Toward vicarious calibration of microwave remote-sensing satellites in arid environments

The Soil Moisture and Ocean Salinity (SMOS) satellite marks the commencement of dedicated global surface soil moisture missions, and the first mission to make passive microwave observations at L-band. On-orbit calibration is an essential part of the instrument calibration strategy, but on-board beam-filling targets are not practical for such large apertures. Therefore, areas to serve as vicarious calibration targets need to be identified. Such sites can only be identified through field experiments including both in situ and airborne measurements. For this purpose, two field experiments were performed in central Australia. Three areas are studied as follows: 1) Lake Eyre, a typically dry salt lake; 2) Wirrangula Hill, with sparse vegetation and a dense cover of surface rock; and 3) Simpson Desert, characterized by dry sand dunes. Of those sites, only Wirrangula Hill and the Simpson Desert are found to be potentially suitable targets, as they have a spatial variation in brightness temperatures of <4 K under normal conditions. However, some limitations are observed for the Simpson Desert, where a bias of 15 K in vertical and 20 K in horizontal polarization exists between model predictions and observations, suggesting a lack of understanding of the underlying physics in this environment. Subsequent comparison with model predictions indicates a SMOS bias of 5 K in vertical and 11 K in horizontal polarization, and an unbiased root mean square difference of 10 K in both polarizations for Wirrangula Hill. Most importantly, the SMOS observations show that the brightness temperature evolution is dominated by regular seasonal patterns and that precipitation events have only little impact.

Diurnal cycle of land surface temperature in a desert encroachment zone as observed from satellites

Climate variability in the African Soudano-Sahel savanna zone has attracted much attention because of the persistence of anomalously low rainfall. Past efforts to monitor the climate of this region have focused on rainfall and vegetation conditions, while land surface temperature (LST) has received less attention. Remote sensing of LST is feasible and possible at global scale. Most remotely sensed estimates of LST are based on the National Oceanic and Atmospheric Administration (NOAA) Advanced Very High Resolution Radiometer (AVHRR) that are limited in their ability to capture the full diurnal cycle. Although more frequent observations are available from past geostationary satellites, their spatial resolution is coarser than that of polar orbiting satellites. In this study, the improved capabilities of the Spinning Enhanced Visible and Infrared Imager (SEVIRI) on the METEOSAT Second Generation (MSG) instrument are used to remotely sense the LST in the African Soudano-Sahel savanna zone at a resolution of 3 km and 15 minutes. In support of the Radiative Atmospheric Divergence using the ARM Mobile Facility (AMF), GERB and AMMA Stations (RADAGAST) project, African Monsoon Multidisciplinary Analyses (AMMA) project and the Department of Energy's Atmospheric Radiation Measurement (ARM) program, the ARM Mobile Facility was deployed during 2006 in this climatically sensitive region, thereby providing a unique opportunity to evaluate remotely sensed algorithms for deriving LST.

Observations of changes in marine boundary layer clouds

Recent research outlined by the Intergovernmental Panel on Climate Change (IPCC) highlights the response of marine boundary layer (MBL) clouds to warming associated with increasing greenhouse gases as a major contributor to uncertainties in model projections of climate change. Understanding how MBL clouds respond to increasing temperatures is hampered by the relative scarcity of marine surface observations and the difficulty of retrieving accurate parameters remotely from satellites. In this study we combine data from surface observations with that from the International Satellite Cloud Climatology Project (ISCCP), CloudSat and CALIPSO, with a view to investigating the spatial distribution and variations in MBL cloud fraction and cloud liquid water path (LWP). These results are then compared with the treatment of MBL clouds in the UK Met Office HadGEM models. Future work will assess how variations in LWP impact the top of atmosphere radiative energy balance using data from the Geostationary Earth Radiation Budget (GERB), in order to quantify the response of MBL clouds on interannual timescales to a changing climate

Hidden interlocutor misidentification in practical Turing Tests

Based on insufficient evidence, and inadequate research, Floridi and his students report inaccuracies and draw false conclusions in their Minds and Machines evaluation, which this paper aims to clarify. Acting as invited judges, Floridi et al. participated in nine, of the ninety-six, Turing tests staged in the finals of the 18th Loebner Prize for Artificial Intelligence in October 2008. From the transcripts it appears that they used power over solidarity as an interrogation technique. As a result, they were fooled on several occasions into believing that a machine was a human and that a human was a machine. Worse still, they did not realise their mistake. This resulted in a combined correct identification rate of less than 56%. In their paper they assumed that they had made correct identifications when they in fact had been incorrect.

