Variational calculations of rovibrational states: a precise high-energy potential surface for HCN [and discussion]

We report the results of variational calculations of the rovibrational energy levels of HCN for J = 0, 1 and 2, where we reproduce all the ca. 100 observed vibrational states for all observed isotopic species, with energies up to 18000 cm$^{-1}$, to about $\pm $1 cm$^{-1}$, and the corresponding rotational constants to about $\pm $0.001 cm$^{-1}$. We use a hamiltonian expressed in internal coordinates r$_{1}$, r$_{2}$ and $\theta $, using the exact expression for the kinetic energy operator T obtained by direct transformation from the cartesian representation. The potential energy V is expressed as a polynomial expansion in the Morse coordinates y$_{i}$ for the bond stretches and the interbond angle $\theta $. The basis functions are built as products of appropriately scaled Morse functions in the bond-stretches and Legendre or associated Legendre polynomials of cos $\theta $ in the angle bend, and we evaluate matrix elements by Gauss quadrature. The hamiltonian matripx is factorized using the full rovibrational symmetry, and the basis is contracted to an optimized form; the dimensions of the final hamiltonian matrix vary from 240 $\times $ 240 to 1000 $\times $ 1000.We believe that our calculation is converged to better than 1 cm$^{-1}$ at 18 000 cm$^{-1}$. Our potential surface is expressed in terms of 31 parameters, about half of which have been refined by least squares to optimize the fit to the experimental data. The advantages and disadvantages and the future potential of calculations of this type are discussed.

Regional changes in wind energy potential over Europe using regional climate model ensemble projections

The impact of climate change on wind power generation potentials over Europe is investigated by considering ensemble projections from two regional climate models (RCMs) driven by a global climate model (GCM). Wind energy density and its interannual variability are estimated based on hourly near-surface wind speeds. Additionally, the possible impact of climatic changes on the energy output of a sample 2.5-MW turbine is discussed. GCM-driven RCM simulations capture the behavior and variability of current wind energy indices, even though some differences exist when compared with reanalysis-driven RCM simulations. Toward the end of the twenty-first century, projections show significant changes of energy density on annual average across Europe that are substantially stronger in seasonal terms. The emergence time of these changes varies from region to region and season to season, but some long-term trends are already statistically significant in the middle of the twenty-first century. Over northern and central Europe, the wind energy potential is projected to increase, particularly in winter and autumn. In contrast, energy potential over southern Europe may experience a decrease in all seasons except for the Aegean Sea. Changes for wind energy output follow the same patterns but are of smaller magnitude. The GCM/RCM model chains project a significant intensification of both interannual and intra-annual variability of energy density over parts of western and central Europe, thus imposing new challenges to a reliable pan-European energy supply in future decades.

Resolving the energy paradox of chaperone/usher-mediated fibre assembly

Periplasmic chaperone/usher machineries are used for assembly of filamentous adhesion organelles of Gram-negative pathogens in a process that has been suggested to be driven by folding energy. Structures of mutant chaperone-subunit complexes revealed a final folding transition (condensation of the subunit hydrophobic core) on the release of organelle subunit from the chaperone-subunit pre-assembly complex and incorporation into the final fibre structure. However, in view of the large interface between chaperone and subunit in the pre-assembly complex and the reported stability of this complex, it is difficult to understand how final folding could release sufficient energy to drive assembly. In the present paper, we show the X-ray structure for a native chaperone-fibre complex that, together with thermodynamic data, shows that the final folding step is indeed an essential component of the assembly process. We show that completion of the hydrophobic core and incorporation into the fibre results in an exceptionally stable module, whereas the chaperone-subunit preassembly complex is greatly destabilized by the high-energy conformation of the bound subunit. This difference in stabilities creates a free energy potential that drives fibre formation.

Projected changes in wind energy potentials over Iberia

Wind energy potential in Iberia is assessed for recent–past (1961–2000) and future (2041–2070) climates. For recent–past, a COSMO-CLM simulation driven by ERA-40 is used. COSMO-CLM simulations driven by ECHAM5 following the A1B scenario are used for future projections. A 2 MW rated power wind turbine is selected. Mean potentials, inter-annual variability and irregularity are discussed on annual/seasonal scales and on a grid resolution of 20 km. For detailed regional assessments eight target sites are considered. For recent–past conditions, the highest daily mean potentials are found in winter over northern and eastern Iberia, particularly on high-elevation or coastal regions. In northwestern Iberia, daily potentials frequently reach maximum wind energy output (50 MWh day−1), particularly in winter. Southern Andalucía reveals high potentials throughout the year, whereas the Ebro valley and central-western coast show high potentials in summer. The irregularity in annual potentials is moderate (<15% of mean output), but exacerbated in winter (40%). Climate change projections show significant decreases over most of Iberia (<2 MWh day−1). The strong enhancement of autumn potentials in Southern Andalucía is noteworthy (>2 MWh day−1). The northward displacement of North Atlantic westerly winds (autumn–spring) and the strengthening of easterly flows (summer) are key drivers of future projections.

Different strategies for improving summer thermal comfort in heavyweight traditional buildings

In order to exploit the passive energy potential of the building envelope, it is important to provide a right combination of insulation thickness, heat capacity and night-time ventilation. In this paper, this issue will be tackled with reference to an historic building in Catania (Southern Italy). The building was built at the end of the XIX century, and its opaque envelope is entirely made with lava stones, which is typical of traditional architecture in this area. Starting from the current configuration of the building, many hypotheses for refurbishment are considered, combined with different strategies for passive cooling, such as night-time ventilation, use of shading devices and adoption of highly-reflective coatings. The effectiveness of each solution in terms of summer thermal comfort is evaluated through dynamic thermal simulations carried out with EnergyPlus. The results show the synergic effect of these strategies, as well as their individual impact, and allow to draw some general conclusions about the behaviour of heavyweight buildings under moderately hot weather conditions.

