Testing white line strength in the dairy cow

The tensile strength of 576 pieces of white line horn collected over 6 mo from 14 dairy cows restricted to parity 1 or 2 was tested. None of the cows had ever been lame. Seven cows were randomly assigned to receive 20 mg/d biotin supplementation, and 7 were not supplemented. Hoof horn samples were taken from zones 2 and 3 (the more proximal and distal sites of the abaxial white line) of the medial and lateral claws of both hind feet on d 1 and on 5 further occasions over 6 mo. The samples were analyzed at 100% water saturation. Hoof slivers were notched to ensure that tensile strength was measured specifically across the white line region. The tensile stress at failure was measured in MPa and was adjusted for the cross-sectional area of the notch site. Data were analyzed in a multilevel model, which accounted for the repeated measures within cows. All other variables were entered as fixed effects. In the final model, there was considerable variation in strength over time. Tensile strength was significantly higher in medial compared with lateral claws, and zone 2 was significantly stronger than zone 3. Where the white line was visibly damaged the tensile strength was low. Biotin supplementation did not affect the tensile strength of the white line. Results of this study indicate that damage to the white line impairs its tensile strength and that in horn with no visible abnormality the white line is weaker in the lateral hind claw than the medial and in zone 3 compared with zone 2. The biomechanical strength was lowest at zone 3 of the lateral hind claw, which is the most common site of white line disease lameness in cattle.

Actinomyces vaccimaxillae sp. nov., from the jaw of a cow

A previously undescribed Actinomyces-like bacterium was isolated from a lesion in the jaw of a cow. Based on its cellular morphology and the results of biochemical testing, the organism was tentatively identified as a member of the genus Actinomyces. Comparative 16S rRNA gene sequencing studies showed that the bacterium represents a hitherto unknown species within the genus Actinomyces, and is related to a group of species that includes Actinomyces turicensis and its close relatives. It is proposed that the unknown organism be classified as Actinomyces vaccimaxillae sp. nov. (the type strain is CCUG 46091(T)=CIP 107423(T)).

Testing the influence of small crystals on ice size spectra using Doppler lidar observations

Analysis of the vertical velocity of ice crystals observed with a 1.5micron Doppler lidar from a continuous sample of stratiform ice clouds over 17 months show that the distribution of Doppler velocity varies strongly with temperature, with mean velocities of 0.2m/s at -40C, increasing to 0.6m/s at -10C due to particle growth and broadening of the size spectrum. We examine the likely influence of crystals smaller than 60microns by forward modelling their effect on the area-weighted fall speed, and comparing the results to the lidar observations. The comparison strongly suggests that the concentration of small crystals in most clouds is much lower than measured in-situ by some cloud droplet probes. We argue that the discrepancy is likely due to shattering of large crystals on the probe inlet, and that numerous small particles should not be included in numerical weather and climate model parameterizations.

Why are some handaxes symmetrical? Testing the influence of handaxe morphology on butchery effectiveness

The morphology of Acheulean handaxes continues to be a subject of debate amongst Lower Palaeolithic archaeologists, with some arguing that many handaxes are over-engineered for a subsistence function alone. This study aims to provide an empirical foundation for these debates by testing the relationship between a range of morphological variables, including symmetry, and the effectiveness of handaxes for butchery. Sixty handaxes were used to butcher 30 fallow deer by both a professional and a non-professional butcher. Regression analysis on the resultant data set indicates that while frontal symmetry may explain a small amount of variance in the effectiveness of handaxes for butchery, a large percentage of variance remains unexplained by symmetry or any of the other morphological variables under consideration.

A simple model for predicting soil temperature in snow-covered and seasonally frozen soil: model description and testing

Microbial processes in soil are moisture, nutrient and temperature dependent and, consequently, accurate calculation of soil temperature is important for modelling nitrogen processes. Microbial activity in soil occurs even at sub-zero temperatures so that, in northern latitudes, a method to calculate soil temperature under snow cover and in frozen soils is required. This paper describes a new and simple model to calculate daily values for soil temperature at various depths in both frozen and unfrozen soils. The model requires four parameters average soil thermal conductivity, specific beat capacity of soil, specific heat capacity due to freezing and thawing and an empirical snow parameter. Precipitation, air temperature and snow depth (measured or calculated) are needed as input variables. The proposed model was applied to five sites in different parts of Finland representing different climates and soil types. Observed soil temperatures at depths of 20 and 50 cm (September 1981-August 1990) were used for model calibration. The calibrated model was then tested using observed soil temperatures from September 1990 to August 2001. R-2-values of the calibration period varied between 0.87 and 0.96 at a depth of 20 cm and between 0.78 and 0.97 at 50 cm. R-2 -values of the testing period were between 0.87 and 0.94 at a depth of 20cm. and between 0.80 and 0.98 at 50cm. Thus, despite the simplifications made, the model was able to simulate soil temperature at these study sites. This simple model simulates soil temperature well in the uppermost soil layers where most of the nitrogen processes occur. The small number of parameters required means, that the model is suitable for addition to catchment scale models.

Primality-testing Mersenne numbers

Report of a systematic review of Mersenne numbers 2^p-1 for p < 62982.

Primality-testing Mersenne Numbers (II)

Reports the factor-filtering and primality-testing of Mersenne Numbers Mp for p < 100000, the latter using the ICL 'DAP' Distributed Array Processor.

Endgame table testing of studies - 1

The van der Heijden Studies Database has been reviewed to identify 'Draw Studies' with sub-7-man positions in the main line which are not draws. The data-mining method is described. Some 1,500 studies were faulted, 700 for the first time: 14 of the more interesting faults are highlighted and discussed.

Testing the limits of quasi-geostrophic theory: application to observed laboratory flows outside the quasi-geostrophic regime

We compare laboratory observations of equilibrated baroclinic waves in the rotating two-layer annulus, with numerical simulations from a quasi-geostrophic model. The laboratory experiments lie well outside the quasi-geostrophic regime: the Rossby number reaches unity; the depth-to-width aspect ratio is large; and the fluid contains ageostrophic inertia–gravity waves. Despite being formally inapplicable, the quasi-geostrophic model captures the laboratory flows reasonably well. The model displays several systematic biases, which are consequences of its treatment of boundary layers and neglect of interfacial surface tension and which may be explained without invoking the dynamical effects of the moderate Rossby number, large aspect ratio or inertia–gravity waves. We conclude that quasi-geostrophic theory appears to continue to apply well outside its formal bounds.