Sponge layer feedbacks in middle-atmosphere models

Middle-atmosphere models commonly employ a sponge layer in the upper portion of their domain. It is shown that the relaxational nature of the sponge allows it to couple to the dynamics at lower levels in an artificial manner. In particular, the long-term zonally symmetric response to an imposed extratropical local force or diabatic heating is shown to induce a drag force in the sponge that modifies the response expected from the “downward control” arguments of Haynes et al. [1991]. In the case of an imposed local force the sponge acts to divert a fraction of the mean meridional mass flux upward, which for realistic parameter values is approximately equal to exp(−Δz/H), where Δz is the distance between the forcing region and the sponge layer and H is the density scale height. This sponge-induced upper cell causes temperature changes that, just below the sponge layer, are of comparable magnitude to those just below the forcing region. In the case of an imposed local diabatic heating, the sponge induces a meridional circulation extending through the entire depth of the atmosphere. This circulation causes temperature changes that, just below the sponge layer, are of opposite sign and comparable in magnitude to those at the heating region. In both cases, the sponge-induced temperature changes are essentially independent of the height of the imposed force or diabatic heating, provided the latter is located outside the sponge, but decrease exponentially as one moves down from the sponge. Thus the effect of the sponge can be made arbitrarily small at a given altitude by placing the sponge sufficiently high; e.g., its effect on temperatures two scale heights below is roughly at the 10% level, provided the imposed force or diabatic heating is located outside the sponge. When, however, an imposed force is applied within the sponge layer (a highly plausible situation for parameterized mesospheric gravity-wave drag), its effect is almost entirely nullified by the sponge-layer feedback and its expected impact on temperatures below largely fails to materialize. Simulations using a middle-atmosphere general circulation model are described, which demonstrate that this sponge-layer feedback can be a significant effect in parameter regimes of physical interest. Zonally symmetric (two dimensional) middle-atmosphere models commonly employ a Rayleigh drag throughout the model domain. It is shown that the long-term zonally symmetric response to an imposed extratropical local force or diabatic heating, in this case, is noticeably modified from that expected from downward control, even for a very weak drag coefficient

The dynamics and relationships of precipitation, temperature and convection boundaries in the dayside auroral ionosphere

A continuous band of high ion temperature, which persisted for about 8 h and zigzagged north-south across more than five degrees in latitude in the dayside (07:00– 15:00MLT) auroral ionosphere, was observed by the EISCAT VHF radar on 23 November 1999. Latitudinal gradients in the temperature of the F-region electron and ion gases (Te and Ti , respectively) have been compared with concurrent observations of particle precipitation and field-perpendicular convection by DMSP satellites, in order to reveal a physical explanation for the persistent band of high Ti , and to test the potential role of Ti and Te gradients as possible markers for the open-closed field line boundary. The north/south movement of the equatorward Ti boundary was found to be consistent with the contraction/expansion of the polar cap due to an unbalanced dayside and nightside reconnection. Sporadic intensifications in Ti , recurring on _10-min time scales, indicate that frictional heating was modulated by time-varying reconnection, and the band of high Ti was located on open flux. However, the equatorward Ti boundary was not found to be a close proxy of the open-closed boundary. The closest definable proxy of the open-closed boundary is the magnetosheath electron edge observed by DMSP. Although Te appears to be sensitive to magnetosheath electron fluxes, it is not found to be a suitable parameter for routine tracking of the open-closed boundary, as it involves case dependent analysis of the thermal balance. Finally, we have documented a region of newly-opened sunward convecting flux. This region is situated between the convection reversal boundary and the magnetosheath electron edge defining the openclosed boundary. This is consistent with a delay of several minutes between the arrival of the first (super-Alfv´enic) magnetosheath electrons and the response in the ionospheric convection, conveyed to the ionosphere by the interior Alfv´en wave. It represents a candidate footprint of the low-latitude boundary mixing layer on sunward convecting open flux

Generating recipient-centred explanations about drug prescription

In this paper we describe how we generated written explanations to ‘indirect users’ of a knowledge-based system in the domain of drug prescription. We call ‘indirect users’ the intended recipients of explanations, to distinguish them from the prescriber (the ‘direct’ user) who interacts with the system. The Explanation Generator was designed after several studies about indirect users' information needs and physicians' explanatory attitudes in this domain. It integrates text planning techniques with ATN-based surface generation. A double modeling component enables adapting the information content, order and style to the indirect user to whom explanation is addressed. Several examples of computer-generated texts are provided, and they are contrasted with the physicians' explanations to discuss advantages and limits of the approach adopted.

Data based constructive identification - overcoming the curse of dimensionality

The modelling of a nonlinear stochastic dynamical processes from data involves solving the problems of data gathering, preprocessing, model architecture selection, learning or adaptation, parametric evaluation and model validation. For a given model architecture such as associative memory networks, a common problem in non-linear modelling is the problem of "the curse of dimensionality". A series of complementary data based constructive identification schemes, mainly based on but not limited to an operating point dependent fuzzy models, are introduced in this paper with the aim to overcome the curse of dimensionality. These include (i) a mixture of experts algorithm based on a forward constrained regression algorithm; (ii) an inherent parsimonious delaunay input space partition based piecewise local lineal modelling concept; (iii) a neurofuzzy model constructive approach based on forward orthogonal least squares and optimal experimental design and finally (iv) the neurofuzzy model construction algorithm based on basis functions that are Bézier Bernstein polynomial functions and the additive decomposition. Illustrative examples demonstrate their applicability, showing that the final major hurdle in data based modelling has almost been removed.