Using airborne laser altimetry to improve river flood extents delineated from SAR data

Flood extent maps derived from SAR images are a useful source of data for validating hydraulic models of river flood flow. The accuracy of such maps is reduced by a number of factors, including changes in returns from the water surface caused by different meteorological conditions and the presence of emergent vegetation. The paper describes how improved accuracy can be achieved by modifying an existing flood extent delineation algorithm to use airborne laser altimetry (LiDAR) as well as SAR data. The LiDAR data provide an additional constraint that waterline (land-water boundary) heights should vary smoothly along the flooded reach. The method was tested on a SAR image of a flood for which contemporaneous aerial photography existed, together with LiDAR data of the un-flooded reach. Waterline heights of the SAR flood extent conditioned on both SAR and LiDAR data matched the corresponding heights from the aerial photo waterline significantly more closely than those from the SAR flood extent conditioned only on SAR data.

Calibration of uncertain flood inundation models using remotely sensed water levels

A traditional method of validating the performance of a flood model when remotely sensed data of the flood extent are available is to compare the predicted flood extent to that observed. The performance measure employed often uses areal pattern-matching to assess the degree to which the two extents overlap. Recently, remote sensing of flood extents using synthetic aperture radar (SAR) and airborne scanning laser altimetry (LIDAR) has made more straightforward the synoptic measurement of water surface elevations along flood waterlines, and this has emphasised the possibility of using alternative performance measures based on height. This paper considers the advantages that can accrue from using a performance measure based on waterline elevations rather than one based on areal patterns of wet and dry pixels. The two measures were compared for their ability to estimate flood inundation uncertainty maps from a set of model runs carried out to span the acceptable model parameter range in a GLUE-based analysis. A 1 in 5-year flood on the Thames in 1992 was used as a test event. As is typical for UK floods, only a single SAR image of observed flood extent was available for model calibration and validation. A simple implementation of a two-dimensional flood model (LISFLOOD-FP) was used to generate model flood extents for comparison with that observed. The performance measure based on height differences of corresponding points along the observed and modelled waterlines was found to be significantly more sensitive to the channel friction parameter than the measure based on areal patterns of flood extent. The former was able to restrict the parameter range of acceptable model runs and hence reduce the number of runs necessary to generate an inundation uncertainty map. A result of this was that there was less uncertainty in the final flood risk map. The uncertainty analysis included the effects of uncertainties in the observed flood extent as well as in model parameters. The height-based measure was found to be more sensitive when increased heighting accuracy was achieved by requiring that observed waterline heights varied slowly along the reach. The technique allows for the decomposition of the reach into sections, with different effective channel friction parameters used in different sections, which in this case resulted in lower r.m.s. height differences between observed and modelled waterlines than those achieved by runs using a single friction parameter for the whole reach. However, a validation of the modelled inundation uncertainty using the calibration event showed a significant difference between the uncertainty map and the observed flood extent. While this was true for both measures, the difference was especially significant for the height-based one. This is likely to be due to the conceptually simple flood inundation model and the coarse application resolution employed in this case. The increased sensitivity of the height-based measure may lead to an increased onus being placed on the model developer in the production of a valid model

Sensitivity of tropospheric forecasts to stratospheric initial conditions

A number of recent papers in the atmospheric science literature have suggested that a dynamical link exists between the stratosphere and troposphere. Numerical modelling studies have shown that the troposphere has a time-mean response to changes to the stratospheric climatological state. In this study the response of the troposphere to an imposed transient stratospheric change is examined. The study uses a high horizontal and vertical resolution numerical weather-prediction model. Experiments compare the tropospheric forecasts of two medium-range forecast ensembles which have identical tropospheric initial conditions and different stratospheric initial conditions. In three case studies described here, stratospheric initial conditions have a statistically significant impact on the tropospheric flow. The mechanism for this change involves, in its most basic step, a change to tropospheric synoptic-scale systems. A consistent change to the tropospheric synoptic-scale systems occurs in response to the stratospheric initial conditions. The aggregated impact of changes to individual synoptic systems maps strongly onto the structure of the Arctic Oscillation, particularly over the North Atlantic storm track. The relationship between the stratosphere and troposphere, while apparent in Arctic Oscillation diagnostics, does not occur on coherent, hemispheric scales.

