Influence of probabilistic climate projections on building energy simulation

The Chartered Institute of Building Service Engineers (CIBSE) produced a technical memorandum (TM36) presenting research on future climate impacting building energy use and thermal comfort. One climate projection for each of four CO2 emissions scenario were used in TM36, so providing a deterministic outlook. As part of the UK Climate Impacts Programme (UKCIP) probabilistic climate projections are being studied in relation to building energy simulation techniques. Including uncertainty in climate projections is considered an important advance to climate impacts modelling and is included in the latest UKCIP data (UKCP09). Incorporating the stochastic nature of these new climate projections in building energy modelling requires a significant increase in data handling and careful statistical interpretation of the results to provide meaningful conclusions. This paper compares the results from building energy simulations when applying deterministic and probabilistic climate data. This is based on two case study buildings: (i) a mixed-mode office building with exposed thermal mass and (ii) a mechanically ventilated, light-weight office building. Building (i) represents an energy efficient building design that provides passive and active measures to maintain thermal comfort. Building (ii) relies entirely on mechanical means for heating and cooling, with its light-weight construction raising concern over increased cooling loads in a warmer climate. Devising an effective probabilistic approach highlighted greater uncertainty in predicting building performance, depending on the type of building modelled and the performance factors under consideration. Results indicate that the range of calculated quantities depends not only on the building type but is strongly dependent on the performance parameters that are of interest. Uncertainty is likely to be particularly marked with regard to thermal comfort in naturally ventilated buildings.

Preparation of consistent soil data sets for modelling purposes: Secondary SOTER data for four case study areas

The common GIS-based approach to regional analyses of soil organic carbon (SOC) stocks and changes is to define geographic layers for which unique sets of driving variables are derived, which include land use, climate, and soils. These GIS layers, with their associated attribute data, can then be fed into a range of empirical and dynamic models. Common methodologies for collating and formatting regional data sets on land use, climate, and soils were adopted for the project Assessment of Soil Organic Carbon Stocks and Changes at National Scale (GEFSOC). This permitted the development of a uniform protocol for handling the various input for the dynamic GEFSOC Modelling System. Consistent soil data sets for Amazon-Brazil, the Indo-Gangetic Plains (IGP) of India, Jordan and Kenya, the case study areas considered in the GEFSOC project, were prepared using methodologies developed for the World Soils and Terrain Database (SOTER). The approach involved three main stages: (1) compiling new soil geographic and attribute data in SOTER format; (2) using expert estimates and common sense to fill selected gaps in the measured or primary data; (3) using a scheme of taxonomy-based pedotransfer rules and expert-rules to derive soil parameter estimates for similar soil units with missing soil analytical data. The most appropriate approach varied from country to country, depending largely on the overall accessibility and quality of the primary soil data available in the case study areas. The secondary SOTER data sets discussed here are appropriate for a wide range of environmental applications at national scale. These include agro-ecological zoning, land evaluation, modelling of soil C stocks and changes, and studies of soil vulnerability to pollution. Estimates of national-scale stocks of SOC, calculated using SOTER methods, are presented as a first example of database application. Independent estimates of SOC stocks are needed to evaluate the outcome of the GEFSOC Modelling System for current conditions of land use and climate. (C) 2007 Elsevier B.V. All rights reserved.

Cigarette smokers differ in their handling of natural (RRR) and synthetic (all rac) alpha-tocopherol: a biokinetic study in apoE4 male subjects

We have compared the biokinetics of deuterated natural (RPR) and synthetic (all rac) alpha-tocopherol in male apoE4-carrying smokers and nonsmokers. In a randomized, crossover study subjects underwent two 4-week treatments (400 mg/day) with undeuterated RRR- and all rac-alpha-tocopheryl acetate around a 12-week washout. Before and after each supplementation period subjects underwent a biokinetic protocol (48 h) with 150 mg deuterated RRR- or all rac-alpha-tocopheryl acetate. During the biokinetic protocols, the elimination of endogenous plasma alpha-tocopherol was significantly faster in smokers (P < 0.05). However, smokers had a lower uptake of deuterated RRR than nonsmokers, but there was no difference in uptake of deuterated all rac. The supplementation regimes significantly raised plasma alpha-tocopherol (P < 0.001) with no differences in response between smokers and nonsmokers or between alpha-tocopherol forms. Smokers had significantly lower excretion of alpha-carboxyethyl-hydroxychroman than nonsmokers following supplementation (P < 0.05). Nonsmokers excreted more alpha-carboxyethyl-hydroxychroman following RRR than all rac; however, smokers did not differ in excretion between forms. At baseline, smokers had significantly lower ascorbate (P < 0.01) and higher F(2-)isoprostarres (P < 0.05). F-2-isoprostanes in smokers remained unchanged during the study, but increased in nonsmokers following alpha-tocopherol supplementation. These data suggest that apoE4-carrying smokers and nonsmokers differ in their handling of natural and synthetic alpha-tocopherol. (c) 2006 Elsevier Inc. All rights reserved.

Collaborative grid infrastructure for molecular simulations: The eMinerals minigrid as a prototype integrated computer and data grid

This paper describes a prototype grid infrastructure, called the eMinerals minigrid, for molecular simulation scientists. which is based on an integration of shared compute and data resources. We describe the key components, namely the use of Condor pools, Linux/Unix clusters with PBS and IBM's LoadLeveller job handling tools, the use of Globus for security handling, the use of Condor-G tools for wrapping globus job submit commands, Condor's DAGman tool for handling workflow, the Storage Resource Broker for handling data, and the CCLRC dataportal and associated tools for both archiving data with metadata and making data available to other workers.

Modeling data with structural and temporal correlation using lower level and higher level multilevel models

Novel imaging techniques are playing an increasingly important role in drug development, providing insight into the mechanism of action of new chemical entities. The data sets obtained by these methods can be large with complex inter-relationships, but the most appropriate statistical analysis for handling this data is often uncertain - precisely because of the exploratory nature of the way the data are collected. We present an example from a clinical trial using magnetic resonance imaging to assess changes in atherosclerotic plaques following treatment with a tool compound with established clinical benefit. We compared two specific approaches to handle the correlations due to physical location and repeated measurements: two-level and four-level multilevel models. The two methods identified similar structural variables, but higher level multilevel models had the advantage of explaining a greater proportion of variation, and the modeling assumptions appeared to be better satisfied.

Are informed citizens more trusting? Transparency of performance data and trust towards a British police force

In Britain, substantial cuts in police budgets alongside controversial handling of incidents such as politically sensitive enquiries, public disorder and relations with the media have recently triggered much debate about public knowledge and trust in the police. To date, however, little academic research has investigated how knowledge of police performance impacts citizens’ trust. We address this long-standing lacuna by exploring citizens’ trust before and after exposure to real performance data in the context of a British police force. The results reveal that being informed of performance data affects citizens’ trust significantly. Furthermore, direction and degree of change in trust are related to variations across the different elements of the reported performance criteria. Interestingly, the volatility of citizens’ trust is related to initial performance perceptions (such that citizens with low initial perceptions of police performance react more significantly to evidence of both good and bad performance than citizens with high initial perceptions), and citizens’ intentions to support the police do not always correlate with their cognitive and affective trust towards the police. In discussing our findings, we explore the implications of how being transparent with performance data can both hinder and be helpful in developing citizens’ trust towards a public organisation such as the police. From our study, we pose a number of ethical challenges that practitioners face when deciding what data to highlight, to whom, and for what purpose.