Characterization of mineral surfaces using FIB and TEM: a case study of naturally weathered alkali feldspars

Using a focused ion beam (FIB) instrument, electron-transparent samples (termed foils) have been cut from the naturally weathered surfaces of perthitic alkali feldspars recovered from soils overlying the Shap granite, northwest England. Characterization of these foils by transmission electron microscopy (TEM) has enabled determination of the crystallinity and chemical composition of near-surface regions of the feldspar and an assessment of the influence of intragranular microtextures on the microtopography of grain surfaces and development of etch pits. Damage accompanying implantation of the 30 kV Ga+ ions used for imaging and deposition of protective platinum prior to ion milling creates amorphous layers beneath outer grain surfaces, but can be overcome by coating grains with > 85 nm of gold before FIB work. The sidewalls of the foil and feldspar surrounding original voids are also partially amorphized during later stages of ion milling. No evidence was found for the presence of amorphous or crystalline weathering products or amorphous "leached layers" immediately beneath outer grain surfaces. The absence of a leached layer indicates that chemical weathering of feldspar in the Shap soils is stoichiometric, or if non-stoichiometric, either the layer is too thin to resolve by the TEM techniques used (i.e., <=similar to 2.5 nm) or an insufficient proportion of ions have been leached from near-surface regions so that feldspar crystallinity is maintained. No evidence was found for any difference in the mechanisms of weathering where a microbial filament rests on the feldspar surface. Sub-micrometer-sized steps on the grain surface have formed where subgrains and exsolution lamellae have influenced the propagation of fractures during physical weathering, whereas finer scale corrugations form due to compositional or strain-related differences in dissolution rates of albite platelets and enclosing tweed orthoclase. With progressive weathering, etch pits that initiated at the grain surface extend into grain interiors as etch tubes by exploiting preexisting networks of nanopores that formed during the igneous history of the grain. The combination of FIB and TEM techniques is an especially powerful way of exploring mechanisms of weathering within the "internal zone" beneath outer grain surfaces, but results must be interpreted with caution owing to the ease with which artifacts can be created by the high-energy ion and electron beams used in the preparation and characterization of the foils.

Mesozoic climates: General circulation models and the rock record

General circulation models (GCMs) use the laws of physics and an understanding of past geography to simulate climatic responses. They are objective in character. However, they tend to require powerful computers to handle vast numbers of calculations. Nevertheless, it is now possible to compare results from different GCMs for a range of times and over a wide range of parameterisations for the past, present and future (e.g. in terms of predictions of surface air temperature, surface moisture, precipitation, etc.). GCMs are currently producing simulated climate predictions for the Mesozoic, which compare favourably with the distributions of climatically sensitive facies (e.g. coals, evaporites and palaeosols). They can be used effectively in the prediction of oceanic upwelling sites and the distribution of petroleum source rocks and phosphorites. Models also produce evaluations of other parameters that do not leave a geological record (e.g. cloud cover, snow cover) and equivocal phenomena such as storminess. Parameterisation of sub-grid scale processes is the main weakness in GCMs (e.g. land surfaces, convection, cloud behaviour) and model output for continental interiors is still too cold in winter by comparison with palaeontological data. The sedimentary and palaeontological record provides an important way that GCMs may themselves be evaluated and this is important because the same GCMs are being used currently to predict possible changes in future climate. The Mesozoic Earth was, by comparison with the present, an alien world, as we illustrate here by reference to late Triassic, late Jurassic and late Cretaceous simulations. Dense forests grew close to both poles but experienced months-long daylight in warm summers and months-long darkness in cold snowy winters. Ocean depths were warm (8 degrees C or more to the ocean floor) and reefs, with corals, grew 10 degrees of latitude further north and south than at the present time. The whole Earth was warmer than now by 6 degrees C or more, giving more atmospheric humidity and a greatly enhanced hydrological cycle. Much of the rainfall was predominantly convective in character, often focused over the oceans and leaving major desert expanses on the continental areas. Polar ice sheets are unlikely to have been present because of the high summer temperatures achieved. The model indicates extensive sea ice in the nearly enclosed Arctic seaway through a large portion of the year during the late Cretaceous, and the possibility of sea ice in adjacent parts of the Midwest Seaway over North America. The Triassic world was a predominantly warm world, the model output for evaporation and precipitation conforming well with the known distributions of evaporites, calcretes and other climatically sensitive facies for that time. The message from the geological record is clear. Through the Phanerozoic, Earth's climate has changed significantly, both on a variety of time scales and over a range of climatic states, usually baldly referred to as "greenhouse" and "icehouse", although these terms disguise more subtle states between these extremes. Any notion that the climate can remain constant for the convenience of one species of anthropoid is a delusion (although the recent rate of climatic change is exceptional). (c) 2006 Elsevier B.V. All rights reserved.

