Structural, magnetic, and electronic properties of VxCr2−xS3(0

A new family of vanadium-substituted chromium sulfides (VxCr2-xS3, 0 < x < 2) has been prepared and characterized by powder X-ray and neutron diffraction, SQUID magnetometry, electrical resistivity, and Seebeck coefficient measurements. Vanadium substitution leads to a single-phase region with a rhombohedral Cr2S3 structure over the composition range 0.0 < x e 0.75, while at higher vanadium contents (1.6 e x < 2.0) a second single-phase region, in which materials adopt a cation-deficient Cr3S4 structure, is observed. Materials with the Cr2S3 structure all exhibit semiconducting behavior. However, both transport and magnetic properties indicate an increasing degree of electron delocalization with increasing vanadium content in this compositional region. Materials that adopt a Cr3S4-type structure exhibit metallic behavior. Magnetic susceptibility data reveal that all materials undergo a magnetic ordering transition at temperatures in the range 90–118 K. Low-temperature magnetization data suggest that this involves a transition to a ferrimagnetic state.

Identification of partial resetting using De as a function of illumination time

Modern age samples from various depositional environments were examined for signal resetting. For 19 modern aeolian/beach samples all De values obtained were View the MathML source, with ∼70% having View the MathML source. For 21 fluvial/colluvial samples, all De values were View the MathML source with ∼80% being View the MathML source. De as a function of illumination (OSL measurement) time (De(t)) plots were examined for all samples. Based on previous laboratory experiments, increases in De(t) were expected for partially reset samples, and constant De(t) for fully reset samples. All aeolian samples, both modern age and additional ‘young’ samples (<1000 years), showed constant (flat) De(t) while all modern, non-zero De, fluvial/colluvial samples showed increasing De(t). ‘Replacement plots’, where a regenerated signal is substituted for the natural, yielded constant (flat) De(t). These findings support strongly the use of De(t) as a method of identifying incomplete resetting in fluvial samples. Potential complicating factors, such as illumination (bleaching) spectrum, thermal instability and component composition are discussed and a series of internal checks on the applicability of the De(t) for each individual aliquot/grain level are outlined.

Synthesis and Electronic Structure of Dissymmetrical, Naphthalene-Bridged Sandwich Complexes [Cp′Fe(μ‑C10H8)MCp*]x (x = 0, +1; M =Fe, Ru; Cp′ = η5‑C5H2‑1,2,4‑tBu3; Cp* = η5‑C5Me5)

The dissymmetrical naphthalene-bridged complexes [Cp′Fe(μ-C10H8)FeCp*] (3; Cp* = η5-C5Me5, Cp′ = η5-C5H2-1,2,4-tBu3) and [Cp′Fe(μ-C10H8)RuCp*] (4) were synthesized via a one-pot procedure from FeCl2(thf)1.5, Cp′K, KC10H8, and [Cp* FeCl(tmeda)] (tmeda = N,N,N′,N′- tetramethylethylenediamine) or [Cp*RuCl]4, respectively. The symmetrically substituted iron ruthenium complex [Cp*Fe(μ-C10H8)RuCp*] (5) bearing two Cp* ligands was prepared as a reference compound. Compounds 3−5 are diamagnetic and display similar molecular structures, where the metal atoms are coordinated to opposite sides of the bridging naphthalene molecule. Cyclic voltammetry and UV/vis spectroelectrochemistry studies revealed that neutral 3−5 can be oxidized to monocations 3+−5+ and dications 32+−52+. The chemical oxidation of 3 and 4 with [Cp2Fe]PF6 afforded the paramagnetic hexafluorophosphate salts [Cp′Fe(μ-C10H8)FeCp*]PF6 ([3]PF6) and [Cp′Fe(μ-C10H8)RuCp*]PF6 ([4]PF6), which were characterized by various spectroscopic techniques, including EPR and 57Fe Mössbauer spectroscopy. The molecular structure of [4]PF6 was determined by X-ray crystallography. DFT calculations support the structural and spectroscopic data and determine the compositions of frontier molecular orbitals in the investigated complexes. The effects of substituting Cp* with Cp′ and Fe with Ru on the electronic structures and the structural and spectroscopic properties are analyzed.

