Direct time-resolved study of the gas-phase reactions of germylene with ethyl- and diethylgermane: absolute rate constants, temperature dependences, and mechanism

Time-resolved studies of germylene, GeH2, generated by the 193 nm laser flash photolysis of 3,4-dimethyl-1-germacyclopent-3-ene, have been carried out to obtain rate constants for its bimolecular reactions with ethyl- and diethylgermanes in the gas phase. The reactions were studied over the pressure range 1-100 Torr with SF6 as bath gas and at five temperatures in the range 297-564 K. Only slight pressure dependences were found for GeH2 + EtGeH3 (399, 486, and 564 K). The high pressure rate constants gave the following Arrhenius parameters: for GeH2 + EtGeH3, log A = -10.75 +/- 0.08 and E-a = -6.7 +/- 0.6 kJ mol(-1); for GeH2 + Et2GeH2, log A = -10.68 +/- 0.11 and E-a = -6.95 +/- 0.80 kJ mol(-1). These are consistent with fast, near collision-controlled, association processes at 298 K. RRKM modeling calculations are, for the most part, consistent with the observed pressure dependence of GeH2 + EtGeH3. The ethyl substituent effects have been extracted from these results and are much larger than the analogous methyl substituent effects in the SiH2 + methylsilane reaction series. This is consistent with a mechanistic model for Ge-H insertion in which the intermediate complex has a sizable secondary barrier to rearrangement.

Gas phase kinetic and quantum chemical studies of the reactions of silylene with the methylsilanes. Absolute rate constants, temperature dependences, RRKM modelling and potential energy surfaces

Time resolved studies of silylene, SiH2, generated by the 193 nm laser. ash photolysis of phenylsilane, have been carried out to obtain rate coefficients for its bimolecular reactions with methyl-, dimethyl- and trimethyl-silanes in the gas phase. The reactions were studied over the pressure range 3 - 100 Torr with SF6 as bath gas and at five temperatures in the range 300 - 625 K. Only slight pressure dependences were found for SiH2 + MeSiH3 ( 485 and 602 K) and for SiH2 + Me2SiH2 ( 600 K). The high pressure rate constants gave the following Arrhenius parameters: [GRAPHICS] These are consistent with fast, near to collision-controlled, association processes. RRKM modelling calculations are consistent with the observed pressure dependences ( and also the lack of them for SiH2 + Me3SiH). Ab initio calculations at both second order perturbation theory (MP2) and coupled cluster (CCSD(T)) levels, showed the presence of weakly-bound complexes along the reaction pathways. In the case of SiH2 + MeSiH3 two complexes, with different geometries, were obtained consistent with earlier studies of SiH2 + SiH4. These complexes were stabilised by methyl substitution in the substrate silane, but all had exceedingly low barriers to rearrangement to product disilanes. Although methyl groups in the substrate silane enhance the intrinsic SiH2 insertion rates, it is doubtful whether the intermediate complexes have a significant effect on the kinetics. A further calculation on the reaction MeSiH + SiH4 shows that the methyl substitution in the silylene should have a much more significant kinetic effect ( as observed in other studies).

Total synthesis of (+/-) maculalactone A, maculalactone B and maculalactone C and the determination of the absolute configuration of natural (+) maculalactone A by asymmetric synthesis

Maculalactones A, B and C from the marine cyanobacterium Kyrtuthrix maculans are amongst the only compounds based on the tribenzylbutyrolactone skeleton known in nature and (+) maculalactone A from the natural source possesses significant biological activity against various marine herbivores and marine settlers. We now report a concise synthesis of racemic maculalactone A in five steps from inexpensive starting materials. Maculalactones B and C were synthesized by a minor modification to this procedure, and the synthetic design also permitted an asymmetric synthesis of maculalactone A to be achieved in around 85% ee. The (+) and (-) enantiomers of maculalactone A were assigned, respectively, to the S and R configurations on the basis of the chiral selectivity expected for catecholborane reduction of an unsymmetrical ketone in the presence of Corey's oxazoborolidine catalyst. Surprisingly, it appeared that natural (+) maculalactone A was biosynthesized in K. maculans in a partially racemic form, comprising ca. 90-95% of the (S) enantiomer and 5-10% of its (R) enantiomer. Coincidentally therefore, the percentage enantiomeric excess of the product obtained from asymmetric synthesis almost exactly matched that found in nature. (C) 2004 Elsevier Ltd. All rights reserved.

