Potassium leaching in undisturbed soil cores following surface applications of gypsum

Displacement studies on leaching of potassium (K+) were conducted under unsaturated steady state flow conditions in nine undisturbed soil columns (15.5 cm in diameter and 25 cm long). Pulses of K+ applied to columns of undisturbed soil were leached with distilled water or calcium chloride (CaCl2) at a rate of 18 mm h(-1). The movement of K+ in gypsum treated soil leached with distilled water was at a similar rate to that of the untreated soil leached with 15 mM CaCl2. The Ca2+ concentrations in the leachates were about 15 mM, the expected values for the dissolution of the gypsum. When applied K+ was displaced with the distilled water, K+ was retained in the top 10-12.5 cm depth of soil. In the undisturbed soil cores there is possibility of preferential flow and lack of K+ sorption. The application of gypsum and CaCl2 in the reclamation of sodic soils would be expected to leach K+ from soils. It can also be concluded that the use of sources of water for irrigation which have a high Ca2+ concentration can also lead to leaching of K+ from soil. Average effluent concentration of K+ during leaching period was 30.2 and 28.6 mg l(-1) for the gypsum and CaCl2 treated soils, respectively. These concentrations are greater than the recommended guideline of the World Health Organisation (12 mg K+ l(-1)).

Discarding Like Pieces

The guideline of ‘discarding like men’ to estimate the merit of a chess position is well known. This note compares it with some statistics.

Provision of information about drug side-effects to patients

To make informed decisions about taking medicinal drugs, people need accurate information about side-effects. A European Union guideline now recommends use of qualitative descriptions for five bands of risk, ranging from very rare (affecting < 0·01% of the population), to very common (>10%). We did four studies of more than 750 people, whom we asked to estimate the probability of having a side-effect on the basis of qualitative and quantitative descriptions. Our results showed that qualitative descriptions led to gross overestimation of risk. Until further work is done on how patients taking the drugs interpret these terms, the terms should not be used in drug information leaflets.

Is 15 per cent very common? Informing people about the risks of medication side effects

Objectives - To assess the general public's interpretation of the verbal descriptors for side effect frequency recommended for use in medicine information leaflets by a European Union (EU) guideline, and to examine the extent to which differences in interpretation affect people's perception of risk and their judgments of intention to comply with the prescribed treatment. Method - Two studies used a controlled empirical methodology in which people were presented with a hypothetical, but realistic, scenario about visiting their general practitioner and being prescribed medication. They were given an explanation that focused on the side effects of the medicine, together with information about the probability of occurrence using either numerical percentages or the corresponding EU verbal descriptors. Interpretation of the descriptors was assessed. In study 2, participants were also required to make various judgments, including risk to health and intention to comply. Key findings - In both studies, use of the EU recommended descriptors led to significant overestimations of the likelihood of particular side effects occurring. Study 2 further showed that the "overestimation" resulted in significantly increased ratings of perceived severity of side effects and risk to health, as well as significantly reduced ratings of intention to comply, compared with those for people who received the probability information in numerical form. Conclusion - While it is recognised that the current findings require replication in a clinical setting, the European and national authorities should suspend the use of the EU recommended terms until further research is available to allow the use of an evidence-based approach.

An assessment of the fine sediment dynamics in an upland river system: INCA-Sed modifications and implications for fisheries

There is a need for better links between hydrology and ecology, specifically between landscapes and riverscapes to understand how processes and factors controlling the transport and storage of environmental pollution have affected or will affect the freshwater biota. Here we show how the INCA modelling framework, specifically INCA-Sed (the Integrated Catchments model for Sediments) can be used to link sediment delivery from the landscape to sediment changes in-stream. INCA-Sed is a dynamic, process-based, daily time step model. The first complete description of the equations used in the INCA-Sed software (version 1.9.11) is presented. This is followed by an application of INCA-Sed made to the River Lugg (1077 km2) in Wales. Excess suspended sediment can negatively affect salmonid health. The Lugg has a large and potentially threatened population of both Atlantic salmon (Salmo salar) and Brown Trout (Salmo trutta). With the exception of the extreme sediment transport processes, the model satisfactorily simulated both the hydrology and the sediment dynamics in the catchment. Model results indicate that diffuse soil loss is the most important sediment generation process in the catchment. In the River Lugg, the mean annual Guideline Standard for suspended sediment concentration, proposed by UKTAG, of 25 mg l− 1 is only slightly exceeded during the simulation period (1995–2000), indicating only minimal effect on the Atlantic salmon population. However, the daily time step simulation of INCA-Sed also allows the investigation of the critical spawning period. It shows that the sediment may have a significant negative effect on the fish population in years with high sediment runoff. It is proposed that the fine settled particles probably do not affect the salmonid egg incubation process, though suspended particles may damage the gills of fish and make the area unfavourable for spawning if the conditions do not improve.