Tagged phosphine reagents to assist reaction work-up by phase-switched scavenging using a modular flow reactor

The use of three orthogonally tagged phosphine reagents to assist chemical work-up via phase-switch scavenging in conjunction with a modular flow reactor is described. These techniques (acidic, basic and Click chemistry) are used to prepare various amides and tri-substituted guanidines from in situ generated iminophosphoranes.

Synthesis of linked heterocycles via use of bis-acetylenic compounds

Linked bis-pyrazoles, a pyrazolyl-isoxazole, a pyrazolyl-pyrimidine and a pyrazolyl-triazole were synthesized starting with commercially available 1,4-bis(trimethylsilyl)-1,3-butadiyne 1 or readily available bis-acetylenic diketone 22. A stepwise approach based on the use of 1 allowed the synthesis of nonsymmetrically substituted bis-pyrazoles and linked heterocycles with two different cores whereas a symmetric approach based on the use of 22 allowed a very short synthesis of symmetric bis-pyrazoles.

Multistep π dimerization of tetrakis(n-decyl)heptathienoacene radical cations: a combined experimental and theoretical study

Radical cations of a heptathienoacene a,b-substituted with four n-decyl side groups (D4T7C+) form exceptionally stable p-dimer dications already at ambient temperature (Chem. Comm. 2011, 47, 12622). This extraordinary p-dimerization process is investigated here with a focus on the ultimate[D4T7C+]2 p-dimer dication and yet-unreported transitoryspecies formed during and after the oxidation. To this end, we use a joint experimental and theoretical approach that combines cyclic voltammetry, in situ spectrochemistry and spectroelectrochemistry, EPR spectroscopy, and DFT calculations. The impact of temperature, thienoacene concentration, and the nature and concentration of counteranions on the p-dimerization process is also investigated in detail. Two different transitory species were detected in the course of the one-electron oxidation: 1) a different transient conformation of the ultimate [D4T7C+]2 p-dimer dications, the stability of which is strongly affected by the applied experimental conditions, and 2) intermediate [D4T7]2C+ p-dimer radical cations formed prior to the fully oxidized [D4T7]2C+ p-dimer dications. Thus, this comprehensive work demonstrates the formation of peculiar supramolecular species of heptathienoacene radical cations, the stability, nature, and structure of which have been successfully analyzed. We therefore believe that this study leads to a deeper fundamental understanding of the mechanism of dimer formation between conjugated aromatic systems.

The effect of alkyl substitution on the extraction properties of BTPhen ligands for the partitioning of trivalent minor actinides and lanthanides in spent nuclear fuels

Bis-triazinylphenanthroline ligands (BTPhens), which contain additional alkyl (n-butyl and sec-butyl) groups attached to the triazine rings, have been synthesized, and the effects of this alkyl substitution on their extraction properties with Ln(III) and An(III) cations in simulated nuclear waste solutions have been studied. The speciation of n-butyl-substituted ligand (C4- BTPhen) with some trivalent lanthanide nitrates was elucidated by 1 H-NMR spectroscopic titrations. These experiments have shown that the dominant species in solution were the 1:2 complexes [Ln(III)(BTPhen)2], even at higher Ln(III) concentrations, and the relative stability of 2:1 to 1:1 BTPhen-Ln(III) complexes varied with different lanthanides. As expected, sec-butylsubstituted ligand (sec-C4 BTPhen) showed higher solubility than C4-BTPhen in certain diluents. A greater separation factor (SFAm/Eu = ca. 210) was observed for sec-C4-BTPhen compared to C4-BTPhen (SFAm/Eu = ca. 125) in 1-octanol at 4 M HNO3 solutions. The greater separation factor may be due to the higher solubility of the 2:1 complex for sec-C4-BTPhen at the interface than the 1:1 complex of C4-BTPhen.