Effects of presenting the baseline risk when communicating absolute and relative risk reductions

This study compares relative and absolute forms of presenting risk information about influenza and the need for vaccination. It investigates whether differences in people's risk estimates and their evaluations of risk information, as a result of the different presentation formats, are still apparent when they are provided with information about the baseline level of risk. The results showed that, in the absence of baseline information, the relative risk format resulted in higher ratings of satisfaction, perceived effectiveness of vaccination, and likelihood of being vaccinated. However, these differences were not apparent when baseline information was presented. Overall, provision of baseline information resulted in more accurate risk estimates and more positive evaluations of the risk messages. It is recommended that, in order to facilitate shared and fully informed decision making, information about baseline level of risk should be included in all health communications specifying risk reductions, irrespective of the particular format adopted.

Expressing medicine side effects: assessing the effectiveness of absolute risk, relative risk, and number needed to harm, and the provision of baseline risk information

Objective: To assess the effectiveness of absolute risk, relative risk, and number needed to harm formats for medicine side effects, with and without the provision of baseline risk information. Methods: A two factor, risk increase format (relative, absolute and NNH) x baseline (present/absent) between participants design was used. A sample of 268 women was given a scenario about increase in side effect risk with third generation oral contraceptives, and were required to answer written questions to assess their understanding, satisfaction, and likelihood of continuing to take the drug. Results: Provision of baseline information significantly improved risk estimates and increased satisfaction, although the estimates were still considerably higher than the actual risk. No differences between presentation formats were observed when baseline information was presented. Without baseline information, absolute risk led to the most accurate performance. Conclusion: The findings support the importance of informing people about baseline level of risk when describing risk increases. In contrast, they offer no support for using number needed to harm. Practice implications: Health professionals should provide baseline risk information when presenting information about risk increases or decreases. More research is needed before numbers needed to harm (or treat) should be given to members of the general populations. (c) 2005 Elsevier Ireland Ltd. All rights reserved.

The relationship between absolute and proportion scores of serial order memory: simulation predictions and empirical data

The capability of a feature model of immediate memory (Nairne, 1990; Neath, 2000) to predict and account for a relationship between absolute and proportion scoring of immediate serial recall when memory load is varied (the list-length effect, LLE) is examined. The model correctly predicts the novel finding of an LLE in immediate serial order memory similar to that observed with free recall and previously assumed to be attributable to the long-term memory component of that procedure (Glanzer, 1972). The usefulness of formal models as predictive tools and the continuity between short-term serial order and longer term item memory are considered.

Optimising the feedback loop of a millimetre-wave absolute photoacoustic power meter using H-infinity control synthesis

An H-infinity control strategy has been developed for the design of controllers used in feedback controlled electrical substitution measurements (FCESM). The methodology has the potential to provide substantial improvements in both response time and resolution of a millimetre-wave absolute photoacoustic power meter.

Gas-phase kinetics of chlorosilylene reactions II. ClSiH + C2H4: absolute rate measurements and quantum chemical and RRKM calculations for the prototype pi addition reaction

Time-resolved studies of chlorosilylene, ClSiH, generated by the 193 nm laser flash photolysis of 1-chloro-1-silacyclopent-3-ene, are carried out to obtain rate constants for its bimolecular reaction with ethene, C2H4, in the gas-phase. The reaction is studied over the pressure range 0.13-13.3 kPa (with added SF6) at five temperatures in the range 296-562 K. The second order rate constants, obtained by extrapolation to the high pressure limits at each temperature, fitted the Arrhenius equation: log(k(infinity)/cm(3) molecule(-1) s(-1))=(-10.55 +/- 0.10) + (3.86 +/- 0.70) kJ mol(-1)/RT ln10. The Arrhenius parameters correspond to a loose transition state and the rate constant at room temperature is 43% of that for SiH2 + C2H4, showing that the deactivating effect of Cl-for-H substitution in the silylene is not large. Quantum chemical calculations of the potential energy surface for this reaction at the G3MP2//B3LYP level show that, as well as 1-chlorosilirane, ethylchlorosilylene is a viable product. The calculations reveal how the added effect of the Cl atom on the divalent state stabilisation of ClSiH influences the course of this reaction. RRKM calculations of the reaction pressure dependence suggest that ethylchlorosilylene should be the main product. The results are compared and contrasted with those of SiH2 and SiCl2 with C2H4.