Particle image velocimetry measurements of turbulent flow within outdoor and indoor urban scale models and flushing motions in urban canopy layers

We investigate the spatial characteristics of urban-like canopy flow by applying particle image velocimetry (PIV) to atmospheric turbulence. The study site was a Comprehensive Outdoor Scale MOdel (COSMO) experiment for urban climate in Japan. The PIV system captured the two-dimensional flow field within the canopy layer continuously for an hour with a sampling frequency of 30 Hz, thereby providing reliable outdoor turbulence statistics. PIV measurements in a wind-tunnel facility using similar roughness geometry, but with a lower sampling frequency of 4 Hz, were also done for comparison. The turbulent momentum flux from COSMO, and the wind tunnel showed similar values and distributions when scaled using friction velocity. Some different characteristics between outdoor and indoor flow fields were mainly caused by the larger fluctuations in wind direction for the atmospheric turbulence. The focus of the analysis is on a variety of instantaneous turbulent flow structures. One remarkable flow structure is termed 'flushing', that is, a large-scale upward motion prevailing across the whole vertical cross-section of a building gap. This is observed intermittently, whereby tracer particles are flushed vertically out from the canopy layer. Flushing phenomena are also observed in the wind tunnel where there is neither thermal stratification nor outer-layer turbulence. It is suggested that flushing phenomena are correlated with the passing of large-scale low-momentum regions above the canopy.

Urban tracer dispersion experiments during the second DAPPLE field campaign in London 2004

As part of the DAPPLE programme two large scale urban tracer experiments using multiple simultaneous releases of cyclic perfluoroalkanes from fixed location point sources was performed. The receptor concentrations along with relevant meteorological parameters measured are compared with a three screening dispersion models in order to best predict the decay of pollution sources with respect to distance. It is shown here that the simple dispersion models tested here can provide a reasonable upper bound estimate of the maximum concentrations measured with an empirical model derived from field observations and wind tunnel studies providing the best estimate. An indoor receptor was also used to assess indoor concentrations and their pertinence to commonly used evacuation procedures.

The influence of office location on commuting behaviour

To fully appreciate the environmental impact of an office building, the transport-related carbon dioxide (CO2) emissions resulting from its location should be considered in addition to the emissions that result from the operation of the building itself. Travel-related CO2 emissions are a function of three criteria, two of which are influenced by physical location and one of which is a function of business practice. The two spatial criteria are, first, the location of the office relative to the location of the workforce, the market, complementary business activities (and the agglomeration benefits this offers) and, second, the availability and cost of transport modes. The business criterion is the need for, and therefore frequency of, visits and this, in turn, depends on the requirement for a physically present workforce and face-to-face contact with clients. This paper examines the commuting-related CO2 emissions that result from city centre and out-of-town office locations. Using 2001 Census Special Workplace Statistics which record people’s residence, usual workplace and mode of transport between them, distance travelled and mode of travel were calculated for a sample of city centre and out-of-town office locations. The results reveal the extent of the difference between transport-related CO2 emitted by commuters to out-of-town and city centre locations. The implications that these findings have for monitoring the environmental performance of offices are discussed.

Virtual landmarking for locality aware peer IDs

In Peer-to-Peer (P2P) networks, it is often desirable to assign node IDs which preserve locality relationships in the underlying topology. Node locality can be embedded into node IDs by utilizing a one dimensional mapping by a Hilbert space filling curve on a vector of network distances from each node to a subset of reference landmark nodes within the network. However this approach is fundamentally limited because while robustness and accuracy might be expected to improve with the number of landmarks, the effectiveness of 1 dimensional Hilbert Curve mapping falls for the curse of dimensionality. This work proposes an approach to solve this issue using Landmark Multidimensional Scaling (LMDS) to reduce a large set of landmarks to a smaller set of virtual landmarks. This smaller set of landmarks has been postulated to represent the intrinsic dimensionality of the network space and therefore a space filling curve applied to these virtual landmarks is expected to produce a better mapping of the node ID space. The proposed approach, the Virtual Landmarks Hilbert Curve (VLHC), is particularly suitable for decentralised systems like P2P networks. In the experimental simulations the effectiveness of the methods is measured by means of the locality preservation derived from node IDs in terms of latency to nearest neighbours. A variety of realistic network topologies are simulated and this work provides strong evidence to suggest that VLHC performs better than either Hilbert Curves or LMDS use independently of each other.

The location of executive suites and business centers in the United States: an exploratory analysis

Increasingly, corporate occupiers seek more flexible ways of meeting their accommodation needs. One consequence of this process has been the growth of the executive suite, serviced office or business centre market. This paper, the final report of a research project funded by the Real Estate Research Institute, focuses upon the geographical distribution of business centers offering executive suites within the US. After a brief review of the development of the market, the paper examines the availability of data, provides basic descriptive statistics of the distribution of executive suites by state and by metropolitan statistical area and then attempts to model the distribution using demographic and socio-economic data at MSA level. The distribution reflects employment in key growth sectors and the position of the MSA in the urban hierarchy. An appendix presents a preliminary view of the global distribution of suites.

Location and collocation advantages in international innovation

Purpose – This paper examines the role of location-specific (L) advantages in the spatial distribution of multinational enterprise (MNE) R&D activity. The meaning of L advantages is revisited. In addition to L advantages that are industry-specific, the paper emphasises that there is an important category of L advantages, referred to as collocation advantages. Design/methodology/approach – Using the OLI framework, this paper highlights that the innovation activities of MNEs are about interaction of these variables, and the essential process of internalising L advantages to enhance and create firm-specific advantages. Findings – Collocation advantages derive from spatial proximity to specific unaffiliated firms, which may be suppliers, competitors, or customers. It is also argued that L advantages are not always public goods, because they may not be available to all firms at a similar or marginal cost. These costs are associated with access and internalisation of L advantages, and – especially in the case of R&D – are attendant with the complexities of embeddedness. Originality/value – The centralisation/decentralisation, spatial separation/collocation debates in R&D location have been mistakenly viewed as a paradox facing firms, instead of as a trade-off that firms must make.