Tuning thermal properties and microphase separation in aliphatic polyester ABA copolymers

Four alkyl substituted β-lactones were investigated as monomers in ring opening polymerisation to produce a family of poly(3-hydroxyalkanoate)s. Homopolymers were synthesised using a robust aluminium salen catalyst, resulting in polymers with low dispersity (Đ < 1.1) and predictable molecular weights. ABA triblock copolymers were prepared using poly(L-lactic acid) as the A block and the aforementioned poly(3-hydroxyalkanoate) as the B block via a sequential addition method. Characterisation of these copolymers determined they were well controlled with low dispersities and predictable molecular weight. DSC analysis determined copolymers prepared from β-butyrolactone or β-valerolactone yielded polymers with tunable and predictable thermal properties. Copolymers prepared from β-heptanolactone yielded a microphase separated material as indicated by SAXS, with two distinct Tgs. The polymers could be readily cast into flexible films and their improved tensile properties were explored.

Stabilization of the i-motif structure by the intra-strand cross-link formation

The i-motif structures are formed by oligonucleotides containing cytosine tracts under acidic conditions. The folding of the i-motif under physiological conditions is of great interest because of its biological role. In this study, we investigated the effect of the intra-strand cross-link on the stability of the i-motif structure. The 4-vinyl-substituted analog of thymidine (T-vinyl) was incorporated into the 5′-end of the human telomere complementary strand, which formed the intra-strand cross-link with the internal adenine. The intra-strand cross-linked i-motif displayed CD spectra similar to that of the natural i-motif at acidic pH, which was transformed into a random coil with the increasing pH. The pH midpoint for the transition from the i-motif to random coil increased from pH 6.1 for the natural one to pH 6.8 for the cross-linked one. The thermodynamic parameters were obtained by measuring the thermal melting behaviors by CD and UV, and it was determined that the intra-strand cross-linked i-motif is stabilized due to a favorable entropy effect. Thus, this study has clearly indicated the validity of the intra-strand cross-linking for stabilization of the i-motif structure.

Ball milling as an effective route for the preparation of doped bornite: synthesis, stability and thermoelectric properties

Bornite, Cu5FeS4, is a naturally-occuring mineral with an ultralow thermal conductivity and potential for thermoelectric power generation. We describe here a new, easy and scalable route to synthesise bornite, together with the thermoelectric behaviour of manganese-substituted derivatives, Cu5Fe1-xMnxS4 (0 ≤ x ≤ 0.10). The electrical and thermal transport properties of Cu5Fe1-xMnxS4 (0 ≤ x ≤ 0.10), which are p-type semiconductors, were measured from room temperature to 573 K. The stability of bornite was investigated by thermogravimetric analysis under inert and oxidising atmospheres. Repeated measurements of the electrical transport properties confirm that bornite is stable up to 580 K under an inert atmosphere, while heating to 890 K results in rapid degradation. Ball milling leads to a substantial improvement in the thermoelectric figure of merit of unsusbtituted bornite (ZT = 0.55 at 543 K), when compared to bornite prepared by conventional high-temperature synthesis (ZT < 0.3 at 543 K). Manganese-substituted samples have a ZT comparable to that of unsubstituted bornite.

Alan Rugman’s methodology

This paper argues that the intellectual contribution of Alan Rugman reflects his distinctive research methodology. Alan Rugman trained as an economist, and relied heavily on economic principles throughout his work. He believed that one good theory was sufficient for IB studies, and that theory, he maintained, was internalisation theory. He rejected theoretical pluralism, and believed that IB suffered from a surfeit of theories. Alan was a positivist. The test of a good theory was that it led to clear predictions which were corroborated by empirical evidence. Many IB theories, Alan believed, were weak; their proliferation sowed confusion and they needed to be refuted. Alan’s interpretation of internalisation was, however, unconventional in some respects. He played down the trade-offs presented in Coase’s original work, and substituted heuristics in their place. Instead of analysing internalisation as a context-specific choice between alternative contractual arrangements, he presented it as a strategic imperative for firms possessing strong knowledge advantages. His heuristics did not apply to every possible case, but in Alan’s view they applied in the great majority of cases and were therefore a basis for management action.