The concept of a new video detector for ghosted IF signals

The effect of terrestrial television multipath signals on the intermediate frequency (IF) vestigial sideband filter and the video detector are discussed. A new detector is proposed which, by processing the detected phase quadrature information, derives the correct phase for synchronous detection in the presence of multipath effects. This minimizes dispersion and produces a detected video signal with the linear addition of any ghosts.

Vidibus: a low-cost, modular bus system for real-time video processing

The advantages of standard bus systems have been appreciated for many years. The ability to connect only those modules required to perform a given task has both technical and commercial advantages over a system with a fixed architecture which cannot be easily expanded or updated. Although such bus standards have proliferated in the microprocessor field, a general purpose low-cost standard for digital video processing has yet to gain acceptance. The paper describes the likely requirements of such a system, and discusses three currently available commercial systems. A new bus specification known as Vidibus, developed to fulfil these requirements, is presented. Results from applications already implemented using this real-time bus system are also given.

Distributed water ingress and water potential measurements using fibre optics

We report on a distributed moisture detection scheme which uses a cable design based on waterswellable hydrogel polymers. The cable modulates the loss characteristic of light guided within a multi-mode optical fibre in response to relative water potentials in the surrounding environment. Interrogation of the cable using conventional optical time-domain reflectometry (OTDR) instruments allows water ingress points to be identified and located with a spatial resolution of 50 cm. The system has been tested in a simulated tendon duct grouting experiment as a means of mapping the extent of fill along the duct during the grouting process. Voided regions were detected and identified to within 50 cm. A series of salt solutions has been used to determine the sensor behaviour over a range of water potentials. These experiments predict that measurements of soil moisture content can be made over the range 0 to – 1500 kPa. Preliminary data on soil measurements have shown that the sensor can detect water pressure changes with a resolution of 45 kPa. Applications for the sensor include quality assurance of grouting procedures, verification of waterproofing barriers and soil moisture content determination (for load-bearing calculations).

An agent based approach to distributed task modeling for co-operative task support

This paper describes the design and implementation of an agent based network for the support of collaborative switching tasks within the control room environment of the National Grid Company plc. This work includes aspects from several research disciplines, including operational analysis, human computer interaction, finite state modelling techniques, intelligent agents and computer supported co-operative work. Aspects of these procedures have been used in the analysis of collaborative tasks to produce distributed local models for all involved users. These models have been used as the basis for the production of local finite state automata. These automata have then been embedded within an agent network together with behavioural information extracted from the task and user analysis phase. The resulting support system is capable of task and communication management within the transmission despatch environment.

Distortion in distributed virtual environments

This paper proposes a solution to the problems associated with network latency within distributed virtual environments. It begins by discussing the advantages and disadvantages of synchronous and asynchronous distributed models, in the areas of user and object representation and user-to-user interaction. By introducing a hybrid solution, which utilises the concept of a causal surface, the advantages of both synchronous and asynchronous models are combined. Object distortion is a characteristic feature of the hybrid system, and this is proposed as a solution which facilitates dynamic real-time user collaboration. The final section covers implementation details, with reference to a prototype system available from the Internet.

Minimising the latency induced by consistency control, within a large scale multi-user distributed virtual reality system

Where users are interacting in a distributed virtual environment, the actions of each user must be observed by peers with sufficient consistency and within a limited delay so as not to be detrimental to the interaction. The consistency control issue may be split into three parts: update control; consistent enactment and evolution of events; and causal consistency. The delay in the presentation of events, termed latency, is primarily dependent on the network propagation delay and the consistency control algorithms. The latency induced by the consistency control algorithm, in particular causal ordering, is proportional to the number of participants. This paper describes how the effect of network delays may be reduced and introduces a scalable solution that provides sufficient consistency control while minimising its effect on latency. The principles described have been developed at Reading over the past five years. Similar principles are now emerging in the simulation community through the HLA standard. This paper attempts to validate the suggested principles within the schema of distributed simulation and virtual environments and to compare and contrast with those described by the HLA definition documents.

A specific pole placement technique to minimise hardware requirements within a real time terrestrial and cable video echo canceller

The real time hardware architecture of a deterministic video echo canceller (deghoster) system is presented. The deghoster is capable of calculating all the multipath channel distortion characteristics from terrestrial and cable television in one single pass while performing real time video in-line ghost cancellation. The results from the actual system are also presented in this paper.

Local oscillator phase lock under multipath for video deghoster systems

Under multipath conditions, standard Video Intermediate Frequency (VIF) detectors generate a local oscillator phase error and consequently produce a dispersed non-ideal detected video signal due to the presence of additional IF carriers. The dispersed video causes problems when attempting to identify and remove the multipath interference, or ghosts, by the use of Digital Signal Processing and digital filtering. A digital phase lock system is presented which derives the correct phase for synchronous detection in the presence of multipath by using correlation information that has already been calculated as part of the deghosting process. As a result, the video deghoster system is made simpler, faster and more economical.

The findings from a single pass deghoster prototype for terrestrial transmitted video

A deterministic prototype video deghoster is presented which is capable of calculating all the multipath channel distortion characteristics in one single pass and subsequently removing the multipath distortions, commonly termed ghosts. Within the system, a channel identification algorithm finds in isolation all the ghost components while a dedicated DSP filter subsystem is capable of removing ghosts in real time. The results from the system are presented.

A new method for multipath channel characterisation for terrestrial transmitted video

Under the multipath conditions of terrestrial television transmission, ghost carriers cause additive information to be generated by the VSB filter within the television receiver. By analysis of this a priori effect of the VSB filter under a ghosted condition the inphase and phase quadrature detected video signals are defined. Derived from these results, a new algorithm based upon correlation techniques is presented which finds the characteristics of the amplitude and delay of individual ghosts. These characteristics are then passed to a deterministic deghoster to minimise ghost effects.

Children playing branded video games: The impact of interactivity on product placement effectiveness

This study extends product placement research by testing the impact of interactivity on product placement effectiveness. The results suggest that when children cannot interact with the placements in video games, perceptual fluency is the underlying mechanism leading to positive affect. Therefore, the effects are only evident in a stimulus-based choice where the same stimulus is provided as a cue. However, when children have the opportunity to interact with the placements in video games, they may be influenced by conceptual fluency. Thus, placements are still effective in a memory-based choice where no stimulus is provided as a cue. Keywords: Perceptual fluency; Conceptual fluency; Video games; Interactivity; Children; Product placement