Pervaporation dehydration of isopropyl alcohol with NaY zeolite incorvorated hybrid membranes

With a solution technique, NaY zeolite incorporated, tetraethylorthosilicate-crosslinked poly(vinyl alcohol) membranes were prepared. The resulting membranes were tested for their ability to separate isopropyl alcohol/water mixtures by pervaporation in the temperature range of 30-50 degrees C. The effects of the zeolite content and feed composition on the pervaporation performance of the membranes were investigated. The experimental results demonstrated that both flux and selectivity increased simultaneously with increasing zeolite content in the membranes. This was explained on the basis of the enhancement of hydrophilicity, selective adsorption, and establishment of a molecular sieving action attributed to the creation of pores in the membrane matrix. The membrane containing 15 mass % zeolite exhibited the highest separation selectivity of 3991 with a flux of 5.39 X 10(-2) kg/m(2) h with 10 mass % water in the feed at 30 degrees C. The total flux and flux of water were close to each other for almost all the studied membranes, and this suggested that the membranes could be used effectively to break the azeotropic point of water/isopropyl alcohol mixtures to remove a small amount of water from isopropyl alcohol. From the temperature-dependent diffusion and permeation values, the Arrhenius activation parameters were estimated. The activation energy values obtained for water were significantly lower than those for isopropyl alcohol, and this suggested that the developed membranes had a higher separation efficiency for water/isopropyl alcohol systems. The activation energy values for total permeation and water permeation were found to be almost the same for all the membranes, and this signified that coupled transport was minimal because of the highly selective nature of the membranes. Positive heat of sorption values were observed in all the membranes, and this suggested that Henry's mode of sorption was predominant. (c) 2008 Wiley Periodicals, lnc.

Developing an engaging virtual action learning programme for SME managers – A UK perspective

In this paper we present results from an EU-funded project with the aim of examining the adaptation of e-learning to meet the needs of managers in different contexts. A set of design considerations is elucidated. These principles were derived from an analysis of five completed projects. This was followed by focus group discussion in the UK to test the principles derived.. These focus group were planned so as to gain greater clarity in the design of e-learning programmes aimed at UK-based SME leaders and managers. This paper starts by looking at the importance of SME management development for the economic wellbeing of the community and goes on to review research into issues in engaging managers in development activities. The results of a review of an earlier experimental programme (ESeN) are presented as it formed part of the process which led to the identification of theoretical design principles then tested in the focus groups. Finally, recommendations are presented for SME e-learning providers as well as areas for further research.

The price of risk in construction projects: contingency approximation model (CAM)

Little attention has been focussed on a precise definition and evaluation mechanism for project management risk specifically related to contractors. When bidding, contractors traditionally price risks using unsystematic approaches. The high business failure rate our industry records may indicate that the current unsystematic mechanisms contractors use for building up contingencies may be inadequate. The reluctance of some contractors to include a price for risk in their tenders when bidding for work competitively may also not be a useful approach. Here, instead, we first define the meaning of contractor contingency, and then we develop a facile quantitative technique that contractors can use to estimate a price for project risk. This model will help contractors analyse their exposure to project risks; and help them express the risk in monetary terms for management action. When bidding for work, they can decide how to allocate contingencies strategically in a way that balances risk and reward.

Application of the entropy technique and genetic algorithms to construction site layout planning of medium-size projects

Genetic algorithms (GAs) have been introduced into site layout planning as reported in a number of studies. In these studies, the objective functions were defined so as to employ the GAs in searching for the optimal site layout. However, few studies have been carried out to investigate the actual closeness of relationships between site facilities; it is these relationships that ultimately govern the site layout. This study has determined that the underlying factors of site layout planning for medium-size projects include work flow, personnel flow, safety and environment, and personal preferences. By finding the weightings on these factors and the corresponding closeness indices between each facility, a closeness relationship has been deduced. Two contemporary mathematical approaches - fuzzy logic theory and an entropy measure - were adopted in finding these results in order to minimize the uncertainty and vagueness of the collected data and improve the quality of the information. GAs were then applied to searching for the optimal site layout in a medium-size government project using the GeneHunter software. The objective function involved minimizing the total travel distance. An optimal layout was obtained within a short time. This reveals that the application of GA to site layout planning is highly promising and efficient.

Are clinical documents optimised for patient safety? A critical analysis of patient safety outcomes using the EDA error model

Iatrogenic errors and patient safety in clinical processes are an increasing concern. The quality of process information in hardcopy or electronic form can heavily influence clinical behaviour and decision making errors. Little work has been undertaken to assess the safety impact of clinical process planning documents guiding the clinical actions and decisions. This paper investigates the clinical process documents used in elective surgery and their impact on latent and active clinical errors. Eight clinicians from a large health trust underwent extensive semi- structured interviews to understand their use of clinical documents, and their perceived impact on errors and patient safety. Samples of the key types of document used were analysed. Theories of latent organisational and active errors from the literature were combined with the EDA semiotics model of behaviour and decision making to propose the EDA Error Model. This model enabled us to identify perceptual, evaluation, knowledge and action error types and approaches to reducing their causes. The EDA error model was then used to analyse sample documents and identify error sources and controls. Types of knowledge artefact structures used in the documents were identified and assessed in terms of safety impact. This approach was combined with analysis of the questionnaire findings using existing error knowledge from the literature. The results identified a number of document and knowledge artefact issues that give rise to latent and active errors and also issues concerning medical culture and teamwork together with recommendations for further work.

Auto ID-Bridging the physical and the digital on construction projects

This book looks at how auto-ID has evolved and how it can be used in the construction industry and across projects from the perspective of all the stakeholders, from owners to design consultants, contractors and the supply chain. It could help to improve efficiency, reduce costs, ensure quality, protect the environment, and enhance safety.

The role of animal nutrition in designing optimal foods of animal origin as reviewed by the COST Action Feed for Health (FA0802)

This review provides an overview of the main scientific outputs of a network (Action) supported by the European Cooperation in Science and Technology (COST) in the field of animal science, namely the COST Action Feed for Health (FA0802). The main aims of the COST Action Feed for Health (FA0802) were: to develop an integrated and collaborative network of research groups that focuses on the roles of feed and animal nutrition in improving animal wellbeing and also the quality, safety and wholesomeness of human foods of animal origin; to examine the consumer concerns and perceptions as regards livestock production systems. The COST Action Feed for Health has addressed these scientific topics during the last four years. From a practical point of view three main scientific fields of achievement can be identified: feed and animal nutrition; food of animal origin quality and functionality and consumers’ perceptions. Finally, the present paper has the scope to provide new ideas and solutions to a range of issues associated with the modern livestock production system.

Il/legitimate risks? Occupational health and safety and the public in Britain, c. 1960-2015

The last 20 years have seen the emergence of a popular climate of antipathy towards occupational health and safety regulation within the UK, particularly within the mainstream British media. The governance of health and safety has thus in recent years become an increasingly visible and contested public and political issue. The extent of this contestation, and its impact on the State’s governance of health and safety in the workplace and beyond, is explained and historicized within this chapter. Why has public rhetoric about health and safety apparently become so important in framing the ways in which the State could legitimately act in recent years? The chapter demonstrates how since 1960 the State remained a significant player – one among many, admittedly – and that while its roles in managing health and safety had long been bounded by a number of factors, a variable that emerged with particular saliency over the last 20 years has been a mediated notion of ‘public opinion’. This focus serves to remind us of the ways in which State action has at certain moments been pushed in particular directions by factors beyond formal mechanisms of rule.