Opportunities for reduction in acute toxicity testing via improved design

The conventional method for assessing acute oral toxicity (OECD Test Guideline 401) was designed to identify the median lethal dose (LD50), using the death of animals as an endpoint. Introduced as an alternative method (OECD Test Guideline 420), the Fixed Dose Procedure (FDP) relies on the observation of clear signs of toxicity, uses fewer animals and causes less suffering. More recently, the Acute Toxic Class method and the Up-and-Down Procedure have also been adopted as OECD test guidelines. Both of these methods also use fewer animals than the conventional method, although they still use death as an endpoint. Each of the three new methods incorporates a sequential dosing procedure, which results in increased efficiency. In 1999, with a view to replacing OECD Test Guideline 401, the OECD requested that the three new test guidelines be updated. This was to bring them in line with the regulatory needs of all OECD Member Countries, provide further reductions in the number of animals used, and introduce refinements to reduce the pain and distress experienced by the animals. This paper describes a statistical modelling approach for the evaluation of acute oral toxicity tests, by using the revised FDP for illustration. Opportunities for further design improvements are discussed.

Statistical evaluation of an acute dermal toxicity test using the dermal fixed dose procedure

The conventional method for the assessment of acute dermal toxicity (OECD Test Guideline 402, 1987) uses death of animals as an endpoint to identify the median lethal dose (LD50). A new OECD Testing Guideline called the dermal fixed dose procedure (dermal FDP) is being prepared to provide an alternative to Test Guideline 402. In contrast to Test Guideline 402, the dermal FDP does not provide a point estimate of the LD50, but aims to identify that dose of the substance under investigation that causes clear signs of nonlethal toxicity. This is then used to assign classification according to the new Globally Harmonised System of Classification and Labelling scheme (GHS). The dermal FDP has been validated using statistical modelling rather than by in vivo testing. The statistical modelling approach enables calculation of the probability of each GHS classification and the expected numbers of deaths and animals used in the test for imaginary substances with a range of LD50 values and dose-response curve slopes. This paper describes the dermal FDP and reports the results from the statistical evaluation. It is shown that the procedure will be completed with considerably less death and suffering than guideline 402, and will classify substances either in the same or a more stringent GHS class than that assigned on the basis of the LD50 value.

Statistical evaluation of the fixed concentration procedure for acute inhalation toxicity assessment

The conventional method for the assessment of acute inhalation toxicity (OECD Test Guideline 403, 1981) uses death of animals as an endpoint to identify the median lethal concentration (LC50). A new OECD Testing Guideline called the Fixed Concentration Procedure (FCP) is being prepared to provide an alternative to Test Guideline 403. Unlike Test Guideline 403, the FCP does not provide a point estimate of the LC50, but aims to identify an airborne exposure level that causes clear signs of nonlethal toxicity. This is then used to assign classification according to the new Globally Harmonized System of Classification and Labelling scheme (GHS). The FCP has been validated using statistical simulation rather than byin vivo testing. The statistical simulation approach predicts the GHS classification outcome and the numbers of deaths and animals used in the test for imaginary substances with a range of LC50 values and dose response curve slopes. This paper describes the FCP and reports the results from the statistical simulation study assessing its properties. It is shown that the procedure will be completed with considerably less death and suffering than Test Guideline 403, and will classify substances either in the same or a more stringent GHS class than that assigned on the basis of the LC50 value.

A statistical evaluation of the fixed dose procedure

The fixed-dose procedure (FDP) was introduced as OECD Test Guideline 420 in 1992, as an alternative to the conventional median lethal dose (LD50) test for the assessment of acute oral toxicity (OECD Test Guideline 401). The FDP uses fewer animals and causes less suffering than the conventional test, while providing information on the acute toxicity to allow substances to be ranked according to the EU hazard classification system. Recently the FDP has been revised, with the aim of providing further reductions and refinements, and classification according to the criteria of the Globally Harmonized Hazard Classification and Labelling scheme (GHS). This paper describes the revised FDP and analyses its properties, as determined by a statistical modelling approach. The analysis shows that the revised FDP classifies substances for acute oral toxicity generally in the same, or a more stringent, hazard class as that based on the LD50 value, according to either the GHS or the EU classification scheme. The likelihood of achieving the same classification is greatest for substances with a steep dose-response curve and median toxic dose (TD50) close to the LD50. The revised FDP usually requires five or six animals with two or fewer dying as a result of treatment in most cases.

