmission, canopy shape, leaf size, flowering and flushing intensity) were measured from the International Clone Trial, typically over the course of two years. Data were collected from six locations, these being: Brazil, Ecuador, Trinidad, Venezuela, Côte d’Ivoire and Ghana. Canopy shape varied significantly between clones, although it showed little variation between locations. Genotypic variation in leaf size was differentially affected by the growth location; such differences appeared to underlie a genotype by environment interaction in relation to canopy light transmission. Flushing data were recorded at monthly intervals over the course of a year. Within each location, a significant interaction was observed between genotype and time of year, suggesting that some genotypes respond to a greater extent than others to environmental stimuli. A similar interaction was observed for flowering data, where significant correlations were found between flowering intensity and temperature in Brazil and flowering intensity and rainfall in Côte d’Ivoire. The results demonstrate the need for local evaluation of cocoa clones and also suggest that the management practices for particular planting material may need to be fine-tuned to the location in which they are cultivated.

The role of the international cocoa germplasm database and the international cocoa quarantine centre in information management and distribution of cocoa genetic resources

A range of physiological parameters (canopy light transmission, canopy shape, leaf size, flowering and flushing intensity) were measured from the International Clone Trial, typically over the course of two years. Data were collected from six locations, these being: Brazil, Ecuador, Trinidad, Venezuela, Côte d’Ivoire and Ghana. Canopy shape varied significantly between clones, although it showed little variation between locations. Genotypic variation in leaf size was differentially affected by the growth location; such differences appeared to underlie a genotype by environment interaction in relation to canopy light transmission. Flushing data were recorded at monthly intervals over the course of a year. Within each location, a significant interaction was observed between genotype and time of year, suggesting that some genotypes respond to a greater extent than others to environmental stimuli. A similar interaction was observed for flowering data, where significant correlations were found between flowering intensity and temperature in Brazil and flowering intensity and rainfall in Côte d’Ivoire. The results demonstrate the need for local evaluation of cocoa clones and also suggest that the management practices for particular planting material may need to be fine-tuned to the location in which they are cultivated.

Far-red light filtering by plastic film, greenhouse-cladding materials: effects on growth and flowering in Petunia and Impatiens

Photoselective plastic films with low transmission to far-red (FR) light (700-800 nm) are now available so that plants grown in greenhouses clad with such plastics exhibit reduced stem extension and, consequently, plant height. Here we compare the action of three FR-absorbing polythene films on extension growth of Petunia (Petunia X hybrida) cv. 'Express Blue' and Impatiens walleriana cv. 'Accent Deep Pink' with plants grown under a control polythene film (standard UVI/EVA film). Half of the plants under the control film were treated with a chemical plant growth regulator (PGR; diaminozide, B-Nine) and half were sprayed with water alone. Possible negative effects of such film plastics on flowering, and on fresh and dry weight accumulation, were also quantified. Plants were harvested destructively when all plants in each treatment had reached the first open flower stage. In Petunia, plant height was reduced by all three FR-filtering films and by PGR-treatment. The FR-filtering films giving the highest R:FR ratios also reduced plant height in Impatiens. Leaf number, leaf area and total dry Weight in both species. were greatest in the controls and smallest under films with the lowest PAR transmission. The film giving the highest R:FR ratio and PAR transmission also produced the most compact Petunia plants;, while the film. with. the lowest PAR transmission produced the least compact plants in both species. There was no significant effect of treatments on time to first flower in Impatiens. However, Petunia plants under low PAR transmission films took longer to flower. Plastic-films which filter out FR light to increase the R:FR ratio, combined With high PAR transmission, can therefore be used as an alternative to conventional PGRs.

Transmission of social anxiety from mother to infant: an experimental study using a social referencing paradigm

In this experiment we investigated the impact of indirect expressions of maternal social anxiety on infant interactions with a stranger. A social referencing paradigm was used in which infants first observed their mothers interacting with a stranger and then interacted with the stranger themselves. Mothers made no direct communicative gestures to the infant concerning the stranger throughout the procedure. There were two experimental conditions experienced by all mother-infant pairs (N = 24; 12 boys)-non-anxious and socially anxious-and there were two male strangers. Infants were between 12 and 14 months (M = 12.8, SD =.76). Order of condition and stranger presentation were counterbalanced. Before testing, mothers, none of whom were significantly socially anxious, were trained to behave in a non-anxious and a socially anxious manner on the basis of clinical and empirical descriptions of social phobia. The results showed that, compared to their responses following their mothers interacting normally with a stranger, following a socially anxious mother-stranger interaction, infants were significantly more fearful and avoidant with the stranger. Infant-stranger avoidance was further modified by infant temperament; high fear infants were more avoidant in the socially anxious condition than low-fear infants. We discuss these findings in light of the possible mechanisms underpinning infant affective and behavioral responsiveness. (c) 2005 Elsevier Ltd. All rights reserved

A transmission electron microscopy study of polymer-stabilised liquid crystal structure

A method has been established for observing the internal structure of the network component of polymer-stabilised liquid crystals. In situ photopolymerisation of a mesogenic diacrylate monomer using ultraviolet light leads to a sparse network (∼1 wt%) within a nematic host. Following polymerisation, the host was removed through dissolution in heptane, revealing the network. In order to observe a cross-section through the network, it was embedded in a resin and then sectioned using an ultramicrotome. However, imaging of the network was not possible due to poor contrast. To improve this, several reagents were used for network staining, but only one was successful: bromine. The use of a Melinex-resin composite for sectioning was also found to be advantageous. Imaging of the network using transmission electron microscopy revealed solid “droplets” of width 0.07–0.20 μm, possessing an open, yet homogeneous structure, with no evidence for any large-scale internal structures.

Raytracing simulation for predicting light pipe transmittance

Daylighting systems can offer energy savings primarily by reducing electric lighting usage. Accurate predictive models of daylighting system performances are crucial for effective design and implementation of this renewable energy technology. A comparative study of predictive methods was performed and the use of a commercial raytracing software program was validated as a method of predicting light pipe performance. Raytracing simulation was shown to more accurately predict transmission effi ciency than existing analytical methods.