Compression of polyelectrolyte brushes in a salt-free theta solvent

This paper examines the normal force between two opposing polyelectrolyte brushes and the interpenetration of their chains that is responsible for sliding friction. It focuses on the special case of semi-dilute brushes in a salt-free theta solvent, for which Zhulina and Borisov [J. Chem. Phys., {\bf 107}, 5952, (1997)] have derived analytical predictions using the classical strong-stretching theory (SST) introduced by Semenov and developed by Milner, Witten and Cates. Interestingly, the SST predicts that the brushes contract maintaining a polymer-free gap as they are compressed together, which provides an explanation for the ultra-low frictional forces observed in experiment. We examine the degree to which the SST predictions are affected by chain fluctuations by employing self-consistent field theory (SCFT). While the normal force is relatively unaffected, fluctuations are found to have a strong impact on brush interpenetration. Even still, the contraction of the brushes does significantly prolong the onset of interpenetration, implying that a sizeable normal force can be achieved before the sliding friction becomes significant.

Effect of salt on the compression of polyelectrolyte brushes in a theta solvent

Classical strong-stretching theory (SST) predicts that, as opposing polyelectrolyte brushes are compressed together in a salt-free theta solvent, they contract so as to maintain a finite polymer-free gap, which offers a potential explanation for the ultra-low frictional forces observed in experiments even with the application of large normal forces. However, the SST ignores chain fluctuations, which would tend to close the gap resulting in physical contact and in turn significant friction. In a preceding study, we examined the effect of fluctuations using self-consistent field theory (SCFT) and illustrated that high normal forces can still be applied before the gap is destroyed. We now look at the effect of adding salt. It is found to reduce the long-range interaction between the brushes but has little effect on the short-range part, provided the concentration does not enter the salted-brush regime. Consequently, the maximum normal force between two planar brushes at the point of contact is remarkably unaffected by salt. For the crossed-cylinder geometry commonly used in experiments, however, there is a gradual reduction because in this case the long-range part of the interaction contributes to the maximum normal force.

Phase separation in thin films of end-grafted block copolymers

An atomic force microscopy investigation was carried out on various thick (30–120 nm) polymethyl methacrylate-bpolystyrene and poly(2-(dimethyl amino)ethyl methacrylate)-b-polystyrene films prepared via a grafting-from method. The structure of the films was examined with both topographic and phase imaging. Several different morphologies were observed including a perforated lamellar phase with irregular perforations. In addition, complementary small-angle X-ray scattering and reflectometry results measurements on a non-grafted polymer are presented.

Nonspherical assemblies generated from polystyrene-b-poly(L-lysine) polyelectrolyte block copolymers

This report describes the aqueous solution self-assembly of a series of polystyrene(m)-b-poly(L-lysine)n block copolymers (m = 8-10; n = 10-70). The polymers are prepared by ring-opening polymerization of epsilon-benzyloxycarbonyl-L-lysine N-carboxyanhydride using amine terminated polystyrene macroinitiators, followed by removal of the benzyloxycarbonyl side chain protecting groups. The critical micelle concentration of the block copolymers determined using the pyrene probe technique shows a parabolic dependence on peptide block length exhibiting a maximum at n = approximately 20 (m = 8) or n = approximately 60 (m = 10). The shape and size of the aggregates has been studied by dynamic and static light scattering, small-angle neutron scattering (SANS), and analytical ultracentrifugation (AUC). Surprisingly, Holtzer and Kratky analysis of the static light scattering results indicates the presence of nonspherical, presumably cylindrical objects independent of the poly(L-lysine)n block length. This is supported by SANS data, which can be fitted well by assuming cylindrical scattering objects. AUC analysis allows the molecular weight of the aggregates to be estimated as several million g/mol, corresponding to aggregation numbers of several 10s to 100s. These aggregation numbers agree with those that can be estimated from the length and diameter of the cylinders obtained from the scattering results.

Finite-stretching corrections to the Milner-Witten-Cates theory for polymer brushes

This paper investigates finite-stretching corrections to the classical Milner-Witten-Cates theory for semi-dilute polymer brushes in a good solvent. The dominant correction to the free energy originates from an entropic repulsion caused by the impenetrability of the grafting surface, which produces a depletion of segments extending a distance $\mu \propto L^{-1}$ from the substrate, where $L$ is the classical brush height. The next most important correction is associated with the translational entropy of the chain ends, which creates the well-known tail where a small population of chains extend beyond the classical brush height by a distance $\xi \propto L^{-1/3}$. The validity of these corrections is confirmed by quantitative comparison with numerical self-consistent field theory.

