Remote sensing of intertidal morphological change in Morecambe Bay, U.K., between 1991 and 2007

Tidal Flats are important examples of extensive areas of natural environment that remain relatively unaffected by man. Monitoring of tidal flats is required for a variety of purposes. Remote sensing has become an established technique for the measurement of topography over tidal flats. A further requirement is to measure topographic changes in order to measure sediment budgets. To date there have been few attempts to make quantitative estimates of morphological change over tidal flat areas. This paper illustrates the use of remote sensing to measure quantitative and qualitative changes in the tidal flats of Morecambe Bay during the relatively long period 1991–2007. An understanding of the patterns of sediment transport within the Bay is of considerable interest for coastal management and defence purposes. Tidal asymmetry is considered to be the dominant cause of morphological change in the Bay, with the higher currents associated with the flood tide being the main agency moulding the channel system. Quantitative changes were measured by comparing a Digital Elevation Model (DEM) of the intertidal zone formed using the waterline technique applied to satellite Synthetic Aperture Radar (SAR) images from 1991–1994, to a second DEM constructed from airborne laser altimetry data acquired in 2005. Qualitative changes were studied using additional SAR images acquired since 2003. A significant movement of sediment from below Mean Sea Level (MSL) to above MSL was detected by comparing the two Digital Elevation Models, though the proportion of this change that could be ascribed to seasonal effects was not clear. Between 1991 and 2004 there was a migration of the Ulverston channel of the river Leven north-east by about 5 km, followed by the development of a straighter channel to the west, leaving the previous channel decoupled from the river. This is thought to be due to independent tidal and fluvial forcing mechanisms acting on the channel. The results demonstrate the effectiveness of remote sensing for measurement of long-term morphological change in tidal flat areas. An alternative use of waterlines as partial bathymetry for assimilation into a morphodynamic model of the coastal zone is also discussed.

Bt cotton, pesticides, labour and health - A case study of smallholder farmers in the Makhathini Flats, Republic of South Africa

This paper describes some of the results of a detailed farm-level survey of 32 small-scale cotton farmers in the Makhathini Flats region of South Africa. The aim was to assess and measure some of the impacts (especially in terms of savings in pesticide and labour as well as benefits to human health) attributable to the use of insect-tolerant Bt cotton. The study reveals a direct cost benefit for Bt growers of SAR416 ($51) per hectare per season due to a reduction in the number of insecticide applications. Cost savings emerged in the form of lower requirements for pesticide, but also important were reduced requirements for water and labour. The reduction in the number of sprays was particularly beneficial to women who do some spraying and children who collect water and assist in spraying. The increasing adoption rate of Bt cotton appears to have a health benefit measured in terms of reported rates of accidental insecticide poisoning. These appear to be declining as the uptake of Bt cotton increases. However, the understanding of refugia and their management by local farmers are deficient and need improving. Finally, Bt cotton growers emerge as more resilient in absorbing price fluctuations.

Extraction of tidal channel networks from aerial photographs alone and combined with laser altimetry

Tidal channel networks play an important role in the intertidal zone, exerting substantial control over the hydrodynamics and sediment transport of the region and hence over the evolution of the salt marshes and tidal flats. The study of the morphodynamics of tidal channels is currently an active area of research, and a number of theories have been proposed which require for their validation measurement of channels over extensive areas. Remotely sensed data provide a suitable means for such channel mapping. The paper describes a technique that may be adapted to extract tidal channels from either aerial photographs or LiDAR data separately, or from both types of data used together in a fusion approach. Application of the technique to channel extraction from LiDAR data has been described previously. However, aerial photographs of intertidal zones are much more commonly available than LiDAR data, and most LiDAR flights now involve acquisition of multispectral images to complement the LiDAR data. In view of this, the paper investigates the use of multispectral data for semiautomatic identification of tidal channels, firstly from only aerial photographs or linescanner data, and secondly from fused linescanner and LiDAR data sets. A multi-level, knowledge-based approach is employed. The algorithm based on aerial photography can achieve a useful channel extraction, though may fail to detect some of the smaller channels, partly because the spectral response of parts of the non-channel areas may be similar to that of the channels. The algorithm for channel extraction from fused LiDAR and spectral data gives an increased accuracy, though only slightly higher than that obtained using LiDAR data alone. The results illustrate the difficulty of developing a fully automated method, and justify the semi-automatic approach adopted.

Bt cotton, pesticides, labour and health - A case study of smallholder farmers in the Makhathini Flats, Republic of South Africa

This paper describes some of the results of a detailed farm-level survey of 32 small-scale cotton farmers in the Makhathini Flats region of South Africa. The aim was to assess and measure some of the impacts (especially in terms of savings in pesticide and labour as well as benefits to human health) attributable to the use of insect-tolerant Bt cotton. The study reveals a direct cost benefit for Bt growers of SAR416 ($51) per hectare per season due to a reduction in the number of insecticide applications. Cost savings emerged in the form of lower requirements for pesticide, but also important were reduced requirements for water and labour. The reduction in the number of sprays was particularly beneficial to women who do some spraying and children who collect water and assist in spraying. The increasing adoption rate of Bt cotton appears to have a health benefit measured in terms of reported rates of accidental insecticide poisoning. These appear to be declining as the uptake of Bt cotton increases. However, the understanding of refugia and their management by local farmers are deficient and need improving. Finally, Bt cotton growers emerge as more resilient in absorbing price fluctuations.

A comparative study of the main mechanisms controlling indoor air pollution in residential flats

The relative contribution of the main mechanisms that control indoor air quality in residential flats was examined. Indoor and outdoor concentration measurements of different type pollutants (black carbon, SO2, O3, NO, NO2,) were monitored in three naturally ventilated residential flats in Athens, Greece. At each apartment, experiments were conducted during the cold as well as during the warm period of the year. The controlling parameters of transport and deposition mechanisms were calculated from the experimental data. Deposition rates of the same pollutant differ according to the site (different construction characteristics) and to the measuring period for the same site (variations in relative humidity and differences in furnishing). Differences in the black carbon deposition rates were attributed to different black carbon size distributions. The highest deposition rates were observed for O3 in the residential flats with the older construction and the highest humidity levels. The calculated parameters as well as the measured outdoor concentrations were used as input data of a one-compartment indoor air quality model, and the indoor concentrations, the production, and loss rates of the different pollutants were calculated. The model calculated concentrations are in good agreement with the measured values. Model simulations revealed that the mechanism that mainly affected the change rate of indoor black carbon concentrations was the transport from the outdoor environment, while the removal due to deposition was insignificant. During model simulations, it was also established that that the change rate of SO2 concentrations was governed by the interaction between the transport and the deposition mechanisms while NOX concentrations were mainly controlled through photochemical reactions and the transport from outdoors.

Mesolithic to Neolithic and medieval coastal environmental change: intertidal survey at Woolaston, Gloucestershire

At Woolaston on the western shores of the middle Severn Estuary c. 7 km upstream of Chepstow intertidal Holocene sediment exposures have been surveyed and the stratigraphic sequence established by coring and limited excavation. There are two main peats each with a submerged forest. An existing dendrochronological sequence for the Upper Submerged Forest has been extended and the preliminary results of pollen analysis from the peat sequence are summarised. A few flint flakes were found but were not stratified in the mid-Holocene sequence. There is evidence for late Mesolithic / early Neolithic burning episodes which may relate to human activity. Evidence is reported for Medieval activity and the extensive modification of drainage in this period is suggested.