A comparison of cross-hole electrical and seismic data in fractured rock

Cross-hole anisotropic electrical and seismic tomograms of fractured metamorphic rock have been obtained at a test site where extensive hydrological data were available. A strong correlation between electrical resistivity anisotropy and seismic compressional-wave velocity anisotropy has been observed. Analysis of core samples from the site reveal that the shale-rich rocks have fabric-related average velocity anisotropy of between 10% and 30%. The cross-hole seismic data are consistent with these values, indicating that observed anisotropy might be principally due to the inherent rock fabric rather than to the aligned sets of open fractures. One region with velocity anisotropy greater than 30% has been modelled as aligned open fractures within an anisotropic rock matrix and this model is consistent with available fracture density and hydraulic transmissivity data from the boreholes and the cross-hole resistivity tomography data. However, in general the study highlights the uncertainties that can arise, due to the relative influence of rock fabric and fluid-filled fractures, when using geophysical techniques for hydrological investigations.

Multivariate relationships between groundwater chemistry and toxicity in an urban aquifer

Multivariate statistical methods were used to investigate file Causes of toxicity and controls on groundwater chemistry from 274 boreholes in an Urban area (London) of the United Kingdom. The groundwater was alkaline to neutral, and chemistry was dominated by calcium, sodium, and Sulfate. Contaminants included fuels, solvents, and organic compounds derived from landfill material. The presence of organic material in the aquifer caused decreases in dissolved oxygen, sulfate and nitrate concentrations. and increases in ferrous iron and ammoniacal nitrogen concentrations. Pearson correlations between toxicity results and the concentration of individual analytes indicated that concentrations of ammoinacal nitrogen, dissolved oxygen, ferrous iron, and hydrocarbons were important where present. However, principal component and regression analysis suggested no significant correlation between toxicity and chemistry over the whole area. Multidimensional Scaling was used to investigate differences in sites caused by historical use, landfill gas status, or position within the sample area. Significant differences were observed between sites with different historical land use and those with different gas status. Examination of the principal component matrix revealed that these differences are related to changes in the importance of reduced chemical species.

Holocene alluvial environments at Barking, Lower Thames Valley (London, UK)

Deposit modelling based on archived borehole logs supplemented by a small number of dedicated boreholes is used to reconstruct the main boundary surfaces and the thickness of the main sediment units within the succession of Holocene alluvial deposits underlying the floodplain in the Barking Reach of the Lower Thames Valley. The basis of the modelling exercise is discussed and the models are used to assess the significance of floodplain relief in determining patterns of sedimentation. This evidence is combined with the results of biostratigraphical and geochronological investigations to reconstruct the environmental conditions associated with each successive stage of floodplain aggradation. The two main factors affecting the history and spatial pattern of Holocene sedimentation are shown to be the regional behaviour of relative sea level and the pattern of relief on the surface of the sub-alluvial, Late Devensian Shepperton Gravel. As is generally the case in the Lower Thames Valley, three main stratigraphic units are recognised, the Lower Alluvium, a peat bed broadly equivalent to the Tilbury III peat of Devoy (1979) and an Upper Alluvium. There is no evidence to suggest that the floodplain was substantially re-shaped by erosion during the Holocene. Instead, the relief inherited from the Shepperton Gravel surface was gradually buried either by the accumulation of peat or by deposition of fine-grained sediment from suspension in standing or slow-moving water. The palaeoenvironmental record from Barking confirms important details of the Holocene record observed elsewhere in the Lower Thames Valley, including the presence of Taxus in the valley-floor fen carr woodland between about 5000 and 4000 cal BP, and the subsequent growth of Ulmus on the peat surface.