Structures of Pd(CN)2and Pt(CN)2: intrinsically nanocrystalline materials?

Analysis and modeling of X-ray and neutron Bragg and total diffraction data show that the compounds referred to in the literature as “Pd(CN)2”and“Pt(CN)2” are nanocrystalline materials containing of small sheets of vertex-sharing square-planar M(CN)4 units, layered in a disordered manner with an intersheet separation of 3.44 A at 300 K. The small size of the crystallites means that the sheets’ edges form a significant fraction of each material. The Pd(CN)2 nanocrystallites studied using total neutron diffraction are terminated by water and the Pt(CN)2 nanocrystallites by ammonia, in place of half of the terminal cyanide groups, thus maintaining charge neutrality. The neutron samples contain sheets of approximate dimensions 30 A x 30 A. For sheets of the size we describe, our structural models predict compositions of Pd(CN)2-xH2O and Pt(CN)2-yNH3 (x = y = 0.29). These values are in good agreement with those obtained from total neutron diffraction and thermal analysis, and are also supported by infrared and Raman spectroscopy measurements. It is also possible to prepare related compounds Pd(CN)2-pNH3 and Pt(CN)2-qH2O, in which the terminating groups are exchanged. Additional samples showing sheet sizes in the range 10 A x 10 A (y = 0.67) to 80 A x 80 A (p = q = 0.12), as determined by X-ray diffraction, have been prepared. The related mixed-metal phase, Pd1/2Pt1/2(CN)2-qH2O(q = 0.50), is also nanocrystalline (sheet size 15 A x 15 A). In all cases, the interiors of the sheets are isostructural with those found in Ni(CN)2. Removal of the final traces of water or ammonia by heating results in decomposition of the compounds to Pd and Pt metal, or in the case of the mixed-metal cyanide, the alloy, Pd1/2Pt1/2, making it impossible to prepare the simple cyanides, Pd(CN)2, Pt(CN)2 or Pd1/2Pt1/2(CN)2, by this method.

Interior Life

Interior Life was curated by Tim Renshaw, Mary Maclean and Bernice Donszelmann who together form ‘Outside Architecture’. The aim of this project was to argue that interior space should not be negatively defined as a retreat from the public realm. Instead, following the thought of the philosopher Peter Slotterdijk, interior space was proposed as a human need. The five artists selected by ‘Outside Architecture’ each visualized this need differently. A contention here was that interiors give rise to a multiplicity of experiences that potentially change the way we dwell in contemporary man-made space. This contention was primarily figured in relation to the materiality of contemporary interiors. Each gave attention to the effects of contemporary materials and surfaces and each considered that these forms produce new modes of sensing and immersion in a place. The exhibition included two talks by the members of ‘Outside Architecture. The project was supported by an Arts Council of England grant of £6,323 www.ucreative.ac.uk/galleries

Portals to the world: technological extensions to the boundaries of the home

This article examines the ways that technological objects inside the home are viewed and productively used by a group of older people to extend their access to environments beyond the home. Beginning with a discussion of types of domestic object, we highlight appliances and gadgets, and focus our attentions on the latter. The changes in life brought on by ageing, in particular a reduction in mobility, provide the context for our study, in which access to the outside world becomes increasingly difficult. Recognising their changing circumstances led our participants to actively and selectively engage with these objects, mitigating the shrinking of their accessible environment by using them as a gateway to the many virtual worlds now available. We coin the term ‘portal objects’ to describe the potential that this type of technological object provides, and suggest that the investigation of interiors can be enriched by recognising and including the worlds outside that become integral to occupation inside.

