A potential energy surface for the ground state of formaldehyde, H2CO(1A1)

A model potential energy function for the ground state of H2CO has been derived which covers the whole space of the six internal coordinates. This potential reproduces the experimental energy, geometry and quadratic force field of formaldehyde, and dissociates correctly to all possible atom, diatom and triatom fragments. Thus there are good reasons for believing it to be close to the true potential energy surface except in regions where both hydrogen atoms are close to the oxygen. It leads to the prediction that there should be a metastable singlet hydroxycarbene HCOH which has a planar trans structure and an energy of 2•31 eV above that of equilibrium formaldehyde. The reaction path for dissociation into H2 + CO is predicted to pass through a low symmetry transition state with an activation energy of 4•8 eV. Both of these predictions are in good agreement with recently published ab initio calculations.

Using a water-soluble melamine-formaldehyde resin to improve the hardness of Norway spruce wood

Samples of Norway spruce wood were impregnated with a water-soluble melamine formaldehyde resin by using short-term vacuum treatment and long-term immersion, respectively. By means of Fourier transform infrared (FTIR) spectroscopy and UV microspectrophotometry, it was shown that only diffusion during long-term immersion leads to sufficient penetration of melamine resin into the wood structure, the flow of liquids in Norway spruce wood during vacuum treatment being greatly hindered by aspirated pits. After an immersion in aqueous melamine resin solution for 3 days, the resin had penetrated to a depth > 4 mm, which, after polymerization of the resin, resulted in an improvement of hardness comparable to the hardwood beech. A finite element model describing the effect of increasing depth of modification on hardness demonstrated that under the test conditions chosen for this study, a minimum impregnation depth of 2 mm is necessary to achieve an optimum increase in hardness. (C) 2004 Wiley Periodicals, Inc.

Chlorine tolerant, multilayer reverse-somosis membranes with high permeate flux and high salt rejection

A new class of high molecular weight polyethersulfone ionomers is described in which the ionic content can be varied, at will, over a very wide and fully-controllable range. A novel type of coating process enables these materials to be deposited from alcohol-type solvents as cohesive but very thin (50 – 250 nm) films on porous support-membranes, giving high-flux membranes (3.3 – 5.0 L m-2 h-1 bar-1) with very good, though not outstanding salt rejection (typically 92 - 96%). A secondary layer, of formaldehyde-cross-linked polyvinyl alcohol, can be deposited from aqueous solution on the surface of the ionomer membrane, and this layer increases salt rejection to greater than 99% without serious loss of water permeability. The final multi-layer membrane shows excellent chlorine tolerance in reverse-osmosis operation.

A model for stretch-bend interactions in molecular force fields

Interaction force constants between bond-stretching and angle-bending co-ordinates in polyatomic molecules have been attributed, by some authors, to changes of hybridization due to orbital-following of the bending co-ordinate, and consequent changes of bond length due to the change of hybridization. A method is described for using this model quantitatively to reduce the number of independent force constants in the potential function of a polyatomic molecule, by relating stretch-bend interaction constants to the corresponding diagonal stretching constants. It is proposed to call this model the Hybrid Orbital Force Field. The model is applied to the tetrahedral four co-ordinated carbon atom (as in methane) and to the trigonal planar three coordinated carbon atom (as in formaldehyde).

The Mannich reaction of hydrazones: improved reactivity under solvent-free conditions

The Mannich reaction of hydrazones can be performed without solvent by simply mixing the hydrazone with two to three equivalents of a secondary amine and formaldehyde. Best yields and conditions are obtained with p-nitro substituted arylhydrazones. These conditions allow the efficient coupling of simple hydrazones that failed to react in toluene or ethanol solutions.

Synthesis of bischromones by deformylative Mannich type reaction on chromone-3-carbaldehyde using alpha-aminoacid as the source of amine

Chromone-3-carbaldehyde reacts with N-methylglycine or glycine in the presence of excess formaldehyde to produce N-(chromone-3-ylmethyl)-N-methylglycine or N,N-di(chromone-3-ylmethyl)glycine, respectively, by a deformylative Mannich type reaction. Use of alanine or leucine or methionine in place of glycine produces N-(chromone-3-ylmethyl)alanine/-leucine/-methionine, respectively. (C) 2009 Elsevier Ltd. All rights reserved.