Assessing the natural ventilation cooling potential of office buildings in different climate zones in China

This paper presents an investigation of the natural ventilation cooling potential (NVCP) of office buildings in the five generally recognised climate zones in China using the Thermal Resistance Ventilation (TRV) model, which is a simplified, coupled, thermal and airflow model. The acceptable operative temperature for naturally conditioned space supplied by the ASHARE Standard 55-2004 has been used for the comfort temperature setting. Dynamic simulations for a typical office room in the five representative cities, which are Harbin, Beijing, Shanghai, Kunming and Guangzhou, have been carried out. The study demonstrates that the NVCP depends on the multiple impacts of climate, the building's thermal characteristics, internal gains, ventilation profiles and regimes. The work shows how the simplified method can be used to generate detailed, indoor, operative temperature data based on the various building conditions and control profiles which are used to investigate the NVCP at the strategic design stage. The simulation results presented in this paper can be used as a reference guideline for natural ventilation design in China.

Patients' understanding of risk associated with medication use: impact of European Commission guidelines and other risk scales

Patients want and need comprehensive and accurate information about their medicines so that they can participate in decisions about their healthcare: In particular, they require information about the likely risks and benefits that are associated with the different treatment options. However, to provide this information in a form that people can readily understand and use is a considerable challenge to healthcare professionals. One recent attempt to standardise the Language of risk has been to produce sets of verbal descriptors that correspond to specific probability ranges, such as those outlined in the European Commission (EC) Pharmaceutical Committee guidelines in 1998 for describing the incidence of adverse effects. This paper provides an overview of a number of studies involving members of the general public, patients, and hospital doctors, that evaluated the utility of the EC guideline descriptors (very common, common, uncommon, rare, very rare). In all studies it was found that people significantly over-estimated the likelihood of adverse effects occurring, given specific verbal descriptors. This in turn resulted in significantly higher ratings of their perceived risks to health and significantly lower ratings of their likelihood of taking the medicine. Such problems of interpretation are not restricted to the EC guideline descriptors. Similar levels of misinterpretation have also been demonstrated with two other recently advocated risk scales (Caiman's verbal descriptor scale and Barclay, Costigan and Davies' lottery scale). In conclusion, the challenge for risk communicators and for future research will be to produce a language of risk that is sufficiently flexible to take into account different perspectives, as well as changing circumstances and contexts of illness and its treatments. In the meantime, we urge the EC and other legislative bodies to stop recommending the use of specific verbal labels or phrases until there is a stronger evidence base to support their use.

Uncanny Valley revisited

The 'Uncanny Valley' was conceived in 1970 by Prof Masahiro Mori and details a possible relationship between an object's appearance or motion and how people perceive the object. Initially this research was used without validation. Modern technology has enabled initial investigations, summarised here, that conclude further work is required. A good design guideline for humanoid robots is desired if humanoid robots are to assist with an increasingly elderly population, but not yet possible due to technological constraints. Prosthetics is considered a good resource as the user interaction is comparable to the anticipated level of human-robot interaction and there is a wide range of existing devices.

The impact of urban wind environments on natural ventilation

The aim of this paper is to illustrate the impact of urban wind environments when assessing the availability of natural ventilation. A numerical study of urban airflow for a complex of five building blocks located at the University of Reading, UK is presented. The computational fluid dynamics software package ANSYS was used to simulate six typical cases of urban wind environments and the potential for natural ventilation assessed. The study highlights the impact of three typical architectural forms (street canyons, semi-enclosures and courtyards) on the local wind environment. Simulation results have also been compared with experimental data collected from six locations on the building complex. The study demonstrates that ventilation strategies formed using regional weather data, may have a propensity to over-estimate the potential for natural ventilation and cooling, due to the impact of urban form which creates a unique microclimate. Characteristics of urban wind flow patterns are presented as a guideline and can be used to assess the design and performance of natural or hybrid ventilation and the opportunity for passive cooling.

A study on effect of built forms on urban wind environment by using CFD simulations

This paper presents a numerical study of urban air-flow for a group of five buildings that is located at the University of Reading in the United Kingdom. The airflow around these buildings has been simulated by using ANSYS CFD software package. In this study, the association between certain architectural forms: a street canyon, a semi-closure, and a courtyard-like space in a low-rise building complex, and the wind environment were investigated. The analysis of CFD results has provided detailed information on the wind patterns of these urban built forms. The numerical results have been compared with the experimental measurements within the building complex. The observed characteristics of urban wind pattern with respect to the built structures are presented as a guideline. This information is needed for the design and/or performance assessments of systems such as passive and low energy design approach, a natural or hybrid ventilation, and passive cooling. Also, the knowledge of urban wind patterns allows us to develop better design options for the application of renewable energy technologies within urban environment.

Nutritional value of edible seaweeds

This article presents information on the nutritional aspects of seaweeds in terms of fiber, mineral content, fats and lipids, vitamin contents, and components that have a confirmed and investigated nutritional effect. The nutrient levels of seaweeds are also shown in comparison to currently applicable reference nutrient intakes or guideline daily amounts of nutrients and are contrasted with terrestrial foodstuffs with respect to selected nutrients. For the purpose of comparison, a sample serving size of 8 g dry weight of seaweed is used to illustrate the potential contribution of seaweeds to the diet.