Modelling convective processes during the suppressed phase of the a Madden-Julian Oscillation: Comparing single-column models with cloud resolving models

The role of convective processes in moistening the atmosphere during suppressed periods of the suppressed phase of a Madden-Julian oscillation is investigated in cloud-resolving model (CRM) simulations, and the impact of moistening on the subsequent evolution of convection is assessed as part of a Global Energy and Water Cycle Experiment Cloud System Study (GCSS) intercomparison project. The ability of single-column model (SCM) versions of a number of state-of-the-art climate and numerical weather prediction models to capture these convective processes is also evaluated. During the suppressed periods, the CRMs are found to simulate a maximum moistening around 3 km, which is associated with a predominance of shallow convection. All SCMs produce adequate amounts of shallow convection during the suppressed periods, comparable to that seen in CRMs, but the relatively drier SCMs have higher precipitation rates than the relatively wetter SCMs and CRMs. The relatively drier SCMs dry, rather than moisten, the lower troposphere below the melting level. During the transition periods, convective processes act to moisten the atmosphere above the level at which mean advection changes from moistening to drying, despite an overall drying effect for the column. The SCMs capture some essence of this moistening at upper levels. A gradual transition from shallow to deep convection is simulated by the CRMs and the wetter SCMs during the transition periods, but the onset of deep convection is delayed in the drier SCMs. This results in lower precipitation rates for these SCMs during the active periods, although much better agreement exists between the models at this time.

What is the new medicines use review ‘patient survey’ attempting to capture in the context of existing patient satisfaction with pharmacy questionnaires and a new conceptual framework?

The community pharmacy service medicines use review (MUR) was introduced in 2005 ‘to improve patient knowledge, concordance and use of medicines’ through a private patient–pharmacist consultation. The MUR presents a fundamental change in community pharmacy service provision. While traditionally pharmacists are dispensers of medicines and providers of medicines advice, and patients as recipients, the MUR considers pharmacists providing consultation-type activities and patients as active participants. The MUR facilitates a two-way discussion about medicines use. Traditional patient–pharmacist behaviours transform into a new set of behaviours involving the booking of appointments, consultation processes and form completion, and the physical environment of the patient–pharmacist interaction moves from the traditional setting of the dispensary and medicines counter to a private consultation room. Thus, the new service challenges traditional identities and behaviours of the patient and the pharmacist as well as the environment in which the interaction takes place. In 2008, the UK government concluded there is at present too much emphasis on the quantity of MURs rather than on their quality.[1] A number of plans to remedy the perceived imbalance included a suggestion to reward ‘health outcomes’ achieved, with calls for a more focussed and scientific approach to the evaluation of pharmacy services using outcomes research. Specifically, the UK government set out the main principal research areas for the evaluation of pharmacy services to include ‘patient and public perceptions and satisfaction’as well as ‘impact on care and outcomes’. A limited number of ‘patient satisfaction with pharmacy services’ type questionnaires are available, of varying quality, measuring dimensions relating to pharmacists’ technical competence, behavioural impressions and general satisfaction. For example, an often cited paper by Larson[2] uses two factors to measure satisfaction, namely ‘friendly explanation’ and ‘managing therapy’; the factors are highly interrelated and the questions somewhat awkwardly phrased, but more importantly, we believe the questionnaire excludes some specific domains unique to the MUR. By conducting patient interviews with recent MUR recipients, we have been working to identify relevant concepts and develop a conceptual framework to inform item development for a Patient Reported Outcome Measure questionnaire bespoke to the MUR. We note with interest the recent launch of a multidisciplinary audit template by the Royal Pharmaceutical Society of Great Britain (RPSGB) in an attempt to review the effectiveness of MURs and improve their quality.[3] This template includes an MUR ‘patient survey’. We will discuss this ‘patient survey’ in light of our work and existing patient satisfaction with pharmacy questionnaires, outlining a new conceptual framework as a basis for measuring patient satisfaction with the MUR. Ethical approval for the study was obtained from the NHS Surrey Research Ethics Committee on 2 June 2008. References 1. Department of Health (2008). Pharmacy in England: Building on Strengths – Delivering the Future. London: HMSO. www. official-documents.gov.uk/document/cm73/7341/7341.pdf (accessed 29 September 2009). 2. Larson LN et al. Patient satisfaction with pharmaceutical care: update of a validated instrument. JAmPharmAssoc 2002; 42: 44–50. 3. Royal Pharmaceutical Society of Great Britain (2009). Pharmacy Medicines Use Review – Patient Audit. London: RPSGB. http:// qi4pd.org.uk/index.php/Medicines-Use-Review-Patient-Audit. html (accessed 29 September 2009).

Overview: oxidant and particle photochemical processes above a south-east Asian tropical rain forest (the OP3 project); introduction, rationale, location, characteristics and tools

In April–July 2008, intensive measurements were made of atmospheric composition and chemistry in Sabah, Malaysia, as part of the "Oxidant and particle photochemical processes above a South-East Asian tropical rainforest" (OP3) project. Fluxes and concentrations of trace gases and particles were made from and above the rainforest canopy at the Bukit Atur Global Atmosphere Watch station and at the nearby Sabahmas oil palm plantation, using both ground-based and airborne measurements. Here, the measurement and modelling strategies used, the characteristics of the sites and an overview of data obtained are described. Composition measurements show that the rainforest site was not significantly impacted by anthropogenic pollution, and this is confirmed by satellite retrievals of NO2 and HCHO. The dominant modulators of atmospheric chemistry at the rainforest site were therefore emissions of BVOCs and soil emissions of reactive nitrogen oxides. At the observed BVOC:NOx volume mixing ratio (~100 pptv/pptv), current chemical models suggest that daytime maximum OH concentrations should be ca. 105 radicals cm−3, but observed OH concentrations were an order of magnitude greater than this. We confirm, therefore, previous measurements that suggest that an unexplained source of OH must exist above tropical rainforest and we continue to interrogate the data to find explanations for this.