A study of the ethene-ozone reaction with photoelectron spectroscopy: measurement of product branching ratios and atmospheric implications

The ozone-ethene reaction has been investigated at low pressure in a flow-tube interfaced to a u.v. photoelectron spectrometer. Photoelectron spectra recorded as a function of reaction time have been used to estimate partial pressures of the reagents and products, using photoionization cross-sections for selected photoelectron bands of the reagents and products, which have been measured separately. Product yields compare favourably with results of other studies, and the production of oxygen and acetaldehyde have been measured as a function of time for the first time. A reaction scheme developed for the ozone-ethene reaction has been used to simulate the reagents and products as a function of time. The results obtained are in good agreement with the experimental measurements. For each of the observed products, the simulations allow the main reaction (or reactions) for production of that product to be established. The product yields have been used in a global model to estimate their global annual emissions in the atmosphere. Of particular interest are the calculated global annual emissions of formaldehyde (0.96 ± 0.10 Tg) and formic acid, (0.05 ± 0.01 Tg) which are estimated as 0.04% and 0.7% of the total annual emission respectively.

Phenotypic and proteomic characterization of multiply antibiotic-resistant variants of Salmonella entetica serovar typhimurium selected following exposure to disinfectants

In previous work, Salmonella enterica serovar Typhimurium strain SL1344 was exposed to sublethal concentrations of three widely used farm disinfectants in daily serial passages for 7 days in an attempt to investigate possible links between the use of disinfectants and antimicrobial resistance. Stable variants OXCR1, QACFGR2, and TOPR2 were obtained following treatment with an oxidizing compound blend, a quaternary ammonium disinfectant containing formaldehyde and glutaraldehyde, and a tar acid-based disinfectant, respectively. All variants exhibited ca. fourfold-reduced susceptibility to ciprofloxacin, chloramphenicol, tetracycline, and ampicillin. This coincided with reduced levels of outer membrane proteins for all strains and high levels of AcrAB-To1C for OXCR1 and QACFGR2, as demonstrated by two-dimensional high-performance liquid chromatography-mass spectrometry. The protein profiles of OXCR1 and QACFGR2 were similar, but they were different from that of TOPR2. An array of different proteins protecting against oxidants, nitroaromatics, disulfides, and peroxides were overexpressed in all strains. The growth and motility of variants were reduced compared to the growth and motility of the parent strain, the expression of several virulence proteins was altered, and the invasiveness in an enteric epithelial cell line was reduced. The colony morphology of OXCR1 and QACFGR2 was smooth, and both variants exhibited a loss of modal distribution of the lipopolysaccharide O-antigen chain length, favoring the production of short O-antigen chain molecules. Metabolic changes were also detected, suggesting that there was increased protein synthesis and a shift from oxidative phosphorylation to substrate level phosphorylation. In this study, we obtained evidence that farm disinfectants can select for strains with reduced susceptibility to antibiotics, and here we describe changes in protein expression in such strains.

Prolonged treatment of Salmonella enterica serovar Typhimurium with commercial disinfectants selects for multiple antibiotic resistance, increased efflux and reduced invasiveness

Objectives: To study how disinfectants affect antimicrobial susceptibility and phenotype of Salmonella enterica serovar Typhimurium SL1344. Methods: Wild-type strain SL1344 and its isogenic gyrA mutant were passaged daily for 7 days in subinhibitory concentrations, and separately for 16 days in gradually increasing concentrations of a quaternary ammonium disinfectant containing formaldehyde and glutaraldehyde (QACFG), an oxidizing compound blend (OXC), a phenolic tar acids-based disinfectant (TOP) and triclosan. The MICs of antimicrobials and antibiotics for populations and representative isolates and the proportion of cells resistant to the MICs for the wild-type were determined. Expression of acrB gene, growth at 37 degrees C and invasiveness of populations in Caco-2 intestinal epithelial cells were assessed. Results: QACFG and triclosan showed the highest selectivity for variants with reduced susceptibility to chloramphenicol, tetracycline, ampicillin, acriflavine and triclosan. Populations treated with the above biocides had reduced invasiveness in Caco-2 cells, and altered growth kinetics. Resistance to disinfectants was observed only after exposure to gradually increasing concentrations of triclosan, accompanied with a 2000-fold increase in its MIC. Growth in OXC and TOP did not affect the MICs of antibiotics, but resulted in the appearance of a proportion of cells resistant to the MIC of acriflavine and triclosan for the wild-type. Randomly selected stable variants from all populations, except the one treated with TOP, over-expressed acrB. Conclusions: In vitro exposure to QACFG and triclosan selects for Salmonella Typhimurium cells with reduced susceptibility to several antibiotics. This is associated with overexpression of AcrAB efflux pump, but accompanied with reduced invasiveness.