Specificity grafting of human antibody frameworks selected from a phage display library: generation of a highly stable humanized anti-CD22 single-chain Fv fragment

A prerequisite for the enrichment of antibodies screened from phage display libraries is their stable expression on a phage during multiple selection rounds. Thus, if stringent panning procedures are employed, selection is simultaneously driven by antigen affinity, stability and solubility. To take advantage of robust pre-selected scaffolds of such molecules, we grafted single-chain Fv (scFv) antibodies, previously isolated from a human phage display library after multiple rounds of in vitro panning on tumor cells, with the specificity of the clinically established murine monoclonal anti-CD22 antibody RFB4. We show that a panel of grafted scFvs retained the specificity of the murine monoclonal antibody, bound to the target antigen with high affinity (6.4-9.6 nM), and exhibited exceptional biophysical stability with retention of 89-93% of the initial binding activity after 6 days of incubation in human serum at 37degreesC. Selection of stable human scaffolds with high sequence identity to both the human germline and the rodent frameworks required only a small number of murine residues to be retained within the human frameworks in order to maintain the structural integrity of the antigen binding site. We expect this approach may be applicable for the rapid generation of highly stable humanized antibodies with low immunogenic potential.

Synthesis of the ester side chains of some potently antileukemic harringtonia alkaloids from chiral citrates

The selective reduction of one of the three carboxyl groups of two chiral citric acid derivatives to the corresponding aldehydes, under Rosenmund conditions, are reported together with the application of these aldehydes to the syntheses of the ester side chains of some potently antileukemic Cephalotaxus alkaloids e.g. anhydroharringtonine.

From alpha-cedrene to crinipellin B and onward: 25 years of the alkene-arene meta-photocycloaddition reaction in natural product synthesis

Wender and Howbert's remarkable synthesis of alpha-cedrene in 1981 brought the attention of the synthetic community to the alkene - arene meta-photocycloaddition reaction. Here we review the natural product syntheses that have been achieved, over the last 25 years, utilising this strategic level reaction.

Hydrothermal synthesis and structural characterization of novel alpha-Keggin unit-supported Cu(II)- and Mn(II)-bipyridine complexes from a tri-lacunary precursor

Blue [{Cu(2,2'-bipy)(2)}(2){alpha-SiW12O40}] (bipy = bipyridyl) (1) and pale yellow [Mn(2,2'-bipy)(3)](2)[alpha-SiW12O40] (2) have been synthesized hydrothermally and characterized by IR spectroscopy and single crystal X-ray structure analysis. In 1, the [alpha-SiW12O40](4-) ion acts as a bridge between the two [{Cu(2,2'-bipy)(2)](2+) moieties via coordination through the terminal oxygen atoms, while in 2, the [Mn(2,2'-bipy)(3)](2+) ion balances the charge on the polyoxo anion without forming any covalent bond. To the best of our knowledge, this is the first example of transition metal-mediated transformation of [alpha-SiW9O34](10-) to [alpha-SiW12O40](4-).

Zinc(II) mediated synthesis of an N-substituted 2-(2-pyridyl)imidazole from a 1,2-diketone and 2-(aminomethyl)pyridine and its ligational behaviour

Reaction of anhydrous ZnCl2 with the 1:2 condensate (L) of benzil and 2-(aminomethyl)pyridine in methanol gives monomeric ZnL'Cl-2 (1) where L' is 2-[(4,5-diphenyl-2-pyridin-2-yl-1H-imidazol-1-yl)-methyl]pyridine. In the X-ray crystal structure, 1 is found to contain tetrahedral zinc with an N2Cl2 coordination sphere and the N-substituent methylpyridine fragment hanging as a free arm. A tentative mechanism is proposed for the zinc mediated conversion of L-->L'. Demetallation of 1 by the action of aqueous NaOH yields L' in the free state. When L' is reacted with Zn(ClO4)(2).6H(2)O in a 1:2 molar proportion, [Zn(L')(2)](n)(ClO4)(2n).(H2O)(n/2).(CH2Cl2)(n/2) (2) is obtained. The zinc atom in 2, as revealed by X-ray crystallography, has a trigonal bipyramidal N-5 coordination sphere. There are two independent ligands in the asymmetric unit of 2. One of them bonds only to one zinc atom in a bidentate mode with the N-substituent methylpyridine hanging free while the other ligand binds to two different zinc atoms in a tridentate fashion, employing the N-substituent methylpyridine nitrogen atom to form the polymeric one-dimensional chain cation.