The impact of the stratosphere on the troposphere during the southern hemisphere stratospheric sudden warming, September 2002

Recent research has established that a small but statistically significant link exists between the stratosphere and the troposphere in the northern hemisphere extratropics. In this paper it is shown that a similar link exists between the stratosphere and troposphere during the unprecedented September 2002 sudden warming in the southern hemisphere. Two ensemble forecasts of the stratospheric sudden warming are run which have different stratospheric initial conditions and identical tropospheric initial conditions. Stratospheric initial conditions have an impact on the tropospheric flow at the peak of the major warming (5 days into the run) and on longer time-scales (18 days into the run). The character of this influence is a localized, equatorward shift of the tropospheric storm track. The averaged impact of the change in the position of the storm-track maps strongly onto the Southern Annular Mode structure, but does not have an annular character.

Incorporating Legacy Soil pH Databases into Digital Soil Maps

Soil data and reliable soil maps are imperative for environmental management. conservation and policy. Data from historical point surveys, e.g. experiment site data and farmers fields can serve this purpose. However, legacy soil information is not necessarily collected for spatial analysis and mapping such that the data may not have immediately useful geo-references. Methods are required to utilise these historical soil databases so that we can produce quantitative maps of soil propel-ties to assess spatial and temporal trends but also to assess where future sampling is required. This paper discusses two such databases: the Representative Soil Sampling Scheme which has monitored the agricultural soil in England and Wales from 1969 to 2003 (between 400 and 900 bulked soil samples were taken annually from different agricultural fields); and the former State Chemistry Laboratory, Victoria, Australia where between 1973 and 1994 approximately 80,000 soil samples were submitted for analysis by farmers. Previous statistical analyses have been performed using administrative regions (with sharp boundaries) for both databases, which are largely unrelated to natural features. For a more detailed spatial analysis that call be linked to climate and terrain attributes, gradual variation of these soil properties should be described. Geostatistical techniques such as ordinary kriging are suited to this. This paper describes the format of the databases and initial approaches as to how they can be used for digital soil mapping. For this paper we have selected soil pH to illustrate the analyses for both databases.

An ichnofabric approach to the depositional interpretation of the intensely burrowed Bateig Limestone, Miocene, SE Spain

The foraminiferal-rich pelagic Bateig Limestone forms several varieties of the important building stones quarried at Bateig Hill in southeastern Spain. Three principal ichnofabrics (Bichordites, mottled-Palaeophycus and mottled-Ophiomorpha) are recognized, which are present in at least two (possibly up to four) repeated successions (cycles). Each succession begins with an erosional event. The Bichordites ichnofabric represents a new type of facies, formed as thin turbidity/grain flow, stratiform units derived from sediment slips off a fault into deep water. Each slipped unit became almost completely bioturbated by infaunal echinoids, colonizing by lateral migration. Because of the thinness of the units, successive colonizations tended to truncate the underlying burrows giving rise to a pseudo-stratification. As the Bichordites ichnofabric accumulated on the fault apron, thus reducing the effective height of the fault scarp, the substrate gradually came under the influence of currents traversing the shelf. This led to a change in hydraulic regime, and to the mottled-Palaeophycus and mottled-Ophiomorpha ichnofabrics in sediment deposited under bed load transport, and associated with laminar and cross-stratified beds and local muddy intervals. Reactivation of the fault triggered erosion and channeling and a return to grain flow sedimentation, and to the Bichordites ichnofabric of the succeeding cycle. The highest unit of the Bateig Limestone is formed entirely of cross-stratified calcarenites with occasional Ophiomorpha (Ophiomorpha-primary lamination ichnofabric) and is similar to many shallow marine facies but they still bear a significant content of pelagic foraminifera. The sedimentary setting bears resemblance with that described for the Pleistocene Monte Torre Paleostrait and the modem Strait of Messina (Italy), where the narrow morphology of the depositional area enhanced tidal currents and allowed for high-energy sandy deposition in relatively deep areas. More data on the Miocene paleogeography of the Bateig area should provide further testing for this hypothesis. The ichnofacies and stacking of the Bateig Limestone differ from the classic Seilacherian model in that they reflect changes in hydraulic process and are associated with faulting and subsidence and changes in sediment supply. Recognition of the unusual ichnofabrics and their relationships provides a clear indication of the overall dynamic setting. (c) 2006 Elsevier B.V. All rights reserved.