Evaluation of forest snow processes models (SnowMIP2)

Thirty‐three snowpack models of varying complexity and purpose were evaluated across a wide range of hydrometeorological and forest canopy conditions at five Northern Hemisphere locations, for up to two winter snow seasons. Modeled estimates of snow water equivalent (SWE) or depth were compared to observations at forest and open sites at each location. Precipitation phase and duration of above‐freezing air temperatures are shown to be major influences on divergence and convergence of modeled estimates of the subcanopy snowpack. When models are considered collectively at all locations, comparisons with observations show that it is harder to model SWE at forested sites than open sites. There is no universal “best” model for all sites or locations, but comparison of the consistency of individual model performances relative to one another at different sites shows that there is less consistency at forest sites than open sites, and even less consistency between forest and open sites in the same year. A good performance by a model at a forest site is therefore unlikely to mean a good model performance by the same model at an open site (and vice versa). Calibration of models at forest sites provides lower errors than uncalibrated models at three out of four locations. However, benefits of calibration do not translate to subsequent years, and benefits gained by models calibrated for forest snow processes are not translated to open conditions.

Towards an assessment of multiple ecosystem processes and services via functional traits

Managing ecosystems to ensure the provision of multiple ecosystem services is a key challenge for applied ecology. Functional traits are receiving increasing attention as the main ecological attributes by which different organisms and biological communities influence ecosystem services through their effects on underlying ecosystem processes. Here we synthesize concepts and empirical evidence on linkages between functional traits and ecosystem services across different trophic levels. Most of the 247 studies reviewed considered plants and soil invertebrates, but quantitative trait–service associations have been documented for a range of organisms and ecosystems, illustrating the wide applicability of the trait approach. Within each trophic level, specific processes are affected by a combination of traits while particular key traits are simultaneously involved in the control of multiple processes. These multiple associations between traits and ecosystem processes can help to identify predictable trait–service clusters that depend on several trophic levels, such as clusters of traits of plants and soil organisms that underlie nutrient cycling, herbivory, and fodder and fibre production. We propose that the assessment of trait–service clusters will represent a crucial step in ecosystem service monitoring and in balancing the delivery of multiple, and sometimes conflicting, services in ecosystem management.

Bottlenecks in name resolution of migrating processes

Three naming strategies are discussed that allow the processes of a distributed application to continue being addressed by their original logical name, along all the migrations they may be forced to undertake because of performance-improvement goals. A simple centralised solution is firstly discussed which showed a software bottleneck with the increase of the number of processes; other two solutions are considered that entail different communication schemes and different communication overheads for the naming protocol. All these strategies are based on the facility that each process is allowed to survive after migration, even in its original site, only to provide a forwarding service to those communications that used its obsolete address.

Insights into processes and deposits of hazardous vulcanian explosions at Soufrière Hills Volcano during 2008 and 2009 (Montserrat, West Indies)

During the Soufrière Hills eruption, vulcanian explosions have generally occurred 1) in episodic cycles; 2) isolated during pauses in extrusion, and 3) after major collapses of the dome. In a different eruptive context, significant vulcanian explosions occurred on 29 July 2008, 3 December 2008, and 3 January 2009. Deposits are pumiceous except for the 3 December event. We reconstructed the dispersal pattern of the deposits and their textural characteristics to evaluate erupted volume and vesicularity of the magma at fragmentation. We discuss the implications of these explosions in terms of eruptive processes and chronology, and the hazards posed by their sudden and often unheralded occurrence. We suggest that overpressurization of the conduit can develop over time-scales of months to weeks by a process of self-sealing of conduit walls and/or the cooling dome by silica polymorphs. This work provides new insights for understanding the generation of hazardous vulcanian explosions at andesitic volcanoes.

Controls on boundary layer ventilation: Boundary layer processes and large-scale dynamics

Midlatitude cyclones are important contributors to boundary layer ventilation. However, it is uncertain how efficient such systems are at transporting pollutants out of the boundary layer, and variations between cyclones are unexplained. In this study 15 idealized baroclinic life cycles, with a passive tracer included, are simulated to identify the relative importance of two transport processes: horizontal divergence and convergence within the boundary layer and large-scale advection by the warm conveyor belt. Results show that the amount of ventilation is insensitive to surface drag over a realistic range of values. This indicates that although boundary layer processes are necessary for ventilation they do not control the magnitude of ventilation. A diagnostic for the mass flux out of the boundary layer has been developed to identify the synoptic-scale variables controlling the strength of ascent in the warm conveyor belt. A very high level of correlation (R-2 values exceeding 0.98) is found between the diagnostic and the actual mass flux computed from the simulations. This demonstrates that the large-scale dynamics control the amount of ventilation, and the efficiency of midlatitude cyclones to ventilate the boundary layer can be estimated using the new mass flux diagnostic. We conclude that meteorological analyses, such as ERA-40, are sufficient to quantify boundary layer ventilation by the large-scale dynamics.