Intercomparison of simulated global vegetation distribution in response to 6 kyr BP orbital forcing

The response of ten atmospheric general circulation models to orbital forcing at 6 kyr BP has been investigated using the BIOME model, which predicts equilibrium vegetation distribution, as a diagnostic. Several common features emerge: (a) reduced tropical rain forest as a consequence of increased aridity in the equatorial zone, (b) expansion of moisture-demanding vegetation in the Old World subtropics as a consequence of the expansion of the Afro–Asian monsoon, (c) an increase in warm grass/shrub in the Northern Hemisphere continental interiors in response to warming and enhanced aridity, and (d) a northward shift in the tundra–forest boundary in response to a warmer growing season at high northern latitudes. These broadscale features are consistent from model to model, but there are differences in their expression at a regional scale. Vegetation changes associated with monsoon enhancement and high-latitude summer warming are consistent with palaeoenvironmental observations, but the simulated shifts in vegetation belts are too small in both cases. Vegetation changes due to warmer and more arid conditions in the midcontinents of the Northern Hemisphere are consistent with palaeoenvironmental data from North America, but data from Eurasia suggests conditions were wetter at 6 kyr BP than today. The models show quantitatively similar vegetation changes in the intertropical zone, and in the northern and southern extratropics. The small differences among models in the magnitude of the global vegetation response are not related to differences in global or zonal climate averages, but reflect differences in simulated regional features. Regional-scale analyses will therefore be necessary to identify the underlying causes of such differences among models.

Climate and biome simulations for the past 21,000 years

This paper reports on a set of paleoclimate simulations for 21, 16, 14, 11 and 6 ka (thousands of years ago) carried out with the Community Climate Model, Version 1 (CCM1) of the National Center for Atmospheric Research (NCAR). This climate model uses four interactive components that were not available in our previous simulations with the NCAR CCM0 (COHMAP, 1988Science, 241, 1043–1052; Wright et al., 1993Global Climate Since the Last Glocial Maximum, University of Minnesota Press, MN): soil moisture, snow hydrology, sea-ice, and mixed-layer ocean temperature. The new simulations also use new estimates of ice sheet height and size from ( Peltier 1994, Science, 265, 195–201), and synchronize the astronomically dated orbital forcing with the ice sheet and atmospheric CO2 levels corrected from radiocarbon years to calendar years. The CCM1 simulations agree with the previous simulations in their most general characteristics. The 21 ka climate is cold and dry, in response to the presence of the ice sheets and lowered CO2 levels. The period 14–6 ka has strengthened northern summer monsoons and warm mid-latitude continental interiors in response to orbital changes. Regional differences between the CCM1 and CCM0 simulations can be traced to the effects of either the new interactive model components or the new boundary conditions. CCM1 simulates climate processes more realistically, but has additional degrees of freedom that can allow the model to ‘drift’ toward less realistic solutions in some instances. The CCM1 simulations are expressed in terms of equilibrium vegetation using BIOME 1, and indicate large shifts in biomes. Northern tundra and forest biomes are displaced southward at glacial maximum and subtropical deserts contract in the mid-Holocene when monsoons strengthen. These vegetation changes could, if simulated interactively, introduce additional climate feedbacks. The total area of vegetated land remains nearly constant through time because the exposure of continental shelves with lowered sea level largely compensates for the land covered by the expanded ice sheets.