Evolution of the modern Nile delta promontories: development of accretional features during shoreline retreat

The active accretional features that have developed along the modern Nile Delta promontories during shoreline retreat are analysed using topographic maps, remote imagery, ground and hydrographic surveys, together providing 15 time-slice maps (1922-2000) at Rosetta and 14 time-slice maps (1909-2000) at Damietta. Small double sandy spits developed and persisted at Rosetta between 1986 and 1991. At Damietta, a much larger single spit, 9 km long, formed approximately east of the mouth of the Damietta Nile branch between 1955 and 1972, although its source has now been depleted. Both the Rosetta and Damietta inlets are associated with submerged mouth bars that accumulated prior to the damming of the Nile, but that continue to contribute to local sedimentation problems, particularly at Rosetta. The development of the active accretional features along the Nile promontories reflects a combination of factors including sediment availability, transport pathways from source areas, a decrease in the magnitude of Nile flood discharges, as well as the impact of protective structures at the river mouths.

Conservation strategy maps: a tool to facilitate biodiversity action planning illustrated using the heath fritillary butterfly

1. The UK Biodiversity Action Plan (UKBAP) identifies invertebrate species in danger of national extinction. For many of these species, targets for recovery specify the number of populations that should exist by a specific future date but offer no procedure to plan strategically to achieve the target for any species. 2. Here we describe techniques based upon geographic information systems (GIS) that produce conservation strategy maps (CSM) to assist with achieving recovery targets based on all available and relevant information. 3. The heath fritillary Mellicta athalia is a UKBAP species used here to illustrate the use of CSM. A phase 1 habitat survey was used to identify habitat polygons across the county of Kent, UK. These were systematically filtered using relevant habitat, botanical and autecological data to identify seven types of polygon, including those with extant colonies or in the vicinity of extant colonies, areas managed for conservation but without colonies, and polygons that had the appropriate habitat structure and may therefore be suitable for reintroduction. 4. Five clusters of polygons of interest were found across the study area. The CSM of two of them are illustrated here: the Blean Wood complex, which contains the existing colonies of heath fritillary in Kent, and the Orlestone Forest complex, which offers opportunities for reintroduction. 5. Synthesis and applications. Although the CSM concept is illustrated here for the UK, we suggest that CSM could be part of species conservation programmes throughout the world. CSM are dynamic and should be stored in electronic format, preferably on the world-wide web, so that they can be easily viewed and updated. CSM can be used to illustrate opportunities and to develop strategies with scientists and non-scientists, enabling the engagement of all communities in a conservation programme. CSM for different years can be presented to illustrate the progress of a plan or to provide continuous feedback on how a field scenario develops.

Field meeting: Romney Marsh - its churches and geology, 22 May 2004

The building fabrics of seven churches situated either on Romney Marsh or the marshland fringe were examined briefly. These revealed important differences in the relative abundance of the two principal building stones. Ragstones from the Hythe Formation occurred more frequently in the northeast, while sandstones from the Ashdown 'Beds' were more common in the west. In the Romney Marsh area, both stones were quarried mainly from their adjoining coastlines, with, up to the thirteenth century, opportunist collection of beach boulders generally preceding the exploitation or hewn stone. Other building stones, possible distribution routes and impacts of the quarrying upon coastline development were also discussed.

Fast training of self organizing maps for the visual exploration of molecular compounds

Visual exploration of scientific data in life science area is a growing research field due to the large amount of available data. The Kohonen’s Self Organizing Map (SOM) is a widely used tool for visualization of multidimensional data. In this paper we present a fast learning algorithm for SOMs that uses a simulated annealing method to adapt the learning parameters. The algorithm has been adopted in a data analysis framework for the generation of similarity maps. Such maps provide an effective tool for the visual exploration of large and multi-dimensional input spaces. The approach has been applied to data generated during the High Throughput Screening of molecular compounds; the generated maps allow a visual exploration of molecules with similar topological properties. The experimental analysis on real world data from the National Cancer Institute shows the speed up of the proposed SOM training process in comparison to a traditional approach. The resulting visual landscape groups molecules with similar chemical properties in densely connected regions.