A facile one step synthesis of N-2 substituted 3-phenyliminoisoindolinones from N-(2-carboxybenzoyl)-anthranilic acid and the design of reverse-turn mimetics

Stirring of N-(2-carboxybenzoyl) anthranilic acid with anilines and amines such as p-toluidine, benzylamine, methyl esters of Leu, Phe, Ile and Val in presence of DCC produces N- 2 substituted 3-phenyliminoisoindolinones in very good yields. Single crystal X-ray diffraction studies and solution phase NMR and CD studies reveal that the 3-phenyliminoisoindolinone moiety is a turn-inducing scaffold which should be useful for reverse-turn mimetics.

Application of olefin metathesis for the synthesis of constrained beta-amino esters from norbornenes

Synthesis of a number of novel, conformationally rigid beta-amino esters has been achieved via a tandem olefin metathesis reaction. The starting materials are readily accessible from the Diels-Alder adduct between cyclopentadiene and maleic anhydride.

Carbanucleosides: synthesis of both enantiomers of 2-(6-chloro-purin-9-yl)-3,5-bishydroxymethyl cyclopentanol from D-glucose

The key intermediate 1,2:5,6-di-O-isopropylidene-3-deoxy-3 beta-allyl-alpha-D-glucofuranose (8) could be conveniently prepared through radical induced allyl substitution at C-3 of appropriate 1,2:5,6-di-O-isopropylidene-alpha-D-glucofuranose derivatives (7a,b) and used to synthesize enantiomeric bishydroxymethyl aminocyclopentanols 13 and 19 by the application of a 1,3-dipolar nitrone cycloaddition reaction involving the C-5 or C-1 aldehyde functionality. The products were subsequently transformed into carbanucleoside enantiomers 15 and 21. The diastercomeric isoxazolidinocyclopentane derivative 20 was similarly converted to carbanucleoside 22. (c) 2006 Elsevier Ltd. All rights reserved.

Synthesis of oxepane ring containing monocyclic, conformationally restricted bicyclic and spirocyclic nucleosides from d-glucose: a cycloaddition approach

Carbohydrate-derived substrates having (i) C-5 nitrone and C-3-O-allyl, (ii) C-4 vinyl and a C-3-O-tethered nitrone, and (iii) C-5 nitrone and C-4-allyloxymethyl generated tetracyclic isoxazolidinooxepane/-pyrart ring systems upon intramolecular nitrone cycloaddition reactions. Deprotection of the 1,2acetonides of these derivatives followed by introduction of uracil base via Vorbruggen reaction condition and cleavage of the isooxazolidine rings as well as of benzyl groups by transfer hydrogenolysis yielded an oxepane ring containing blicyclic and spirocyclic nucleosides. The corresponding oxepane based nucleoside analogues were prepared by cleavage of isoxazolidine and furanose rings, coupling of the generated amino functiontalities with 5-amino-4,6-dichloropyrimidine, cyclization to purine rings, and finally aminolysis.

Synthesis of alpha-galactooligosaccharides with alpha-galactosidase from Lactobacillus reuteri of canine origin

Crude cell-free extracts from Lactobacillus reuteri grown on cellobiose, maltose, lactose and raffinose were assayed for glycosidic activities. When raffinose was used as the carbon source, alpha-galactosidase was produced, showing the highest yield at the beginning of the stationary growth phase. A 64 kDa enzyme was purified by ultra- and gel filtration, and characterized for its hydrolytic and synthetic activity. Highest hydrolytic activity was found at pH 5.0 at 50 degreesC (K-M 0.55 mM, V-max 0.80 mumol min(-1) mg(-1) of protein). The crude cell-free extract was further used in glycosyl transfer reactions to synthesize oligosaccharides from melibiose and raffinose. At a substrate concentration of 23% (w/v) oligosaccharide mixtures were formed with main products being a trisaccharide at 26% (w/w) yield from melibiose after 8 h and a tetrasaccharide at 18% (w/w) yield from raffinose after 7 h. Methylation analysis revealed the trisaccharide to be 6' alpha-galactosyl melibiose and the tetrasaccharide to be stachyose. In both cases synthesis ceased when hydrolysis of the substrate reached 50%.