Analytical potentials for triatomic molecules IX. The prediction of anharmonic force constants from potential energy surfaces based on harmonic force fields and dissociation energies for SO2 and O3

Analytical potential energy functions which are valid at all dissociation limits have been derived for the ground states of SO2 and O3. The procedure involves minimizing the errors between the observed vibrational spectra and spectra calculated by a variational procedure. Good agreement is obtained between the observed and calculated spectra for both molecules. Comparisons are made between anharmonic force fields, previously determined from the spectral data, and the force fields obtained by differentiating the derived analytical functions at the equilibrium configurations.

A potential energy surface for the ground state of acetylene, C2H2

A potential energy function has been derived for the ground state surface of C2H2 as a many-body expansion. The 2- and 3-body terms have been obtained by preliminary investigation of the ground state surfaces of CH2( 3B1) and C2H( 2Σ+). A 4-body term has been derived which reproduces the energy, geometry and harmonic force field of C2H2. The potential has a secondary minimum corresponding to the vinylidene structure and the geometry and energy of this are in close agreement with predictions from ab initio calculations. The saddle point for the HCCH-H2CC rearrangement is predicted to lie 2•530 eV above the acetylene minimum.

A potential energy surface for the ground state of formaldehyde, H2CO(1A1)

A model potential energy function for the ground state of H2CO has been derived which covers the whole space of the six internal coordinates. This potential reproduces the experimental energy, geometry and quadratic force field of formaldehyde, and dissociates correctly to all possible atom, diatom and triatom fragments. Thus there are good reasons for believing it to be close to the true potential energy surface except in regions where both hydrogen atoms are close to the oxygen. It leads to the prediction that there should be a metastable singlet hydroxycarbene HCOH which has a planar trans structure and an energy of 2•31 eV above that of equilibrium formaldehyde. The reaction path for dissociation into H2 + CO is predicted to pass through a low symmetry transition state with an activation energy of 4•8 eV. Both of these predictions are in good agreement with recently published ab initio calculations.

Analytical potentials for triatomic molecules from spectroscopic data VI. On choosing internal coordinates to describe triatomic potential energy surfaces with more than one minimum

Orthogonal internal coordinates are defined which have useful properties for constructing the potential energy functions of triatomic molecules with two or three minima on the surface. The coordinates are used to obtain ground state potentials of ClOO and HOF, both of which have three minima.

Potential energy surface intersections in triatomic molecules

The different types of surface intersection which may occur in linear configurations of triatomic molecules are reviewed, particularly with regard to the way in which the degeneracy is split as the molecule bends. The Renner-Teller effect in states of symmetry Π, Δ, Φ, etc., and intersections between Σ and Π, Σ and Δ, and Π and Δ states are discussed. A general method of modelling such intersecting potential surfaces is proposed, as a development of the model previously used by Murrell and Carter and co-workers for single-valued surfaces. Some of the lower energy surfaces of H2O, NH2, O3, C3, and HNO are discussed as examples.

Potential energy functions for ground state surfaces of HCO and HNO

Analytical potential functions are reported for the ground state surfaces of HCO and HNO, the functions being derived from spectroscopic and ab initio data. Harmonized force fields have been deduced for the stable configurations of both molecules and vibration frequencies predicted for the metastable species COH and NOH.

Potential energy for slantwise parcel motion

Two formulations for the potential energy for slantwise motion are compared: one which applies strictly only to two-dimensional flows (SCAPE) and a three-dimensional formulation based on a Bernoulli equation. The two formulations share an identical contribution from the vertically integrated buoyancy anomaly and a contribution from different Coriolis terms. The latter arise from the neglect of (different) components of the total change in kinetic energy along a trajectory in the two formulations. This neglect is necessary in order to quantify the potential energy available for slantwise motion relative to a defined steady environment. Copyright © 2000 Royal Meteorological Society.

Gas phase kinetic and quantum chemical studies of the reactions of silylene with the methylsilanes. Absolute rate constants, temperature dependences, RRKM modelling and potential energy surfaces

Time resolved studies of silylene, SiH2, generated by the 193 nm laser. ash photolysis of phenylsilane, have been carried out to obtain rate coefficients for its bimolecular reactions with methyl-, dimethyl- and trimethyl-silanes in the gas phase. The reactions were studied over the pressure range 3 - 100 Torr with SF6 as bath gas and at five temperatures in the range 300 - 625 K. Only slight pressure dependences were found for SiH2 + MeSiH3 ( 485 and 602 K) and for SiH2 + Me2SiH2 ( 600 K). The high pressure rate constants gave the following Arrhenius parameters: [GRAPHICS] These are consistent with fast, near to collision-controlled, association processes. RRKM modelling calculations are consistent with the observed pressure dependences ( and also the lack of them for SiH2 + Me3SiH). Ab initio calculations at both second order perturbation theory (MP2) and coupled cluster (CCSD(T)) levels, showed the presence of weakly-bound complexes along the reaction pathways. In the case of SiH2 + MeSiH3 two complexes, with different geometries, were obtained consistent with earlier studies of SiH2 + SiH4. These complexes were stabilised by methyl substitution in the substrate silane, but all had exceedingly low barriers to rearrangement to product disilanes. Although methyl groups in the substrate silane enhance the intrinsic SiH2 insertion rates, it is doubtful whether the intermediate complexes have a significant effect on the kinetics. A further calculation on the reaction MeSiH + SiH4 shows that the methyl substitution in the silylene should have a much more significant kinetic effect ( as observed in other studies).